Search NASA⌕ Search

SEARCH · Search NASA

Results for “AVIATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,387 records · Page 77

A Loran-C prototype navigation receiver for general aviation

Prototype equipment was developed for flight evaluation which provides enroute navigation in both latitude-longitude and rho-theta coordinates. The nonprecision approach capabilities of this equipment was evaluated. The antenna/preamplifier coupler, the RF processor, tracking loop hardware, tracking loop software, and the video output are discussed. Laboratory and flight test results are evaluated.

Lilley, R. W.↗

A study of general aviation community noise impact and annoyance

The method involved the selection of three airports which were dominated by aircraft weighing 12,500 lbs or under and which were also undergoing a change relative to utilization. Also, there was interest in airports with different utilization levels so that effect of number of operations could be considered. In addition, there was a requirement to select airports with communities in the surrounding areas which were exposed to aircraft operations noise. Noise annoyance response data was obtained from available sources. These sources included environmental impact statements, interviews with airport managers, noise complaint information, community meetings concerned with projected changes in airport utilization, and social survey data. As a means of objectively assessing the noise impact due to aircraft operations, noise measurement and computer noise modeling determinations were obtained for each airport. Listening quality tape recordings were also obtained.

Mabry, J. E.↗

Downbursts and microbursts - An aviation hazard

Downburst and microburst phenomena occurring since 1975 are studied, based on meteorological analyses of aircraft accidents, aerial surveys of wind effects left behind downbursts, and studies of sub-mesoscale wind systems. It is concluded that microbursts beneath small, air mass thunderstorms are unpredictable in terms of weather forecast. Most aircraft incidents, however, were found to have occurred in the summer months, June through August. An intense microburst could produce 150 mph horizontal winds as well as 60 fps downflows at the tree-top level. The largest contributing factor to aircraft difficulties seemed to be a combination of the headwind decrease and the downflow. Anemometers and/or pressure sensors placed near runways were found effective for detecting gust fronts, but not for detecting downbursts. It is recommended that new detection systems placed on the ground or airborne, be developed, and that pilots be trained for simulated landing and go-around through microbursts.

Fujita, T. T.↗

Aviation turbine fuel properties and their trends

This paper is an examination of published Jet A inspection data covering selected property distributions, averages, and trends for the period from 1969 to 1979. Yearly median values of aromatics, mercaptan sulfur content, 10-percent distillation temperature, smoke point, and freezing point are changing with time, approaching their specification limit values, particularly in the last three years. A near-specification property is defined as one within a stated tolerance band around the specification limit. On this basis, most fuel samples have one to three near-specification properties, the most common being aromatics, smoke point, and freezing point.

Friedman, R.↗

Determining performance parameters of general aviation aircraft

A method for determining propeller efficiency and drag from flight tests, using relatively simple instrumentation, is under development at Mississippi State University. Flight test data from several simple maneuvers are combined to produce sufficient information to determine the desired parameters. Information obtained from the transient response of airspeed to a step change in power or drag in level flight is utilized. Theory is developed and results of preliminary computer studies and preliminary flight test are presented.

Bull, G.↗

Symposium on Aviation Psychology, 1st, Ohio State University, Columbus, OH, April 21, 22, 1981, Proceedings

The impact of modern technology on the role, responsibility, authority, and performance of human operators in modern aircraft and ATC systems was examined in terms of principles defined by Paul Fitts. Research into human factors in aircraft operations and the use of human factors engineering for aircraft safety improvements were discussed, and features of the man-machine interface in computerized cockpit warning systems are examined. The design and operational features of computerized avionics displays and HUDs are described, along with results of investigations into pilot decision-making behavior, aircrew procedural compliance, and aircrew judgment training programs. Experiments in vision and visual perception are detailed, as are behavioral studies of crew workload, coordination, and complement. The effectiveness of pilot selection, screening, and training techniques are assessed, as are methods for evaluating pilot performance.

Source record↗

General Aviation Synthesis Program

Program performs preliminary design of fixed-wing aircraft. Emphasis placed on fixed wing aircraft with propulsion systems varying from single piston engine with fixed-pitch propeller through twin turbo-prop/turbofan systems used in business or transport aircraft. GASP written in FORTRAN IV.

Galloway, T.↗

An investigation of the aerodynamic characteristics of a new general aviation airfoil in flight

A low speed airfoil, the GA(W)-2, - a 13% thickness to chord ratio airfoil was evaluated. The wing of a Beech Sundowner was modified at by adding balsa ribs and covered with aluminum skin, to alter the existing airfoil shape to that of the GA(W)-2 airfoil. The aircraft was flown in a flight test program that gathered wing surface pressures and wake data from which the lift drag, and pitching moment of the airfoil could be determined. After the base line performance of the airfoil was measured, the drag due to surface irregularities such as steps, rivets and surface waviness was determined. The potential reduction of drag through the use of surface coatings such as KAPTON was also investigated.

Gregorek, G. M.↗

Study of the damping characteristics of general aviation aircraft panels and development of computer programs to calculate the effectiveness of interior noise control treatment, part 1

Tests were carried out on 20 inch x 20 inch panels at different test conditions using free-free panels, clamped panels, and panels as installed in the KU-FRL acoustic test facility. Tests with free-free panels verified the basic equipment set-up and test procedure. They also provided a basis for comparison. The results indicate that the effect of installed panels is to increase the damping ratio at the same frequency. However, a direct comparison is not possible, as the fundamental frequency of a free-free panel differs from the resonance frequency of the panel when installed. The damping values of panels installed in the test facility are closer to the damping values obtained with fixed-fixed panels. Effects of damping tape, stiffeners, and bonded and riveted edged conditions were also investigated. Progress in the development of a simple interior noise level control program is reported.

Navaneethan, R.↗

A microcomputer-based position updating system for general aviation utilizing Loran-C

Modern digital electronic technology is used to produce a device to convert LORAN C to useful pilot information using a simple software algebra and low cost microprocessor devices. Results indicate that the processor based LORAN C navigator has an accuracy of 1.0 nm or less over an area typically covered by a triad of Loran C stations and can execute a position update in less than 0.2 seconds. The system was tested in 30 hours of flight and proved that it can give reliable and accurate navigation information. Methods of converting time differences to position, design considerations for the microcomputer system, and the system for coordinate conversion are discussed. Testing with predetermined points and possible fixes for errors are also considered.

Fischer, J. P.↗

An overview of general aviation propulsion research programs at NASA Lewis Research Center

The review covers near-term improvements for current-type piston engines, as well as studies and limited corroborative research on several advanced g/a engine concepts, including diesels, small turboprops and both piston and rotary stratified-charge engines. Also described is basic combustion research, cycle modeling and diagnostic instrumentation work that is required to make new engines a reality.

Willis, E. A.↗

General Aviation Turbine Engine (GATE) Overview

When all the technology studies were done and the accompanying market analyses were complete, the conclusion was that it is indeed possible to reduce the cost of turbine engines by a factor of 3 using low-cost manufacturing techniques and increased production rates. In the interest of reducing engine cost, some performance was sacrificed. Yet we ended up with about a 20 percent predicted improvement in SFC over current technology turboprops. However, even this level of improvement does not match the low SFC of reciprocating powerplants--particularly those advanced concepts described earlier. The 20 percent better SFC and much lower weight of a turboprop does mean that if such a powerplant were installed in a resized small airplane, one could save between 10 and 30 percent fuel relative to existing recip engines, depending on different mission and airplane combinations. The price of the aircraft would go down about 15 percent in the case of a high powered single, or 25 percent in the case of a normal size twin. The operating costs would decrease about 10 percent in the case of the single, and as much as 35 percent in the case of the twin.

Strack, W. C.↗

Research on aviation fuel instability

The underlying causes of fuel thermal degradation are discussed. Topics covered include: nature of fuel instability and its temperature dependence, methods of measuring the instability, chemical mechanisms involved in deposit formation, and instrumental methods for characterizing fuel deposits. Finally, some preliminary thoughts on design approaches for minimizing the effects of lowered thermal stability are briefly discussed.

Baker, C. E.↗

Aviation weather services

The primary responsibilities of the National Weather Service (NWS) are to: provide warnings of severe weather and flooding for the protection of life and property; provide public forecasts for land and adjacent ocean areas for planning and operation; and provide weather support for: production of food and fiber; management of water resources; production, distribution and use of energy; and efficient and safe air operations.

Charles H. Sprinkle↗

NASA's aviation safety - meteorology research programs

The areas covering the meteorological hazards program are: severe storms and the hazards to flight generated by severe storms; clear air turbulence; icing; warm fog dissipation; and landing systems. Remote sensing of ozone by satellites, and the use of satellites as data relays is also discussed.

Roger L. Winblade↗