Grain Size and Phase Purity Characterization of U 3 Si 2 Pellet Fuel
Characterization of U 3 Si 2 fresh fuel pellets is important for quality assurance and validation of the finished product. Grain size measurement methods, phase identification methods using scanning electron microscopes equipped with energy dispersive spectroscopy and x-ray diffraction, and phase quantification methods via image analysis have been developed and implemented on U 3 Si 2 pellet samples. A wide variety of samples have been characterized including representative pellets from an initial irradiation experiment, and samples produced using optimized methods to enhance phase purity from an extended fabrication effort. The average grain size for initial pellets was between 16 and 18 µm. The typical average grain size for pellets from the extended fabrication was between 20 and 30 µm with some samples exhibiting irregular grain growth. Pellets from the latter half of extended fabrication had a bimodal grain size distribution consisting of coarsened grains (>80 µm) surrounded by the typical (20-30 µm) grain structure around the surface. Phases identified in initial uranium silicide pellets included: U 3 Si 2 as the main phase composing about 80 vol. %, Si rich phases (USi and U 5 Si 4 ) composing about 13 vol. %, and UO 2 composing about 5 vol. %. Initial batches from the extended U 3 Si 2 pellet fabrication had similar phases and phase quantities. The latter half of the extended fabrication pellet batches did not contain Si rich phases, and had between 1-5% UO 2 : achieving U 3 Si 2 phase purity between 95 vol. % and 98 vol. % U 3 Si 2 . The amount of UO 2 in sintered U 3 Si 2 pellets is correlated to the length of time between U 3 Si 2 powder fabrication and pellet formation. These measurements provide information necessary to optimize fabrication efforts and a baseline for future work on this fuel compound.