Search NASA⌕ Search

SEARCH · Search NASA

Results for “Protection”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,387 records · Page 77

Air sampler collects and protects minute particles

Air ejector impactor sampler collects and protects samples of particles greater than 0.1 micron in diameter. In operation, it causes impaction of particle-laden air onto several collection surfaces within a collection cylinder. When not operating, the collector cylinder is maintained in a retracted state within a protective envelope.

Wood, R. C.↗

Fuse protects circuit from voltage and current overloads

Low-melting resistor connected in series with the load protects the circuit against current overloads. It protects test subjects and patients being monitored by electronic instrumentation from inadvertant overloads of current, and sensitive electronic equipment against high-voltage damage.

Casey, L. O.↗

Evaluation of heat- and blast-protection materials

A program was initiated at the Kennedy Space Center in December 1967 and conducted through December 1969 to evaluate the performance of heat- and blast-protection materials for ground support equipment used during the Apollo/Saturn launches. Materials believed to be generally suitable for heat and blast protection were subjected to launch-exposure tests. Tests were made during the Apollo/Saturn 502, 503, and 505 launches. Tests were also made in a local laboratory, as an alternative to the restrictive requirements of launch-exposure tests, to determine the effects of torch-flame exposure on ablative materials. Five materials were found to be satisfactory in all major test categories. It was determined that torch-flame tests can probably be utilized as an acceptable substitute for the booster-engine-exhaust exposure tests for basic screening of candidate materials.

Morrison, J. D.↗

Apollo experience report: Protection of life and health

The development, implementation, and effectiveness of the Apollo Lunar Quarantine Program and the Flight Crew Health Stabilization Program are discussed as part of the broad program required for the protection of the life and health of U.S. astronauts. Because the goal of the Apollo Program has been the safe transport of men to the moon and back to earth, protection of the astronauts and of the biosphere from potentially harmful lunar contaminants has been required. Also, to ensure mission success, the continuing good health of the astronauts before and during a mission has been necessary. Potential applications of specific aspects of the health and quarantine programs to possible manned missions to other planets are discussed.

Wooley, B. C.↗

Advanced Extravehicular Protective System (AEPS) study

A summary is presented of Advanced Extravehicular Protective Systems (AEPS) for the future missions beyond Skylab in earth orbit, on the lunar surface, and on the Martian surface. The study concentrated on the origination of regenerable life support concepts for use in portable extravehicular protective systems, and included evaluation and comparison with expendable systems, and selection of life support subsystems. The study was conducted in two phases. In the first phase, subsystem concepts for performing life support functions in AEPS which are regenerable or partially regenerable were originated, and in addition, expendable subsystems were considered. Parametric data for each subsystem concept were evolved including subsystem weight and volume, power requirement, thermal control requirement; base regeneration equipment weight and volume, requirement. The second phase involved an evaluation of the impact of safety considerations involving redundant and/or backup systems on the selection of the regenerable life support subsystems. In addition, the impact of the space shuttle program on regenerable life support subsystem development was investigated.

Williams, J. L.↗

Protective coatings for columbium applied in the field.

The various aspects of field repair of columbium alloy panels with protective coatings designed as part of the Space Shuttle thermal protection system are examined. The field repair of the coatings is accomplished by employing ceramic cement repairs, and reapplying the fused slurry silicide coating. Techniques are described which improve the practicality of these repairs by employing torch heating. The repair coating quality is demonstrated by testing which simulates flight temperature, pressure, stress and acoustic vibration conditions as a function of time. Conclusions on the present status of field repair coatings are presented and recommendations are given for appropriate future activities relative to the use on an operational Space Shuttle system.

Carter, J.↗

Proceedings of the Symposium on the Protection Against Radiation Hazards in Space Book 1: Radiation Environment in Space. Effects of Space Radiation on Radio Sensitive Objects. Biological Effects of Space Radiation

The realization in recent years that outer space is traversed by high-energy radiations has caused man to reevaluate the feasibility of manned or even instrumented exploration outside our atmosphere. Fortunately, it is possible to determine the nature and intensities of these radiations and to produce similar radiations on earth by means of accelerators. Thus we can learn how to attenuate them and to design capsules which afford protection against them. Of course this protection carries a weight penalty so that there is a premium on optimizing the shield design. Many groups in the United states are engaged in research to this end,and it was the purpose of this symposium to bring these groups together so that they could exchange information. To make the meeting more comprehensive, sessions on the nature of the radiations and their effects on people and things were included. However, the major part of the meeting was devoted to discussions on shielding research, comprising theoretical calculations and experiments carried out mainly with high-energy accelerators. The symposium committee feels that the aims of the symposium were met and that progress in space research program was greatly accelerated thereby.

Source record↗

Optimization of thermal protection systems for the space vehicle. Volume 2: User's manual

The development of the computational techniques for the design optimization of thermal protection systems for the space shuttle vehicle are discussed. The resulting computer program was then used to perform initial optimization and sensitivity studies on a typical thermal protection system (TPS) to demonstrate its application to the space shuttle TPS design. The program was developed in FORTRAN IV for CDC 6400 computer, but it was subsequently converted to the FORTRAN V language to be used on the Univac 1108.

Source record↗

Application of ERTS-1 data to the protection and management of New Jersey's coastal environment

The author has identified the following significant results. Analysis of ERTS-1 imagery and complementary aircraft overflights has led to the development of seventeen information products that are being utilized within the Department of Environmental Protection as new sources of information for coastal zone management. Problem areas of significance to the State, and in which product development has contributed to date, have been identified as: the environmental effects of offshore waste disposal, the placement of ocean outfalls, the better understanding of littoral processes for shore protection, the delineation of the coastal ecozones, and determination of the flushing characteristics of the State's estuaries. Of equal importance has been the development of a capability within the State to use and understand remote sensor-derived information.

Yunghans, R. S.↗

Application of ERTS-1 data to the protection and management of New Jersey's coastal environment

The author has identified the following significant results. The principal thrust of this ERTS-1 experiment is to develop quasi-operational information products from analysis of ERTS-1 imagery and collateral aerial photography and to apply these products to the practical regulation, protection, and management of New Jersey's coastal environment. Incorporated into this goal is the development of procedures for the operational use of ERTS-1 data products within New Jersey's Department of Environmental Protection. Analysis and product preparation for operational needs has centered on four major coastal resource problem areas: detection of land use changes in the coastal zone; siting of ocean outfalls; monitoring of offshore waste disposal; and calculation of recession rates along the Atlantic Shore. The relative utility and estimated monetary benefits derived from ERTS and aircraft imagery for each problem area have been determined. Of equal importance is the development to a capability within the State to use and understand remote sensor-derived information, and the application of this information to meet the requirements of current and anticipated coastal zone legislation.

Yunghans, R. S.↗

Overvoltage protection network

Electrical equipment to be protected from overvoltage is connected with a possible source of overvoltage via an input conductor. A fuse is connected in series with the input conductor. A spark gap is connected between the input conductor and ground for conducting the overvoltage current to ground and for blowing the fuse to open the circuit to the electrical equipment. A pulse attenuator network is provided between the spark gap and the electrical equipment to be protected for attenuating the pulse of energy passing through the fuse and spark gap prior to blowing of the fuse. The pulse attenuator network includes additional shunt spark gaps, series inductance, and a series connection of a twisted shielded pair of conductors having low-voltage insulation.

Cambra, J. M.↗

Potential of thin, sputtered films as erosion resistant protective coatings, part 1

The characteristics of thin, pyrolytically deposited films for protection of surfaces from oxidation and abrasion are discussed. The limitations of depositing erosion resistant films are described. Environmental tests of first stage compressor blades in a T-58 engine after coating with a thin film were conducted. Photographic examples of the effectiveness of the thin films in protecting the turbine blades are provided. Methods for operating a sputtering system and the equipment used for film deposition are defined.

Gentner, K.↗

Pathogenetic validation of the use of biological protective agents and early treatment in cases of radiation injury simulating radiation effects under space flight conditions

In considering a radiation safety system for space flights, the various measures to protect man against radiation include drug prophylaxis. At the present time a great deal of experimental material has been accumulated on the prevention and treatment of radiation injuries. Antiradiation effectiveness has been established for sulfur- and nitrogen-containing substances, auxins, cyanides, polynucleotides, mucopolysaccharides, lipopolysaccharides, aminosaccharides, synthetic polymers, vitamins, hormones, amino acids and other compounds which can be divided into two basic groups - biological and chemical protective agents.

Rogozkin, V. D.↗

Protective overcoating of films

Kodak Film Type SO-212 was emulsion overcoated with gelatin and lacquer to evaluate the feasibility of application of the coatings, any image degradation, and the relative protection offered against abrasion. Evaluated were: Eastman motion picture film lacquer Type 485, water solutions of Eastman purified Calfskin gelatin, and experimental Eastman gelatin stripping film of 4 and 6 microns. Conclusions reached were: (1) All coatings can be applied with relative ease with the only limitation being that of equipment. (2) None of the coatings degrade the processed image. (3) All of the coatings provide protection to the emulsion. These conclusions apply to any film which may be considered for overcoating.

Maas, K. A.↗

Application of ERTS-1 data to the protection and management of New Jersey's coastal environment

The author has identified the following significant results. Quasi-operational information products for coastal zone management have been prepared using ERTS-1 imagery and collateral aerial photography. These products were applied to the practical regulation, protection, and management of New Jersey's coastal environment. Procedures were developed for the operational use of ERTS-1 data products within New Jersey's Department of Environmental Protection. Successful analysis and product preparation for operational needs centered on four major coastal resource problem areas: (1) detection of environmental changes in coastal areas, (2) siting of ocean outfalls, (3) monitoring of offshore waste disposal, and (4) calculation of recession rates along the Atlantic Shore. The utility and monetary benefits derived from ERTS and aircraft imagery for each problem area have been determined. The NJDEP estimates the possibility of $620,000 yearly savings through the use of an operational ERTS system and a one-time savings of $2.8 million on current or planned projects if a truly operational ERTS type satellite were available.

Yunghans, R. S.↗

The Langley thermal protection system test facility: A description including design operating boundaries

A description of the Langley thermal protection system test facility is presented. This facility was designed to provide realistic environments and times for testing thermal protection systems proposed for use on high speed vehicles such as the space shuttle. Products from the combustion of methane-air-oxygen mixtures, having a maximum total enthalpy of 10.3 MJ/kg, are used as a test medium. Test panels with maximum dimensions of 61 cm x 91.4 cm are mounted in the side wall of the test region. Static pressures in the test region can range from .005 to .1 atm and calculated equilibrium temperatures of test panels range from 700 K to 1700 K. Test times can be as long as 1800 sec. Some experimental data obtained while using combustion products of methane-air mixtures are compared with theory, and calibration of the facility is being continued to verify calculated values of parameters which are within the design operating boundaries.

Klich, G. F.↗

Space shuttle program: Lightning protection criteria document

The lightning environment for space shuttle design is defined and requirements that the design must satisfy to insure protection of the vehicle system from direct and indirect effects of lightning are imposed. Specifications, criteria, and guidelines included provide a practical and logical approach to protection problems.

Source record↗