Search NASA⌕ Search

SEARCH · Search NASA

Results for “circularity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,387 records · Page 77

Antenna feed for linear and circular polarization

Antenna system ransmits linearly-polarized microwave radio signal, yet circularly-polarized incoming signal is received without polarization-mismatch losses. Network uses only hybrid junctions, diplexer, and four-probe antenna; no waveguide switches are required. Other circuit arrangements are possible, using additional transmitters and receivers.

Bathker, D. A.↗

Pitot pressure measurements in flow fields behind circular-arc nozzles with exhaust jets at subsonic free-stream Mach numbers

The flow field behind a circular arc nozzle with exhaust jet was studied at subsonic free stream Mach numbers. A conical probe was used to measure the pitot pressure in the jet and free stream regions. Pressure data were recorded for two nozzle configurations at nozzle pressure ratios of 2.0, 2.9, and 5.0. At each set of test conditions, the probe was traversed from the jet center line into the free stream region at seven data acquisition stations. The survey began at the nozzle exit and extended downstream at intervals. The pitot pressure data may be applied to the evaluation of computational flow field models, as illustrated by a comparison of the flow field data with results of inviscid jet plume theory.

Mason, M. L.↗

On wings of circular design

Prandtl's method of sources and sinks for air foils is used to investigate the aerodynamics of circular wings in constant flow. Lift distribution, total lift, and pitching moment are investigated as well as the influence of changes in the angle of attack.

Kinner, W.↗

Stress distribution in a semi-infinite body symmetrically loaded over a circular area

Algorithms are developed for computing stresses in a semi-infinite body when loaded by a uniform pressure acting over a circular area. The algorithm allows easy determination of any stress component in a semi-infinite body having a known Poisson's ratio. Example curves are plotted for Portland cement grout and metal representative values.

Mcginness, H.↗

Periodic steamwise variations of heat transfer coefficients for incline and staggered arrays of circular jets with crossflow of spent air

Heat transfer characteristics were measured for inline and staggered arrays of circular jets impinging on a surface parallel to the jet orifice plate. The impinging flow was constrained to exit in a single direction along the channel formed by the jet plate and the heat transfer surface. In this configuration the air discharged from upstream transverse rows of jet holes imposes a crossflow of increasing magnitude on the succeeding downstream jet rows. Streamwise heat transfer coefficient profiles were determined for a streamwise resolution of one-third the streamwise hole spacing, utilizing a specially constructed test surface.

Florschuetz, L. W.↗

Electrical conductivity anomalies associated with circular lunar maria

A strong anisotropy is observed in magnetic field fluctuations measured by the Lunokhod 2 magnetometer located on the eastern edge of Mare Serenitatis. This anisotropy can be explained by a regional anomaly in the subsurface electrical conductivity distribution associated with the mare similar to the proposed conductivity anomaly associated with Mare Imbrium. The Serenitatis magnetic field anisotropy is compared to the field fluctuation measured by the Apollo 16 magnetometer 1100 km to the south, and this comparison indicates that the subsurface conductivity distribution can be modeled by a nonconducting layer in the lunar lithosphere which is 150 km thick beneath the highlands and 300 km thick beneath Serenitatis. The decrease in electrical conductivity of the upper mantle beneath the mare may result from lower temperatures due to transport of thermal energy and radioactive heat sources to the surface during mare flooding. This proposed anomaly, along with that proposed for Mare Imbrium, strengthens the possibility of regional anomalies in electrical conductivity associated with all circular lunar maria.

Dyal, P.↗

Transmission of sound through nonuniform circular ducts with compressible mean flows

An acoustic theory is developed to determine the sound transmission and attenuation through an infinite hard-walled or lined circular duct carrying compressible, sheared mean flows and having a variable cross section. The theory is applicable to large as well as small axial variations, as long as the mean flow does not separate. The technique is based on solving for the envelopes of the quasi-parallel acoustic modes that exist in the duct instead of solving for the actual wave, thereby reducing the computation time and the round-off error encountered in purely numerical techniques. A number of test cases that demonstrate the flexibility of the program are included. Convergence of the transmission coefficients and the acoustic pressure profiles with an increasing number of modes is illustrated.

Nayfeh, A. H.↗

Image contrast of diffraction-limited telescopes for circular incoherent sources of uniform radiance

A simple approximate formula is derived for the background intensity beyond the edge of the image of uniform incoherent circular light source relative to the irradiance near the center of the image. The analysis applies to diffraction-limited telescopes with or without central beam obscuration due to a secondary mirror. Scattering off optical surfaces is neglected. The analysis is expected to be most applicable to spaceborne IR telescopes, for which diffraction can be the major source of off-axis response.

Shackleford, W. L.↗

Rigorous solutions for sound radiation from circular ducts with hyperbolic horns or infinite plane baffle

A rigorous treatment is presented of sound radiation from circular ducts with either a hyperbolic horn or an infinite plane baffle. In the analysis hyperboloidal wave functions are used, which are defined here, for the first time, as a class of eigensolutions of the wave equation for oblate spheroidal co-ordinates. The numerical results include the complex conversion (or reflection) coefficients and the radiation directivity for various incident wave modes, spinning modes as well as axisymmetric modes. The solutions are valid for the whole frequency range including frequencies above and below the cut-off frequencies of the duct modes involved.

Cho, Y. C.↗

A visual investigation of turbulence in stagnation flow about a circular cylinder

A diagnostic visualization study of turbulence in stagnation flow around a circular cylinder was carried out to gain physical insight into the coherent structure of turbulence in flow around a bluff body advanced by the vorticity-amplification theory. The visualization was conducted at a cylinder-diameter Reynolds number of 8000 utilizing titanium dioxide white smoke for an approaching flow containing turbulence at scales larger than the neutral wavelength of the stagnation flow. Analyses of the flow events focused on tracing out the temporal and spatial evolution of a cross-vortex tube outlined by the entrained smoke filaments from its emergence near the stagnation zone through its penetration into the cylinder boundary layer.

Sadeh, W. Z.↗

Green's function for a crack emanating from a circular hole in an infinite sheet

Stress-intensity factors, K/I/ and K/II/, are obtained for a point loaded crack emanating from a circular hole in an infinite plate. A series approach and the Muskhelishvili formulation in the two-dimensional theory of elasticity are used to derive the solution. The applicability of the solution is demonstrated by using it as a Green's function to obtain K/I/ and K/II/ and the case of (1) biaxial tension of an infinite plate and (2) bending of a wide strip.

Shivakumar, V.↗

Periodic orbits of the asteroidal type in the circular restricted three-body problem

Periodic orbits of the asteroidal type in the circular restricted problem are studied by varying the period of the infinitesimal body (asteroid) and the mass ratio of the primaries (Sun-Jupiter mass ratio). The results indicate that asteroidal periodic orbits can exist for the actual Sun-Jupiter mass ratio for resonances of the Hecuba (2:1), Hilda (3:2) and Thule (4:3) groups, but not for resonances of higher consecutive integer ratios. It is also found that an asteroid can be placed in a periodic orbit at a position with mean motion between 2:1 and 3:2 even if Jupiter is about 9 times more massive than its actual value. However, an asteroid cannot be placed in a periodic orbit beyond the 4:3 resonance for the actual Sun-Jupiter mass ratio.

Kwok, J. H.↗

The mechanics of vortex pairing in a circular jet under controlled excitation

The vortex pairing phenomenon in the near field circular jet under controlled excitation is monitored by the method of phase-averaging. Hot-wire measurements were made in a 7.62 cm diameter air at Re(D) = 32,000, excited at St(D) = 0.85 with an excitation amplitude of 3%. The trajectories of the vortex centers and their longitudinal and transverse convection velocities during the pairing program are measured. Spatial distributions of the average velocity, vorticity, coherent Reynolds numbers, streamlines and pseudo-streamfunction are presented at a particular phase of the pairing. These represent field measurements at one particular time and do not involve the use of Taylor hypothesis.

Zaman, K. B. M. Q.↗

Surface geometry of circular cut spiral bevel gears

The tooth surface principal radii of curvature of crown (flat) gears were determined. Specific results are presented for involute, straight, and hyperbolic cutter profiles. It is shown that the geometry of circular cut spiral bevel gears is somewhat simpler than a theoretical logarithmic spiral bevel gear.

Huston, R. L.↗

Flaw criticality of circular disbond defects in compressive laminates

The compressive behavior of T300/5208 graphite-epoxy laminates containing circular delaminations was studied to determine the flaw criticality of two types of implanted defect, Kapton bag and Teflon film, on several laminate configurations. Defect size was varied. Results, presented in the form of residual strength curves, indicate that the Teflon film defect reduced strength more than the Kapton bad defect in 12-ply samples, but that two laminates (+ or - 45) sub 2s and (90/+ or - 45) sub s were insensitive to any implanted defect. A clear thickness effect was shown to exist for the (o/+ pr 45) sub ns laminate and was attributed to failure mode transition. The analytically predicted buckling loads show excellent agreement with experimental results and are useful in predicting failure mode transition.

Webster, J. D.↗

A modal separation measurement technique for broadband noise propagating inside circular ducts

A measurement technique which separates broadband noise propagating inside circular ducts into the acoustic duct modes is developed. The technique is also applicable to discrete frequency noise. The acoustic modes are produced by weighted combinations of the instantaneous outputs of microphones spaced around the duct circumference. The technique is compared with the cross spectral density approach presently available and found to have certain advantages, and disadvantages. Considerable simplification of both the new technique and the cross spectral density approach occurs when no correlation exists between different circumferential mode orders. The properties leading to uncorrelated modes and experimental tests which verify this condition are discussed. The modal measurement technique is applied to the case of broadband noise generated by flow through a coaxial obstruction (nozzle or orifice) in a pipe. Different circumferential mode orders are shown to be uncorrelated for this type of noise source.

Kerschen, E. J.↗

Correct generalized solar radiation pressure force on a circular cylinder in an arbitrary orientation

In response to the inconsistency seen in Geogevic (1973) with respect to the solution for solar radiation pressure in the case of a circular cylinder, a succinct derivation of the correct solution is presented. Numerical comparisons of the two sets of results confirm that the new formulation yields physically reasonable results for both general and special cases. A detailed graphic representation of the mathematical model used is included.

Tang, C. C. H.↗