SEARCH · Search NASA

Results for “AUGMENTATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

All sources NASA NTRS DOE OSTI

NASA NTRS1979

Some results from the use of a control augmentation system to study the developed spin of a light plane

A control augmentation system consisting of hydrogen peroxide rockets mounted on the wing tips of a light airplane has been developed and used to study spin recovery characteristics. Recovery from spins that were unrecoverable with aerodynamic controls was accomplished in less than one turn at maximum thrust in about three turns at minimum thrust. The rocket system at maximum thrust produced spin recovery characteristics similar to those obtained using a parachute. An advantage of using the control augmentation system on any airplane being used in a spin test program is its capability to demonstrate configuration effects on stall/spin characteristics at very high angles of attack and clearly determine the existence of all possible spin modes.

Obryan, T. C.↗

NASA NTRS1979

Nonsteady-Flow Thrust Augmenting Ejectors

Ejector augmenters in which the transfer of mechanical energy from the primary to the secondary flow takes place through the work of interface pressure forces are investigated. Nonsteady flow processes are analyzed from the standpoint of energy transfer efficiency and a comparison of a rotary jet augmenter to an ejector is presented.

Foa, J. V.↗

NASA NTRS1981

Entrainment and thrust augmentation in pulsatile ejector flows

This study comprised direct thrust measurements, flow visualization by use of a spark shadowgraph technique, and mean and fluctuating velocity measurements with a pitot tube and linearized constant temperature hot-wire anemometry respectively. A gain in thrust of as much as 10 to 15% was observed for the pulsatile ejector flow as compared to the steady flow configuration. From the velocity profile measurements, it is concluded that this enhanced augmentation for pulsatile flow as compared to a nonpulsatile one was accomplished by a corresponding increased entrainment by the primary jet flow. It is also concluded that the augmentation and total entrainment by a constant area ejector critically depends upon the inlet geometry of the ejector. Experiments were performed to evaluate the influence of primary jet to ejector area ratio, ejector length, and presence of a diffuser on pulsatile ejector performance.

Sarohia, V.↗

NASA NTRS1982

An assessment of various side-stick controller/stability and control augmentation systems for night nap-of-Earth flight using piloted simulation

Several night nap-of-the-earth mission tasks were evaluated using a helmet-mounted display which provided a limited field-of-view image with superimposed flight control symbology. A wide range of stability and control augmentation designs was investigated. Variations in controller force-deflection characteristics and the number of axes controlled through an integrated side-stick controller were studied. In general, a small displacement controller is preferred over a stiffstick controller particularly for maneuvering flight. Higher levels of stability augmentation were required for IMC tasks to provide handling qualities comparable to those achieved for the same tasks conducted under simulated visual flight conditions.

Landis, K. H.↗

NASA NTRS1982

Development and flight test evaluation of a pitch stability augmentation system for a relaxed stability L-1011

The L-1011 has been flight tested to demonstrate the relaxed static stability concept as a means of obtaining significant drag benefits to achieve a more energy efficient transport. Satisfactory handling qualities were maintained with the design of an active control horizontal tail for stability and control augmentation to allow operation of the L-1011 at centers of gravity close to the neutral point. Prior to flight test, a motion base visual flight simulator program was performed to optimize the augmentation system. The system was successfully demonstrated in a test program totaling forty-eight actual flight hours.

Rising, J. J.↗

NASA NTRS1984

Simulator investigations of side-stick controller/stability and control augmentation systems for night nap-of-earth flight

Landis, K. H.↗

NASA NTRS1984

Detonation wave augmentation of gas turbines

The results of a feasibility study that examined the effects of using detonation waves to augment the performance of gas turbines are reported. The central ideas were to reduce compressor requirements and to maintain high performance in jet engines. Gasdynamic equations were used to model the flows associated with shock waves generated by the detonation of fuel in detonator tubes. Shock wave attenuation to the level of Mach waves was found possible, thus eliminating interference with the compressor and the necessity of valves and seals. A preliminary parametric study of the performance of a compressor working at a 4:1 ratio in a conceptual design of a detonation wave augmented jet engine in subsonic flight indicated a clear superiority over conventional designs in terms of fuel efficiency and thrust.

Wortman, A.↗

NASA NTRS1984

A piloted simulator investigation of side-stick controller/stability and control augmentation system requirements for helicopter visual flight tasks

A piloted simulator experiment was conducted to assess the effects of side-stick controller characteristics and level of stability and control augmentation on handling qualities for several low-altitude control tasks. Visual flight tasks were simulated using four-window computer-generated imagery depicting either a nap-of-the-earth course or a runway with obstacles positioned to provide a slalom course. Both low speed and forward flight control laws were implemented, and a method for automatically switching control modes was developed. Variations in force-deflection characteristics and the number of axes controlled through an integrated side-stick were investigated. With high levels of stability and control augmentation, a four-axis controller with small-deflection in all four axes achieved satisfactory handling qualities for low-speed tasks.

Landis, K. H.↗

NASA NTRS1984

Shuffle-exchanges on augmented meshes

A mesh connected array of size N = two to the Kth power, K an integer, can be augmented by adding at most one edge per node such that it can perform a shuffle-exchange of size N/2 in constant time. A shuffle-exchange of size N is performed on this augmented array in constant time. This is done by combining the available perfect shuffle of size N/2 with the existing nearest neighbor connections of the mesh. By carefully scheduling the different permutations that are composed in order to achieve the shuffle, the time required is reduced to 5 steps, which is optimal for this network.

Bokhari, S. H.↗

NASA NTRS1985

On the identification of a highly augmented airplane

The results of applying linear least squares and maximum likelihood estimation procedures to flight data from the AFTI/F-16 airplane are presented. Data from two flight control system modes are analyzed. It is shown that though a simple aerodynamic model structure is adequate for the simple mode, a more complicated model is necessary to adequately describe the highly augmented mode. The effect of augmentation of roll control is shown to be visible in the control parameters.

Batterson, J. G.↗

NASA NTRS1985

Flight evaluation of highly augmented controls and electronic displays for precision approach and landing of powered-lift aircraft

Experiments were conducted on simulators and on the Quiet Short-Haul Research Aircraft to evaluate the effect of highly augmented control modes and electronic displays on the ability of pilots to execute precision approaches and landings on a short runway. It is found that the primary benefits of highly augmented flightpath and airspeed controls and electronic displays are realized when the pilot is required to execute precisely a complex transition and approach under instrument conditions and in the presence of a wide range of wind and turbulence conditions. A flightpath and airspeed command and stabilization system incorporating nonlinear, inverse system concepts produced fully satisfactory flightpath control throughout the aircraft's terminal operating envelope.

Franklin, J. A.↗

NASA NTRS1987

Behavior sensitivities for control augmented structures

During the past few years it has been recognized that combining passive structural design methods with active control techniques offers the prospect of being able to find substantially improved designs. These developments have stimulated interest in augmenting structural synthesis by adding active control system design variables to those usually considered in structural optimization. An essential step in extending the approximation concepts approach to control augmented structural synthesis is the development of a behavior sensitivity analysis capability for determining rates of change of dynamic response quantities with respect to changes in structural and control system design variables. Behavior sensitivity information is also useful for man-machine interactive design as well as in the context of system identification studies. Behavior sensitivity formulations for both steady state and transient response are presented and the quality of the resulting derivative information is evaluated.

Manning, R. A.↗

NASA NTRS1987

Stability boundaries for command augmentation systems

The Stability Augmentation System (SAS) is a special case of the Command Augmentation System (CAS). Control saturation imposes bounds on achievable commands. The state equilibrium depends only on the open loop dynamics and control deflection. The control magnitude to achieve a desired command equilibrium is independent of the feedback gain. A feedback controller provides the desired response, maintains the system equilibrium under disturbances, but it does not affect the equilibrium values of states and control. The saturation boundaries change with commands, but the location of the equilibrium points in the saturated region remains unchanged. Nonzero command vectors yield saturation boundaries that are asymmetric with respect to the state equilibrium. Except for the saddle point case with MCE control law, the stability boundaries change with commands. For the cases of saddle point and unstable nodes, the region of stability decreases with increasing command magnitudes.

Shrivastava, P. C.↗

NASA NTRS1987

Presentation of flight control design and handling quality commonality by separate surface stability augmentation for the family of commuter airplanes

The methodology and results for a flight control design and implementation for common handling qualities by Separate Surface Stability Augmentation (SSSA) for the family of commuter airplanes are contained. The open and closed loop dynamics and the design results of augmenting for common handling qualities are presented. The physical and technology requirements are presented for implementing the SSSA system. The conclusion of this report and recommendations for changes or improvement are discussed.

Hensley, Douglas↗

NASA NTRS1987

An analysis of a candidate control algorithm for a ride quality augmentation system

This paper presents a detailed analysis of a candidate algorithm for a ride quality augmentation system. The algorithm consists of a full-state feedback control law based on optimal control output weighting, estimators for angle of attack and sideslip, and a maneuvering algorithm. The control law is shown to perform well by both frequency and time domain analysis. The rms vertical acceleration is reduced by about 40 percent over the whole mission flight envelope. The estimators for the angle of attack and sideslip avoid the often inaccurate or costly direct measurement of those angles. The maneuvering algorithm will allow the augmented airplane to respond to pilot inputs. The design characteristics and performance are documented by the closed-loop eigenvalues; rms levels of vertical, lateral, and longitudinal acceleration; and representative time histories and frequency response.

Suikat, Reiner↗

NASA NTRS1988

Numerical simulation of wing lift augmentation with spanwise tip blowing

Navier-Stokes simulations are used to study the phenomena of wing lift augmentation with spanwise tip blowing. Flowfields calculated for varying blowing conditions are analyzed to determine the mechanisms responsible for providing lift augmentation. It is found that both viscous and inviscid effects are important.

Caruso, S. C.↗

NASA NTRS1989

An experimental study of a three-dimensional thrust augmenting ejector using laser Doppler velocimetry

Flow field measurements were obtained in a three-dimensional thrust augmenting ejector using laser Doppler velocimetry and hot wire anemometry. The primary nozzle, segmented into twelve slots of aspect ratio 3.0, was tested at a pressure ratio of 1.15. Results are presented on the mean velocity, turbulence intensity, and Reynolds stress progressions in the mixing chamber of the constant area ejector. The segmented nozzle was found to produce streamwise vortices that may increase the mixing efficiency of the ejector flow field. Compared to free jet results, the jet development is reduced by the presence of the ejector walls. The resulting thrust augmentation ratio of this ejector was also calculated to be 1.34.

Storms, Bruce Lowell↗

NASA NTRS1988

A Saturn atmospheric probe - A proposed augmentation to the Cassini mission

The Saturn probe augmentation of the Cassini mission is studied with particular attention given to the scientific rationale for such an augmentation and any associated issues of technical feasibility, system requirements, performance penalties, and costs. A minimal science complement probe, which concentrates only on atmospheric composition and structure with a total mass requirement of slightly less than 200 kg, is described as well as a full science complement probe with a total mass requirement of about 240 kg. It is noted that either of these Saturn probe configurations can be added to the currently planned mission within the launch performance limitations of the Titan 34D7/Centaur G(prime) launch vehicle.

Swenson, Byron L.↗