Search NASA⌕ Search

SEARCH · Search NASA

Results for “BASE FLOW”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

Investigation of Compressibility Effect for Aeropropulsive Shear Flows

Rocket Based Combined Cycle (RBCC) engines operate within a wide range of Mach numbers and altitudes. Fundamental fluid dynamic mechanisms involve complex choking, mass entrainment, stream mixing and wall interactions. The Propulsion Research Center at the University of Alabama in Huntsville is involved in an on- going experimental and numerical modeling study of non-axisymmetric ejector-based combined cycle propulsion systems. This paper attempts to address the modeling issues related to mixing, shear layer/wall interaction in a supersonic Strutjet/ejector flow field. Reynolds Averaged Navier-Stokes (RANS) solutions incorporating turbulence models are sought and compared to experimental measurements to characterize detailed flow dynamics. The effect of compressibility on fluids mixing and wall interactions were investigated using an existing CFD methodology. The compressibility correction to conventional incompressible two- equation models is found to be necessary for the supersonic mixing aspect of the ejector flows based on 2-D simulation results. 3-D strut-base flows involving flow separations were also investigated.

Balasubramanyam, M. S.↗

Real-air data reduction procedures based on flow parameters measured in the test section of supersonic and hypersonic facilities

Data-reduction procedures for determining free stream and post-normal shock kinetic and thermodynamic quantities are derived. These procedures are applicable to imperfect real air flows in thermochemical equilibrium for temperatures to 15 000 K and a range of pressures from 0.25 N/sq m to 1 GN/sq m. Although derived primarily to meet the immediate needs of the 6-inch expansion tube, these procedures are applicable to any supersonic or hypersonic test facility where combinations of three of the following flow parameters are measured in the test section: (1) Stagnation pressure behind normal shock; (2) freestream static pressure; (3) stagnation point heat transfer rate; (4) free stream velocity; (5) stagnation density behind normal shock; and (6) free stream density. Limitations of the nine procedures and uncertainties in calculated flow quantities corresponding to uncertainties in measured input data are discussed. A listing of the computer program is presented, along with a description of the inputs required and a sample of the data printout.

Miller, C. G., III↗

Lava flow materials in the Tharsis region of Mars

Lava-flow materials in the Tharsis region of Mars were studied from moderate-resolution (100-280 m/pixel) Viking Orbiter imagery. Individual eruptive sequences were recognized primarily by stratigraphic relations, density of superimposed impact craters, flow morphology, flow trend, and variations in surface albedo. Nine detailed maps of lava flows based on delineation of flow scarps were compiled for a total area of 7.25 million sq km. Two thirds of this area was covered by mappable flows representing at least 14 distinct eruptive sequences. Assuming a rate of crater production twice that of the moon, the observed range of superimposed crater densities (90 to 3200 craters at least 1 km in diameter per sq km) indicates an age range of 100 m.y. to several billion years for these flows. The youngest lavas are associated with flood lavas filling the depression surrounding the Olympus Mons shield. Flow thicknesses range from less than 5 meters to 20 meters on steeper shield slopes (0.5 to 4.5 deg) and from 20 to 65 meters on relatively flat (less than 0.5 deg slope) terrain.

Schaber, G. G.↗

Laser transit anemometer measurements of a JANNAF nozzle base velocity flow field

Velocity flow fields of a nozzle jet exhausting into a supersonic flow were surveyed. The measurements were obtained with a laser transit anemometer (LTA) system in the time domain with a correlation instrument. The LTA data is transformed into the velocity domain to remove the error that occurs when the data is analyzed in the time domain. The final data is shown in velocity vector plots for positions upstream, downstream, and in the exhaust plane of the jet nozzle.

Hunter, William W., Jr.↗

Nonlinear Instability of a Uni-directional Transversely Sheared Mean Flow

It is well known that the presence of a weak cross flow in an otherwise two-dimensional shear flow results in a spanwise variation in the mean streamwise velocity profile that can lead to an amplification of certain three-dimensional disturbances through a kind of resonant-interaction mechanism (Goldstein and Wundrow 1994). The spatial evolution of an initially linear, finite-growth-rate, instability wave in such a spanwise-varying shear flow is considered, The base flow, which is governed by the three-dimensional parabolized Navier-Stokes equations, is initiated by imposing a spanwise- periodic cross-flow velocity on an otherwise two-dimensional shear flow at some fixed streamwise location. The resulting mean-flow distortion initially grows with increasing streamwise distance, reaches a maximum and eventually decays through the action of viscosity. This decay, which coincides with the viscous spread of of the shear layer, means that the local growth rate of the instability wave will eventually decrease as the wave propagates downstream. Nonlinear effects can then become important within a thin spanwise-modulated critical layer once the local instability-wave amplitude and growth rate become sufficiently large and small, respectively. The amplitude equation that describes this stage of evolution is shown to be a generalization of the one obtained by Goldstein and Choi (1989) who considered the related problem of the interaction of two oblique modes in a two-dimensional shear layer.

Wundrow, David W.↗

Computational Aeroservoelastic Analysis with an Euler-Based Unsteady Flow Solver

The effectiveness of transpiration for simulation of structural deformations in steady and unsteady aeroelastic applications is examined. The majority of the investigations were performed using a highly integrated, finite-element code for the multidisciplinary analysis of flight vehicles. A supplement to this code, which allows for the generation of deflected meshes using modal superposition, was developed in this study. This research demonstrated that the transpiration boundary condition has strong potential for applications in unsteady aeroelastic analysis, such as in the prediction of flutter boundaries.

Arena, Andrew S., Jr.↗

Novel Confocal Microscopic and Flow Cytometric Based Assays to Visualize and Detect the (Beta)2-Adrenergic Receptor in Human Lymphocyte and Mononuclear Cell Populations

The data show that immunophenotyping of leukocyte populations with (beta)2AR is possible with the commercially available Ab, although the FC assay is limited to the IST as a result of the Ab binding site to the intracellular C-terminus of the 2AR. The FC assay has applications for measuring alterations in total (beta)2AR in human leukocyte populations as changes in fluorescence. In addition, CM confirms that both surface and intracellular compartments stain positively for the (beta)2AR and can be used for qualitative assays that screen for changes in receptor compartmentalization and localization.

Salicru, A. N.↗

Demonstrating the Early Adopter Benefits of Submitting Multiple Trajectory Options for Airlines

Integrated Demand Management (IDM), is a NASA developed Traffic Flow Management (TFM) concept that uses Collaborative Trajectory Options Program (CTOP) to precondition traffic flows into the Time Based Flow Management (TBFM) region, helping traffic planners manage imbalances between demand and capacity in the National Airspace (NAS). A workshop held at NASA was conducted to demonstrate how individual airlines can be impacted by using Trajectory Options Sets (TOS) during IDM operations. A primary concern that was specifically addressed in a part-task Human-in-the-Loop simulation was who received the greater benefit, TOS participating or non-TOS participating airlines? The results showed that TOS participating airlines received greater benefit in terms of ground delay, number of reroute options, and additional flight time, than non-TOS participating airlines. However, this result was dependent on the number and location of flights. Therefore, it was advantageous for airlines to equip TOS. In addition, we found that non-TOS participating airlines also benefitted from other airlines participating in TOS, because the total system-wide ground delay was reduced as more TOS were introduced into the system. The evidence suggests that the benefits were distributed fairly, and there were no unfair disadvantages for airlines who did not equip TOS.

Integrated Demand Management↗

Basic flow characteristics of a linear aerospike nozzle segment.

The separated base flow region within a linear aerospike nozzle segment is investigated experimentally in an ejector-diffuser system. The nozzle-diffuser system and base pressure characteristics are described over the pressure ratio range from the 'open wake' to the 'closed wake' operation. Schlieren photographs and static pressure distributions along the test section centerline and top contour describe the transition from 'open wake' to 'closed wake' flow fields. Base pressure and static pressure distributions are utilized to present the effects of a ramp diffuser. The effects of base bleed on the base pressure ratio and structure of the nozzle flow field are also presented.

Mueller, T. J.↗