SEARCH · Search NASA

Results for “DI”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

All sources NASA NTRS DOE OSTI

NASA NTRS1973

Study of ball bearing torque under elastohydrodynamic lubrication

Spinning and rolling torques were measured in an angular-contact ball bearing with and without a cage under several lubrication regimes in a modified NASA spinning torque apparatus. Two lubricants were used - a di-2 ethylhexyl sebacate and a synthetic paraffinic oil, at shaft speeds of 1000, 2000, and 3000 rpm and bearing loads from 45 newtons (10 lb) to 403 newtons (90 lb). An analytical model was developed from previous spinning friction models to include rolling with spinning under lubrication regimes from thin film to flooded conditions. The bearing torque values have a wide variation, under any condition of speed and load, depending on the amount of lubricant present in the bearing. The analytical model compared favorably with experimental results under several lubrication regimes.

Townsend, D. P.↗

NASA NTRS1975

Annealing of aromatic polyimide precursors

A study has been made of the thermal behavior of polyimide precursors: an isomeric pair of crystals of the complex formed by p-phenylenediamine with the separated isomers of the di-isopropyl ester of pyromellitic acid. Specimens of this material were isothermally annealed in the temperature range 120 C to 170 C for periods of time up to 1 week. Although this temperature range is well below that customarily used for imidizations, the working hypothesis was that it would be more likely that a polymer embodying at least part of the precursor structure could be formed if the molecular motion was minimized to that actually required for the formation of the imide linkage. The progress of the annealing was followed by: infrared spectroscopy, differential thermal analysis, powder X-ray diffraction, and thermal gravimetric analysis. Single crystal X-ray analysis of the meta monomer yields a structure of chains of alternating acid and base and suggests that this monomer is amenable to polymerization with a minimum of geometrical disruption.

Wakelyn, N. T.↗

NASA NTRS1975

Measurement of viscosity and elasticity of lubricants at high pressures

The oscillating quartz crystal viscometer has been used to investigate possible viscoelastic behavior in synthetic lubricating fluids and to obtain viscosity-pressure-temperature data for these fluids at temperatures to 300 F and pressures to 40,000 psig. The effect of pressure and temperature on the density of the test fluids was measured concurrently with the viscosity measurements. Viscoelastic behavior of one fluid, di-(2-ethylhexyl) sebacate, was observed over a range of pressures. These data were used to compute the reduced shear elastic (storage) modulus and reduced loss modulus for this fluid at atmospheric pressure and 100 F as functions of reduced frequency.

Rein, R. G., Jr.↗

NASA NTRS1976

Pulse height response of an optical particle counter to monodisperse aerosols

The pulse height response of a right angle scattering optical particle counter has been investigated using monodisperse aerosols of polystyrene latex spheres, di-octyl phthalate and methylene blue. The results confirm previous measurements for the variation of mean pulse height as a function of particle diameter and show good agreement with the relative response predicted by Mie scattering theory. Measured cumulative pulse height distributions were found to fit reasonably well to a log normal distribution with a minimum geometric standard deviation of about 1.4 for particle diameters greater than about 2 micrometers. The geometric standard deviation was found to increase significantly with decreasing particle diameter.

Wilmoth, R. G.↗

NASA NTRS1975

The optical nature of methylsuccinic acid in human urine

Methylsuccinic acid was isolated from human urine, derivatized as the di-S-(+)-2-butyl ester, and analyzed using a gas chromatographic system capable of separating the enantiomers of the derivative. The R-(+)-isomer was found to be present. Methylsuccinic acid is potentially important as a criterion for abiogenicity, having been obtained as a racemic mixture from sources known to be abiotic.

Zeitman, B.↗

NASA NTRS1977

The stereoisomeric composition of phytanyl chains in lipids of Dead Sea sediments

Lipid extracts from five recent Dead Sea sediments were analyzed for isoprenoid compounds and the following were isolated: free and phospholipid-bound di-O-phytanylglycerol, free phytanol and free and esterified phytanic acid. The phytanyl groups of the diether and the free phytanol were oxidized to the corresponding phytanic acid; the stereoisomeric composition of the derived phytanic acids as well as of the ester-bound phytanic acid was determined by open-tubular gas-liquid chromatography of the corresponding methyl esters on butanediolsuccinate polyester. Only the 3R, 7R, 11R-isomer of phytanic acid was detected in each of the phytanate samples, indicating that these phytanyl chains in the Dead Sea sediments are most likely derived from extremely halophilic bacteria rather than from phytol of chlorophyll origin. These findings also provide further evidence that the mixtures of RRR and SRR-phytanic acids previously isolated from organic-rich shales were most likely derived from the phytyl chain in chlorophyll.

Anderson, R.↗

NASA NTRS1979

High-pressure liquid chromatography of aromatic amines

Analysis made on commercially available liquid chromatograph demonstrates high-pressure liquid chromatographic conditions for separation of approximately 50 aromatic amines ranging from simple aniline derivatives to complex multiring di- and tri-amines.

Young, P. R.↗

NASA NTRS1978

Metric remote sensing experiments in preparation for Spacelab flights

Aerial and ground photographs of Wallis mountains and of Dolomiti di Cortina d'Ampezzo in Italy were made using spectrozonal emulsions and optical multichannel filters. A metric camera was used in the perspective of the first Spacelab flight aboard the space shuttle. Elementary forms of alpine geomorphology and ice or snow phenomena are detectable on these metric scenes.

Galibert, G.↗

NASA NTRS1978

Synthesis of improved moisture resistant polymers

The synthesis and characterization of novel moisture resistant aliphatic polyimides are described. Several novel aliphatic imides of diversified functionalities were synthesized, purified, and characterized, they include: (1) N-(12-aminododecyl)-5-norbornene-2,3-dicarboximide; (2) N,N'-2,2,2-trifluoro-1-(trifluoromethyl)ethylidene bis (1,3-dioxo-5,2-iosoindolinediyl)dodecamethylene di-5-norbornene-2,3-dicarboximide; (3) N,N'-dodecamethylenedi-5-nobornene-2,3-dicarbonoximide; (4) N,N'-dodecamethylenebis 5,6-epoxy-2,3-norbornanedicarboximide ; and (5) N,N'-Bis 12-(5-norbornene-2, 3-dicarboximidido)dodecyl - 1,2,3,4- butanetetracarboxylic 1,2:3,4-diimide. The structures of these compounds were established by elemental analysis, IR, NMR, and mass spectra.

Scola, D. A.↗

NASA NTRS1979

Ultraviolet absorption of common spacecraft contaminants

Organic contamination of ultraviolet optical systems is discussed. Degradation of signal by reflection, scattering, interference, and absorption is shown. The first three processes depend on the physical state of the contaminant while absorption depends on its chemical structure. The latter phenomenon is isolated from the others by dissolving contaminants in cyclohexane and determining absorption spectra from 2100A to 3600A. A variety of materials representing the types of contaminants responsible for most spaceflight hardware problems is scanned and the spectra is presented. The effect of thickness is demonstrated for the most common contaminant, di(2 ethyl hexyl)phthalate, by scanning successive dilutions.

Colony, J. A.↗

NASA NTRS1980

Effect of fuel molecular structure on soot formation in gas turbine combustion

The effect of fuel variations at the same hydrogen content on the formation of soot in a gas turbine combustor was studied. Six fuels were burned to a combustor over a matrix of about 50 test conditions with test conditions ranging over 500-1800 kPa (5-18 atm) pressure and 500-1000 K burner inlet temperature; fuel-air ratios were varied from 0.008-0.024. Flame radiation measurements were made through a sapphire window toward the end of the primary zone. The hydrogen content of the six test fuels ranged from 12.80 to 12.88%. Five fuels emphasized hydrocarbon types: (mono, di, and tricyclic), naphthenes (decalin) and partially hydrogenated aromatics (tetralin); the sixth fuel emphasized final boiling point.

Naegeli, D. W.↗

NASA NTRS1979

Comparison of dynamic crystallization techniques on Apollo 15 quartz normative basalts

The paper compares dynamic crystallization techniques used on Apollo 15 quartz normative basalts which show differences related to their method. The variation of pyroxene core major element chemistry with cooling rate is confirmed, and it is shown that the Fe loss from liquid is shifted toward the En-Di joint; it is suggested that the nucleation temperature and breakdown of equilibrium partitioning as a function of cooling rate dictate the core composition. It is concluded that the different crystallization behavior that results from the Fe-capsule and Fe-loop container methods is related to the nucleation kinetics.

Lofgren, G. E.↗

NASA NTRS1980

A new planar injection-gated bulk switching device based upon deep impurity trapping

Under the proper conditions, double-injection (DI) diodes with partially compensated deep impurities will exhibit 'S'-type switching characteristics similar to conventional silicon-controlled rectifiers (SCR's). A practical injection-gating scheme has been achieved for the first time in a planar configuration to control the switching behavior of these devices, marked by extreme sensitivity of the gate over a range of switching voltages. An experiment to demonstrate the feasibility of these devices for practical application is described. Finally, a phenomenological explanation is presented for the gate-controlled switching of these devices.

Kapoor, A. K.↗

NASA NTRS1980

The identification of trends in outgassing technology

A large amount of chemical analysis data involving identification of outgassing products from spacecraft, experiment modules, and support equipment accumulated at the Goddard Space Flight Center over the past ten years were reduced to a computer compatible format and subjected to a variety of relevant program operations. From these data a list of the most troublesome outgassing species were compiled and several useful and interesting materials' correlations were developed. The frequency of occurrence totals show that in aerospace program, di(2-ethyl hexyl) phthalate (DEHP) is the most often found individual species in outgassing samples and that esters are the leading generic class of compounds. The effectiveness of this data bank was demonstrated by the good correlations between materials and their outgassing products for solar panel bakeouts and cable bakeouts. However, trends in frequency of occurrence of many compounds were demonstrated where no correlation could be established. In the case of the class of compounds called aliphatic hydrocarbons, it is shown that the number of instances of significant outgassing due to these materials is increasing.

Colony, J. A.↗

NASA NTRS1980

Modelling of DNA-protein recognition

Computer model-building procedures using stereochemical principles together with theoretical energy calculations appear to be, at this stage, the most promising route toward the elucidation of DNA-protein binding schemes and recognition principles. A review of models and bonding principles is conducted and approaches to modeling are considered, taking into account possible di-hydrogen-bonding schemes between a peptide and a base (or a base pair) of a double-stranded nucleic acid in the major groove, aspects of computer graphic modeling, and a search for isogeometric helices. The energetics of recognition complexes is discussed and several models for peptide DNA recognition are presented.

Rein, R.↗

NASA NTRS1980

Chemical analysis of LARC-160 polyimide

As part of a detailed NASA-sponsored study of chemical composition/property sensitivity of the LARC-160 polymerization of monomeric reactants (PMR) polyimide system, a number of liquid chromatographic techniques have been employed. The ester monomers in this system are characterized by a reverse-phase ion-suppression method. Mono, di, and triesters of the 3,3',4,4'-benzophenonetetracarboxylic acid ingredient are identified and their isomeric forms resolved. The 5-norbornene-2,3-dicarboxylic acid ester (nadic ester) endcapper is detected by low wavelength ultraviolet sensing. A second method, reverse-phase ion-pair chromatography, is employed for determining unreacted amines. The extent of resin B-staging is monitored through analysis of the ester/amine oligomers.

Dynes, P. J.↗

NASA NTRS1981

Grafting of 2 (2-hydroxy-5-vinylphenyl) 2H-benzotriazole onto polymers with aliphatic groups. Synthesis and polymerization of 2 (2-hydroxy-5-isopropenylphenyl) 2H-benzotriazole and a new synthesis of 2 (2-hydroxy-5-vinylphenyl) 2H-benzotriazole

Successful grafting of 2(2-hydroxy-5-vinylphenyl)2H-benzotriazole onto saturated aliphatic C-H groups of polymers has been accomplished. When the grafting reaction was carried out in chlorobenzene at 150 C = 160 C with di-tertiarybutylperoxide as the grafting initiator, grafts as high as 20 percent - 30 percent at a grafting efficiency of 50 percent and 80 percent have readily been obtained. The grafting reaction was carried out in tubes sealed under high vacuum since trace amounts of oxygen cause complete inhibition of the grafting reaction by the phenolic monomer. On a variety of different polymers including atactic polypropylene, ethylene/vinyl acetate copolymer, poly(methyl methacrylate), poly(butyl acrylate), and polycarbonate were used.

Pradellok, W.↗

NASA NTRS1982

The partitioning of Zr and Nb between diopside and melts in the system diopside-albite-anorthite

The crystal/liquid distribution coefficient for Zr between diopside and melt is measured for six compositions and three temperatures in the diopside field of Di-Ab-An, and the distribution coefficient for Nb is measured for three of these compositions. Nb is found to be excluded from diopside, while D(Zr), which is defined as wt % ZrO2 in crystals/wt % ZrO2 in melt, is variable and ranging from 0.05 to 0.45. D(Zr) is positively correlated with the Al content of both the melt and the pyroxene, and is negatively correlated with temperature. Both D(Zr) and D(Nb) are independent of oxygen fugacity, which implies that neither Zr nor Nb suffer valence changes over a range of oxygen fugacities spanning lunar and terrestrial conditions.

Dunn, T.↗