Search NASA⌕ Search

SEARCH · Search NASA

Results for “JET TRANSPORT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS1997

Piloted Simulation Tests of Propulsion Control as Backup to Loss of Primary Flight Controls for a B747-400 Jet Transport

Partial failures of aircraft primary flight control systems and structural damages to aircraft during flight have led to catastrophic accidents with subsequent loss of lives (e.g. DC-10, B-747, C-5, B-52, and others). Following the DC-10 accident at Sioux City, Iowa in 1989, the National Transportation Safety Board recommended 'Encourage research and development of backup flight control systems for newly certified wide-body airplanes that utilize an alternate source of motive power separate from that source used for the conventional control system.' This report describes the concept of a propulsion controlled aircraft (PCA), discusses pilot controls, displays, and procedures; and presents the results of a PCA piloted simulation test and evaluation of the B747-400 airplane conducted at NASA Ames Research Center in December, 1996. The purpose of the test was to develop and evaluate propulsion control throughout the full flight envelope of the B747-400 including worst case scenarios of engine failures and out of trim moments. Pilot ratings of PCA performance ranged from adequate to satisfactory. PCA performed well in unusual attitude recoveries at 35,000 ft altitude, performed well in fully coupled ILS approaches, performed well in single engine failures, and performed well at aft cg. PCA performance was primarily limited by out-of-trim moments.

Bull, John↗
NASA NTRS1975

A parametric determination of transport aircraft price

Cost per unit weight and other airframe and engine cost relations are given. Power equations representing these relations are presented for six airplane groups: general aircraft, turboprop transports, small jet transports, conventional jet transports, wide-body transports, supersonic transports, and for reciprocating, turboshaft, and turbothrust engines. Market prices calculated for a number of aircraft by use of the equations together with the aircraft characteristics are in reasonably good agreement with actual prices. Such price analyses are of value in the assessment of new aircraft devices and designs and potential research and development programs.

Anderson, J. L.↗
NASA NTRS1991

Controlling crippled aircraft-with throttles

A multiengine crippled aircraft, with most or all of the flight control system inoperative, may use engine thrust for control. A study was conducted of the capability and techniques for emergency flight control. Included were light twin engine piston powered airplanes, an executive jet transport, commercial jet transports, and a high performance fighter. Piloted simulations of the B-720, B-747, B-727, MD-11, C-402, and F-15 airplanes were studied, and the Lear 24, PA-30, and F-15 airplanes were flight tested. All aircraft showed some control capability with throttles and could be kept under control in up-and-away flight for an extended period of time. Using piloted simulators, landings with manual throttles-only control were extremely difficult. However, there are techniques that improve the chances of making a survivable landing. In addition, augmented control systems provide major improvements in control capability and make repeatable landings possible. Control capabilities and techniques are discussed.

Burcham, Frank W., Jr.↗
DOE OSTI2024

Linear Boltzmann transport for jet propagation in the quark-gluon plasma: Inelastic processes and jet modification

A linear Boltzmann transport (LBT) Monte Carlo model has been developed to describe jet propagation and interaction with the quark-gluon plasma (QGP) in relativistic heavy-ion collisions. A complete set of elastic-scattering processes and medium-induced gluon emissions based on the higher-twist formalism are incorporated for both jet shower and medium recoil partons. It has been employed to describe experimental data on large transverse momentum hadron and jet spectra, correlation and jet substructures in high-energy heavy-ion collisions. Here, we document in detail the structure of the model and validation of the Monte Carlo implementations of the physics processes in LBT, in particular, the inelastic process of medium-induced gluon radiation. We carry out a comprehensive examination of the jet-medium interaction as implemented in LBT through energy loss and momentum broadening of a single hard parton, the energy and transverse momentum transfer from leading partons to medium-induced gluons and jet-induced medium excitation, and medium modification of reconstructed jets in a static and uniform medium. With realistic and event-by-event hydrodynamic medium in heavy-ion collisions, we compute and compare with experimental data on the jet cone-size dependence of the single inclusive jet suppression at both the BNL Relativistic Heavy-Ion Collider (RHIC) and the CERN Large Hadron Collider (LHC), the dijet asymmetry at the LHC and γ-jet correlation at RHIC. Effects of medium-induced gluon emissions and jet-induced medium excitation on jet observables are systematically examined. Rescatterings of the radiated gluons and recoil partons with the QGP are found essential to account for the enhancement of soft particle yield toward the edge of the jet cone.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗
NASA NTRS1972

Propulsion system studies for an advanced high subsonic, long range jet commercial transport aircraft

Propulsion system characteristics for a long range, high subsonic (Mach 0.90 - 0.98), jet commercial transport aircraft are studied to identify the most desirable cycle and engine configuration and to assess the payoff of advanced engine technologies applicable to the time frame of the late 1970s to the mid 1980s. An engine parametric study phase examines major cycle trends on the basis of aircraft economics. This is followed by the preliminary design of two advanced mixed exhaust turbofan engines pointed at two different technology levels (1970 and 1985 commercial certification for engines No. 1 and No. 2, respectively). The economic penalties of environmental constraints - noise and exhaust emissions - are assessed. The highest specific thrust engine (lowest bypass ratio for a given core technology) achievable with a single-stage fan yields the best economics for a Mach 0.95 - 0.98 aircraft and can meet the noise objectives specified, but with significant economic penalties. Advanced technologies which would allow high temperature and cycle pressure ratios to be used effectively are shown to provide significant improvement in mission performance which can partially offset the economic penalties incurred to meet lower noise goals. Advanced technology needs are identified; and, in particular, the initiation of an integrated fan and inlet aero/acoustic program is recommended.

Source record↗
NASA NTRS1976

Wake vortex encounter hazards criteria for two aircraft classes

An investigation was conducted using a piloted, motion-base simulator to determine wake vortex hazard criteria for two classes of jet transport aircraft. A light business jet and a large multiengine jet transport were represented respectively. The hazard boundaries were determined in terms of the maximum bank angle due to the vortex encounter. Upsets as small as 7 deg in bank angle were considered to be hazardous at breakout altitude (200 ft (61.0 m)) for Instrument Flight Rule (IFR) and at 50 ft (15.2 m) for Visual Flight Rule (VFR) for both aircraft classes. Proximity to the ground was the primary reason for a hazardous rating. This was reflected in the reduction in the maximum bank angle at the hazard boundary and in more consistent ratings as altitude was decreased.

Sammonds, R. I.↗
NASA NTRS1976

Advanced Transonic Aerodynamic Technology

Supercritical airfoils and their applications to wings for various types of aircraft are studied. The various wings discussed were designed for a subsonic jet transport with increased speed, a variable sweep fighter with greater transonic maneuverability, a high subsonic speed STOL jet transport with improved low speed characteristics, and a subsonic jet transport with substantially improved aerodynamic efficiency. Results of wind tunnel and flight demonstration investigations are described. Also discussed are refinements of the transonic area rule concept and methods for reducing the aerodynamic interference between engine nacelles and wings at high subsonic speeds.

Whitcomb, R. T.↗
DOE OSTI2022

Numerical studies on saturated kink and sawtooth induced fast ion transport in JET ITER-like plasmas

Here, this presentation examines the energetic particle transport induced by saturated kink modes and sawtooth crashes in JET deuterium plasmas. It is known that kink mode-resonant transport and phase-space redistribution from sawtooth crashes can drive strong fast ion transport with dependencies on particle pitch and energy. Measurements with JET's Faraday cup fast ion loss detector array have shown that the internal kink growth phase preceding sawtooth crashes produces substantial fast ion losses. This report will numerically investigate the dominant energetic particle transport mechanism with a detailed examination of the fast ion phase-space dependencies, resonances, orbit topology changes, induced losses, and redistribution associated with the long-lived, resonant, kink mode and non-resonant sawtooth crash. The ORBIT-kick model forms the basis of the transport studies with realistic fast ion distributions produced from TRANSP. A recently created reduced model for sawtooth induced transport is used while the saturated kink modes are modeled with ideal MHD codes. The simulations were further validated against experiment with a newly developed synthetic Faraday cup fast ion loss detector in addition to scintillator probe and neutron measurements.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
NASA NTRS1973

Analytical study of takeoff and landing performance for a jet STOL transport configuration with full-span, externally blown, triple-slotted flaps

Takeoff and landing performance characteristics and field length requirements were determined analytically for a jet STOL transport configuration with full-span, externally blown, tripleslotted flaps. The configuration had a high wing, high T-tail, and four pod-mounted high-bypass-ratio turbofan engines located under and forward of the wing. One takeoff and three approach and landing flap settings were evaluated. The effects of wing loading, thrust-to-weight ratio, weight, ambient temperature, altitude on takeoff and landing field length requirements are discussed.

Washington, H. P.↗
NASA NTRS1965

A Simulator Study of Take-Off Characteristics of Proposed Supersonic Transports

Fixed-cockpit piloted simulator studies of delta-planform and variable-wing-sweep supersonic transport configurations are being conducted at the Ames Research Center to investigate the handling qualities and certification requirements related to the take-off maneuver. Validation of the simulation was achieved by duplicating the take-off certification program of a subsonic jet transport. Evaluation of the simulator was made by NASA pilots as well as company and FAA pilots involved in the actual certification flights of the airplane. The present paper is limited to a discussion of normal take-off, minimum control speed (ground), rotation characteristics, and initial climbout. Comparisons of the take-off characteristics are made between the supersonic transport and the current class of subsonic jet transports. Results indicate that minimum control speed (ground) characteristics are a function of thrust-weight ratio, the time provided for SST rotation should be at least as long as that for the subsonic jet transports, abused take-offs are more likely to result in tail scrapes, and climbout below the minimum drag speed requires that the pilot carefully monitor airspeed.

Jackson, Charles T., Jr.↗
NASA NTRS1972

An assessment of repeated loads on general aviation and transport aircraft.

An assessment is made of recent repeated loads data from short-haul jet transports and several general aviation airplanes. The jet transport data indicate that except for check flight maneuvers the load histories are essentially independent of operator and airplane type. General aviation data show a large amount of scatter in the repeated load history. The use and geographical location of operations may be the primary means of specifying the repeated loads environment.

Donely, P.↗