Search NASA⌕ Search

SEARCH · Search NASA

Results for “MANEUVERABILITY”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

Effect of canard location and size on canard-wing interference and aerodynamic center shift related to maneuvering aircraft at transonic speeds

A generalized wind-tunnel model, typical of highly maneuverable aircraft, was tested in the Langley 8-foot transonic pressure tunnel at Mach numbers from 0.70 to 1.20 to determine the effects of canard location and size on canard-wing interference effects and aerodynamic center shift at transonic speeds. The canards had exposed areas of 16.0 and 28.0 percent of the wing reference area and were located in the chord plane of the wing or in a position 18.5 percent of the wing mean geometric chord above or below the wing chord plane. Two different wing planforms were tested, one with leading-edge sweep of 60 deg and the other 44 deg; both wings had the same reference area and span. The results indicated that the largest benefits in lift and drag were obtained with the canard above the wing chord plane for both wings tested. The low canard configuration for the 60 deg swept wing proved to be more stable and produced a more linear pitching-moment curve than the high and coplanar canard configurations for the subsonic test Mach numbers.

Gloss, B. B.↗

Preliminary performance estimates of an oblique, all-wing, remotely piloted vehicle for air-to-air combat

A computerized aircraft synthesis program has been used to assess the effects of various vehicle and mission parameters on the performance of an oblique, all-wing, remotely piloted vehicle (RPV) for the highly maneuverable, air-to-air combat role. The study mission consists of an outbound cruise, an acceleration phase, a series of subsonic and supersonic turns, and a return cruise. The results are presented in terms of both the required vehicle weight to accomplish this mission and the combat effectiveness as measured by turning and acceleration capability. This report describes the synthesis program, the mission, the vehicle, and results from sensitivity studies. An optimization process has been used to establish the nominal RPV configuration of the oblique, all-wing concept for the specified mission. In comparison to a previously studied conventional wing-body canard design for the same mission, this oblique, all-wing nominal vehicle is lighter in weight and has higher performance.

Nelms, W. P., Jr.↗

Supercirculation effects induced by vectoring a partial-span rectangular jet

Thrust-induced supercirculation effects from thrust vectoring have indicated a potential for not only increasing maneuverability of fighter aircraft but also as a means of improving cruise performance. The current study investigated a partial-span rectangular jet-exhaust nozzle located at the wing trailing edge that acts similar to a jet flap by increasing lift due to supercirculation. This paper summarizes experimental studies including the effects of nozzle deflection angle, wing camber, and nozzle shape and exit location on lift, drag and load distributions. The results indicate that significant increases in thrust-induced lift along with substantial decreases in drag are possible.

Capone, F. J.↗

Application of modern control theory to the design of optimum aircraft controllers

A procedure is described for synthesis of optimal aircraft control systems by application of the concepts of optimal control theory to time-invariant linear systems with quadratic performance criteria. Essential in this synthesis procedure is the solution of the Riccati matrix equation which results in a constant linear feedback control law for an output regulator which maintains a plant in an equilibrium in the presence of impulse disturbances. An algorithm is derived for designing maneuverable output regulators with selected state variables for feedback.

Power, L. J.↗

The effect of canard leading edge sweep and dihedral angle on the longitudinal and lateral aerodynamic characteristic of a close-coupled canard-wing configuration

A generalized wind-tunnel model, with canard and wing planforms typical of highly maneuverable aircraft, was tested in the Langley high-speed 7- by 10-foot tunnel at a Mach number of 0.30. The test was conducted in order to determine the effects of canard sweep and canard dihedral on canard-wing interference at high angles of attack. In general, the effect of canard sweep on lift is small up to an angle of attack of 16 deg. However, for angles of attack greater than 16 deg, an increase in the canard sweep results in an increase in lift developed by the canard when the canard is above or in the wing chord plane. This increased lift results in a lift increase for the total configuration for the canard above the wing chord plane. For the canard in the wing chord plane, the increased canard lift is partially lost by increased interference on the wing.

Gloss, B. B.↗

Effect of wing planform and canard location and geometry on the longitudinal aerodynamic characteristics of a close-coupled canard wing model at subsonic speeds

A generalized wind-tunnel model with canard and wing planforms typical of highly maneuverable aircraft was tested in the Langley 7- by 10-foot high-speed tunnel at a Mach number of 0.30 to determine the effect of canard location, canard size, wing sweep, and canard strake on canard-wing interference to high angles of attack. The major results of this investigation may be summarized as follows: the high-canard configuration (excluding the canard strake and canard flap), for both the 60 deg and 44 deg swept leading-edge wings, produced the highest maximum lift coefficient and the most linear pitching-moment curves; substantially larger gains in the canard lift and total lift were obtained by adding a strake to the canard located below the wing chord plane rather than by adding a strake to the canard located above the wing chord plane.

Gloss, B. B.↗

Effect of canard position and wing leading-edge flap deflection on wing buffet at transonic speeds

A generalized wind-tunnel model, with canard and wing planform typical of highly maneuverable aircraft, was tested. The addition of a canard above the wing chord plane, for the configuration with leading-edge flaps undeflected, produced substantially higher total configuration lift coefficients before buffet onset than the configuration with the canard off and leading-edge flaps undeflected. The wing buffet intensity was substantially lower for the canard-wing configuration than the wing-alone configuration. The low-canard configuration generally displayed the poorest buffet characteristics. Deflecting the wing leading-edge flaps substantially improved the wing buffet characteristics for canard-off configurations. The addition of the high canard did not appear to substantially improve the wing buffet characteristics of the wing with leading-edge flaps deflected.

Gloss, B. B.↗

The design and development of a space laboratory to conduct magnetospheric and plasma research

A design study was conducted concerning a proposed shuttle-borne space laboratory for research on magnetospheric and plasma physics. A worldwide survey found two broad research disciplines of interest: geophysical studies of the dynamics and structure of the magnetosphere (including wave characteristics, wave-particle interactions, magnetospheric modifications, beam-plasma interactions, and energetic particles and tracers) and plasma physics studies (plasma physics in space, wake and sheath studies, and propulsion and devices). The Plasma Physics and Environmental Perturbation Laboratory (PPEPL) designed to perform experiments in these areas will include two 50-m booms and two maneuverable subsatellites, a photometer array, standardized proton, electron, and plasma accelerators, a high-powered transmitter for frequencies above 100 kHz, a low-power transmitter for VLF and below, and complete diagnostic packages. Problem areas in the design of a space plasma physics laboratory are indicated.

Rosen, A.↗

A summary of experimental research on propulsive-lift concepts in the Langley 16-foot transonic tunnel

A summary of research on both conceptual and practical configurations in which the aircraft's powerplant is integrated to take advantage of propulsion-induced aerodynamics conducted in the Langley 16-foot transonic tunnel has been made. These investigations included: (1) vectoring a partial-span jet exhaust at a wing trailing edge; (2) thrust vectoring characteristics of a twin, two-dimensional variable-geometry wedge nozzle; (3) a jet exhaust/upper surface blowing concept for fighter aircraft; and (4) jets blowing over the wing. These studies indicate a potential for increasing maneuverability of fighter aircraft at high lift coefficients. With proper integration of the powerplant and the airframe, significant improvements in cruise performance of both fighter and transport aircraft are possible.

Capone, F. J.↗

Some aspects of hybrid-zeppelins

To increase an airship's maneuverability and payload capacity as well as to save bouyant gas it is proposed to outfit it with a slender delta-wing, which carries about one half of the total take-off weight of the vehicle. An optimization calculation based on the data of LZ 129 (the last airship, which saw passenger-service) leads to a Hybrid-Zeppelin with a wing of aspect-ratio 1.5 and 105 m span. The vehicle carries a payload of 40% of it's total take-off weight and consumes 0.8 t fuel per ton payload over a distance of 10000 km.

Mackrodt, P. A.↗

A differential game solution to the Coplanar tail-chase aerial combat problem

Numerical results obtained in a simplified version of the one on one aerial combat problem are presented. The primary aim of the data is to specify the roles of pursuer and evader as functions of the relative geometry and of the significant physical parameters of the problem. Numerical results are given in a case in which the slower aircraft is more maneuverable than the faster aircraft. A third order dynamic model of the relative motion is described, for which the state variables are relative range, bearing, and heading. The ranges at termination are arbitary in the present version of the problem, so the weapon systems of both aircraft can be visualized as forward firing high velocity weapons, which must be aimed at the tail pipe of the evader. It was found that, for the great majority of the ralative geometries, each aircraft can evade the weapon system of the other.

Merz, A. W.↗

An analytical study of turbulence responses, including horizontal-tail loads, of a control-configured vehicle with relaxed static stability

A static stability augmentation system (SSAS) with angle-of-attack, pitch-rate, and forward-speed feedback is used to stabilize control-configured rigid vehicles with relaxed static stability. Airplane configurations include a baseline configuration and two representative control-configured vehicle configurations. The first statically unstable configuration has baseline geometry and an aft center of gravity; the second statically unstable configuration has reduced tail length and area and a forward neutral point. Stability, flying-qualities, and maneuverability requirements are imposed on the airplane-SSAS systems. Turbulence responses of the rigid airframe and tail loads are examined in terms of configuration changes for a given control law and in terms of control law changes for a given configuration.

Perry, B., III↗

Simulator study of the effectiveness of an automatic control system designed to improve the high-angle-of-attack characteristics of a fighter airplane

A piloted, fixed-base simulation was conducted to study the effectiveness of some automatic control system features designed to improve the stability and control characteristics of fighter airplanes at high angles of attack. These features include an angle-of-attack limiter, a normal-acceleration limiter, an aileron-rudder interconnect, and a stability-axis yaw damper. The study was based on a current lightweight fighter prototype. The aerodynamic data used in the simulation were measured on a 0.15-scale model at low Reynolds number and low subsonic Mach number. The simulation was conducted on the Langley differential maneuvering simulator, and the evaluation involved representative combat maneuvering. Results of the investigation show the fully augmented airplane to be quite stable and maneuverable throughout the operational angle-of-attack range. The angle-of-attack/normal-acceleration limiting feature of the pitch control system is found to be a necessity to avoid angle-of-attack excursions at high angles of attack. The aileron-rudder interconnect system is shown to be very effective in making the airplane departure resistant while the stability-axis yaw damper provided improved high-angle-of-attack roll performance with a minimum of sideslip excursions.

Gilbert, W. P.↗

Analysis and design of a capsule landing system and surface vehicle control system for Mars exploration

Problems related to the design and control of an autonomous rover for the purpose of unmanned exploration of the planets were considered. Building on the basis of prior studies, a four wheeled rover of unusual mobility and maneuverability was further refined and tested under both laboratory and field conditions. A second major effort was made to develop autonomous guidance. Path selection systems capable of dealing with relatively formidable hazard and terrains involving various short range (1.0-3.0 meters), hazard detection systems using a triangulation detection concept were simulated and evaluated. The mechanical/electronic systems required to implement such a scheme were constructed and tested. These systems include: laser transmitter, photodetectors, the necessary data handling/controlling systems and a scanning mast. In addition, a telemetry system to interface the vehicle, the off-board computer and a remote control module for operator intervention were developed. Software for the autonomous control concept was written. All of the systems required for complete autonomous control were shown to be satisfactory except for that portion of the software relating to the handling of interrupt commands.

Gisser, D. G.↗

Results of recent NASA studies on spin resistance

Some of the factors which contribute to good stall/spin characteristics of a current fighter configuration indicate that the design of airframe components for inherent spin resistance is very configuration dependent and that few generalizations can be made. Secondary design features, such as fuselage forebody shape, can have significant effects on stability characteristics at high angles of attack. Recent piloted simulator studies and airplane flight tests have indicated that current automatic control systems can be tailored so as to provide a high degree of spin resistance for some configurations without restrictions to maneuverability. Such systems result in greatly increased pilot confidence and increased tactical effectiveness.

Chambers, J. R.↗

NASA's goal - Keeping the US number one in aeronautics

This article discusses the wide range of efforts being pursued by NASA to maintain the preeminence of the United States in military and commercial aircraft design. Emphasis is placed on the question of where industry should concentrate its research and technology efforts to support the aviation needs of the future. The major military and civil aircraft developments forseen for the period from 1985 to 2000 are identified, and NASA's role in the Highly Maneuverable Aircraft Technology program is briefly considered. Other programs discussed include those concerning airfoils, propulsion systems, aviation safety, next-generation subsonic transports, STOL and VTOL vehicles, and supersonic cruise aircraft.

Lovelace, A. M.↗

RPRV research focus on HiMAT

A review is presented of the F-15 Remotely Piloted Research Vehicle (RPRV) project. The F-15 RPRV is air-launched from a B-52 at 50,000 ft. Following launch a series of research maneuvers are performed during an unpowered descent to a recovery altitude. Another RPRV program considered is the Highly Maneuverable Aircraft Technology (HiMAT) program. This program is designed to use RPRVs to speed the technology transition from wind tunnel to flight and to reduce the cost of aeronautical experiments. It is pointed out that HiMAT will make extensive use of composite materials.

Lockenour, J. L.↗

Hand fin for swimming

Paddle mounted on forearm aids propulsion and maneuverability and frees hand for work without interference.

Martin, H. L.↗