Search NASA⌕ Search

SEARCH · Search NASA

Results for “Prevalence”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8

Discordance of exercise thallium testing with coronary arteriography in patients with atypical presentations

Eighty-one patients with diagnostically difficult clinical presentations suggesting coronary artery disease underwent symptom-limited maximal-exercise treadmill testing (ETT) and exercise radionuclide scanning with thallium-201 followed by coronary angiography. Results showed that in nearly half of the patients (47%) these tests were in agreement, while either exercise thallium or ETT was positive in 94% of patients with coronary artery disease. It was found that agreement between exercise thallium and ETT tests predicted disease in 92% of the instances or excluded disease in 82% of the instances. It is concluded that despite frequent discord between these two tests in 53% of the cases, a significant gain in exclusive diagnostic capability is realized when applied to a patient population anticipated to have a disease prevalence equal to the 67% encountered in this study.

Bungo, M. W.↗

Experiments on flow through one to four inlets of the orifice and Borda type

Choked flow rate and pressure profile data were taken on sequential axially aligned inlets of the orifice and Borda type. The configuration consisted of from two to four inlets spaced at two nominal separation distances of 0.7 and 30 diameters. At the nominal 30 diameter spacing, the reduced flow rate follows a simple empirical relation based on the reduced flow rate for a single inlet. At the nominal 0.7 diameter spacing, fluid jetting was prevalent at low temperatures and flow rates were the same as for a single inlet. Previously announced in STAR as N81-30391

Hendricks, R. C.↗

Einstein and IUE observations of nearby red dwarfs

This paper summarizes data for 40 representative nearby stars from one guest observer's coordinated programs with the Einstein Observatory or IUE Observatory. The coronal X-ray, chromospheric ultraviolet, and auxiliary optical properties of sets of these stars are tabulated or illustrated in several ways. Factors of stellar duplicity are shown to be quite prevalent in presenting the observations. The most luminous X-ray dwarfs below the sun are strongly prone to binary status. X-ray luminosity, and the ratio of chromospheric flux to X-ray flux, are dependent on photospheric radius. A very long period BY Draconis variable of type dM6e (HH And) is a detected X-ray source, and some presumably quite old (halo) stars are detected.

Johnson, H. M.↗

Standardization in software conversion of (ROM) estimating

Technical problems and their solutions comprise by far the majority of work involved in space simulation engineering. Fixed price contracts with schedule award fees are becoming more and more prevalent. Accurate estimation of these jobs is critical to maintain costs within limits and to predict realistic contract schedule dates. Computerized estimating may hold the answer to these new problems, though up to now computerized estimating has been complex, expensive, and geared to the business world, not to technical people. The objective of this effort was to provide a simple program on a desk top computer capable of providing a Rough Order of Magnitude (ROM) estimate in a short time. This program is not intended to provide a highly detailed breakdown of costs to a customer, but to provide a number which can be used as a rough estimate on short notice. With more debugging and fine tuning, a more detailed estimate can be made.

Roat, G. H.↗

Severe storm electricity

Successful ground truth support of U-2 overflights was been accomplished. Data have been reduced for 4 June 1984 and some of the results have been integrated into some of MSFC's efforts. Staccato lightning (multiply branched, single stroke flash with no continuing current) is prevalent within the rainfree region around the main storm updraft and this is believed to be important, i.e., staccato flashes might be an important indicator of severe storm electrification. Results from data analysis from two stations appear to indicate that charge center heights can be estimated from a combination of intercept data with data from the fixed laboratory at NSSL. An excellent data base has been provided for determining the sight errors and efficiency of NSSL's LLP system. Cloud structures, observable in a low radar reflectivity region and on a scale smaller than is currently resolved by radar, which appear to be related to electrical activity are studied.

Arnold, R. T.↗

Thermal considerations in the use of solid state power amplifiers on the GOES spacecraft

The use of solid state power amplifiers (SSPA) in satellites has been quite prevalent in several frequency bands. This trend is evidenced by the use of SSPAs at Hughes in the UHF band (Leasat/Syncom IV), S band (GOES), C band (Telstar), and SHF band. The junction temperature of the transistor is the driving requirement which determines the lifetime of the transistor, SSPA, and the payload. This temperature is determined by the transistor characteristics, use of the device, and mounting temperature of the SSPA. The temperature of the spacecraft in the area of the SSPA can be controlled by active or passive means. The various factors and interrelationships used to calculate and control the temperatures of SSPAs are described. The thermal design and calculation of junction temperatures are exemplified with the Geostationary Operational Environmental Satellite spacecraft.

Mallette, L.↗

Kelvin wave packets and flow acceleration - A comparison of modeling and observations

Atmospheric Kelvin waves, as revealed by temperatures obtained from the recent Limb Infrared Monitor of the Stratosphere (LIMS) experiment, commonly occur in packets. A simple two-dimensional gravity-wave model is used to study the upward propagation of these packets through different zonal mean wind profiles derived from the LIMS data. The observed prevalence of high frequency waves in the lower mesosphere and low frequency waves in the lower stratosphere can be exlained by dispersion of energy associated with the range of frequencies comprising a packet. Dominant wave frequencies at upper and lower levels are more distinctly separated if the packet propagates through a layer of westerly winds. Due to dispersion and shear effects, a packet of short temporal length at low levels will have a considerably extended impact on a layer of westerly winds at higher levels. Observed and modeled westerly accelerations resulting from packet absorption occur in the same layer, and are similar in magnitude and duration. These results support the theory that Kelvin waves are responsible for the westerly phase of the semiannual oscillation.

Coy, L.↗

Optimum Cyclic Redundancy Codes for Noisy Channels

Capabilities and limitations of cyclic redundancy codes (CRC's) for detecting transmission errors in data sent over relatively noisy channels (e.g., voice-grade telephone lines or very-high-density storage media) discussed in 16-page report. Due to prevalent use of bytes in multiples of 8 bits data transmission, report primarily concerned with cases in which both block length and number of redundant bits (check bits for use in error detection) included in each block are multiples of 8 bits.

Posner, E. C.↗

Flow rates and pressure profiles for one to four axially alined Borda inlets

Choked flow rate and pressure profile data were taken on sequential, axially alined inlets of the Borda type. The configurations consisted of two to four inlets spaced 0.8 and 30 diameters apart. At a spacing of 30 diameters the reduced flow rate appeared to follow the simple empirical relation G sub r/G sub r,1=N(-b), where G sub r,1 is the reduced flow rate for a single inlet; N is the number of inlets; and b, which is weakly temperature dependent, is approximately 0.4. The relation is in reasonable agreement with an analysis of the N-inlet configuration. At a spacing of 30 diameters the pressure profiles dropped sharply at the entrance and partially recovered within each inlet somewhat independently of N. Jetting through the last Borda was common at low temperatures. At a spacing of 0.8 diameter fluid jetting was prevalent at low temperatures for each configuration studied and flow rates were the same as that for a single inlet.

Hendricks, R. C.↗

Flow rate and pressure profiles for 1 to 4 axially alined orifice inlets

Choked flow rate and pressure profile data were taken on sequential axially alined inlets of the orifice type, with an orifice length-to-diameter ratio of 0.5. The configuration consisted of two to four inlets spaced at 0.66 and 32 orifice diameters apart. At a spacing of 32 diameters the reduced flow rate appeared to follow the simple power-law relation G(sub r)/G(sub r,1) = N (sup-b), where G(sub r,1) is the reduced flow rate for a single inlet, N is the number of inlets, and b, although temperature dependent, is approximately 0.4. At this spacing the instrumented orifices and spacers gave pressure profiles that dropped sharply at the entrance and partially recovered within each inlet, somewhat independent of N. At low inlet temperature jetting through the last orifice was common. At a spacing of 0.66 diameter fluid jetting through all N inlets was prevalent at low temperatures for each configuration studied, as indicated by the flat pressure profiles and flow rates that were nearlly identical to those for a single orifice inlet. A simplifying relation was developed between the friction loss parameters for flow through N sequential tubes and N sequential inlets. The predicted flow rates for N tubes were in reasonable agreement with the N inlet analysis and followed the simple power-law relation.

Hendricks, R. C.↗

Mechanism of strength degradation for hot corrosion of alpha-SiC

Sintered alpha SiC was corroded by thin films of Na2SO4 and Na2CO3 molten salts at 1000%. This hot corrosion attack reduced room temperature strengths by as much as 50%. Strength degradation was porportional to the degree and uniformity of corrosion pitting attack as controlled by the chemistry of the molten salt. Extensive fractography identified corrosion pits as the most prevalent source of failure. A fracture mechanics treatment of the strength/pit depth relationship produced an average K sub IC equal to 2.6 MPa sub m 1/2, which is consistent with published values.

Smialek, J. L.↗

Modeling crater topography and albedo from monoscopic Viking Orbiter images. I - Methodology

The methodology for a new photoclinometric technique for extracting topographic data from planetary images is described. The technique fully compensates for oblique viewing geometry prevalent in many spacecraft images. Brightness data are taken from a pair of profiles simultaneously, overcoming the problem of albedo variations in the application of photoclinometry to planetary surfaces. An additional procedure is described for eliminating the requirement of topographic symmetry along a pair of profiles. Test results show that both procedures have an accuracy of about two degrees for slopes of typical bowl-shaped craters, or about 5 percent for depths.

Davis, P. A.↗

Preferential rifting of continents - A source of displaced terranes

Lithospheric rifting, while prevalent in the continents, rarely occurs in oceanic regions. To explain this preferential rifting of continents, the total strength of different lithospheres is compared by integrating the limits of lithospheric stress with depth. Comparisons of total strength indicate that continental lithosphere is weaker than oceanic lithosphere by about a factor of three. Also, a thickened crust can halve the total strength of normal continental lithosphere. Because the weakest area acts as a stress guide, any rifting close to an ocean-continent boundary would prefer a continental pathway. This results in the formation of small continental fragments or microplates that, once accreted back to a continent during subduction, are seen as displaced terranes. In addition, the large crustal thicknesses associated with suture zones would make such areas likely locations for future rifting episodes. This results in the tendency of new oceans to open along the suture where a former ocean had closed.

Vink, G. E.↗

Aircraft noise annoyance at three joint air carrier and general aviation airports

The results of social surveys conducted near three airports that support both general aviation and scheduled air carrier operations are presented and discussed. Inferences supported by these data include: (1) the nature of noise exposure and community reaction at smaller airports may differ from that at larger airports; (2) survey techniques are capable of identifying changes in annoyance associated with numerically small changes in noise exposure; (3) changes in the prevalence of annoyance are causally produced by changes in noise exposure; and (4) changes in annoyance associated with changes in exposure vary with time.

Fidell, S.↗

Control plate for shock-boundary layer interaction

Paper describes tests and computations for a relatively unique technique to greatly reduce/eliminate the separation region for shock-boundary layer interactions. A number of studies have shown that the usual effects of such interactions include increased local heating and wall pressures, thickening of the boundary layer and a decrease in the momentum of the flow and, for stronger waves, flow separation. This flow situation is particularly prevalent in supersonic and hypersonic inlets where severe performance degradation can occur due to flow separation. High performance engine design generally requires a uniform entering flow field with little stagnation pressure loss. Previous approaches to the problem involved primarily active devices (e.g., suction or blowing); the present paper considers a passive device. The boundary layer separation control technique considered herein involves the placement of an embedded plate in the outer portion of the boundary layer and parallel to the wall. This control plate is situated such that the incident shock impinges upon and reflects from its surface, thus greatly lessening the pressure gradient in the low momentum near wall region.

Goodman, W. L.↗

Variation in the stratospheric aerosol associated with the North Cyclonic Polar Vortex as measured by the SAM II satellite sensor

Optical depth data gathered by the stratospheric aerosol measurement (SAM II) satellite during the 1979-80 winter season are analyzed to study mean atmospheric motions. The spacecraft photometer yielded extinction rates over the Northern Hemisphere in the 8-30 km altitude interval. Filtering was performed to remove the effects of high clouds and polar stratospheric clouds. Free horizontal mixing was prevalent below 14 km, as was a systematic difference across the polar jet stream above that altitude. The aerosol declined in altitude as the winter progressed. The polar vortex is concluded to have a base at the 14 km altitude and an outer boundary which coincides with the jet stream axis. The model accords with atmospheric tracer measurements made during the open-air nuclear testing programs in the 1950s.

Kent, G. S.↗

Laboratory simulations of PH3 photolysis in the atmospheres of Jupiter and Saturn

The effects of pressure, temperature, light wavelength and intensity, and components of the atmosphere of the Jovian planets on the photolysis of PH3 were experimentally studied. The products of the photolysis, P2H4 and red phosphorus, exhibited little variation when the irradiation experiments were performed under conditions prevalent in Jupiter's atmosphere. No quenching of PH2 radicals by the levels of hydrocarbons present in the Jovian atmosphere was noted. The high partial pressure of hydrogen present on Jupiter should have no effect on the course of the photolysis. The low temperatures on Jupiter and Saturn may result in some condensation of P2H4, but P2H4 had sufficient vapor pressure in the experimental studies at 157 K to be slowly converted to red phosphorus. The products of PH3 photolysis were the same whether a 147, 184.9, or 206.2 nm monochromatic light source or a xenon lamp with a broad spectral output was used.

Ferris, J. P.↗

Use of observational and model-derived fields and regime model output statistics in mesoscale forecasting

Various empirical and statistical weather-forecasting studies which utilize stratification by weather regime are described. Objective classification was used to determine weather regime in some studies. In other cases the weather pattern was determined on the basis of a parameter representing the physical and dynamical processes relevant to the anticipated mesoscale phenomena, such as low level moisture convergence and convective precipitation, or the Froude number and the occurrence of cold-air damming. For mesoscale phenomena already in existence, new forecasting techniques were developed. The use of cloud models in operational forecasting is discussed. Models to calculate the spatial scales of forcings and resultant response for mesoscale systems are presented. The use of these models to represent the climatologically most prevalent systems, and to perform case-by-case simulations is reviewed. Operational implementation of mesoscale data into weather forecasts, using both actual simulation output and method-output statistics is discussed.

Forbes, G. S.↗