Search NASA⌕ Search

SEARCH · Search NASA

Results for “RADIO RECEIVER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS2013

Sleuthing the MSL EDL Performance from an X Band Carrier Perspective

During the Entry, Descent, and Landing (EDL) of NASA's Mars Science Laboratory (MSL), or Curiosity, rover to Gale Crater on Mars on August 6, 2012 UTC, the rover transmitted an X-band signal composed of carrier and tone frequencies and a UHF signal modulated with an 8kbps data stream. During EDL, the spacecraft's orientation is determined by its guidance and mechanical subsystems to ensure that the vehicle land safely at its destination. Although orientation to maximize telecom performance is not possible, antennas are especially designed and mounted to provide the best possible line of sight to Earth and to the Mars orbiters supporting MSL's landing. The tones and data transmitted over these links are selected carefully to reflect the most essential parameters of the vehicle's state and the performance of the EDL subsystems for post-EDL reconstruction should no further data transmission from the vehicle be possible. This paper addresses the configuration of the X band receive system used at NASA / JPL's Deep Space Network (DSN) to capture the signal spectrum of MSL's X band carrier and tone signal, examines the MSL vehicle state information obtained from the X band carrier signal only and contrasts the Doppler-derived information against the post-EDL known vehicle state. The paper begins with a description of the MSL EDL sequence of events and discusses the impact of the EDL maneuvers such as guided entry, parachute deploy, and powered descent on the frequency observables expected at the DSN. The range of Doppler dynamics possible is derived from extensive 6 Degrees-Of-Freedom (6 DOF) vehicle state calculations performed by MSL's EDL simulation team. The configuration of the DSN's receive system, using the Radio Science Receivers (RSR) to perform open-loop recording for both for nominal and off-nominal EDL scenarios, is detailed. Expected signal carrier power-to-noise levels during EDL are shown and their impact on signal detection is considered. Particular attention is given to the selection of the appropriate RSR processing bandwidths and to its configuration for real-time signal detection. The X-band carrier frequency obtained through post-processing of the open-loop recorded spectrum is given. Detection of spacecraft status and completion of key vehicle events through their Doppler signature is discussed and illustrated. This Doppler-derived information is compared against the very accurate vehicle data obtained post-EDL via MSL's UHF radio subsystem. The paper concludes with a discussion on the advantages and disadvantages of transmitting the X-band carrier and tone signal in the general context of EDL communications and lessons learned for future missions with EDL sequences are given

Mars Science Laboratory (MSL)↗
NASA NTRS1983

The effect of partial coherence in receiving system noise temperature on array gain for telemetry and radio frequency carrier reception for receiving systems with unequal predetection signal-to-noise ratios

Signal to noise ratio improvement realized by arraying receiving systems or stations for coherent reception is reduced when some portion of the predetection noise is coherent in the array. This effect for arrayed receiving systems with unequal apertures including expected performance for selected planets of the solar system within the array beamwidth is examined.

Brockman, M. H.↗
NASA NTRS1980

RF spectrometers for heterodyne receivers

Several types of spectrometers developed for radio astronomy receivers which utilize RF filters, multiple oscillators and mixers, digital autocorrelators and acoustic/optic devices are considered. The RF spectrometer developed at GSFC to provide wide bandwidths (greater than 1 GHz) as well as high resolution (5MHz) is described. The 128 channel filter bank is divided into high and low resolution sections. The high resolution section is tunable by providing a second mixer ahead of the filter bank. This is necessary because infrared receivers which use gas lasers as local oscillators are only tunable to specific laser frequencies. To compensate for astronomical Doppler shifts and molecule frequency differences a second local oscillator and mixer is needed. A diagram of the RF section of the filter bank is shown. The RF spectrometer is shown to be the best means of achieving ultra-wide bandwidths for infrared heterodyne receivers. For high resolution with a large number of channels, the acousto/optical spectrometer is the principle instrument, particularly for balloon or space flight applications.

Buhl, D.↗
NASA NTRS2011

Adaptation of the Electra Radio to Support Multiple Receive Channels

Proposed future Mars missions plan communication between multiple assets (rovers). This paper presents the results of a study carried out to assess the potential adaptation of the Electra radio to a multi-channel transceiver. The basic concept is a Frequency Division multiplexing (FDM) communications scheme wherein different receiver architectures are examined. Options considered include: (1) multiple IF slices, A/D and FPGAs each programmed with an Electra baseband modem; (2) common IF but multiple A/Ds and FPGAs and (3) common IF, single A/D and single or multiple FPGAs programmed to accommodate the FDM signals. These options represent the usual tradeoff between analog and digital complexity. Given the space application, a common IF is preferable; however, multiple users present dynamic range challenges (e.g., near-far constraints) that would favor multiple IF slices (Option 1). Vice versa, with a common IF and multiple A/Ds (Option 2), individual AGC control of the A/Ds would be an important consideration. Option 3 would require a common AGC control strategy and would entail multiple digital down conversion paths within the FPGA. In this paper, both FDM parameters as well as the different Electra design options will be examined. In particular, signal channel spacing as a function of user data rates and transmit powers will be evaluated. In addition, tradeoffs between the different Electra design options will be presented with the ultimate goal of defining an augmented Electra radio architecture for potential future missions.

Time Division multiplexing↗
NASA NTRS2008

Radio Frequency Compatibility of an RFID Tag on Glideslope Navigation Receivers

A process is demonstrated to show compatibility between a radio frequency identification (RFID) tag and an aircraft glideslope (GS) radio receiver. The particular tag chosen was previously shown to have significant peak spurious emission levels that far exceeded the emission limits in the GS aeronautical band. The spurious emissions are emulated in the study by capturing the RFID fundamental transmission and playing back the signal in the GS band. The signal capturing and playback are achieved with a vector signal generator and a spectrum analyzer that can output the in-phase and quadrature components (IQ). The simulated interference signal is combined with a desired GS signal before being injected into a GS receiver s antenna port for interference threshold determination. Minimum desired propagation loss values to avoid interference are then computed and compared against actual propagation losses for several aircraft.

Nguyen, Truong X.↗
NASA NTRS1996

Investigation of the High Latitude Magnetosphere and its Response to the Solar Wind

INSPIRE is a non-profit scientific, educational corporation whose objective is to bring the excitement of observing natural and manmade radio waves in the audio region to high school students. Stimulating students to learn and understand science and technology is the key to them fulfilling their potential in the best interests of our society. INSPIRE also is an innovative, unique opportunity for students to actively gather data that might be used in a basic research project. INSPIRE began with a test bed project, ACTIVE/HSGS, which involved 100 high schools, with a centerpiece of making observations of 10.5 kHz transmissions from the Soviet ACTIVE satellite. A large number of ground receiving sites was needed, both to enhance the probability of receiving the radio waves from ACTIVE, and to determine the propagation paths to the ground. The second major project was support to SEPAC (Space Experiments using Particle ACcelerators), a payload on the ATLAS I Spacelab mission, flown in March/April 1992. With its electron accelerator SEPAC performed many experiments in the ionosphere, including producing an artificial aurora and the electromagnetic waves produced by pulsing the electron beam. INSPIRE/SEPAC provided more than 1000 ground stations to receive the radio waves, and, at the same time, allowed high school students the opportunity to take data that would be used in a published basic research project. The third major project is to make observations of the effects of a pulsed electron beam and plasma generator on the MIR Space Station. On request, these instruments are operated over INSPIRE observers.

Taylor, William W. L.↗
NASA NTRS2016

Mars Cube One (MarCO) Shifting the Paradigm in Relay Deep Space Operations

A very significant challenge in the planetary mission design and operations is communications with ground control teams during critical events and highly risky maneuvers. These include entry, descent, and landing (EDL) and orbit insertion, which should not be carried out in the blind. Although vast planetary distances and long round-trip light times disallow real-time intervention from controllers, acquiring the relevant event performance parameters in near real-time can be imperative for determining the corrective actions needed immediately following or, in the case of significant anomalies, aid in the diagnostic analysis. During several previous Mars missions landing events, and the Huygens probe landing on Titan, the communications strategy relied on proximity links to planetary orbiters, which then relayed the data to the Deep Space Network (DSN). In addition, attempts were successfully made in parallel to receive the signal carrier directly at Earth often using large radio telescopes when the wavelength was outside the DSN’s reception bands. This Direct-to-Earth (DTE) back-up method was only possible due to special techniques utilizing the DSN’s open-loop Radio Science Receivers. In every case, it was very challenging since the link budget of a landing vehicles were designed for proximity orbiter relays and not for distances across the solar system. A new method is introduced since not all future missions can rely on the presence of pre-existing orbiters at their planetary targets to relay their critical data ad, furthermore, most missions would not likely have the resources to implement a reliable DTE link at acceptable data rates, bypassing a need for a relay asset. With the advent CubeSat form-factor spacecraft, one or more, for added reliability, CubeSats can be launched with the primary mission, travel to the target, and be positioned to view the critical event, such as EDL, and carry out real-time relay of the data to the DSN at higher rates. CubeSats have flown in the Earth environment but never flown or been operated in deep space or planetary environment so careful design as well as flight experience are needed. The relay function requires the development of radio and antenna systems to meet challenging specifications. After initial technical demonstration of the concept and operational experience, the cost can decrease as systems become more standardized with increased reliability. This paper describes the invention of the “carry your own relay” concept and the formulation of the mission likely to be the first planetary CubeSat mission called Mars Cube One (MarCO). It also describes the operational concept of relay small spacecraft and their role reducing mission risk as well as overall mission cost.

Asmar, Sami↗
NASA NTRS1990

Sampling Downconverter For Radio-Frequency Signals

Phase and delay errors reduced greatly. Proposed GaAs integrated-circuit for receiver of radio signals at gigahertz frequencies samples incoming signal in phase and in quadrature, digitizes it, and down-converts it to baseband in single step. Incorporates both digital and analog components in design offering improved stability, versatility, and sampling bandwidth. Eliminates need for several components found in conventional analog designs, including mixers, postmixer filters, and 90 degree phase shifter.

Thomas, J. B.↗
NASA NTRS1989

Impulsive solar wind-driven emission from Uranus

Several days prior to the Voyager spacecraft encounter with Uranus, the plasma wave and radio astronomy receivers detected extraordinarily narrowband bursty signals, the first indication of any radio emission from the planet. The characteristics of these signals were so unusual that their identity as a natural planetary emission was questioned at first. Subsequent analysis has shown, however, that the n bursts are modulated at the 17.24-hour Uranus rotation period and are, therefore, planetary in origin. It is shown, in addition, that the typical bandwidth and time scale for the bursts are about 5 kHz and 250 ms, respectively. The phase of the rotation modulation suggests a probable source for these events in the vicinity of the north (weak) magnetic pole. The waves are right-hand polarized and are therefore emitted in the extraordinary magnetoionic mode if the emission in fact originates above the north magnetic pole.

Desch, M. D.↗
NASA NTRS1999

Simultaneous Observation of Jovian Radio Emissions by Cassini and Wind

During the Cassini instrument checkout interval in January 1999 as the spacecraft was making a distant (0.6 AU) swing by Earth, the radio and plasma wave receiver (RPWS) detected radio emission from the sun, Earth, and Jupiter, the latter including both the hectometric (HOM) and decametric (DAM) components. The WAVES experiment on the Wind spacecraft in orbit near Earth was also making observations of Jupiter at this same time. By combining the RPWS and WAVES data sets, we are able to provide some insight into the instantaneous beaming of Jovian radio emissions. As seen by Jupiter, Cassini and Wind were a few degrees apart during this period, yet the correlation between Jovian DAM arcs observed by the two spacecraft suggests that the beam width is even narrower and does not simultaneously illuminate both. The only earlier spacecraft capable, in principle, of making these observations were Voyager-1 and 2, but their sensitivity to DAM emissions was too limited to reliably measure the instantaneous beaming. The beam width implied by the RPWS-WAVES measurements is approximately the same as the angle through which Jupiter rotates while an arc (at a fixed frequency) is visible. The HOM Jovian emissions, on the other hand, seem similar as observed by RPWS and WAVES, consistent with earlier Wind-Ulysses measurements indicating a somewhat broader beam width.

Kaiser, M. L.↗
NASA NTRS1972

Current methods of radio occultation data inversion

The methods of Abel integral transform and ray-tracing inversion have been applied to data received from radio occultation experiments as a means of obtaining refractive index profiles of the ionospheres and atmospheres of Mars and Venus. In the case of Mars, certain simplifications are introduced by the assumption of small refractive bending in the atmosphere. General inversion methods, independent of the thin atmosphere approximation, have been used to invert the data obtained from the radio occultation of Mariner 5 by Venus; similar methods will be used to analyze data obtained from Jupiter with Pioneers F and G, as well as from the other outer planets in the Outer Planet Grand Tour Missions.

Kliore, A. J.↗
NASA NTRS2016

An Optical Receiver Post Processing System for the Integrated Radio and Optical Communications Software Defined Radio Test Bed

The Integrated Radio and Optical Communications (iROC) project at the National Aeronautics and Space Administrations (NASA) Glenn Research Center is investigating the feasibility of a hybrid radio frequency (RF) and optical communication system for future deep space missions. As a part of this investigation, a test bed for a radio frequency (RF) and optical software defined radio (SDR) has been built. Receivers and modems for the NASA deep space optical waveform are not commercially available so a custom ground optical receiver system has been built. This paper documents the ground optical receiver, which is used in order to test the RF and optical SDR in a free space optical communications link.

waveforms↗