Search NASA⌕ Search

SEARCH · Search NASA

Results for “Synchronization”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRSDate not supplied

Precision Synchronization for Free-Space Quantum Networking

Precision synchronization is vital for robust long-distance quantum networking over fiber and free-space channels for which high-fidelity entanglement swapping between separate sources via an optical Bell state measurement requires temporal overlap of photonic qubits arriving from either source. This challenge is particularly distinct in satellite-based entanglement distribution in which relative motion, channel effects, and propagation delay must be addressed. This work presents a precision synchronization method for free space entanglement distribution, and reports on risk reduction testing in a quantum networking testbed at MIT Lincoln Laboratory. Primary consideration is for a dual-uplink architecture in which photons from entanglement sources at two ground locations interact in an optical Bell-state measurement implemented on a satellite in a low-earth orbit. The control approach uses independent entanglement sources at each ground location supplemented with a synchronization signal for feedback control from a timing discriminant measured at the spacecraft. The approach is being implemented in a laboratory testbed using 1-GHz repetition rate 1550-nm band entanglement sources generating ~10-MHz source entanglement rates with few-ps photon pulse lengths. The paper describes both fundamental architectural considerations and practical implementation details.

quantum↗
NASA NTRS2016

The Inner Edge of the Habitable Zone for Synchronously Rotating Planets Around Low-Mass Stars Using General Circulation Models

Terrestrial planets at the inner edge of the habitable zone (HZ) of late-K and M-dwarf stars are expected to be in synchronous rotation, as a consequence of strong tidal interactions with their host stars. Previous global climate model (GCM) studies have shown that, for slowly rotating planets, strong convection at the substellar point can create optically thick water clouds, increasing the planetary albedo, and thus stabilizing the climate against a thermal runaway. However these studies did not use self-consistent orbital/rotational periods for synchronously rotating planets placed at different distances from the host star. Here we provide new estimates of the inner edge of the HZ for synchronously rotating terrestrial planets around late-K and M-dwarf stars using a 3D Earth-analog GCM with self-consistent relationships between stellar metallicity, stellar effective temperature, and the planetary orbital/rotational period. We find that both atmospheric dynamics and the efficacy of the substellar cloud deck are sensitive to the precise rotation rate of the planet. Around mid-to-late M-dwarf stars with low metallicity, planetary rotation rates at the inner edge of the HZ become faster, and the inner edge of the HZ is farther away from the host stars than in previous GCM studies. For an Earth-sized planet, the dynamical regime of the substellar clouds begins to transition as the rotation rate approaches ∼10 days. These faster rotation rates produce stronger zonal winds that encircle the planet and smear the substellar clouds around it, lowering the planetary albedo, and causing the onset of the water-vapor greenhouse climatic instability to occur at up to ∼25% lower incident stellar fluxes than found in previous GCM studies. For mid-to-late M-dwarf stars with high metallicity and for mid-K to early-M stars, we agree with previous studies.

Planet and satellite atmospheres↗
NASA NTRSDate not supplied

Picosecond Clock Synchronization Across A 7-Node Metropolitan Scale Quantum Network

Quantum networking protocols relying on interference and precise time-of-flight measurements require high precision clock synchronization. This study describes the design, implementation, and characterization of two optical time transfer methods in a metropolitan-scale quantum networking research testbed. The first technique called active electronic stabilization (ELSTAB), was able to achieve sub-picosecond time deviation (TDEV) at integration times between 1 s and 105s over multiple different fiber lengths of both underground and aerial deployed fiber. The second technique, White Rabbit-Precision Time Protocol (WR-PTP), was able to achieve 10-picosecond TDEV’s over similar fiber lengths at comparable integration times. Environmental fluctuations affected the stability of clock synchronization over deployed fiber. These fluctuations resulted in path delay gradients, chromatic dispersion, polarization drift, and optical power variations. The results from this study will inform future work in the development of compensation methods essential for enabling experimental research in developing practical quantum networking protocols.

synchronization↗
NASA NTRS1962

SYNCHRONOUS-ORBIT COMMUNICATIONS SATELLITES

This paper will present (1) a discussion of some of the attractive features of a system using stationary or synchronous satellites, (2) some of the problem areas that we see in getting from where we are today to such a system, (3) a description of the NASA Syncom program, and (4) a very brief description of a more advanced synchronous satellite system.

Synchronous satellite↗
NASA NTRS1961

Classification and Evaluation of Coherent Synchronous Sampled-Data Telemetry Systems

This paper analyzes the various types of continuous wave and pulse modulation for the transmission of sampled data over channels perturbed by white gaussian noise. Optimal coherent synchronous detection schemes for all the different modulation methods are shown to belong to one of two general classes: linear synchronous detection and correlation detection. The figures of merit, mean-square signal-to-error ratio and bandwidth occupancy, are determined for each system and compared.

Viterbi, Andrew↗
NASA NTRS1969

Synchronizing redundant power oscillators

Outputs of oscillators are synchronized by summing the power transformer phase voltages, the summed voltages are applied to the frequency determining inductors of the individual voltage-controlled power oscillators. The beat frequency is eliminated when synchronization is achieved.

Jenson, K. J.↗
NASA NTRS1972

ATS-5 solar cell experiment results after one year in synchronous orbit

The results of the ATS-5 solar cell experiment after one year in synchronous orbit are reported. A partial failure in the experimental electronics package has caused a loss of data from half the 80 experimental solar cells. Procedures for extracting data due to a partial spacecraft failure are described and discussed. Data from the remaining 40 solar cells, including 15 mounted on a thin flexible structure are analyzed. Data are corrected to a solar intensity of 140 mW/sq cm and a temperature of 25 C. It was found that after one year in synchronous orbit: (1) cells with 1.52-mm-thick coverslides did not show a clear-cut advantage over those with 0.15-mm coverslides, (2) cells with solderless grid lines are degrading at the same rate as are cells with solder-dipped grid lines, (3) cells not quite completely covered with coverslides suffered a large power loss in comparison to cells fully covered, (4) no clear-cut advantage of 10-cm cells over 2-cm cells has yet been observed, (5) cells mounted on the flexible panel with relatively little backshielding did not degrade any faster than those with substantial backshielding, and (6) the flight data in large part confirms the adequacy of the ground-based techniques used in our preflight radiation test program.

Anspaugh, B. E.↗
NASA NTRS1972

Handbook of operation and maintenance instructions for Model 5208A bit synchronizer unit

Electrical/mechanical characteristics, operation, theory of operation, parts list, and electrical diagrams for the model 5208A bit synchronizer unit are provided. The unit is capable of performing the functions of bit synchronization and signal conditioning on demodulated wave trains containing amplitude, frequency, and phase distortions, as well as additive noise. Operating frequencies in the 1 to 27 MHz bit rate range are accommodated through the use of discrete frequency plug-in subunits. The unit provides 0 and 180 degree clocks and either a single signal hard decision, or a three bit quantized soft decision data output.

Source record↗
NASA NTRS1971

A simple branch synchronizer for convolutional decoders.

A simple branch synchronizer for rate 1/3, constraint length five, nonsystematic convolutional code is described. The scheme derives the sync information from the received channel bits, thus avoiding the extra formatting of the sync data at the transmitter and receiver, and increasing the data rate. The synchronizer detects the proper sync bits for both the in-phase and phase ambiguous cases. The design is adaptable to nonsystematic codes of different constraint lengths.

Taqvi, S. Z. H.↗
NASA NTRS1972

Dual transponder time synchronization at C band using ATS-3.

The use of artificial satellites for time synchronization of geographically distant clocks is hindered by problems due to satellite motion or equipment delay measurements. The ATS-3 satellite with its two C-band transponder channels helps solve these problems through techniques for synchronization to accuracies of tenths of microseconds. Portable cesium clocks were used to verify the accuracy of the described system.

Mazur, W. E., Jr.↗
NASA NTRS1973

Phase shift keyed, pulse code modulated signal synchronizer

Signal is demodulated and synchronized by three loop circuits: ''Q'' loop uses quadrature signal to stabilize frequency; ''B'' loop acts on baseboard signal to stabilize phase; and decoding ''I'' loop acts on in-phase signal. Synchronizer may be used to eliminate false-lock.

Kobayashi, H. S.↗
NASA NTRS1972

Synchronization using pulsed edge tracking in optical PPM communication system

A pulse position modulated (PPM) optical communication system using narrow pulses of light for data transmission requires accurate time synchronization between transmitter and receiver. The presence of signal energy in the form of optical pulses suggests the use of a pulse edge tracking method of maintaining the necessary timing. The edge tracking operation in a binary PPM system is examined, taking into account the quantum nature of the optical transmissions. Consideration is given first to pure synchronization using a periodic pulsed intensity, then extended to the case where position modulation is present and auxiliary bit decisioning is needed to aid the tracking operation. Performance analysis is made in terms of timing error and its associated statistics. Timing error variances are shown as a function of system signal to noise ratio.

Gagliardi, R.↗
NASA NTRS1968

Pseudonoise (PN) synchronization of data system with derivation of clock frequency from received signal for clocking receiver PN generator

A digital communicating system for automatically synchronizing signals for data detection is described. The systems consists of biphase modulating a subcarrier frequency by the binary data and transmitting a carrier phase modulated by this signal to a receiver, where coherent phase detection is employed to recover the subcarrier. Data detection is achieved by providing, in the receiver, a demodulated reference which is in synchronism with the unmodulated subcarrier in transmitting system. The output of the detector is passed through a matched filter where the signal is integrated over a bit period. As a result, random noise components are averaged out, so that the probability of detecting the correct data transmitted is maximized.

Couvillon, L. A., Jr.↗
NASA NTRS1972

ATS-5 solar cell experiment after 699 days in synchronous orbit.

The data from the ATS-5 solar cell experiment for the first 699 days in synchronous orbit is presented. Comparison of the performance of several different types of solar cell/coverslide configurations is made. This behavior is in turn compared with the calculated performance for such cell/coverslide configurations in synchronous orbit and with the results of accelerator irradiations designed to simulate the omnidirectional electron environment. It is generally found that the cells on the flight experiment perform like the cells irradiated with the accelerator, but they degraded more than predicted by the calculation. Solar cells mounted on a thin kapton panel are degrading about the same as are their counterparts mounted on a rigid panel.

Anspaugh, B. E.↗
NASA NTRS1972

An amplitude-steered, electronically despun antenna for the synchronous meteorological satellite.

Description of the design and performance of a dual-band electronically despun, high-gain, earth-coverage satellite antenna for use on the Synchronous Meteorological Satellite. The SMS satellite is designed to take high-resolution cloud cover pictures from synchronous altitude. Several unique design features are described, including a scheme for steering energy around the array in a continuous fashion to avoid 'phase jumps' caused by sudden energy switches.

Dietrich, F. J.↗