Search NASA⌕ Search

SEARCH · Search NASA

Results for “VIBRATIONAL SPECTRUM”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Vibration detection of component operability

In order to prevent catastrophic failure and eliminate unnecessary periodic maintenance in the Space Shuttle Orbiter dynamic components, instrumentation for detecting incipient failure in these components is required. This study investigated the utilization of vibrational phenomena as one of the principal physical parameters on which to base the design of this instrumentation. Baseline vibration data was collected from three aircraft type fans and two aircraft type pumps over a frequency range from a few Hertz to greater than 300 kHz. The baseline data included spectrum analysis of the vibration and detected carrier signals, as well as several non-spectrum parameters. Several defects were introduced into the five test items, and all defects were detected by at least one of the parameters with a margin of at least 2:1 over the worst case baseline.

Baird, B.↗
NASA NTRS2020

Propionitrile in the Two Lowest Excited Vibrational States in the Laboratory and on Titan

The rotational spectrum of propionitrile (ethyl cyanide, C2H5CN) in the two lowest excited vibrational states, ν(sub 13) = 1 and ν(sub 21) = 1, was studied in detail. The compiled experimental data set consisted of published line lists, lines measured from published spectra up to 645 GHz, and new measurements at frequencies from 8 to 331 GHz. The two states are subject to considerable mutual interaction but application of a- and b-axis Coriolis coupling model to the measured A-symmetry internal rotation substate transitions was found to be successful. A total of over 1900 transitions were fitted for J values up to 76 and Ka up to 24, resulting in determined vibrational separation between the two states ΔE = 6:2070246(14) cm(exp -1), and Coriolis coefficients |ζ(sup a)(sub 13,21)| = 0.378, |ζ(sup b) (sub 13,21)| = 0.127, in good agreement with quantum chemistry calculations. The new line catalog was used to model ALMA spectra of Titan’s atmosphere from 2016, fitting many weak lines not previously modeled. By including the vibrationally excited lines of C2H5CN and a new partition function, we derive a disk-averaged volume mixing ratio estimate in 2016 of 7.8 ± 0.2 ppb assumed constant above 300 km.

Analysis of rotational spectrum↗
NASA NTRS2001

Measuring Rocket Engine Temperatures with Hydrogen Raman Spectroscopy

Optically accessible, high pressure, hot fire test articles are available at NASA Marshall for use in development of advanced rocket engine propellant injectors. Single laser-pulse ultraviolet (UV) Raman spectroscopy has been used in the past in these devices for analysis of high pressure H2- and CH4-fueled combustion, but relies on an independent pressure measurement in order to provide temperature information. A variation of UV Raman (High Resolution Hydrogen Raman Spectroscopy) is under development and will allow temperature measurement without the need for an independent pressure measurement, useful for flows where local pressure may not be accurately known. The technique involves the use of a spectrometer with good spectral resolution, requiring a small entrance slit for the spectrometer. The H2 Raman spectrum, when created by a narrow linewidth laser source and obtained from a good spectral resolution spectrograph, has a spectral shape related to temperature. By best-fit matching an experimental spectrum to theoretical spectra at various temperatures, a temperature measurement is obtained. The spectral model accounts for collisional narrowing, collisional broadening, Doppler broadening, and collisional line shifting of each Raman line making up the H2 Stokes vibrational Q-branch spectrum. At pressures from atmospheric up to those associated with advanced preburner components (5500 psia), collisional broadening though present does not cause significant overlap of the Raman lines, allowing high resolution H2 Raman to be used for temperature measurements in plumes and in high pressure test articles. Experimental demonstrations of the technique are performed for rich H2-air flames at atmospheric pressure and for high pressure, 300 K H2-He mixtures. Spectrometer imaging quality is identified as being critical for successful implementation of technique.

Wehrmeyer, Joseph A.↗
NASA NTRS2000

Sensitivity of Force Specifications to the Errors in Measuring the Interface Force

Force-Limited Random Vibration Testing has been applied in the last several years at the NASA Goddard Space Flight Center (GSFC) and other NASA centers for various programs at the instrument and spacecraft level. Different techniques have been developed over the last few decades to estimate the dynamic forces that the test article under consideration will encounter in the flight environment. Some of these techniques are described in the handbook, NASA-HDBK-7004, and the monograph, NASA-RP-1403. This paper will show the effects of some measurement and calibration errors in force gauges. In some cases, the notches in the acceleration spectrum when a random vibration test is performed with measurement errors are the same as the notches produced during a test that has no measurement errors. The paper will also present the results Of tests that were used to validate this effect. Knowing the effect of measurement errors can allow tests to continue after force gauge failures or allow dummy gauges to be used in places that are inaccessible to a force gage.

Worth, Daniel↗
NASA NTRS1999

Sensitivity of Force Specifications to the Errors in Measuring the Interface Force

Force-Limited Random Vibration Testing has been applied in the last several years at NASA/GSFC for various programs at the instrument and system level. Different techniques have been developed over the last few decades to estimate the dynamic forces that the test article under consideration will encounter in the operational environment. Some of these techniques are described in the handbook, NASA-HDBK-7004, and the monograph, NASA-RP-1403. A key element in the ability to perform force-limited testing is multi-component force gauges. This paper will show how some measurement and calibration errors in force gauges are compensated for w en tie force specification is calculated. The resulting notches in the acceleration spectrum, when a random vibration test is performed, are the same as the notches produced during an uncompensated test that has no measurement errors. The paper will also present the results of tests that were used to validate this compensation. Knowing that the force specification can compensate for some measurement errors allows tests to continue after force gauge failures or allows dummy gauges to be used in places that are inaccessible.

Worth, Daniel↗
NASA NTRS1987

Identification and proposed control of helicopter transmission noise at the source

Helicopter cabin interiors require noise treatment which is expensive and adds weight. The gears inside the main power transmission are major sources of cabin noise. Work conducted by the NASA Lewis Research Center in measuring cabin interior noise and in relating the noise spectrum to the gear vibration of the Army OH-58 helicopter is described. Flight test data indicate that the planetary gear train is a major source of cabin noise and that other low frequency sources are present that could dominate the cabin noise. Companion vibration measurements were made in a transmission test stand, revealing that the single largest contributor to the transmission vibration was the spiral bevel gear mesh. The current understanding of the nature and causes of gear and transmission noise is discussed. It is believed that the kinematical errors of the gear mesh have a strong influence on that noise. The completed NASA/Army sponsored research that applies to transmission noise reduction is summarized. The continuing research program is also reviewed.

Coy, John J.↗
NASA NTRS1988

Identification and proposed control of helicopter transmission noise at the source

Helicopter cabin interiors require noise treatment which is expensive and adds weight. The gears inside the main power transmission are major sources of cabin noise. Work conducted by the NASA Lewis Research Center in measuring cabin interior noise and in relating the noise spectrum to the gear vibration of the Army OH-58 helicopter is described. Flight test data indicate that the planetary gear train is a major source of cabin noise and that other low frequency sources are present that could dominate the cabin noise. Companion vibration measurements were made in a transmission test stand, revealing that the single largest contributor to the transmission vibration was the spiral bevel gear mesh. The current understanding of the nature and causes of gear and transmission noise is discussed. It is believed that the kinematical errors of the gear mesh have a strong influence on that noise. The completed NASA/Army sponsored research that applies to transmission noise reduction is summarized. The continuing research program is also reviewed.

Coy, John J.↗
NASA NTRS1989

Dust coagulation in ISM

Coagulation is an important mechanism in the growth of interstellar and interplanetary dust particles. The microphysics of the coagulation process was theoretically analyzed as a function of the physical properties of the coagulating grains, i.e., their size, relative velocities, temperature, elastic properties, and the van der Waal interaction. Numerical calculations of collisions between linear chains provide the wave energy in individual particles and the spectrum of the mechanical vibrations set up in colliding particles. Sticking probabilities are then calculated using simple estimates for elastic deformation energies and for the attenuation of the wave energy due to absorption and scattering processes.

Chokshi, Arati↗
NASA NTRS1994

The Infrared Spectrum of H(sub 2)S from 1 to 5 Mm

The absorption spectra of H2S from 2000 to 11,147/cm have been obtained with spectral resolutions of 0.006, 0.012 and 0.021/cm using the Fourier transform spectrometer at Kitt Peak National Observatory.

parameters↗
NASA NTRS1994

Observation of CH A->X, Cn B->X, and NH A->X Emissions in Gas-phase Collisions of Fast O ((sup 3)P) Atoms with Hydrazines

Optical emissions in single-collision reactions of fast (20 eV laboratory translational energy) O((sup 3)P) atoms with hydrazine, methylhydrazine, and 1,1-dimethylhydrazine have been measured in a crossed-beams geometry. The emissions were observed in the wavelength range 325-440 nm, and were identified as the CH (A 2(sub A))-->X(sup 2)pi(sub r), (for methylhydrazine), CN (B sup 2) Sigma(sup +) --> X(sup 2) Sigma(sup +) (for methylhydrazine)and NH(A(sup 3)pi --> X(sup3 Sigma) transitions (for all three hydraz vibration-rotation bands were fit to a synthetic spectrum of CH, CN and NH with given vibrational and rotational temperatures.

chemical reactions↗
NASA NTRS1978

Effect of vibration duration on human discomfort

The duration effects of random vertical vibration on passenger discomfort were studied in a simulated section of an aircraft cabin configured to seat six persons in tourist-class style. Variables of the study included time of exposure (0.25 min to 60 min) and the rms amplitude of vibration (0.025g to 0.100g). The vibrations had a white noise spectrum with a bandwidth of 10 Hz centered at 5 Hz. Data indicate that the discomfort threshold occurred at an rms vertical acceleration level of 0.027g for all durations of vibration. However, for acceleration levels that exceeded the discomfort threshold, a systematic decrease in discomfort occurred as a function of increasing duration of vibration. For the range of accelerations used, the magnitude of the discomfort decrement was shown to be independent of acceleration level. The results suggest that discomfort from vertical vibration applied in the frequency range at which humans are most sensitive decreases with longer exposure, which is the opposite of the recommendation of the International Standard ISO 2631-1974 (E) Guide for the Evaluation of Human Exposure to Whole-Body Vibration.

Clevenson, S. A.↗
NASA NTRS1985

Vibrations of circular orthotropic plates in affine space

The vibration of an initially compressed plate having a circular geometry and orthotropy is examined in an affine space. The classical linear plate theory and Hamilton's principle are employed. The equations of motion of the plate are particularly simple in the chosen affine space, permitting a free-vibration study of the entire spectrum of composite materials with polar orthotropy. Approximate but very accurate standing-wave-type mode shapes are used in solving the essentially double eigenvalue problem to determine the effects of midplane forces on the vibration frequencies of the plate. The results indicate that the affine-space frequency increases with increasing stiffness ratio but decreases with increasing midplane compression. It is also discovered that, contrary to the trends observed for rectangular geometry and orthotropy by Oyibo (1981), Brunelle (1982), and Brunelle and Oyibo (1983), the affine-space frequency increases with increasing generalized Poisson's ratio.

Oyibo, G. A.↗