Search NASA⌕ Search

SEARCH · Search NASA

Results for “flow noise”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 145 records · Page 8
All sourcesNASA NTRSDOE OSTI
NASA NTRS2004

Computation of Tone Noises Generated in Viscous Flows

Three benchmark problems from the current and previous CAA workshops involving tone noise generated in viscous flows are investigated using the CE/SE finite volume method. The CE/SE method is first briefly reviewed. Then, the benchmark problems, namely, flow past a single cylinder (CAA Workshop II problem), flow past twin cylinders (from the current CAA Workshop IV, Category 5, Problem 1) and flow past a deep cavity with overhang (CAA Workshop III problem) are investigated. Generally good results are obtained in comparison with the experimental data.

Loh, Ching Y.↗
NASA NTRS1986

Effects of cone surface waviness and freestream noise on transition in supersonic flow

A comparison of transition on wavy-wall and smooth-wall cones in a Mach 3.5 wind tunnel is made under conditions of either low freestream noise (quiet flow) or high freestream noise (noisy flow). The noisy flow compares to that found in conventional wind tunnels while the quiet flow gives transitional Reynolds numbers on smooth sharp cones comparable to those found in flight. The waves were found to have a much smaller effect on transition than similar sized trip wires. A satisfatory correlating parameter for the effect of waves on transition was simply the wave height-to-length ratio. A given value of this ratio was found to cause the same percentage change in transition location in quiet and noisy flows.

Morrisette, E. L.↗
NASA NTRS2008

The Aeroacoustics of Turbulent Flows

Aerodynamic noise prediction has been an important and challenging research area since James Lighthill first introduced his Acoustic Analogy Approach over fifty years ago. This talk attempts to provide a unified framework for the subsequent theoretical developments in this field. It assumes that there is no single approach that is optimal in all situations and uses the framework as a basis for discussing the strengths weaknesses of the various approaches to this topic. But the emphasis here will be on the important problem of predicting the noise from high speed air jets. Specific results will presented for round jets in the 0.5 to 1.4 Mach number range and compared with experimental data taken on the Glenn SHAR rig. It is demonstrated that nonparallel mean flow effects play an important role in predicting the noise at the supersonic Mach numbers. The results explain the failure of previous attempts based on the parallel flow Lilley model (which has served as the foundation for most jet noise analyses during past two decades).

Goldstein, M. E.↗
NASA NTRS2013

The Effects of Surfaces on the Aerodynamics and Acoustics of Jet Flows

Aircraft noise mitigation is an ongoing challenge for the aeronautics research community. In response to this challenge, low-noise aircraft concepts have been developed that exhibit situations where the jet exhaust interacts with an airframe surface. Jet flows interacting with nearby surfaces manifest a complex behavior in which acoustic and aerodynamic characteristics are altered. In this paper, the variation of the aerodynamics, acoustic source, and far-field acoustic intensity are examined as a large at plate is positioned relative to the nozzle exit. Steady Reynolds-Averaged Navier-Stokes solutions are examined to study the aerodynamic changes in the field-variables and turbulence statistics. The mixing noise model of Tam and Auriault is used to predict the noise produced by the jet. To validate both the aerodynamic and the noise prediction models, results are compared with Particle Image Velocimetry (PIV) and free-field acoustic data respectively. The variation of the aerodynamic quantities and noise source are examined by comparing predictions from various jet and at plate configurations with an isolated jet. To quantify the propulsion airframe aeroacoustic installation effects on the aerodynamic noise source, a non-dimensional number is formed that contains the flow-conditions and airframe installation parameters.

Smith, Matthew J.↗
NASA NTRS1978

Analysis of flight effects on noise radiation from jet flow using a convecting quadrupole model

The effects of flight on noise radiation from convecting quadrupoles in a jet flow are examined. The analysis shows that as flight velocity increases there is a steadily increasing amplification of the sound that is radiated into the forward arc and a large reduction of the sound that is radiated into the rearward arc. The analysis also shows the same trend when there is a reduction in the exhaust velocity with, however, a further rise in amplification in the forward quadrant and a drop in attenuation in the aft quadrant. Finally, it is concluded that there is a transmission effect tending to enhance the sound radiation by a density ratio pf/pj which increases with increasing jet temperature.

Dash, R.↗
NASA NTRS1976

Control of cavity noise

Experiments have been conducted on axisymmetric shallow cavity flows with the aim of investigating methods to modify cavity shear flows such that cavity noise may be reduced. The experiments indicate the presence of large gross lateral motion of the shear layer close to the downstream cavity corner which, on interaction with it, results in production of cavity flow noise. Results also show that the continuous injection of a fluid mass at the base of the cavity has a stabilizing effect on cavity shear flows. This stability is believed to have been achieved by supplying the mass required for cavity shear layer entrainment externally. This was also accompanied by a delay in large periodic lateral motion of the cavity shear layer close to the downstream cavity corner as observed without the mass injection. Thus the addition of a continuous fluid mass appears to be an effective means of suppressing cavity flow noise.

Sarohia, V.↗
NASA NTRS1972

Effects of rotating flows on combustion and jet noise.

Experimental investigations of combustion in rotating (swirling) flow have shown that the mixing and combustion processes were accelerated, flame length and noise levels significantly decreased, and flame stability increased relative to that obtained without rotation. Unsteady burning accompanied by a pulsating flame, violent fluctuating jet, and intense noise present in straight flow burning were not present in rotating flow burning. Correlations between theory and experiment show good agreement. Such effects due to rotating flows could lead to suppressing jet noise, improving combustion, reducing pollution, and decreasing aircraft engine size. Quantitative analysis of the aero-acoustic relationship and noise source characteristics are needed.-

Schwartz, I. R.↗
NASA NTRS1976

An analytical study of noise generation by subsonic flows in the presence of rigid surfaces

A general analytical method is developed for determination of the radiated noise field from highly sheared, subsonic flows in the presence of rigid surfaces. The method is specifically formulated to use measurable flow field properties as the basis input data for calculations. The governing equations of a viscous, incompressible fluid are employed to determine approximately the so-called shear noise source strength distribution in the flow. Mean rates of strain and fluctuating velocity covariances are the fundamental input data for calculations. The method is applied to the wall jet region of a circular jet impinging at 45 deg to an infinite plane surface. Velocity field measurements of Foss are used to describe the required flow properties. Comparisons of calculated results with measured surface pressures and sound pressure levels are given and discussed.

Wooley, J. P.↗
NASA NTRS1975

Noise radiation from turbulent flows over compliant surfaces

The present study is based on Lighthill-Curle's theory of aerodynamic noise. Using a correlation approach and the image concept of Powell, the volume contribution of turbulent flow over a large surface is approximated by a surface contribution of pressure fluctuations. Far-field noise intensities are expressed in terms of the surface pressure fluctuations and surface impedance. Based on available experimental measurements, numerical examples are performed for noise radiated from a turbulent boundary layer and from a normal jet impingement over rigid surfaces. Comparisons with available noise measurements are made. For general turbulent flows over compliant surfaces, measurements are suggested to obtain useful data for noise predictions.

Pan, Y. S.↗
NASA NTRS1990

A review of instability and noise propagation in supersonic flows

Originally analytical and numerical models were to be developed for noise production in supersonic jets, wakes and free shear layers. While the effort was concentrated initially on these aspects, other topics were also pursued, most were of interest to the Jet Noise Group of the Aeroacoustics Branch. An overview is given of subjects reviewed and the investigations that were carried out. A significant effort was devoted to numerically predicting the flow field of a turbulent supersonic wall jet. This information is necessary for computing the pressure in the far field. The wall jet was selected because it represents a generic flow that can be associated with plug nozzle in supersonic engines. It combines the characteristic of a boundary layer with that of a free shear flow. The spatially evolving flow obtained using Dash's code would form the input for the stability analysis program. This analysis would determine the large scale instability wave within the flow. The far field pressure can be computed from the shape of the evolving large scale structure by asymptotic methods. Flow characteristics obtained from a program that analyses the turbulent downstream supersonic flow in a nozzle are described and compared with experimental results.

Daudpota, Q. Isa↗
NASA NTRS1973

Jet noise suppression by swirling the jet flow.

The effect of swirling flow on jet noise suppression was experimentally investigated in a relatively small, low-thrust, fan-jet engine. Measurements of acoustic properties of the near and far fields, jet-flow characteristics, and engine thrust were made with and without stationary swirl vanes installed in the primary exhaust nozzle. Preliminary test results indicate that substantial reductions in jet overall sound pressure levels and overall acoustic power were obtained with minimal thrust losses. Based on preliminary analysis, present results, and previous experiments with swirling hot jets, it is predicted that even greater jet noise reductions can be obtained in higher thrust engines, particularly with afterburning, by swirling jet exhaust.

Schwartz, I. R.↗
NASA NTRS1987

An analytical parametric study of the broadband noise from axial-flow fans

The rotating dipole analysis of Ffowcs Williams and Hawkings (1969) is used to predict the far field noise radiation due to various rotor broadband noise mechanisms. Consideration is given to inflow turbulence noise, attached boundary layer/trailing-edge interaction noise, tip-vortex formation noise, and trailing-edge thickness noise. The parametric dependence of broadband noise from unducted axial-flow fans on several critical variables is studied theoretically. The angle of attack of the rotor blades, which is related to the rotor performance, is shown to be important to the trailing-edge noise and to the tip-vortex formation noise.

Chou, Shau-Tak↗
NASA NTRS1975

Cross-correlation methods for studying near- and farfield noise characteristics of flow-surface interactions

Systematic methods based on cross-correlation techniques are presented for experimental studies of near- and farfield noise characteristics in airflow-surface interaction problems. Analyses show that, in near- and farfields, the noise characteristics due to the surface contribution of fluctuating pressures and velocities and due to the volume contribution of the turbulence in the flow can be determined separately. Both farfield noise intensities and nearfield acoustic energy fluxes can be expressed in terms of appropriate cross correlations. These correlations can be obtained by making microphone measurements in the farfield, in the nearfield, and on the surface. Examples of the applications to the noise field generated by impinging jets, by surface blowing jets, and by turbulent flow over trailing edges are presented. Advantages of the present method over conventional methods are also discussed.

Pan, Y. S.↗
NASA NTRS1976

Feasibility of making sound power measurements in the NASA Langley V/STOL tunnel test section

Based on exploratory acoustic measurements in Langley's V/STOL wind tunnel, recommendations are made on the methodology for making sound power measurements of aircraft components in the closed tunnel test section. During airflow, tunnel self-noise and microphone flow-induced noise place restrictions on the amplitude and spectrum of the sound source to be measured. Models of aircraft components with high sound level sources, such as thrust engines and powered lift systems, seem likely candidates for acoustic testing.

Brooks, T. F.↗
NASA NTRS1989

Noise produced by turbulent flow into a rotor: Users manual for atmospheric turbulence prediction and mean flow and turbulence contraction prediction

A users manual for a computer program for predicting atmospheric turbulence and mean flow and turbulence contraction as part of a noise prediction scheme for nonisotropic turbulence ingestion noise in helicopters is described. Included are descriptions of the various program modules and subroutines, their function, programming structure, and the required input and output variables. This routine is incorporated as one module of NASA's ROTONET helicopter noise prediction program.

Simonich, J. C.↗