Search NASA⌕ Search

SEARCH · Search NASA

Results for “Kinetic Modelling”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,441 records · Page 80
All sourcesNASA NTRSDOE OSTI
DOE OSTI2017

The Reduced Effectiveness of EGR to Mitigate Knock at High Loads in Boosted SI Engines

Numerous studies have demonstrated that exhaust gas recirculation (EGR) can attenuate knock propensity in spark ignition (SI) engines at naturally aspirated or lightly boosted conditions. In this paper, we investigate the role of cooled EGR under higher load conditions with multiple fuel compositions, where highly retarded combustion phasing typical of modern SI engines was used. It was found that under these conditions, EGR attenuation of knock is greatly reduced, where EGR doesn’t allow significant combustion phasing advance as it does under lighter load conditions. Detailed combustion analysis shows that when EGR is added, the polytropic coefficient increases causing the compressive pressure and temperature to increase. At sufficiently highly boosted conditions, the increase in polytropic coefficient and additional trapped mass from EGR can sufficiently reduce fuel ignition delay to overcome knock attenuation effects. Kinetic modeling demonstrates that the effectiveness of EGR to mitigate knock is highly dependent on the pressure-temperature condition. Experiments at 2000 rpm have confirmed reduced fuel ignition delay under highly boosted conditions relevant to modern downsized boosted SI engines, where in-cylinder pressure is higher and the temperature is cooler. Finally, at these conditions, charge reactivity increases compared to naturally aspirated conditions, and attenuation of knock by EGR is reduced.

33 ADVANCED PROPULSION SYSTEMS↗
DOE OSTI2018

Ignition Delay in Low Temperature Combustion

Low temperature combustion (LTC) strategies present a means of reducing soot and oxides of nitrogen (NOx) emissions while simultaneously increasing efficiency relative to conventional combustion modes. By sufficiently premixing fuel and air before combustion, LTC strategies avoid high fuel-to-air equivalence ratios that lead to soot production. Dilution of the mixture lowers the combustion temperatures to reduce NOx production and offers thermodynamic advantages for improved efficiency. However, issues such as high heat release rates (HRRs), incomplete combustion, and difficulty in controlling the timing of combustion arise with low equivalence ratios and combustion temperatures. Ignition delay (the time until the start of combustion) is a way to quantify the time available for fuel and air to mix inside the cylinder before combustion. Previous studies have used ignition delay to explain trends seen in LTC such as combustion stability and HRRs. This study provides a novel method of integrating ignition delay into the investigation of LTC to determine what insights ignition delay calculations can provide for the different challenges associated with LTC strategies. To eliminate the need for large chemical kinetic models and interpolation to predict ignition delay, an ignition delay correlation is used. The flexibility gained using the correlation allows this method to be quickly adapted to target different LTC strategies and challenges. In this work, three cases of low temperature gasoline combustion (LTGC) with varying stratification levels were evaluated with an emphasis on the non-monotonic trend of the HRRs. The described method for ignition delay calculation is used to detail the stratification and ignition delay distributions for each case and provide insight into the observed trends.

Drallmeier, Joseph↗
DOE OSTI2019

Organic peroxy radical chemistry in oxidation flow reactors and environmental chambers and their atmospheric relevance

Abstract. Oxidation flow reactors (OFRs) are a promising complement to environmental chambers for investigating atmospheric oxidation processes and secondary aerosol formation. However, questions have been raised about how representative the chemistry within OFRs is of that in the troposphere. We investigate the fates of organic peroxy radicals (RO 2 ), which play a central role in atmospheric organic chemistry, in OFRs and environmental chambers by chemical kinetic modeling and compare to a variety of ambient conditions to help define a range of atmospherically relevant OFR operating conditions. For most types of RO 2 , their bimolecular fates in OFRs are mainly RO 2 + HO 2 and RO 2 + NO, similar to chambers and atmospheric studies. For substituted primary RO 2 and acyl RO 2 , RO 2 + RO 2 can make a significant contribution to the fate of RO 2 in OFRs, chambers and the atmosphere, but RO 2 + RO 2 in OFRs is in general somewhat less important than in the atmosphere. At high NO, RO 2 + NO dominates RO 2 fate in OFRs, as in the atmosphere. At a high UV lamp setting in OFRs, RO 2 + OH can be a major RO 2 fate and RO 2 isomerization can be negligible for common multifunctional RO 2 , both of which deviate from common atmospheric conditions. In the OFR254 operation mode (for which OH is generated only from the photolysis of added O 3 ), we cannot identify any conditions that can simultaneously avoid significant organic photolysis at 254 nm and lead to RO 2 lifetimes long enough ( ∼ 10 s) to allow atmospherically relevant RO 2 isomerization. In the OFR185 mode (for which OH is generated from reactions initiated by 185 nm photons), high relative humidity, low UV intensity and low precursor concentrations are recommended for the atmospherically relevant gas-phase chemistry of both stable species and RO 2 . These conditions ensure minor or negligible RO 2 + OH and a relative importance of RO 2 isomerization in RO 2 fate in OFRs within ∼ × 2 of that in the atmosphere. Under these conditions, the photochemical age within OFR185 systems can reach a few equivalent days at most, encompassing the typical ages for maximum secondary organic aerosol (SOA) production. A small increase in OFR temperature may allow the relative importance of RO 2 isomerization to approach the ambient values. To study the heterogeneous oxidation of SOA formed under atmospherically relevant OFR conditions, a different UV source with higher intensity is needed after the SOA formation stage, which can be done with another reactor in series. Finally, we recommend evaluating the atmospheric relevance of RO 2 chemistry by always reporting measured and/or estimated OH, HO 2 , NO, NO 2 and OH reactivity (or at least precursor composition and concentration) in all chamber and flow reactor experiments. An easy-to-use RO 2 fate estimator program is included with this paper to facilitate the investigation of this topic in future studies.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2018

The effect of electron cyclotron heating on density fluctuations at ion and electron scales in ITER baseline scenario discharges on the DIII-D tokamak

Experiments simulating the ITER Baseline Scenario on the DIII-D tokamak show that torque-free pure electron heating, when coupled to plasmas subject to a net co-current beam torque, affects density fluctuations at electron scales on a sub-confinement time scale, whereas fluctuations at ion scales change only after profiles have evolved to a new stationary state. Modifications to the density fluctuations measured by the Phase Contrast Imaging diagnostic (PCI) are assessed by analyzing the time evolution following the switch-off of Electron Cyclotron Heating (ECH), thus going from mixed beam/ECH to pure neutral beam heating at fixed β N . Within 20 ms after turning off ECH, the intensity of fluctuations is observed to increase at frequencies higher than 200 kHz; in contrast, fluctuations at lower frequency are seen to decrease in intensity on a longer time scale, after other equilibrium quantities have evolved. Non-linear gyro-kinetic modeling at ion and electron scales scales suggest that, while the low frequency response of the diagnostic is consistent with the dominant ITG modes being weakened by the slow-time increase in flow shear, the high frequency response is due to prompt changes to the electron temperature profile that enhance electron modes and generate a larger heat flux and an inward particle pinch. These results suggest that electron heated regimes in ITER will feature multi-scale fluctuations that might affect fusion performance via modifications to profiles.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
NASA NTRS1971

Photoactivation of the manganese catalyst of O2 evolution. II A two-quantum mechanism.

A kinetic analysis is presented of the data obtained in previously described kinetic experiments relating to the photoactivation of the Mn complex required for photosynthetic O2 evolution. The results obtained from the computer simulation of the derived kinetic model compare favorably with the experimentally derived values. They also suggest that photoactivation can be rationalized in terms of a two-quantum process.

Radmer, R.↗
NASA NTRS1974

Shock-wave structure in a partially ionized gas

The structure of a steady plane shock in a partially ionized gas has been investigated using the Boltzmann equation with a kinetic model as the governing equation and the discrete ordinate method as a tool. The effects of the electric field induced by the charge separation on the shock structure have also been studied. Although the three species of an ionized gas travel with approximately the same macroscopic velocity, the individual distribution functions are found to be very different. In a strong shock the atom distribution function may have double peaks, while the ion distribution function has only one peak. Electrons are heated up much earlier than ions and atoms in a partially ionized gas. Because the interactions of electrons with atoms and with ions are different, the ion temperature can be different from the atom temperature.

Lu, C. S.↗
NASA NTRS1976

Investigation of metal hydride materials as hydrogen reservoirs for metal-hydrogen batteries

The performance and suitability of various metal hydride materials were examined for use as possible hydrogen storage reservoirs for secondary metal-hydrogen batteries. Lanthanum pentanickel hydride appears as a probable candidate in terms of stable hydrogen supply under feasible thermal conditions. A kinetic model describing the decomposition rate data of the hydride has been developed.

ONISCHAK↗
NASA NTRS1974

Time-dependent, non-Newtonian behavior of viscoelastic materials

A kinetic model for characterizing the shear stress or shear strain rate of thixotropic materials is developed and combined with Oldroyd's viscoelastic model (1953) modified in this paper in order to predict the first normal stress difference. In order to test the method, transient and steady state data have been obtained with a Weissenberg rheogoniometer used to measure the constant stress and constant shear rate of a solution of polymethyl methacrylate in diethylphthalate. A computer was used to facilitate data acquisition.

Jachimiak, P. D.↗
NASA NTRS1977

Analysis of plasmas generated by fission fragments

A kinetic model is developed for a plasma generated by fission fragments and the results are employed to study helium plasma generated in a tube coated with fissionable material. Because both the heavy particles and electrons play important roles in creating the plasma, their effects are considered simultaneously. The calculations are carried out for a range of neutron fluxes and pressures. In general, the predictions of the theory are in good agreement with available intensity measurements. Moreover, the theory predicts the experimentally measured inversions. However, the calculated gain coefficients are such that lasing is not expected to take place in a helium plasma generated by fission fragments. The effects of an externally applied electric field are also considered.

Deese, J. E.↗
NASA NTRS1977

The effect of ambient conditions on carbon monoxide emissions from an idling gas turbine combustor

A test program employing a gas turbine combustor is outlined; the results of which quantize the effects of changes in ambient temperature and humidity on carbon monoxide emissions at simulated idle operating conditions. A comparison of the experimental results with analytical results generated by a kinetic model of the combustion process, and reflecting changing ambient conditions, is given. It is demonstrated that for a complete range of possible ambient variations, significant changes do occur in the amount of carbon monoxide emitted by a gas turbine at idle, and that the analytical model is reasonably successful in predicting changes.

Subramanian, A. K.↗
NASA NTRS1976

Analysis of nuclear induced plasmas

A kinetic model is developed for a plasma generated by fission fragments, and the results are employed to study He plasma generated in a tube coated with fissionable material. Because both the heavy particles and electrons play important roles in creating the plasma, their effects are considered simultaneously. The calculations are carried out for a range of neutron fluxes and pressures. In general, the predictions of the theory are in good agreement with available intensity measurements. Moreover, the theory predicts the experimentally measured inversions. However, the calculated gain coefficients are such that lasing is not expected to take place in a helium plasma generated by fission fragments.

Deese, J. E.↗
NASA NTRS1977

An experimental and analytical study of acetylene and ethylene oxidation behind shock waves

An experimental and analytical study of the oxidation of acetylene and ethylene behind incident shock waves was carried out over the temperature range 1815-2365 K at reaction pressures between 1.1 and 1.7 atm. The oxidation process was monitored by measuring radiation from carbon dioxide, carbon monoxide, and the reaction O + CO yields CO2 + h nu. The recorded emission profiles were analyzed to obtain concentrations for carbon dioxide, carbon monoxide, and the product of oxygen atom and the carbon monoxide concentrations. On the basis of this data and induction time data reported in the literature, kinetic models for acetylene and ethylene oxidation were assembled.

Jachimowski, C. J.↗
NASA NTRS1976

Analysis of nuclear induced plasmas

A kinetic model is developed for a plasma generated by fission fragments and the results are employed to study He plasma generated in a tube coated with fissionable material. Because both the heavy particles and electrons play important roles in creating the plasma, their effects are considered simultaneously. The calculations are carried out for a range of neutron fluxes and pressures. In general, the predictions of the theory are in good agreement with available intensity measurements. Moreover, the theory predicts the experimentally measured inversions. However, the calculated gain coefficients are such that lasing is not expected to take place in a helium plasma generated by fission fragments.

Deese, J. E.↗