Search NASA⌕ Search

SEARCH · Search NASA

Results for “ION IMPLANTATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,495 records · Page 83

Origin of reverse annealing effect in hydrogen-implanted silicon

In contradiction to conventional damage annealing, thermally annealed H-implanted Si exhibits an increase in damage or reverse annealing behavior, whose mechanism has remained elusive. In this work, we conclusively elucidate that the reverse annealing effect is due to the nucleation and growth of hydrogen-induced platelets. Platelets are responsible for an increase in the height and width of the channeling damage peak following increased isochronal anneals.

36 MATERIALS SCIENCE↗

Interaction between magnetic moments and itinerant carriers in $d^0$ ferromagnetic SiC

Elucidating the interaction between magnetic moments and itinerant carriers is an important step to spintronic applications. In this work, we investigate magnetic and transport properties in d0 ferromagnetic SiC single crystals prepared by postimplantation pulsed laser annealing. Magnetic moments are contributed by the p states of carbon atoms, but their magnetic circular dichroism is different from that in semi-insulating SiC samples. The anomalous Hall effect and negative magnetoresistance indicate the influence of d 0 spin order on free carriers. The ferromagnetism is relatively weak in N-implanted SiC compared with that in Al-implanted SiC after annealing. The results suggest that d 0 magnetic moments and itinerant carriers can interact with each other, which will facilitate the development of SiC spintronic devices with d 0 ferromagnetism.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Approaches to USJ Formation Beyond Molecular Implantation

As junction depth requirements approach sub 10 nm and the sensitivity to residual implant damage continues to increase, the capability to produce abrupt, shallow profiles while maintaining low residual damage becomes a difficult challenge. Implantation induced amorphization has been widely applied to reduce channeling tails of implanted dopant profiles for integrated circuit manufacturing. This has been required to meet aggressive junction depth targets. The problem, however, is that pre-amorphization creates high defect densities that remain near the former amorphous-crystalline interface post anneal. These end of range (EOR) defects become of greater concern as the industry begins to move towards millisecond anneal technologies. Millisecond anneal, while capable of close to diffusionless activation and abrupt junctions, has caused concern for its inability to fully repair these EOR defects. There has been a recent focus on removing traditional PAI through molecular implantation with limited success. Towards this end we have investigated alternative techniques to reduce EOR damage while maintaining the junction depth, sheet resistance and abruptness. Here we describe the results of two of these techniques. The subsequent reduction in EOR through the use of each process and the resultant Rs, junction depth and abruptness are detailed.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Formation and incorporation of SiF{sub 4} molecules in F-implanted preamorphized Si

The local structure of fluorine incorporated in crystalline silicon following solid phase epitaxial regrowth was investigated by means of x-ray absorption spectroscopy at the F K-edge. We clearly demonstrate that most F is found in SiF{sub 4} molecules in the crystalline matrix. A kinetic pathway, which explains our observation and which is also able to rationalize previous results in a common and coherent framework, is proposed.

36 MATERIALS SCIENCE↗

Buried melting in germanium implanted silicon by millisecond flash lamp annealing

Flash lamp annealing in the millisecond range has been used to induce buried melting in silicon. For this purpose high dose high-energy germanium implantation has been employed to lower the melting temperature of silicon in a predetermined depth region. Subsequent flash lamp treatment at high energy densities leads to local melting of the germanium rich layer. The thickness of the molten layer has been found to depend on the irradiation energy density. During the cool-down period, epitaxial crystallization takes place resulting in a largely defect-free layer.

36 MATERIALS SCIENCE↗

Acceptor Type Vacancy Complexes In As-Grown ZnO

One of the many technological areas that ZnO is interesting for is the construction of opto-electronic devices working in the blue-UV range as its large band gap ({approx}3.4 eV at 10 K) makes them suitable for that purpose. As-grown ZnO shows generally n-type conductivity partially due to the large concentration of unintentional shallow donors, like H, but impurities can also form complexes with acceptor type defects (Zn vacancy) leading to the creation of compensating defects. Recently, Li{sub Zn} and Na{sub Zn} acceptors have been measured and H could form similar type of defects. Doppler Broadening Positron Annihilation spectroscopy experimental results on the observation of Zn related vacancy complexes in ZnO thin films, as-grown, O implanted and Al doped will be presented. Results show that as-grown ZnO film show small Zn vacancy related complexed that could be related to presence of H as a unintentional doping element.

36 MATERIALS SCIENCE↗

Segmented YSO scintillation detectors as a new β -implant detection tool for decay spectroscopy in fragmentation facilities

A newly developed segmented YSO scintillator detector was implemented for the first time at the RI-beam Factory at RIKEN Nishina Center as an implantation-decay counter. The results from the experiment demonstrate that the detector is a viable alternative to conventional silicon-strip detectors with its good timing resolution and high detection efficiency for β particles. A Position-Sensitive Photo-Multiplier Tube (PSPMT) is coupled with a 48 × 48 segmented YSO crystal. To demonstrate its capabilities, a known short-lived isomer in 76 Ni and the β decay of 74 Co were measured by implanting those ions into the YSO detector. The half-lives and γ-rays observed in this work are consistent with the known values. The β -ray detection efficiency is more than 80 % for the decay of 74 Co.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Plasma Doping - Enabling Technology for High Dose Logic and Memory Applications

As logic and memory device dimensions shrink with each generation, there are more high dose implants at lower energies. Examples include dual poly gate (also referred to as counter-doped poly), elevated source drain and contact plug implants. Plasma Doping technology throughput and dopant profile benefits at these ultra high dose and lower energy conditions have been well established [1,2,3]. For the first time a production-worthy plasma doping implanter, the VIISta PLAD tool, has been developed with unique architecture suited for precise and repeatable dopant placement. Critical elements of the architecture include pulsed DC wafer bias, closed-loop dosimetry and a uniform low energy, high density plasma source. In this paper key performance metrics such as dose uniformity, dose repeatability and dopant profile control will be presented that demonstrate the production-worthiness of the VIISta PLAD tool for several high dose applications.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗

Development of GaAs solar cells

Solar cells and mesa diodes were fabricated by the implantation of zinc or beryllium ions into n-type gallium arsenide. Annealing temperatures above 750 C (zinc) or 650 C (beryllium) were found to produce 50% to 100% activation of the implanted ions. Junction depths of about 0.4 micron were produced by 600 keV zinc implants or 70 keV beryllium implants. P-layer sheet resistance was about 150 ohms for 2 x 10 to the 15th power cm/2 zinc or 1 x 10 to the 15th power cm/2 beryllium implants. This is sufficiently low for efficient solar cell fabrication. Contacting procedures were improved to yield reproducibly adherent, low resistance front and back contacts.

Source record↗

Photothermal Investigation of Micro-Uniformity Problems Caused by Different Scan Systems

To study beam scanning and beam profiling effects low energy implants of Boron (25 keV) and high energy implants of Helium (5.4 MeV) were carried out by use of different scanning systems including mechanical, electrostatic and hybrid scanning. The sensitivity of photothermal measurement by use of the excess carrier wave in the depth up to 50 {mu}m is proved for buried damage detection and compared with the effect in shallow damage profiles. The micro-mapping capability of the photothermal techniques allows the detection of dose variations in a sub-mm-scale without Moire effects from mapping steps. Conclusion for advanced dose monitoring by multi-frequency photothermal methods will be derived.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Three-dimensional Chemical Imaging of Embedded Nanoparticles using Atom Probe Tomography

Analysis of nanoparticles is often challenging especially when they are embedded in a matrix. Hence, we have used laser-assisted atom probe tomography (APT) to analyze the Au-nanoclusters synthesized in situ using ion beam implantation in single crystal MgO matrix. APT analysis along with scanning transmission electron microscopy and energy dispersive spectroscopy (STEM-EDS) indicated that the nanoparticles have an average size ~ 8 - 12 nm. While it is difficult to analyze the composition of individual nanoparticles using STEM, APT analysis can give three dimensional compositions of the same. It was shown that the maximum Au-concentration in the nanoparticles increases with increasing particle size, with a maximum Au-concentration of up to 50%.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

Continuously controlled optical band gap in oxide semiconductor thin films

The optical band gap of the prototypical semiconducting oxide SnO 2 is shown to be continuously controlled through single axis lattice expansion of nanometric films induced by low-energy helium implantation. While traditional epitaxy-induced strain results in Poisson driven multidirectional lattice changes shown to only allow discrete increases in bandgap, we find that a downward shift in the band gap can be linearly dictated as a function of out-of-plane lattice expansion. Our experimental observations closely match density functional theory that demonstrates that uniaxial strain provides a fundamentally different effect on the band structure than traditional epitaxy-induced multiaxes strain effects. In conclusion, charge density calculations further support these findings and provide evidence that uniaxial strain can be used to drive orbital hybridization inaccessible with traditional strain engineering techniques.

77 NANOSCIENCE AND NANOTECHNOLOGY↗

Raman-active Froehlich optical phonon mode in arsenic implanted ZnO

In this letter, using both off-resonant and resonant Raman spectroscopic techniques, the correlation of optical phonons and structural disorder in As{sup +} implanted ZnO single crystals has been investigated. An additional broad peak shoulder at 550 cm{sup -1} between the transverse optical and longitudinal optical (LO) phonons was clarified to be resonant Froehlich optical phonon mode in the framework of effective dielectric function. Under resonance condition, an asymmetric broadening and softening of the LO phonon along with a blueshifted luminescent peak revealed the decreasing phonon coherent length and nanocrystallization with increasing fluence, respectively, in good agreement with the observations of transmission electron microscopy and atomic force microscopy.

36 MATERIALS SCIENCE↗

Lattice location study of implanted In in Ge

We report on emission channeling experiments to determine the lattice location and the thermal stability of implanted {sup 111}In atoms in Ge. The majority of the In atoms was found on the substitutional site, which is a thermally stable site at least up to 500 deg. C. We also found strong indication that directly after implantation, a fraction of the implanted {sup 111}In atoms occupies the bond-centered (BC) site. This fraction disappears after annealing at 300 deg. C. From comparison with ab initio calculations, electrical studies, and perturbed angular correlation experiments, the In atoms on the BC site can be related to In-vacancy and In-self-interstitial defect complexes. The activation energy for dissociation of this BC related defect was found to be below 1.6 eV.

36 MATERIALS SCIENCE↗

Minority anion substitution by Ni in ZnO

We report on the lattice location of implanted Ni in ZnO using the β{sup −} emission channeling technique. In addition to the majority substituting for the cation (Zn), a significant fraction of the Ni atoms occupy anion (O) sites. Since Ni is chemically more similar to Zn than it is to O, the observed O substitution is rather puzzling. We discuss these findings with respect to the general understanding of lattice location of dopants in compound semiconductors. In particular, we discuss potential implications on the magnetic behavior of transition metal doped dilute magnetic semiconductors.

36 MATERIALS SCIENCE↗

Diluted manganese on the bond-centered site in germanium

The functional properties of Mn-doped Ge depend to large extent on the lattice location of the Mn impurities. Here, we present a lattice location study of implanted diluted Mn by means of electron emission channeling. Surprisingly, in addition to the expected substitutional lattice position, a large fraction of the Mn impurities occupies the bond-centered site. Corroborated by ab initio calculations, the bond-centered Mn is related to Mn-vacancy complexes. These unexpected results call for a reassessment of the theoretical studies on the electrical and magnetic behavior of Mn-doped Ge, hereby including the possible role of Mn-vacancy complexes.

36 MATERIALS SCIENCE↗

Nature of Defects Induced by Au Implantation in Hexagonal Silicon Carbide Single Crystals

Pulsed-slow-positron-beam-based positron lifetime spectroscopy was used to investigate the nature of vacancy defects induced by 20 MeV Au implantation in single crystals 6H-SiC. Preliminary analysis of the data shows that at lower fluence, below 10{sup 14} cm{sup -2}, a positron lifetime of 220 ps has been obtained: it could be associated with the divacancy V{sub Si}-V{sub C} in comparison with the literature. At higher fluence, above 10{sup 15} cm{sup -2}, a positron lifetime of 260-270 ps, increasing with the incident positron energy, has been observed after decomposition of the lifetime spectra. By comparison with lifetime calculations, open-volumes such as quadrivacancy (V{sub Si}-V{sub C}){sub 2} clusters could be associated with this value.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Bimodal distribution of neon nanobubbles in aluminum

Ne 1s core-level photoelectron spectra from Ne nanobubbles implanted in aluminum exhibit two peaks whose binding energies and relative intensities change with implantation energy, isochronal annealing, and sputtering. These changes in the core-level spectra are manifestations of the nanometer size of the bubbles since the screening of the photohole by the Al conduction electrons depends on the bubble size. Existence of a bimodal depth and size distribution of Ne nanobubbles is demonstrated in this work: smaller bubbles of about 4 A in radius are formed close to the Al(111) surface while the larger sized bubbles of 20 A in radius exist deeper below in the beneath subsurface region. A general relation between the radius of the rare-gas bubbles and their core-level binding energies is established.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗