SEARCH · Search NASA

Results for “AMPLIFICATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,531 records · Page 85

All sources NASA NTRS DOE OSTI

NASA NTRS1976

Asymptotic residual pump transmission characteristics in laser-induced stimulated Brillouin scattering

The considered asymptotic relationship is investigated and an expression is sought for the slope of the curve representing the relation between the residual fractional transmitted pump and the pump excitation in backward-traveling-wave amplification. It is found that the characteristic -2 slope of the oscillation curve is a unique property. Rapid exponential decay may very well constitute an inherent limiting factor for efficient energy conversion.

Hsu, H.↗

NASA NTRS1976

Solar wind and extreme ultraviolet modulation of the lunar ionosphere/exosphere

The ALSEP/SIDE detectors routinely monitor the dayside lunar ionosphere. Variations in the ionosphere are found to correlate with both the 2800 MHz radio index which can be related to solar EUV and with the solar wind proton flux. For the solar wind, the ionospheric variation is proportionately greater than that of the solar wind. This suggests an amplification effect on the lunar atmosphere due perhaps to sputtering of the surface or, less probably, an inordinate enhancement of noble gases in the solar wind. The surface neutral number density is calculated under the assumption of neon gas. During a quiet solar wind this number agrees with or is slightly above that expected for neon accreted from the solar wind. During an enhanced solar wind the neutral number density is much higher.

Freeman, J. W.↗

NASA NTRS1977

An optically pumped submillimeter wavelength regenerative amplifier

An optically pumped regenerative submillimeter laser amplifier is described. The amplifier uses a waveguide cavity resonator, and a Fabry-Perot interferometer composed of two dielectric-coated mirrors serves as input and output port for the submillimeter signal. Use of two mirrors enabled obtaining variations of up to 6:1 in transmission by varying the mirror spacing. When the 373-micron transition in CH3CN is excited in the oscillator by the CO2 laser pump beam, the received signal with amplification is about nine times the unamplified signal.

Galantowicz, T. A.↗

NASA NTRS1977

Induced gyroresonant emission of extraordinary mode radiation

Induced amplification of extraordinary-mode electromagnetic waves in a magnetized plasma is investigated. The analysis is performed for a plasma which consists of two components: a relatively dense species of thermal plasma and a diffuse population of suprathermal electrons characterized by a loss cone-type distribution. The excitation mechanism is primarily due to the interaction of the electromagnetic waves with the energetic electrons via the relativistic cyclotron resonance which arises because of the momentum dependence of the gyrofrequency. The present study is particularly concerned with waves propagating perpendicularly and nearly perpendicularly with respect to the external magnetic field, since it is expected that for these cases the cyclotron damping due to thermal electrons is vanishingly small and the growth rates are maximum. The results indicate that excitation occurs primarily for frequencies near the first two gyroharmonics.

Freund, H. P.↗

NASA NTRS1977

Optically activated switch/modulator using a photoconductor and two channel waveguides

An optically activated switch was fabricated on LiNbO3 substrate by deposition of photoconductor-metal electrode structure on two channel waveguides obtained by the outdiffusion process. One waveguide was overcoated with a CdS film, and served as a light detector which converted the optical signal in that waveguide into an electric signal. Utilizing the electrooptic effect, this electric signal modulated the light propagating in the second waveguide by changing the refractive index, and the cutoff condition, of the waveguiding channel between two metal electrodes. The waveguides in the optically controlled switch can be either single or multimode. The length of the device can be short in comparison with other switching schemes. When binary optical signals are applied to the two waveguides, the switch can perform logic AND, NEGATION, OR and pseudo-amplification operations.

Goldberg, L.↗

NASA NTRS1977

Effects of forward motion on jet and core noise

A study was conducted to investigate the effects of forward motion on both jet and core noise. Measured low-frequency noise from static-engine and from flyover tests with a DC-9-30 powered by JT8D-109 turbofan engines and with a DC-10-40 powered by JT9D-59A turbofan engines was separated into jet- and core noise components. Comparisons of the static and the corresponding in-flight jet- and core-noise components are presented. The results indicate that for the DC-9 airplane at low power settings, where core noise is predominant, the effect of convective amplification on core-noise levels is responsible for the higher in-flight low-frequency noise levels in the inlet quadrant. Similarly, it was found that for the DC-10 airplane with engines mounted under the wings and flaps and flap deflection greater than 30 degrees, the contribution from jet-flap-interaction noise is as much as 5 dB in the inlet quadrant and is responsible for higher in-flight low-frequency noise levels during approach conditions. Those results indicate that to properly investigate flight effects, it is important to consider the noise contributions from other low-frequency sources, such as the core and the jet-flap interaction.

Low, J. K. C.↗

NASA NTRS1977

Acoustic source location in the secondary mixing region of a jet-blown flap using a cross-correlation technique

An experimental investigation of the acoustic sources in the secondary mixing region of a laboratory-scale jet-flap was made using a causality correlation technique. The processed signal of a hot-film anemometer probe was cross correlated with the output signal of a far-field microphone. Axial acoustic source strength distributions were measured for three far-field microphone locations: plus or minus 45 deg in the flyover plane and 45 deg in the sideline plane. These measurements showed that the acoustic sources in the secondary mixing region are highly directional, radiating much more effectively to the -45 deg-microphone, located below the plane of the flap surface. A relative maximum in the acoustic source strength measured for the microphones in the flyover plane occurred very near the flap trailing edge, which may be due to an edge amplification effect predicted by the theoretical work of Ffowcs Williams and Hall.

Becker, R. S.↗

NASA NTRS1978

Low-intensity x-ray and gamma-ray imaging device

Low-dosage, low-power X-ray system can be made completely self-contained, allowing fluoroscopy and radiography to be carried out in field and remote locations. New device, known as "lixiscope," can be used with conventional X-ray machine turned down to low level, or, it can be operated with radioisotope source for hand-held portable applications. Originally developed for X-ray astronomy, lixiscope obtains high sensitivity by using intermediate stages of photoelectron conversion and electron amplification to generate image suitable for direct viewing or for recording on film.

Yin, L. I.↗

NASA NTRS1977

Effect of forward motion on engine noise

Methods used to determine a procedure for correcting static engine data for the effects of forward motion are described. Data were analyzed from airplane flyover and static-engine tests with a JT8D-109 low-bypass-ratio turbofan engine installed on a DC-9-30, with a CF6-6D high-bypass-ratio turbofan engine installed on a DC-10-10, and with a JT9D-59A high-bypass-ratio turbofan engine installed on a DC-10-40. The observed differences between the static and the flyover data bases are discussed in terms of noise generation, convective amplification, atmospheric propagation, and engine installation. The results indicate that each noise source must be adjusted separately for forward-motion and installation effects and then projected to flight conditions as a function of source-path angle, directivity angle, and acoustic range relative to the microphones on the ground.

Blankenship, G. L.↗

NASA NTRS1977

Hearing aid malfunction detection system

A malfunction detection system for detecting malfunctions in electrical signal processing circuits is disclosed. Malfunctions of a hearing aid in the form of frequency distortion and/or inadequate amplification by the hearing aid amplifier, as well as weakening of the hearing aid power supply are detectable. A test signal is generated and a timed switching circuit periodically applies the test signal to the input of the hearing aid amplifier in place of the input signal from the microphone. The resulting amplifier output is compared with the input test signal used as a reference signal. The hearing aid battery voltage is also periodically compared to a reference voltage. Deviations from the references beyond preset limits cause a warning system to operate.

Kessinger, R. L.↗

NASA NTRS1978

Development of advanced stability theory suction prediction techniques for laminar flow control

The problem of obtaining accurate estimates of suction requirements on swept laminar flow control wings was discussed. A fast accurate computer code developed to predict suction requirements by integrating disturbance amplification rates was described. Assumptions and approximations used in the present computer code are examined in light of flow conditions on the swept wing which may limit their validity.

Srokowski, A. J.↗

NASA NTRS1978

Preamplifier Noise in VLF Receivers

Noise specifications for junction field-effect transistors are presented in different ways depending on the particular semiconductor manufacturer. Arithmetic involved in converting these specifications to equivalent RMS noise in microvolts developed at the preamplifier input terminal is reviewed. These methods were useful for estimating the noise performance of high input impedance preamplifiers used with E-field antennas operating in the range of 1 KHz to 10 MHz. Both the JFET MPF-102 transistor and the COS/MOS CA3600 transistor array provided amplification for VLF receivers where the internally generated noise was well below the atmospheric noise level. The CA3600 transistor array provided better performance because of the more symmetrical complementary MOS transistor transfer characteristics than a single N-type biased JFET transistor. The CMOS amplifier resulted in self-compensating gain characteristics over a very wide temperature range from -55 to +125 C.

Burhans, R. W.↗

NASA NTRS1978

Transmission of Alfven waves through the earth's bow shock - Theory and observation

From both theoretical and experimental bases, the transmission of Alfven waves through the bow shock is investigated. The theory of Alfven wave transmission through fast MHD shocks is extended to all cases of incident wave vectors. Particular consideration is given to Alfven waves propagating parallel to the ambient magnetic field with field perturbations polarized in the plane formed by the ambient magnetic field and the shock normal. An analysis is also made of magnetic field and plasma data from Explorer-35 in the vicinity of the bow shock. It is suggested that hydromagnetic waves are present in all of the 14 shock crossings studied, and that in upstream regions of at least 6 crossings, predominantly Alfvenic fluctuations exist. Average amplitudes of these fluctuations are measured on either side of the shock and the enhancement is measured by comparing their levels. Theoretical and experimental findings are compared and the apparent discrepancy in amplification factors may be explained by the strong damping of any transmitted magnetoacoustic modes downstream with relatively little damping of any transmitted Alfven waves.

Hassam, A. B.↗

NASA NTRS1978

Influence of internally generated pure tones on the broadband noise radiated from a jet

An experimental study was conducted to determine subsonic-jet-noise amplification by plane waves of sound (pure tones) generated upstream of the nozzle over wide ranges of frequency and amplitude. The data were used to evaluate the behavior of the pure tone and the broadband parts of the radiated sound in the far field. It is shown that a significant increase of broadband noise occurs only when the amplitude of the tone in the far field exceeds the sound pressure of the broadband noise at the same location in the far field. Therefore, the sensitivity of the jet to the pure-tone excitation is not large.

Parthasarathy, S. P.↗

NASA NTRS1978

Modal analysis of turborotors using planar modes - Theory

The generalized dynamic equations of motion have been obtained by the direct stiffness method for multimass flexible rotor bearing systems including the effects of gyroscopic moments, disk skew, and rotor acceleration. A set of undamped critical speed mode shapes calculated from the average horizontal and vertical bearing stiffness is used to transform the equations of motion into a set of coupled modal equations of motion. The modal equations are coupled by the generalized bearing coefficients and the gyroscopic moments. An analysis using only undamped critical speeds or decoupled modal analysis assuming proportional damping may lead to erroneous results. This paper presents a rapid method of calculating rotor resonance speeds with their corresponding amplification factors, stability and unbalance response of turborotors. Examples of the application of this modal approach are presented and results are compared to those of other methods such as matrix transfer analysis.

Gunter, E. J.↗

NASA NTRS1978

Use of computers to exclude the influence of radiometer instability upon measurement results

A radiometer, practically insensitive to great fluctuations in the equipment amplification coefficient, was developed by dividing the useful signal by a reference signal and modulating the two signals at different frequencies. The signals are simultaneously separated by corresponding synchronous detectors and recorded over two channels. The operation is simplified by replacing the continuous signals by a sampling of discrete values, and using a digital computer. The four steps involved in the process are described and a block diagram is included. This technique not only directly connects the radiometer with the computer, but also records all data provided by the control and signal channels.

Domnin, S. L.↗

NASA NTRS1979

Procedure for noise prediction and optimization of advanced technology propellers

The sound field due to a propeller operating at supersonic tip speed in a uniform flow was investigated. Using the fact that the wave front in a uniform stream is a convected sphere, the fundamental solution to the convected wave equation was easily obtained. The Fourier coefficients of the pressure signature were obtained by a far field approximation, and are expressed as an integral over the blade platform. It is shown that cones of silence exist fore and aft the propeller plane. The semiapex angles are shown. These angles are independent of the individual Mach components such as the flight Mach number and the rotation Mach number. The result is confirmed by the computation of the ray path of the emitted Mach waves. The Doppler amplification factor strengthens the signal behind the propeller while it weakens that upstream.

Jou, W. H.↗

NASA NTRS1979

Development of tunable high pressure CO2 laser for lidar measurements of pollutants and wind velocities, January 1976 to December 1977

A tunable multiatmospheric pulsed CO2 laser with emphasis on experimental features and supporting theoretical analyses important to differential absorption lidar and Doppler lidar measurement of pollutants and wind velocities is reported. The energy deposition and the means to produce the uniform high density plasma in the multiatmospheric medium, through UV preionization of an organic seed gas is discussed. Design features of the pulsed CO2 laser are presented. The radiative processes which are operative and prevent the laser from breaking into oscillations in a large number of modes over its broad amplification bandwidth are described. The mode competition for the transient pulsed laser oscillation in a standing wave and traveling wave ring laser configuration is discussed and contrasted with the approach to steady state oscillations. The latter findings are important to transient injection locking for production of a highly stable pulsed CO2 laser output.

Javan, A.↗