Search NASA⌕ Search

SEARCH · Search NASA

Results for “VAPORIZATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,531 records · Page 85

Sensor for distinguishing liquid-vapor phases of superfluid helium

A small, high-accuracy, rapid-response, low-power-dissipation sensor used in determining the distribution of the liquid and vapor phases of helium in a rocket-borne cryogenic cooler is described. The device, which consists of a 6 mm constantan wire coated for about two-thirds of its length with a superconductor alloy, operates on the basis of the coating's alternation between superconductivity (during immersion in the fluid) and a normal resistive state (during immersion in the vapor). The sensor's response time upon shift from one environment to the other is found to be less than 10 milliseconds. Details of design criteria, and installation of an array of sensors in a flight dewar are also given.

Petrac, D.↗

Frequency selection and calibration of a water vapor radiometer

The calibration coefficients of existing water vapor radiometers are dependent upon meteorology profiles. This is shown to be due mainly to incorrect frequency pairs. By properly selecting an optimum frequency pair, the dependency can be reduced to a relatively small amount which can be handily adjusted by surface measurement alone. Hence, a universal calibration equation is applicable to all environmental conditions - site, seasonal and diurnal variations. Optimum frequency pairs are systematically searched. Error analysis indicates that calibration for the water vapor phase delay accurate to less than 2 cm is possible at all elevation angles greater than 15 degrees.

Wu, S. C.↗

Vapor transport mechanisms

The Raman scattering furnace for investigating vapor transport mechanisms was completed and checked out. Preliminary experiments demonstate that a temperature resolution of plus and minus 5 C is possible with this system operating in a backscatter mode. In the experiments presented with the GeI 4 plus excess Ge system at temperatures up to 600 C, only the GeI4 band at 150 cm superscript minus 1 was observed. Further experiments are in progress to determine if GeI2 does become the major vapor species above 440 C.

Workman, G. L.↗

Adiabatic pressure dependence of the 2.7 and 1.9 micron water vapor bands

An acoustic excitation technique is used to determine the adiabatic pressure derivative of the spectral absorptance of the 2.7 and 1.9 micron water vapor bands, and the 3.5 micron HCl band. The dependence of this derivative on thermodynamic parameters such as temperature, concentration, and pressure is evaluated. A cross-flow water vapor system is used to measure spectral absorptance. Taking F as the ratio of nonrigid to rotor line strengths, it is found that an F factor correction is needed for the 2.7 micron band. The F factor for the 1.9 micron band is also determined. In the wings of each band a wavelength can be found where the concentration dependence is predominant. Farther out in the wings a local maximum occurs for the temperature derivative. It is suggested that the pressure derivative is significant in the core of the band.

Mathai, C. V.↗

Experimental vaporization of the Holbrook chondrite

The vapor phase composition obtained by heating samples of the Holbrook L6 chondrite to 1300 C was determined quantitatively by Knudsen cell-quadrupole mass spectrometry. Maximum observed vapor pressures, produced at 1200 C, are reported for Na, K, Fe, and Ni, and the implications of the Na/K ratio are considered. The Fe and Ni data are discussed with attention to their migration in individual equilibrated chondrites. S2 (with minor SO2), H2O, and CO2 were also present in the high-temperature gas phase. Vesicles formed by the release of intrinsically derived volatiles are compared with vesicles in the Ibitira eucrite. Chondrite evolution is briefly discussed.

Gooding, J. L.↗

Impact-induced energy partitioning, melting, and vaporization on terrestrial planets

The reported investigation was conducted in connection with the desirability to obtain information regarding the response of a solidified planetary surface to the primary impact of a meteoroid whose dimensions are small compared to that of the planet. The investigation is an extension of studies conducted by Ahrens and O'Keefe (1977) concerned with a calculation via finite-difference techniques of the entire flow field, the energy partitioning, and the quantity of melt and vapor produced upon impact of an iron object on a gabbroic anorthosite half-space at 15 km/sec. The assumptions used in these calculations are summarized. Calculations based on an equation of state for the low- and high-pressure mineral assemblage of gabbroic anorthosite, initial density 2.94 g/cu cm are considered. An algorithm is formulated for the description of the phase transformation upon shock loading. It is shown that the relative volume of melt and the equivalent volume of shock-induced vapor is proportional to the meteoroid kinetic energy (at high speeds) using the similarity scaling of projectile and target properties as suggested by Dienes and Walsh (1970).

Okeefe, J. D.↗

Soil breccia relationships and vapor deposits on the moon

Sets of Apollo 15 and 17 samples consisting of soil, breccia and breccia glass coating were selected for a study of regolith evolution. The data are inconclusive with respect to local cratering effects or rock weathering. A large number of samples from all missions fall into one of five groups based on their water leachable Cl and Br fractions. A limited number of vapor clouds with distinct labile Cl/Br ratios is suggested. One such vapor cloud may have particular significance since it has a primordial Cl/Br ratio.

Jovanovic, S.↗

Water vapor weathering of Taurus-Littrow orange soil - A pore-structure analysis

A pore-volume analysis was performed on water vapor adsorption data previously obtained on a fresh sample of Taurus-Littrow orange soil, and the analysis was repeated on the same sample after its exposure to moist air for a period of approximately six months. The results indicate that exposure of an outgassed sample to high relative pressures of water vapor can result in the formation of substantial micropore structure, the precise amount being dependent on the sample pretreatment, particularly the outgassing temperature. Micropore formation is explained in terms of water penetration into surface defects. In contrast, long-term exposure to moist air at low relative pressures appears to reverse the process with the elimination of micropores and enlargement of mesopores possibly through surface diffusion of metastable adsorbent material. The results are considered with reference to the storage of lunar samples.

Cadenhead, D. A.↗

Vapor-deposited graded-thickness films

Rotating substrate and slotted mask allow varying film thickness to be deposited from vapor by exposing film substrate to metal vapor through circular mask. Useful for fabricating variable thickness coatings for controlling thermal, electrical, or other properties.

Herzig, H.↗

DSN water vapor radiometer: Tropospheric range delay calibration

A discussion is presented of the Deep Space Network water vapor radiometer by means of simultaneous antenna temperature and radiosonde measurements at Edwards Air Force Base. The calibration of radiometer gain and hot load radiometric noise temperature is also described. Calibration equations are given. It is found that with a selected data set, the RMS error is less than 1 cm over a total delay range of 9 to 38 cm. Limitations on the use of the water vapor radiometer are also given.

Slobin, S. D.↗

Chemical vapor deposition reactor

An improved chemical vapor deposition reactor is characterized by a vapor deposition chamber configured to substantially eliminate non-uniformities in films deposited on substrates by control of gas flow and removing gas phase reaction materials from the chamber. Uniformity in the thickness of films is produced by having reactive gases injected through multiple jets which are placed at uniformally distributed locations. Gas phase reaction materials are removed through an exhaust chimney which is positioned above the centrally located, heated pad or platform on which substrates are placed. A baffle is situated above the heated platform below the mouth of the chimney to prevent downdraft dispersion and scattering of gas phase reactant materials.

Chern, S. S.↗

Study of liquid and vapor flow into a Centaur capillary device

The following areas of liquid and vapor flow were analyzed and experimentally evaluated; 1) the refilling of capillary devices with settled liquid, and 2) vapor flow across wetted screens. These investigations resulted in: 1) the development of a versatile computer program that was successfully correlated with test data and used to predict Centaur D-1S LO2 and LH2 start basket refilling; 2) the development of a semi-empirical model that was only partially correlated with data due to difficulties in obtaining repeatable test results. Also, a comparison was made to determine the best propellant management system for the Centaur D-1S vehicle. The comparison identified the basline Centaur D-1S system (using pressurization, boost pumps and propellant settling) as the best candidate based on payload weight penalty. However, other comparison criteria and advanced mission condition were identified where pressure fed systems, thermally subcooled boost pumps and capillary devices would be selected as attractive alternatives.

Blatt, M. H.↗

Emission and extinction of ground and vapor-condensed silicates from 4 to 14 microns and the 10 micron silicate feature

Emission and absorption spectra from 4 to 14 microns of ground and laser-vaporized olivine and enstatite silicates are compared with the 10-micron emission feature of the Orion Trapezium. The agreement in band center and shape between the amorphous laser-vaporized olivine sample and the Trapezium feature suggests that amorphous silicate grains of approximately olivine composition may be a major constituent of interstellar dust. Differences between the emission and absorption spectral profiles (absorption plus scattering) show characteristics that could be used as a sensitive probe of the morphology of interstellar grain systems when high signal-to-noise ratio (30-100) observational spectra become available.

Stephens, J. R.↗

Reaction of HO2 with O3 and the effect of water vapor on HO2 kinetics

The effects of temperature and water vapor concentration on the ratio of the rate constant of the reaction HO2 + O3 yields OH + 2(O2) to the square root of the rate constant for the reaction HO2 + HO2 yields H2O2 + O2 are determined. Photolysis of H2-O2-O3 mixtures at 253.7 nm was carried out with H2O pressures in the range 0 to 15 torr at a temperature range of -42.5 to 61 C along with 184.9 nm photolysis of H2O-O2-O3 mixtures. It is shown that the rate of O3 photolysis is suppressed by the addition of water vapor and it is suggested that this effect is realized in the HO2 + HO2 yields H2O2 + O2 reaction. The calculated expression for the temperature dependence of the rate constant ratio is found to be in good agreement with that calculated from separate rate constants. Rate constants determined for the reaction OH + HO2 yields H2O + O2 are found to be higher than those previously determined, presumably due to increased pressure, indicating that atmospheric models should take into account the possible pressure dependences of the reactions considered.

Demore, W. B.↗

Measurements of upper atmosphere water vapor made in situ with a new moisture sensor

A new thin-film aluminum oxide sensor, Aquamax II, has been developed for the measurement of stratospheric and upper tropospheric water vapor levels. The sensor is briefly described with attention given to its calibration and performance. Data obtained from six balloon flights are presented; almost all the results show a constant water vapor mixing ratio, in agreement with other data from midlatitude regions.

Chleck, D.↗

Coherent anti-Stokes Raman spectroscopy - Spectra of water vapor in flames

The results of experimental measurements of the coherent anti-Stokes Raman spectra of water vapor in flames are reported. A pulsed, frequency-doubled neodymium laser was used to supply the pump beam and to pump a dye laser to provide a broadband Stokes beam at 6600 A. Spectra were obtained in the postflame region of a premixed methane-air flame in the Raman frequency shift region of the symmetric stretch mode (3651.7 kaysers) at an approximate temperature of 1675 K. A theoretical calculation of the coherent anti-Stokes Raman spectrum of water vapor at this temperature was made, taking into account only isotropic Q-branch transitions, and using the energy level data of Floud et al. (1976). The theoretical prediction is shown essentially to reproduce all qualitative features of the experimental spectrum, and to exhibit a strong temperature dependence.

Hall, R. J.↗