Search NASA⌕ Search

SEARCH · Search NASA

Results for “vortex”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,549 records · Page 86
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

The effects of nozzle exit geometry on forebody vortex control using blowing

An experimental study has been undertaken to examine the influence of the blowing jet geometry on the effectiveness of the aft blowing technique for forebody vortex control. The experiments were conducted with a 3.0 tangent caliber ogive model at subsonic, laminar flow conditions. Asymmetric aft blowing was accomplished using both a single nozzle and a double nozzle configuration. Detailed surface pressure measurements on the model were obtained. The experimental results show that the height and the width of the blowing jet are important parameters that determine the effectiveness of aft blowing; a broad, lowly positioned blowing jet is found to be most effective for the forebody vortex control technique using aft blowing.

Gittner, Nathan M.↗
NASA NTRS1992

Forebody vortex control for suppressing wing rock on a highly-swept wing configuration

Free-to-roll tests were conducted in a wind tunnel with a configuration that consisted of a highly-slender forebody and a 78 deg swept delta wing. A limit cycle oscillation was observed for angles of attack between 22 and 30 deg. In general, the main flow phenomena responsible for the wing-body-tail wing rock are the interactions between the forebody and the wing vortices. Various blowing techniques were evaluated as means of wing rock suppression. Blowing tangentially aft from leeward side nozzles near the forebody tip can damp the roll motion at low blowing rates and stop it completely at higher blowing rates. At the high rates, significant vortex asymmetries are created, causing the model to stop at a non-zero roll angle. Forward blowing and alternating right/left pulsed blowing appear to be more efficient techniques for suppressing wing rock. The oscillations can be damped almost completely at lower blowing coefficients, and, apparently, no major vortex asymmetries are induced. Good agreement is observed between this study and previous water tunnel tests on the same configuration.

Suarez, Carlos J.↗
NASA NTRS1990

Reduction of vortex-induced vibration in vane geometries

Computations using a time-accurate, compressible Navier-Stokes flow model were conducted to analyze both unsteady laminar and turbulent flows over two curved configurations of vanes which were shaped to treat a 4.0 kHz vibration problem which has occurred in several SSMEs. This problem involves vortex shedding from vanes which causes excessive vane vibration and cracking. The original vane configuration exhibited strong flow-induced vibrations at a Strouhal number near 0.19 for a the first bending mode excitation. Scalloping of the leading edge raised the frequency of the vane's first torsional mode, which in turn increased the onset flow velocity at lock-in. Beveling the vane's trailing edge eliminated vortex shedding at the trailing edge, which decoupled the flow oscillation from the vibrating wave. A modified vane configuration with a beveled trailing edge at a 30 deg angle was also studied.

Liu, B. L.↗
NASA NTRS1992

Surface heat transfer and flow properties of vortex arrays induced artificially and from centrifugal instabilities

The paper presents and compares fluid-flow and heat transfer properties from artificially induced vortices in a flat-plate turbulent boundary layer and naturally occurring vortices due to centrifugal instabilities in a curved-channel laminar flow. Pairs and arrays of vortices are artificially induced by placing half-delta wings on the plate surface. With both arrays and pairs of vortices, streamwise velocities and total pressures are high, and surface heat transfer is locally augmented in vortex downwash regions. In contrast to vortices in the arrays vortices in the pairs tend to move in the streamwise direction with significant divergence (when the common flow between pair is toward the wall) or convergence (when the common flow between pair is away from the wall). The vortices in the arrays cause maximum peak-to-peak heat transfer variations of up to 12 percent of local spanwise-averaged values for initial vortex spacings between 1 to 2.5 generator heights.

Subramanian, C. S.↗
NASA NTRS1993

Electrostatically Enhanced Vortex Separator

Proposed device removes fine particles from high-pressure exhaust gas of chemical reactor. Negatively charged sectors on rotating disks in vortex generator attracts positively charged particles from main stream of exhaust gas. Electrostatic charge enhances particle-separating action of vortex. Gas without particles released to atmosphere.

Collins, Earl R.↗
NASA NTRS1993

Photographic System Makes Path Of Vortex Visible

System making rapid flows visible developed to record track followed by ring vortex when encountering object near its path. Schlieren optical setup includes standard Z-configuration mirror arrangement and pulsed, synchronized source of light. System proves valuable in determining position, velocity, and acceleration of vortex as it passes over and interacts with object in its path.

Jones, Stephen B.↗
NASA NTRS1993

Vortex-Shedding Meters For Liquid And Liquid/Gas Flows

Flowmeters without moving parts developed as replacements for conventional turbine flowmeters. No maintenance required so meters installed permanently. In vortex-shedding flowmeter, piezoelectric or other suitable transducer probe senses changes of pressure caused by passage of vortices. Electronic circuitry processes pressure-change signals to extract vortex-passage frequency representing rate of flow.

Howard, Robert H.↗
NASA NTRS1992

Fully nonlinear development of the most unstable goertler vortex in a three dimensional boundary layer

The nonlinear development is studied of the most unstable Gortler mode within a general 3-D boundary layer upon a suitably concave surface. The structure of this mode was first identified by Denier, Hall and Seddougui (1991) who demonstrated that the growth rate of this instability is O(G sup 3/5) where G is the Gortler number (taken to be large here), which is effectively a measure of the curvature of the surface. Previous researchers have described the fate of the most unstable mode within a 2-D boundary layer. Denier and Hall (1992) discussed the fully nonlinear development of the vortex in this case and showed that the nonlinearity causes a breakdown of the flow structure. The effect of crossflow and unsteadiness upon an infinitesimal unstable mode was elucidated by Bassom and Hall (1991). They demonstrated that crossflow tends to stabilize the most unstable Gortler mode, and for certain crossflow/frequency combinations the Gortler mode may be made neutrally stable. These vortex configurations naturally lend themselves to a weakly nonlinear stability analysis; work which is described in a previous article by the present author. Here we extend the ideas of Denier and Hall (1992) to the three-dimensional boundary layer problem. It is found that the numerical solution of the fully nonlinear equations is best conducted using a method which is essentially an adaption of that utilized by Denier and Hall (1992). The influence of crossflow and unsteadiness upon the breakdown of the flow is described.

Otto, S. R.↗
NASA NTRS1992

Non-parallel effects in the instability of Long's vortex

Asymptotic results obtained by Foster and Smith (1989) for inviscid instability modes of the Type-II Long's vortex is extended to account for the effects of finite Reynolds number. It is shown that the nonparallelism of the flow is more important than the viscous terms in determining the finite-Re behavior due to the radial velocity scales with Re exp -1 M. A critical layer of the three-layer structrue of the parallel-flow instability modes is considerably modified by radial velocity. It is found that for azimuthal wavenumber n greater than 1, the nonparallelism stabilizes the unstable inertial modes, leading to determination of neutral curves. For n less than -1, the nonparallel effects always destabilize the vortex to these helical modes.

Foster, M. R.↗
NASA NTRS1992

Effects of a trailing edge flap on the aerodynamics and acoustics of rotor blade-vortex interactions

The use of a trailing edge flap on a helicopter rotor has been numerically simulated to determine if such a device can mitigate the acoustics of blade vortex interactions (BVI). The numerical procedure employs CAMRAD/JA, a lifting-line helicopter rotor trim code, in conjunction with RFS2, an unsteady transonic full-potential flow solver, and WOPWOP, an acoustic model based on Farassat's formulation 1A. The codes were modified to simulate trailing edge flap effects. The CAMRAD/JA code was used to compute the far wake inflow effects and the vortex wake trajectories and strengths which are utilized by RFS2 to predict the blade surface pressure variations. These pressures were then analyzed using WOPWOP to determine the high frequency acoustic response at several fixed observer locations below the rotor disk. Comparisons were made with different flap deflection amplitudes and rates to assess flap effects on BVI. Numerical experiments were carried out using a one-seventh scale AH-1G rotor system for flight conditions simulating BVI encountered during low speed descending flight with and without flaps. Predicted blade surface pressures and acoustic sound pressure levels obtained have shown good agreement with the baseline no-flap test data obtained in the DNW wind tunnel. Numerical results indicate that the use of flaps is beneficial in reducing BVI noise.

Charles, B. D.↗
NASA NTRS1993

Boundary layer energization by means of optimized vortex generators

A three-dimensional, multi-block, multi-zone, Euler analysis has been developed and applied to analyze the flow processes induced by a lateral array of low profile vortex generators (VG). These vortex generators have been shown to alleviate boundary layer separation through the generation of streamwise vorticity. The analysis has been applied to help develop improved VG configurations in an efficient manner. Special attention has been paid to determining the accuracy requirements of the solver for calculations in which vortical mechanisms are dominant. The analysis has been used to assess the effectiveness or boundary layer energization capacity of different VG's, including the effect of scale and shape variation. Finally, the analysis has been validated through comparisons with experimental data obtained in a large-scale low-speed wind tunnel.

Barber, T. J.↗
NASA NTRS1993

Driven cavity simulation of turbomachine blade flows with vortex control

This paper presents a computational study of the three-dimensional flows in a rotating cavity with clearance between cavity walls and lid wall. The objectives of this study is to understand the interaction mechanism between tip leakage and blade passage flows and to assess the means to control the flow pattern and pressure losses. The classes of problems addressed include: passage geometry, passage loading including lid velocity and anti-vortex strength, and placement necessary to provide flow control. The computational model is first validated on generic flow problems and then applied to a specific blade passage configuration. Results of parametric studies for secondary flow pattern control are analyzed, and practical means of vortex control are discussed.

Athavale, M. M.↗
NASA NTRS1993

Lift enhancement of an airfoil using a Gurney flap and vortex generators

The results of a low-speed wind tunnel test are presented for a single-element airfoil incorporating two lift-enhancing devices, namely a Gurney flap and vortex generators. The former consists of a small plate, on the order of one to two percent of the airfoil chord in height, located at the trailing edge perpendicular to the pressure side of the airfoil. The later consist of commercially-available, wishbone-shaped vortex generators. The test was conducted in the NASA Ames 7- by 10-foot Wind Tunnel with a full-span NACA 4412 airfoil. Measurements of surface pressure distributions and wake profiles were made to determine the lift, drag, and pitching-moment coefficients for the various airfoil configurations. The results indicate that the addition of a Gurney flap increased the maximum lift coefficient from 1.49 up to 1.96.

Storms, Bruce L.↗
NASA NTRS1993

Experiments on the enhancement of compressible mixing via streamwise vorticity. II - Vortex strength assessment and seed particle dynamics

The effect of streamwise vorticity on compressible axisymmetric mixing layers is examined using vortex strength assessment and seed particle dynamics analysis. Experimental results indicate that the particles faithfully represent the dynamics of the turbulent swirling flow. A comparison of the previously determined mixing layer growth rates with the present vortex strength data reveals that the increase of turbulent mixing up to 60 percent scales with the degree of swirl. The mixing enhancement appears to be independent of the compressibility level of the mixing layer.

Naughton, J. W.↗
NASA NTRS1992

Investigation of vortex breakdown on delta wings using Navier-Stokes equations

An efficient finite-difference scheme solving for the three-dimensional incompressible Navier-Stokes equations is described. Numerical simulations of vortex breakdown are then carried out for a sharp-edged delta wing and a round-edged double-delta wing at high Reynolds numbers. Computed results show that several major features of vortex breakdown are qualitatively in agreement with observations made in experiments.

Hsu, C.-H.↗
NASA NTRS1991

A study of blade-vortex interaction sound generation and directionality

The directionality and strength of blade-vortex interactions (BVI) is explained through the radiation cone concept. BVI acoustic radiation is primarily the result of two sound mechanisms: the tip effect, and the radiation cone effect. The radiation cone effect is a highly directional mechanism which results when a lift distribution moves supersonically with respect to the fluid. After a physical explanation of the BVI mechanisms, sample cases using translating and rotating blades interacting with a straight line vortex are shown. The radiation cone concept is then applied to specific rotorcraft cases where it helps to explain zones of intense sound pressure level found in experimental results for the XV-15 tiltrotor and for a BO-105 helicopter scale model.

Ringler, Todd D.↗
NASA NTRS1991

Noise reduction for transonic blade-vortex interactions

Several ideas for noise reduction of transonic blade-vortex interactions (BVI) are being introduced and tested using numerical simulation. The model used is the two-dimensional high frequency transonic small disturbance equation with regions of distributed vorticity (VTRAN2 code). The far-field noise signals are obtained by using the Kirchhoff method which extends the numerical two-dimensional near-field aerodynamic results to the linear acoustic three-dimensional far-field. The BVI noise mechanisms are explained and the effects of vortex type and strength, and angle of attack are studied. Particularly, airfoil shape modifications which lead to noise reduction are investigated here. The results presented are expected to be helpful for better understanding of the nature of the BVI noise and better blade design.

Xue, Y.↗
NASA NTRS1993

Nonlinear vortex trail dynamics. II - Analytic solutions

Spatially periodic large amplitude solutions of the von Karman model are obtained in the neighborhood of singularities. These singularities correspond to vortex clusters in the physical plane. The quasi-periodic and unbounded solutions found analytically confirm earlier numerical work and show qualitative agreement with experimental observations of large-scale phenomena of vortex trails. Separatrices or heteroclinic orbits were explicitly found for an integrable approximate equation, which indicate that the von Karman model itself supports chaotic solutions.

Lim, Chjan C.↗