Search NASA⌕ Search

SEARCH · Search NASA

Results for “Dam”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Compressible flow across narrow passages: Comparison of theory and experiment for face seals

Computer calculation for determining compressible flow across radial face seals were compared with measured results obtained in a seal simulator rig at pressure ratios to 0.9 (ambient pressure/sealed pressure). In general, the measured and calculated leakages across the seal dam agreed within 3 percent. The resultant loss coefficient, dependent upon the pressure ratio, ranged from 0.47 to 0.68. The calculated pressures were within 2.5 N/cu um of the measured values.

Allen, G. P.↗
NASA NTRS1978

Local precision nets for monitoring movements of faults and large engineering structures

Along Bocono Fault were installed local high precision geodetic nets to observe the possible horizontal crustal deformations and movements. In the fault area there are few big structures which are also included in the mentioned investigation. In the near future, measurements shall be extended to other sites of Bocono Fault and also to the El Pilar Fault. In the same way and by similar methods high precision geodetic nets are applied in Venezuela to observe the behavior of big structures, as bridges and large dams and of earth surface deformations due to industrial activities.

Henneberg, H. G.↗
NASA NTRS1979

Comparison of analysis and experiment for self-acting seals for liquid-oxygen turbopumps

Two LOX turbopump applications were analyzed over ranges of pressure differential and speed. Predictions were compared with test results. A small seal was analyzed up to 141 m/sec and 310 N/sq cm differential and a larger seal up to 147 m/sec and 448 N/sq cm. Tests confirmed analytical predictions of operation without rubbing contact. The seals evidently operated with mostly liquid in the pads and mostly gas across the dam although the best prediction of trends was based on assuming gas throughout the entire seal.

Allen, G. P.↗
NASA NTRS1980

Instability thresholds for flexible rotors in hydrodynamic bearings

Two types of fixed pad hydrodynamic bearings (multilobe and pressure dam) were considered. Optimum and nonoptimum geometric configurations were tested. The optimum geometric configurations were determined by using a theoretical analysis and then the bearings were constructed for a flexible rotor test rig. It was found that optimizing bearings using this technique produces a 100% or greater increase in rotor stability. It is shown that this increase in rotor stability is carried out in the absence of certain types of instability mechanisms such as aerodynamic crosscoupling. However, the increase in rotor stability should greatly improve rotating machinery performance in the presence of such forces as well.

Allaire, P. E.↗
NASA NTRS1978

Monitoring of deltaic wetland processes with seasonal aerial photography

A year-long study of four river deltas, using color infrared photography at three-month intervals, showed clearly the impact of damming the lower river or channelizing its outlet on the wetland environment. An important result of the season's photography was the dramatic appearance of the detrital material being flushed out of the deltaic wetlands by flood waters, and moved down into the lower estuaries for use by the marine organisms in the lower tropical levels. The species makeup and relative vigor of the deltaic plant communities were well recognizable on the imagery, as was the flushing mechanism in one still viable delta marsh.

Benton, A. R., Jr.↗
NASA NTRS1981

Self-acting geometry for noncontact seals

Performance ot two self acting seal designs for a liquid oxygen (LOX) turbopump was predicted over ranges of pressure differential and speed. Predictions were compared with test results. Performance of a radial face seal for LOX was predicted up to 448 N/cu cm and 147 m/sec. Performance of a segmented circumferential seal for helium was predicted up to 69 N/cu cm and 189 m/sec. Results confirmed predictions of noncontact operation. Qualitative agreement between test and analysis was found. The LOX face seal evidently operated with mostly liquid in the self acting geometry and mostly gas across the dam.

Allen, G. P.↗
NASA NTRS1980

High-Pressure Hot-Gas Self-Acting Floating Ring Shaft Seal for Liquid Rocket Turbopumps

Design analysis, detail design, fabrication, and experimental evaluation was performed on two self acting floating ring shaft seals for a rocket engine turbopump high pressure 24132500 n/sq m (3500 psig) hot gas 533 K 9500 F) high speed 3142 rad/sec (30000 rmp) turbine. The initial design used Rayleigh step hydrodynamic lift pads to assist in centering the seal ring with minimum rubbing contact. The final design used a convergent tapered bore to provide hydrostatic centering force. The Rayleigh step design was tested for 107 starts and 4.52 hours total. The leakage was satisfactory; however, the design was not acceptable due to excessive wear caused by inadequate centering force and failure of the sealing dam caused by erosion damage. The tapered bore design was tested for 370 starts and 15.93 hours total. Satisfactory performance for the required life of 7.5 hours per seal was successfully demonstrated.

Burcham, R. E.↗
NASA NTRS1981

Self-acting geometry for noncontact seals

Two hydrodynamic self-acting seal designs for a LOX turbopump were analyzed in order to predict performance. A radial face seal-to-seal LOX at 310 N/sq cm and 32,000 rpm (130 m/s) was analyzed for pressure differentials of 172 to 448 N/sq cm and speeds from 98 to 147 m/s. A segmented circumferential seal-to-seal helium at 34.5 or 69 N/sq cm and 157 m/s was analyzed for pressures of 35 to 86 N/sq cm (10 N/sq cm ambient) and speeds from 94 to 189 m/s. Test results confirmed noncontact operation near the design speed and pressure, and relatively good qualitative agreement between test and analysis. The face seal was found to operate with mostly liquid in the pads and mostly gas across the dam.

Allen, G. P.↗
NASA NTRS1981

Modified face seal for positive film stiffness

The film stiffness of a face seal is improved without increasing the sealing and dam area by using an apparatus which includes a primary seal ring in the form of a nose piece. A spring forces a sealing surface on the seal ring into sealing contact with a seat to form a face seal. A circumferential clearance seal is formed in series with this face seal by a lip on the piece. The width of the surface of the lip is substantially the same as the width of the sealing surface on the face seal and the clearance between the surface on the lip and the shaft is substantially the same as the spacing between the face sealing surfaces on the face seal when the shaft is rotating. The circumferential clearance seal restricts the flow of fluid from a main cavity to an intermediate cavity with a resulting pressure drop. The hydrostatic opening face is strongly dependent on the face seal clearance, and the desired axial stiffness is achieved.

Etsion, I.↗
NASA NTRS1982

INSAT-1A launch on Delta

The INSAT-1A, the first in a series of 12 transponder communications satellites developed for India, is described as well as the launch plans. The launch vehicle will be the Delta 3910 configuration which incorporates an extended long tank Thor booster, nine Castor IV strap-on motors, a TR-201 second stage, and an 8 foot fairing. The satellite will be placed in a suborbital trajectory. A DAM-D stage will then thrust it into a synchronous transfer orbit. An apogee kick motor will be fired to circularize its orbit at a geosynchronous altitude of 19,300 nautical miles.

Source record↗
NASA NTRS1982

National geotechnical centrifuge

A high G-ton centrifuge, able to take a 2700 kg (6000 lb) payload up to 300 G, is described. The stability of dams and embankments, the bearing capacity of soil foundations, and the dynamic behavior of foundations due to vibration of machinery are examples of applications. A power rating of 6,000 kW (9,000 hp) was established for the motor. An acceptable maximum speed of 70 rpm was determined. A speed increase with a ratio of 1:3 is discussed. The isolated tension straps, the anti-spreader bar and the flexwall bucket, and safety precautions are also discussed.

Hallam, J. A.↗
NASA NTRS1982

Ambient airborne solids concentrations including volcanic ash at Hanford, Washington sampling sites subsequent to the Mount St. Helens eruption

Airborne solids concentrations were measured on a near daily basis at two Hanford, Washington sites after the eruption of Mount St. Helens on May 18, 1980. These sites are about 211 km east of Mount St. Helens. Collected airborne solids included resuspended volcanic ash plus normal ambient solids. Average airborne solids concentrations were greater at the Hanford meteorological station sampling site which is 24 km northwest of the Horn Rapids dam sampling site. These increased concentrations reflect the sampling site proximity to greater ash fallout depths. Both sites are in low ash fallout areas although the Hanford meteorological station site is closer to the greater ash fallout areas. Airborne solids concentrations were decreased by rain, but airborne solids concentrations rapidly increased as surfaces dried. Airborne concentrations tended to become nearly the same at both sampling sites only for July 12 and 13.

Sehmel, G. A.↗
NASA NTRS1982

Assessment Planning and Evaluation of Renewable Energy Resources: an Interactive Computer Assisted Procedure

Adaptation and derivation were used to develop a procedure for assessing the availability of renewable energy resources on the landscape while simultaneously accounting for the economic, legal, social, and environmental issues required. Done in a step-by-step fashion, the procedure can be used interactively at the computer terminals. Its application in determining the hydroelectricity, biomass, and windpower in a 40,000 acre study area of Western Massachusetts shows that: (1) three existing dam sites are physically capable of being retrofitted for hydropower; (2) each of three general areas has a mean annual windspeed exceeding 14 mph and is conductive to windpower; and (3) 20% of the total land area consists of prime agricultural biomass while 30% of the area is prime forest biomass land.

Aston, T. W.↗
NASA NTRS1983

Theories of radio emissions and plasma waves

The complex region of Jupiter's radio emissions at decameter wavelengths, the so-called DAM, is considered, taking into account the basic theoretical ideas which underly both the older and newer theories and models. Linear theories are examined, giving attention to direct emission mechanisms, parallel propagation, perpendicular propagation, and indirect emission mechanisms. An investigation of nonlinear theories is also conducted. Three-wave interactions are discussed along with decay instabilities, and three-wave up-conversio. Aspects of the Io and plasma torus interaction are studied, and a mechanism by which Io can accelerate electrons is reviewed.

Goldstein, M. L.↗
NASA NTRS1985

Relational Information Management Data-Base System

DBMS with several features particularly useful to scientists and engineers. RIM5 interfaced with any application program written in language capable of Calling FORTRAN routines. Applications include data management for Space Shuttle Columbia tiles, aircraft flight tests, high-pressure piping, atmospheric chemistry, census, university registration, CAD/CAM Geometry, and civil-engineering dam construction.

Storaasli, O. O.↗
NASA NTRS1983

A numerical investigation of the President's Day storm of February 18-19, 1979

The reported investigation is based on the use of a three-dimensional, primitive equation model. The President's Day storm, formed in the Gulf of Mexico as a massive anticyclone, affected the northern states with record-breaking cold temperatures. Attention is given to the physical processes relevant to storm formation, the forecast model, a description of experiments and model forecasts, and model results. An attempt is made to determine the important dynamic processes at work during the evolution of the storm. The jet streak interactions which occurred in the cyclogenetic environment, the effects of cold air damming, and the formation of a strong mesoscale coastal front are found to be of particular interest.

Nappi, A. J.↗
NASA NTRS1984

The generation and propagation of internal gravity waves in a rotating fluid

The present investigation is concerned with an extension of a study conducted bu Maxworthy (1979) on internal wave generation by barotropic tidal flow over bottom topography. A short series of experiments was carried out during a limited time period on a large (14-m diameter) rotating table. It was attempted to obtain, in particular, information regarding the plan form of the waves, the exact character of the flow over the obstacle, and the evolution of the waves. The main basin was a dammed section of a long free surface water tunnel. The obstacle was towed back and forth by a wire harness connected to an electronically controlled hydraulic piston, the stroke and period of which could be independently varied. Attention is given to the evolution of the wave crests, the formation of solitary wave groups the evolution of the three-dimensional wave field wave shapes, the wave amplitudes, and particle motion.

Maxworthy, T.↗
NASA NTRS1984

Three dimensional ray tracing of the Jovian magnetosphere in the low frequency range

Ray tracing studies of Jovian low frequency emissions were studied. A comprehensive three-dimensional ray tracing computer code for examination of model Jovian decametric (DAM) emission was developed. The improvements to the computer code are outlined and described. The results of the ray tracings of Jovian emissions will be presented in summary form.

Menietti, J. D.↗