Search NASA⌕ Search

SEARCH · Search NASA

Results for “Induced Currents”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

The impact of defects on the photovoltaic potential of RTR silicon ribbon

Silicon ribbon grown at a high rate by the ribbon-to-ribbon (RTR) method contains a variety of defects and can exhibit an unusual dendritic morphology. This paper is a study of the effect of the defect structure and dendritic morphology on the photovoltaic potential of RTR ribbon. Defects found in RTR ribbon include grain boundaries, twin planes, stacking faults and dislocations. The electrical activity of these defects is investigated by measuring the diffusion length in the ribbon; by fabricating small area diodes on the ribbon and evaluating their photoresponse; and by using a scanning electron microscope in the electron beam induced current mode. It is concluded that although grain boundaries serve very effectively as recombination centers, they do not occur frequently enough in RTR ribbons to significantly affect the generation current. Dislocation densities up to 1,000,000/sq cm can be tolerated without strongly reducing the photoresponse. Similarly, linear boundaries such as twin planes or stacking faults do not affect the cell performance up to densities of 1000/sq cm.

Baghdadi, A.↗
NASA NTRS1978

Response of defects to illumination in silicon solar cells

The enhancement of diffusion length with intensity was examined using spectral response measurements in solar cells based on Silso silicon and EFG silicon ribbon. Local diffusion length variations at defect sites were investigated as a function of illumination level using a scanning electron microscope operated in the electron beam induced current mode. An increase of diffusion length was observed at defect sites as the intensity level was increased. The diffusion length improvements are explained on the basis of saturation of minority carrier traps in these materials. The trap distribution in Silso silicon is shown to be peaked near (Ec - 0.7)eV. EFG silicon ribbon shows a broad, Gaussian distribution of traps located near (Ec - 0.5)eV.

Hari Rao, C. V.↗
NASA NTRS1979

Resonant frequency of microstrip antennas calculated from TE-excitation of an infinite strip embedded in a grounded dielectric slab

The calculation of currents induced by a plane wave normally incident upon an infinite strip embedded in a grounded dielectric slab is used to infer the resonant width (or frequency) of rectangular microstrip antennas. By placing the strip inside the dielectric, the effect of a dielectric cover of the same material as the substrate can be included in the calculation of resonant frequency. A comparison with measured results indicated agreement of 1 percent or better for rectangular microstrip antennas constructed on Teflon-fiberglass substrate.

Bailey, M. C.↗
NASA NTRS1980

A bounds on the resonant frequency of rectangular microstrip antennas

The calculation of currents induced by a transverse electric plane wave normally incident upon an infinite strip embedded in a grounded dielectric slab is used to infer a lower bound on the resonant frequency (or resonant-E-plane dimension) for rectangular microstrip antennas. An upper bound is provided by the frequency for which the E-plane dimension is a half-wavelength.

Bailey, M. C.↗
NASA NTRS1979

Transform approach to electromagnetic scattering

In this paper, a comprehensive review of the Fourier transform technique as applied to the problem of high-frequency scattering is presented and the concepts of the spectral theory of diffraction (STD) are introduced. In contrast to the more commonly employed ray-optical method for high-frequency scattering, the STD approach interprets the scattered field as the spectrum, or the Fourier transform of the induced current on the scatterer. Such an interpretation offers several important advantages: uniform nature of representation, capacity to improve and extend the ray-optical formulas in a systematic manner, and convenient accuracy tests for the results. Methods for combining integral equation methods with the Galerkin procedure and asymptotic techniques in the transform domain are described, and representative examples illustrating the application of the spectral approach are included.

Mittra, R.↗
NASA NTRS1980

Resonant electrodynamic heating of stellar coronal loops: An LRC circuit analogue

The electrodynamic coupling of stellar coronal loops to underlying beta velocity fields. A rigorous analysis revealed that the physics can be represented by a simple yet equivalent LRC circuit analogue. This analogue points to the existence of global structure oscillations which resonantly excite internal field line oscillations at a spatial resonance within the coronal loop. Although the width of this spatial resonance, as well as the induced currents and coronal velocity field, explicitly depend upon viscosity and resistivity, the resonant form of the generalized electrodynamic heating function is virtually independent of irreversibilities. This is a classic feature of high quality resonators that are externally driven by a broad band source of spectral power. Applications to solar coronal loops result in remarkable agreement with observations.

Ionson, J. A.↗
NASA NTRS1982

Three-dimensional relativistic field-electron interaction in a multicavity high-power klystron. 1: Basic theory

A theoretical investigation of three dimensional relativistic klystron action is described. The relativistic axisymmetric equations of motion are derived from the time-dependent Lagrangian function for a charged particle in electromagnetic fields. An analytical expression of the fringing RF electric and magnetic fields within and in the vicinity of the interaction gap and the space-charge forces between axially and radially elastic deformable rings of charges are both included in the formulation. This makes an accurate computation of electron motion through the tunnel of the cavities and the drift tube spaces possible. Method of analysis is based on Lagrangian formulation. Bunching is computed using a disk model of electron stream in which the electron stream is divided into axisymmetric disks of equal charge and each disk is assumed to consist of a number of concentric rings of equal charges. The Individual representative groups of electrons are followed through the interaction gaps and drift tube spaces. Induced currents and voltages in interacting cavities are calculated by invoking the Shockley-Ramo theorem.

Kosmahl, H. G.↗
NASA NTRS1982

An EBIC study of dislocation networks in unprocessed and unprocessed web silicon ribbon

Experimental techniques for the preparation of electron beam induced current samples of Web-dentritic silicon are described. Both as grown and processed material were investigated. High density dislocation networks were found close to twin planes in the bulk of the material. The electrical activity of these networks is reduced in processed material.

Fieldler, F. S.↗
NASA NTRS1982

An EBIC study of HEM polycrystalline silicon

Low-cost silicon for solar cells grown by the heat exchanger method (HEM) was studied in the electron beam induced current (EBIC) mode of a scanning electron microscope (SEM). Comparisons were made between the defects observed optically and the recombination centers visible in EBIC. Much of the HEM material was single crystalline, but structural defects were found from areas near the corners of the grown material. Most of these defects consisted of linear twin boundaries and grain boundaries. The electrical activity of these boundaries was dependent on symmetry of the boundaries. Symmetric twin boundaries did not exhibit recombination activity while unsymmetric twin boundaries were electrically active.

Koch, T.↗
NASA NTRS1981

Evaluation of silicon-on-ceramic material for low-cost solar cells

The silicon-on-ceramic (SOC) process produces thin layers of silicon on inexpensive ceramic substrates. The layers are produced by unidirectional solidification of molten silicon, and are polycrystalline. Solar cells made from SOC material have performed with a conversion efficiency of 10.5%. In connection with the objective to improve the efficiency of SOC solar cells, an investigation was conducted to assess the relative importance of grain boundaries and impurities. In order to separate the two effects, light-beam-induced current (LBIC) measurements of the short-circuit current were made using a micron-sized light beam from a monochromator. The LBIC measurements are closely related to solar cell performance since the technique identifies the various spatial and spectral contributions to solar cell current. On the basis of the obtained results, it appears that structural defects are more important than chemical defects in limiting the performance of present SOC solar cells.

Zook, J. D.↗
NASA NTRS1982

Resonant electrodynamic heating of stellar coronal loops - An LRC circuit analog

The problem of electrodynamic coupling of stellar coronal loops where beta is less than 1 to underlying velocity fields where beta is greater than approximately 1 is treated. A rigorous analysis reveals that the physics can be represented by a simple yet equivalent LRC circuit analog. This derived analog suggests the existence of global structure oscillations which resonantly excite internal field line oscillations at a spatial resonance within the coronal loop. Even though the width of this spatial resonance, as well as the induced currents and coronal velocity field, within the resonance region explicitly depends on viscosity and resistivity, the resonant form of the generalized electrodynamic heating functions is virtually independent of irreversibilities. This is a classic feature of high-quality resonators that are driven externally by a broad-band source of spectral power.

Ionson, J. A.↗
NASA NTRS1982

Model simulations of possible electromagnetic induction effects at Magsat activities

Model simulations are used in a consideration of whether terrestrial induced-current magnetic field effects are significant for near-earth satellite observation, and the nature of the effect at satellite altitudes of lateral differences in the gross conductivity structure of the earth. It is shown that induction in a spherical earth by distant magnetospheric sources can contribute magnetic field fluctuations at Magsat orbit altitudes which are 30-40% of external field amplitudes. It is found that, when phenomenon dimensions are small by comparison with the earth's radius, the earth may be approximated by a plane, horizontal half-space by which electromagnetic energy is reflected with nearly 100% efficiency from the surface. This implies that while the total horizontal field is twice the source field when the source is above the satellite, it is reduced to values smaller than the source field when the source is below the satellite and tends to enhance gross electrical discontinuity signatures in the lithosphere.

Hermance, J. F.↗
NASA NTRS1983

Measuring Diffusion and Recombination in Polycrystalline Silicon

Light-beam-induced currents yield information about solar cell material. Apparatus measures short-circuit current generated when spot of concentrated light is scanned across grains and grain boundaries in material under test. Technique used to evaluate SOC samples for diffusion and recombination effects of cell processing and chemical and structural defects.

Zook, J. D.↗
NASA NTRS1982

Minority carrier diffusion length measurements - A review and comparison of techniques

A review of the major techniques for measuring minority carrier diffusion lengths in solar cells is given. Limits of applicability are indicated for each method, as relevant to indirect bandgap materials such as silicon, and direct bandgap materials like gallium arsenide. A discussion and bibliography is presented for the following techniques: uniform generation, electron beam induced current, Schottky barrier (and other steady-state) photocurrent, surface photovoltage, transient decay, and luminescence.

Khan, A. A.↗
NASA NTRS1982

Response of MnBi-Bi eutectic to freezing rate changes

Reference is made to a study by Fu and Wilcox (1981), which treated theoretically the influence on freezing rate of sudden changes in translation rate in the Bridgman-Stockbarger technique. This treatment is extended here to a linear ramped translation rate and an oscillatory freezing rate. It is found that oscillations above a few hertz are highly damped in small-diameter apparatus. An experimental test is carried out of the theoretical predictions for a sudden change of translation rate. The MnBi-Bi eutectic is solidified with current-induced interface demarcation. The experimental results accord reasonably well with theory if the silica ampoule wall is assumed to either (1) contribute only a resistance to heat exchange between the sample and the furnace wall or (2) transmit heat effectively in the axial direction by radiation. In an attempt to explain the fact that a finer microstructure is obtained in space, MnBi-Bi microstructure is determined when the freezing rate is increased or decreased rapidly. Preliminary results suggest that fiber branching does not occur as readily as fiber termination.

Nair, M.↗
NASA NTRS1984

Process Research of Polycrystalline Silicon Material (PROPSM)

A passivation process (hydrogenation) that will improve the power generation of solar cells fabricated from presently produced, large grain, cast polycrystalline silicon (Semix), a potentially low cost material are developed. The first objective is to verify the operation of a DC plasma hydrogenation system and to investigate the effect of hydrogen on the electrical performance of a variety of polycrystalline silicon solar cells. The second objective is to parameterize and optimize a hydrogenation process for cast polycrystalline silicon, and will include a process sensitivity analysis. The sample preparation for the first phase is outlined. The hydrogenation system is described, and some early results that were obtained using the hydrogenation system without a plasma are summarized. Light beam induced current (LBIC) measurements of minicell samples, and their correlation to dark current voltage characteristics, are discussed.

Culik, J. S.↗
NASA NTRS1982

Interaction between cast silicon properties and solar cell performance

Three types of cast silicon, Silso, HEM (Heat-Exchanger Method) and UCP (Ubiquitous Crystallization Process) were studied for their use as solar cells. Optical microscopy after etching revealed a high density of uniform dislocations (approaching 1,000,000/sq cm), lines of dislocations indicating stress during crystal growth, and precipitates, some of which generate dislocations. Solar cells were fabricated by three processes. Results of solar cell processing revealed that these materials produce cells of lower efficiency than Czochralski control cells, and that the efficiencies of the three materials were quite close. Diffusion length and spectral response data are shown. Certain structural features are correlated with solar cell efficiency, diffusion length, and spectral response. Electron-beam induced current (EBIC) and light spot scanning are used to back up other measurements.

Hyland, S.↗
NASA NTRS1984

Collisionless dissipation in quasi-perpendicular shocks

Microscopic dissipation processes in quasi-perpendicular shocks are studied by two-dimensional plasma simulations in which electrons and ions are treated as particles moving in self-consistent electric and magnetic fields. Cross-field currents induce substantial turbulence at the shock front reducing the reflected ion fraction, increasing the bulk ion temperature behind the shock, doubling the average magnetic ramp thickness, and enhancing the upstream field aligned electron heat flow. The short scale length magnetic fluctuations observed in the bow shock are probably associated with this turbulence.

Forslund, D. W.↗