Search NASA⌕ Search

SEARCH · Search NASA

Results for “Langmuir Probe”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Model representation of the ambient electron density distribution in the middle atmosphere

While the Langmuir probe controlled by rocket propagation experiments by the University of Illinois at midlatitude revealed the existence of a permanent D region turning point (DTP), similar measurements over the Thumba equatorial station did not clearly bring out the above daytime feature. Moreover, the calibration constant (ratio of electron density to the current drawn by the Langmuir probe) increased with height (in the 70 to 100 km region) in the case of the midlatitude observations whereas the recent measurements over Thumba showed a decrease up to about 90 km followed by an increase above 90 km. Secondly, there is the problem of reconciling the station oriented observations from the COSPAR family with the ground based radio propagation measurements from the URSI family. Thirdly, new information on Winter in Northern Europe (WINE) and in USSR is available by asking for its incorporation into any global model such as the IRI. The results of investigation of the above aspects are presented.

Ramanamurty, Y. V.↗
NASA NTRS1988

A precursor to the Venus bow shock

This paper describes the observations by the Pioneer-Venus-Orbiter Langmuir probe of the low-density Venus bow shock precursor, i.e., a region of electron and ion-current enhancements just upstream from the Venus bow shock. It is suggested that the precursor signatures represent the effects of a small population of energetic ions in this region. Several possible planetary sources of these ions are considered. The paper also discusses the Langmuir probe measurement technique itself as it applies to the very low densities of the precursor.

Brace, L. H.↗
NASA NTRS2020

Collisional-Radiative Models of Neutral and Singly-Ionized Xenon in Hall Thrusters: Experimental Validation and Model Investigations

The recently developed collisional radiative (CR) models for neutral xenon (Xe I) and singly charged xenon ion (Xe II) described by Chaplin et al. in the paper "Insights from Collisional-Radiative Models of Neutral and Singly-Ionized Xenon in Hall Thrusters" also submitted to the 2021 AIAA Propulsion and Energy Forum are more thoroughly investigated. Comparisons between the existing and recently developed JPL Xe I CR models are done and reasons for discrepancies between the two models are explored. An experiment to validate the Xe II CR model is carried out in the anode region of the UCLA Plasma interactions facility. The Xe II CR model is applied to measured xenon ion emission line intensities to determine electron temperature and density. Spatial resolution of these optical measurements is obtained through an Abel inversion for direct comparison to Langmuir probe results. Although the measured electron densities were on the order of $10^{17}$ m$^{-3}$ and the Xe II CR model is most suitable for use with densities above $10^{18}$ m$^{-3}$ due to the strong dependence of the line ratios on electron temperature in that regime, initial results from the validation experiment show reasonable agreements between the optical and Langmuir probe results. The 441 nm to 605 nm line ratio appears to have the most promise for non-intrusive electron temperature measurements with the Xe II CR model. Shortcomings of the Xe II CR model revealed in the validation experiment are to be explored further.

Lobbia, Robert B.↗
NASA NTRS2002

Plasma Emission Characteristics from a High Current Hollow Cathode in an Ion Thruster Discharge Chamber

The presence of energetic ions produced by a hollow cathodes operating at high emission currents (greater than 5A) has been documented in the literature. In order to further elucidate these findings, an investigation of a high current cathode operating in an ion thruster discharge chamber has been undertaken. Using Langmuir probes, a low energy charged particle analyzer and emission spectroscopy, the behavior of the near-cathode plasma and the emitted ion energy distribution was characterized. The presence of energetic ions was confirmed. It was observed that these ions had energies in excess of the discharge voltage and thus cannot be simply explained by ions falling out of plasma through a potential difference of this order. Additionally, evidence provided by Langmuir probes suggests the existence of a double layer essentially separating the hollow cathode plasma column from the main discharge. The radial potential difference associated with this double layer was measured to be of order the ionization potential.

Foster, John E.↗
NASA NTRS1990

Solar cycle variations in the neutral exosphere inferred from the location of the Venus bow shock

Solar UV and EUV varies significantly during the solar cycle. Pioneer Venus can measure this variation both directly and indirectly. A direct measure of the EUV is obtained from the photoelectron current of the Langmuir probe when the spacecraft is in the solar wind. The indirect measure is by monitoring the location of the Venus bow shock. The UV and EUV both heat the upper atmosphere and ionize it. When solar activity is high, the upper atmosphere should be ionized more rapidly. This effect adds a greater number of planetary ions to the magnetosheath plasma as it flows by Venus. It is this increase in mass flow that causes the Venus bow shock to move away from its solar minimum location. Pioneer Venus has now monitored the location of the bow shock for an entire solar cycle. The bow shock location is well correlated with the variation in EUV flux as measured by the Langmuir probe. The bow shock is farther from Venus than expected from the sunspot number or 10.7 cm solar radio flux, indicating that solar UV radiation may be even stronger at the present time than would be predicted from the relationships determined during the previous solar cycle.

Russell, C. T.↗
NASA NTRS2010

Characteristics of the Dust-Plasma Interaction Near Enceladus' South Pole

We present RPWS Langmuir probe data from the third Enceladus flyby (E3) showing (he presence of dusty plasma near Enceladus' South Pole. There is a sharp rise in both the electron and ion number densities when the spacecraft traverses through Enceladus plume. The ion density near Enceladus is found to increase abruptly from about 10(exp 2) cm (exp -3) before the closest approach to 10(exp 5) cm (exp -3) just 30 s after the closest approach, an amount two orders of magnitude higher than the electron density. Assuming that the inconsistency between the electron and ion number densities is due to the presence of dust particles that are collecting the missing electron charges, we present dusty plasma characteristics down to sub-micron particle sizes. By assuming a differential dust number density for a range in dust sizes and by making use of Langmuir probe data, the dust densities for certain lower limits in dust size distribution were estimated. In order to achieve the dust densities of micrometer and larger sized grains comparable to the ones reported in the literature. we show that the power law size distribution must hold down to at least 0.03 micron such that the total differential number density is dominated by the smallest sub-micron sized grains. The total dust number density in Enceladus' plume is of the order of l0(exp 2) cm(exp -3) reducing to 1 cm(exp -3) in the E- ring. The dust density for micrometer and larger sized grains is estimated to be about 10(exp -4) cm(exp -3) in the plume while it is about 10(exp -6) - 10(exp -7) cm(exp -3) in the E-ring. Dust charge for micron sized grains is estimated to be about eight thousand electron charges reducing to below one hundred electron charges for 0.03 micron sized grains. The effective dusty plasma Debye length is estimated and compared with intergrain distance as well as the electron Debye length. The maximum dust charging time of 1.4 h is found for 0.03 11mmicron sized grains just 1 min before the closest approach. The charging time decreases substantially in the plume where it is only a fraction of a second for 1 micron sized grains, 1 s for 0.l micron sized grains and about 10 s for 0.03 micron sized grains.

Shafiq, Muhammad↗
NASA NTRS1972

Experimental plasma studies

The rate coefficients for the reactions C(+) + e(-) + e(-) yields C + e(-) and CO(+) + e(-) yields C + O were measured over the electron temperature range of approximately 1500 deg K to 7000 deg K. The measurements were performed in CO that had expanded from equilibrium reservoir conditions of 7060 deg K at 17.3 atm pressure and from 6260 deg K at 10.0 atm pressure. Two RAM flight probes were used to measure electron density and electron temperature in the expanding flow of a shock tunnel. Experiments were performed in the inviscid flow with both probes and in the nozzle-wall boundary layer with the constant bias-voltage probe. The distributions of electron density and electron temperature were independently measured using voltage-swept thin-wire probes. Thin-wire Langmuir probes were also used to measure the electron-density and electron-temperature distributions in the boundary layer of a sharp flat plate located on the nozzle centerline. Admittance measurements were performed with the RAM C and RAM C-C S-band antennas in the presence of an ionized boundary layer.

Dunn, M. G.↗
NASA NTRS2004

Progress on the Plasmoid Thruster Experiment (PTX)

A plasmoid is a compact plasma structure with an integral magnetic field, that may be categorized according to the relative strength of the poloidal and toroidal magnetic field (B(sub p) and B(sub t), respectively). An object with B(sub p)/B(sub t), much much more than 1 is called a Field Reverse Configuration (FRC); if B(sub p) approximately equal to B(sub t), it is called a Spheromak. The thruster operates by repetitively producing plasmoids that are accelerated and ejected at high velocity. As this process is inductive, there are no electrodes. Also, the magnetic structure of the plasmoid should suppress thermal and mass losses to the wall, and improve detachment of the plasma exhaust from the thruster. This concept should be capable of producing an Isp in the range of 5,000 - 10,000 s with thrust densities of order 10(exp 5) N per square meters. The current experiment is designed to produce jet powers in the range of 5-10 kW, although the concept should be scalable into the MW range. In PTX, the plasmoid is formed inside of a single turn conical theta-pinch coil (17.58 cone angle). The coil is driven by a 640 nF, 35 kV capacitor bank, which rings at a frequency of 500 kHz. Previous experiments on PTX were conducted with a static-fill of propellant gas (6% H2 in He), and demonstrated reliable ionization over a pressure range of 40 - 200 mTorr. We are now adding a fast gas-puff valve to load the propellant, and a ringing pre-ionization circuit (f = 5 Mhz) to better control the plasmoid formation. An alternate coil (8.58 cone angle) will also be used, so as to investigate the effect of coil shape on performance. In addition, a variety of propellants will be used, including hydrogen, nitrogen, and argon. The plasmoid mass and velocity will be measured with a variety of diagnostics, including external B-dot probes and flux loops, a high-speed framing camera, and a HeNe laser interferometer. Internal B-dot probes and a quadruple Langmuir probe will provide additional measurements of the plasmoid shape and structure, as well as density, and will be described in a companion paper. The experimental results will be compared to calculations made using a 0-D coil-gun model and also a 2-D time dependent MHD code.

Martin, Adam↗
NASA NTRS2019

Near Field Probe Measurements in the Plume of a NEXT Ion Thruster

Due to the extremely long lifetime and ground testing complications, such as facility backpressure effects, modeling is a necessary tool for validating mission lifetime requirements. Both NASA's Glenn Research Center and Jet Propulsion Laboratory have developed lifetime validation models for the NEXT ion thruster. The largest uncertainties in these models are due to unknown plasma properties, such as plasma potential, that occur very near to the grid. Previous studies have made measurements in the mid to far field. Here, we make very near field measurements of the plasma properties in the ion beam within 0.1 thruster radii of the grid using various probes. Emissive and triple Langmuir probes are swept through the plume to spatially resolve plasma potential, electron temperature and ion density very near to the grid. The goal is to provide refined inputs to the lifetime modeling efforts and increase the accuracy of the models.

Arthur, Neil↗
NASA NTRS2001

Propulsion Instruments for Small Hall Thruster Integration

Planning and development are underway for the propulsion instrumentation necessary for the next AFRL electric propulsion flight project, which includes both a small Hall thruster and a micro-PPT. These instruments characterize the environment induced by the thruster and the associated data constitute part of a 'user's manual' for these thrusters. Several instruments probe the back-flow region of the thruster plume, and the data are intended for comparison with detailed numerical models in this region. Specifically, an ion probe is under development to determine the energy and species distributions, and a Langmuir probe will be employed to characterize the electron density and temperature. Other instruments directly measure the effects of thruster operation on spacecraft thermal control surfaces, optical surfaces, and solar arrays. Specifically, radiometric, photometric, and solar-cell-based sensors are under development. Prototype test data for most sensors should be available, together with details of the instrumentation subsystem and spacecraft interface.

ion probes↗
NASA NTRS1972

Current to a moving cylindrical electrostatic probe

The current collection characteristics of a moving cylindrical Langmuir probe are evaluated for a range of probe speeds and potentials which are applicable to earth and planetary measurements. The current expressions derived include the cases of the general accelerated current, sheath area limited current, orbital motion limited current, and retarded current. For the orbital motion limited current, a simple algebraic expression is obtained which includes and generalizes the Mott-Smith and Langmuir expressions for both a stationary probe and a rapidly moving probe. For a rapidly moving probe a single formula adequately represents both the accelerated and the retarded current.

Hoegy, W. R.↗
NASA NTRS1973

Current to a moving cylindrical electrostatic probe

The current collection characteristics of a moving cylindrical Langmuir probe are evaluated for a range of probe speeds and potentials which are applicable to earth and planetary measurements. The current expressions derived include the cases of the general accelerated current, sheath area limited current, orbital motion limited current, and retarded current. For the orbital motion limited current, a simple algebric expression is obtained which includes and generalizes the Mott-Smith and Langmuir expressions for both a stationary probe and a rapidly moving probe. For a rapidly moving probe, a single formula adequately represents both the accelerated and the retarded current.

Hoegy, W. R.↗