Search NASA⌕ Search

SEARCH · Search NASA

Results for “Near-field”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1987

Operational performance of vapor-screen systems for in-flight visualization of leading-edge vortices on the F-106B aircraft

A flight research program was undertaken at the NASA Langley Research Center to apply the vapor-screen technique, widely used in wind tunnels, to an aircraft. The purpose was to obtain qualitative and quantitative information about near-field vortex flows above the wings of fighter aircraft and ascertain the effects of Reynolds and Mach numbers over the angle-of-attack range. The hardware for the systems required for flight application of the vapor-screen technique was successfully developed and integrated. Details of each system, its operational performance on the F-106B aircraft, and pertinent aircraft and environmental data collected are presented.

Lamar, John E.↗
NASA NTRS1986

The flame structure and vorticity generated by a chemically reacting transverse jet

An analytical model describing the behavior of a turbulent fuel jet injected normally into a cross flow is developed. The model places particular emphasis on the contrarotating vortex pair associated with the jet, and predicts the flame length and shape based on entrainment of the oxidizer by the fuel jet. Effects of buoyancy and density variations in the flame are neglected in order to isolate the effects of large-scale mixing. The results are compared with a simulation of the transverse reacting jet in a liquid (acid-base) system. For a wide range of ratios of the cross flow to jet velocity, the model predicts flame length quite well. In particular, the observed transitional behavior in the flame length between cross-flow velocity to jet velocity of orifice ratios of 0.0 to 0.1, yielding an approximate minimum at the ratio 0.05, is reproduced very clearly by the present model. The transformation in flow structure that accounts for this minimum arises from the differing components of vorticity dominant in the near-field and far-field regions of the jet.

Karagozian, A. R.↗
NASA NTRS1986

Optical fiber characteristics and standards; Proceedings of the Meeting, Cannes, France, November 25-27, 1985

Papers are presented on outside vapor deposition, the plasma activated CVD process for large scale production of telecommunication fibers, axial lateral plasma deposition technology from plastic clad silica, coatings for optical fibers, primary coating characterization, and radiation-induced time dependent attenuation in a fiber. Topics discussed include fibers with high tensile strength, the characteristics and specifications of airborne fiber optic components, the baseband frequency response of multimode fibers, and fibers for local and broadband networks. Consideration is given to industrial measurements for single mode and multimode fibers, the characterization of source power distribution in a multimode fiber by a splice offset technique, the measurement of chromatic dispersion in a single mode optical, and the effect of temperature on the refracted near-field optical fiber profiling technique.

Bouillie, Remy↗
NASA NTRS1986

The AXAF technology mirror assembly program - An overview

The manufacture and testing of the Technology Mirror Assembly (TMA), a prototype Wolter I telescope scaled to the dimensions of the innermost element of the High-Resolution Mirror Assembly for the NASA Advanced X-ray Astrophysics Facility (AXAF), are reviewed. Consideration is given to the grinding, polishing, coating, and assembly of the zerodur TMA blanks, the TMA mount design, and the test procedures used at the MSFC X-ray Calibration Facility. Test results indicate FWHM resolution less than 0.5 arcsec, but with significant near-field scattering attributed to ripple; further long-lap polishing is suggested.

Wyman, Charles L.↗
NASA NTRS1987

The near field behavior of turbulent gas jets in a long confinement

The near-field behavior of a turbulent gas jet (8.73 mm in diameter) in a long confinement was studied using a test rig with a confinement area ratio of about 205 and a length-to-jet diameter ratio of about 1700. Experiments were carried out with CO2, air, and He/air jets at different jet velocities, using a laser Doppler velocimeter for velocity and turbulence measurements and hot-wire anemometers for a detailed examination of the turbulent shear field of an air jet. The air column inside the tunnel was seen to be first compressed by the jet and then to be slowly pushed out of the tunnel, causing the jet to spread rapidly and to decay quickly. As a result, an equilibrium turbulence field is established in the first two diameters of the jet which bears a similarity to that found in self-preserving turbulent free jets and jets in short confinement. However, in contrast to the cases of the two latter jet types, the near field of jets in a long confinement is independent of jet fluid densities and velocities.

So, Ronald M. C.↗
NASA NTRS1987

Near fields in the vicinity of pulsed electron beams in space

Most measurements of the radio frequency emissions from artificial electron beams in space have been made in close proximity to the beam. This paper presents theory and results for the near-field radiation associated with the operation of a pulsed electron beam, taking into account the effects of the ionospheric plasma. The beam is modeled as an infinite train of square-wave pulses and the radiation is obtained by adding coherently the radiation from each individual electron in the idealized helical trajectory assumed by the beam as it traverses the magnetized plasma. The mathematical solution is obtained by taking the Fourier transform in space and time of Maxwell's equations and the driving modulated beam current, and then taking the inverse transform of the resulting electric field. Typical electric field strengths are presented for a range of modulation frequencies extending from below the ion cyclotron to the electron cyclotron frequency.

Harker, K. J.↗
NASA NTRS1987

Dual laser diode array emission coherently summed in an external cavity

The output power from two ten-element laser diodes arrays has been efficiently summed in an external cavity to obtain a coherent, continuous wave beam. In this technique, laser emission from each front surface antireflection coated diode array is stimulated by injection of emission from a second such array. This method was also applied to single-element diode lasers. The output beam characteristics such as spectral distribution, far-field and near-field beam patterns, and overall efficiency have been measured.

Hemmati, Hamid↗
NASA NTRS1987

Optical emission from coupled surface plasmons

Surface plasmons on opposite sides of a thin metal film surrounded by identical dielectrics interact to form coupled surface plasmons (CSP's). Corrugation of the metal film permits interaction of the CSP's with the radiation field. This paper reports the observation of optical emission from CSP's excited by the near-field coupling of molecules adjacent to a corrugated thin metal film embedded in photoresist.

Gruhlke, R. W.↗
NASA NTRS1987

Nonuniform sampling techniques for antenna applications

A two-dimensional sampling technique, which can employ irregularly spaced samples (amplitude and phase) in order to generate the complete far-field patterns is presented. The technique implements a matrix inversion algorithm, which depends only on the nonuniform sampled data point locations and with no dependence on the actual field values at these points. A powerful simulation algorithm is presented to allow a real-life simulation of many reflector/feed configurations and to determine the usefulness of the nonuniform sampling technique for the copolar and cross-polar patterns. Additionally, an overlapped window concept and a generalized error simulation model are discussed to identify the stability of the technique for recovering the field data among the nonuniform sampled data. Numerical results are tailored for the pattern reconstruction of a 20-m offset reflector antenna operating at L-band. This reflector is planned to be used in a proposed measurement concept of large antenna aboard the Space Shuttle, whereby it would be almost impractical to accurately control the movement of the Shuttle with respect to the RF source in prescribed directions in order to generate uniform sampled points. Also, application of the nonuniform sampling technique to patterns obtained using near-field measured data is demonstrated. Finally, results of an actual far-field measurement are presented for the construction of patterns of a reflector antenna from a set of nonuniformly distributed measured amplitude and phase data.

Rahmat-Samii, Yahya↗
NASA NTRS1987

Single longitudinal mode operation of semiconductor laser arrays with etalon feedback

The multiple longitudinal mode output of high-power diode-laser arrays is converted into single mode with 97 percent efficiency by optical feedback from a thin (less than 200-micron thick) etalon external to the laser. The coupled cavities formed by addition of the etalon favor a single longitudinal mode. Single-mode operation is retained at 0.1 MHz pulsed rates. Both the near-field and the far-field patterns of the laser array remain nearly unchanged while the array operates in a single longitudinal mode.

Hemmati, H.↗
NASA NTRS1987

Investigation of low-speed turbulent separated flow around airfoils

Described is a low-speed wind tunnel experiment to measure the flowfield around a two-dimensional airfoil operating close to maximum lift. Boundary layer separation occurs on the upper surface at x/c=0.85. A three-component laser velocimeter, coupled with a computer-controlled data acquisition system, was used to obtain three orthogonal mean velocity components and three components of the Reynolds stress tensor in both the boundary layer and wake of the airfoil. Pressure distributions on the airfoil, skin friction distribution on the upper surface of the airfoil, and integral properties of the airfoil boudary layer are also documented. In addition to these near-field flow properties, static pressure distributions, both upstream and downstream from the airfoil and on the walls of the wind tunnel, are also presented.

Wadcock, Alan J.↗
NASA NTRS1987

Monitoring biological impacts of space shuttle launches from Vandenberg Air Force Base: Establishment of baseline conditions

Space shuttle launches produce environmental impacts resulting from the formation of an exhaust cloud containing hydrogen chloride aerosols and aluminum oxide particulates. Studies have shown that most impacts occur near-field (within 1.5 km) of the launch site while deposition from launches occurs far-field (as distant as 22 km). In order to establish baseline conditions of vegetation and soils in the areas likely to be impacted by shuttle launches from Vandenberg Air Force Base (VAFB), vegetation and soils in the vicinity of Space Launch Complex-6 (SLC-6) were sampled and a vegetation map prepared. The areas likely to be impacted by launches were determined considering the structure of the launch complex, the prevailing winds, the terrain, and predictions of the Rocket Exhaust Effluent Diffusion Model (REEDM). Fifty vegetation transects were established and sampled in March 1986 and resampled in September 1986. A vegetation map was prepared for six Master Planning maps surrounding SLC-6 using LANDSAT Thematic Mapper imagery as well as color and color infrared aerial photography. Soil samples were collected form the 0 to 7.5 cm layer at all transects in the wet season and at a subsample of the transects in the dry season and analyzed for pH, organic matter, conductivity, cation exchange capacity, exchangeable Ca, Mg, Na, K, and Al, available NH3-N, PO4-P, Cu, Fe, Mn, Zn, and TKN.

Schmaizer, Paul A.↗
NASA NTRS1987

Snow property measurements correlative to microwave emission at 35 GHz

Snow microstructure, measured by plane section analysis, and snow wetness, measured by the dilution method, are used to calculate input parameters for a microwave emission model that uses the radiative transfer method. The scattering and absorbing properties are calculated by Mie theory. The effects of different equivalent sphere conversions, adjustments for near-field interference, and different snow wetness characterizations are compared for various snow conditions. The concentric shell geometry of liquid water in snow yields higher emissivities and better model results than the separate-sphere configuration for liquid water contents greater than 0.05, while at lower liquid water contents the separate-sphere treatment gives better results.

Davis, Robert E.↗
NASA NTRS1987

Low-frequency rotational noise in closed-test-section wind tunnels

The effects of closed-section wind-tunnel walls on the sound field radiated from a helicopter rotor are investigated by means of numerical simulations, summarizing the findings reported by Mosher (1986). The techniques used to model the rotor and the test section (including geometry, wall absorption, and measurement location) are outlined, and the results are presented in extensive tables and graphs. It is found that first-harmonic acoustic measurements obtained in a hard-walled wind tunnel twice as wide as the rotor diameter do not accurately represent the free-field rotational noise, that the relationship between the sound-pressure levels in the wind tunnel and in the free field is complex, that multiple near-field measurements are needed to characterize the direct acoustic field of the rotor, and that absorptive linings are of little value in enlarging the accurate-measurement zone.

Mosher, Marianne↗
NASA NTRS1987

Observations and consequences of nonuniform aluminum concentrations in the channel regions of AlGaAs channeled-substrate-planar lasers

Compositional changes in the n-clad layer within the channel region of channel substrate planar (CSP) type semiconductor lasers have been observed. As a consequece, a large optical cavity (LOC) or an enhanced substrate loss (ESL) version of the CSP geometry may result, both of which may have significantly different characteristics from those of a conventional CSP laser. The CSP-LOC generally has a larger near-field spot size, while the ESL-CSP is characterized by an off-axis, asymmetric far-field pattern.

Evans, Gary A.↗
NASA NTRS1987

A VLSI Processor Engine to Support Calculation of the Vector Wave Equation

The development of a VLSI processor engine tailored to support computation of the near-field vector wave equation (VWE) is presented. Calculation of the near field is essential for evaluation of the electromagnetic fields generated by a complex radiating structure. The processor engine presented is optimized such that it takes advantage of the extensive parallelism inherent in the computational algorithm. The utilization of very large scale integration (VLSI) circuit technology and a customized reduced instruction set computer (RISC) architecture support development of a system of these processor engines, each of which is capable of performing the VWE algorithm calculation. By taking maximum advantage of the parallelism present in the calculation and dividing the problem among an array of these processor engines, the calculation can be computed in a realistic time frame.

J W Degroat↗
NASA NTRS1987

Properties of a half-delta wing vortex

The mean flow and turbulence structure of a single longitudinal vortex generated by a half-delta wing placed at a small angle of attack were investigated. Particular consideration was given to the near-field properties of the generator in order to establish the role of the generator wake in the initial rolling-up of the vortex, as well as to the far-field properties so that the approach to equilibrium could be studied. Measurements were made on fine cross-plane grids at seven streamwise locations using hot cross wires. The results show that the point of maximum vorticity and the generator wake do not merge until a streamwise distance equivalent to three generator heights is reached. Comparison with previous data on vortices produced by double-branched generators confirmed that the present vortex had achieved a fully developed state, and at a relatively short streamwise distance.

Mehta, Rabindra D.↗
NASA NTRS1987

Alternative methods for computing sound radiation from vibrating surfaces

The merits of various numerical and experimental methods for computing sound fields radiated from vibrating structures are examined. The finite difference method, the finite element method, direct boundary element method, indirect boundary element near-field acoustic holography, two-microphone methods, and spatial transformation of sound fields are considered. The proper utilization of the methods is discussed.

Bernhard, R. J.↗