SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Voltage regulator alternately connects an inductor in parallel and in series with the input voltage source. This flyback voltage regulator provides a regulated dc voltage to varying loads from a varying dc supply and gives fast response to load and supply changes.
Dual-pressure regulator uses single reference for parallel control of two gases. The regulator uses an external fluid pressure to modulate the flow of one gas, and the regulated flow of the first gas to modulate the flow of the second.
High impact pressure regulator used with a high impact gas scannograph withstands impacts of over 15,000 g. By the passage of fluid through the first and second chambers of the regulator, the pressure of the scannograph is regulated from a specific input valve to the desired output pressure valve.
Single-ended step-up regulator-chopper power supply /employing conventional chopper circuitry/ combines the advantages of the chopper and switching regulator circuits. Schematic of the power supply incorporating the step-up regulator is shown.
Regulator requires minimum amount of power for voltage division and it is not required continuously. The only power loss, except for regulating purposes, is that needed to provide for imbalances in load current requirements. For balanced loads, only leakage current flows through regulating transistors.
Interplanetary Monitoring Probe (IMP) spacecrafts H, I, and J utilize a direct energy transfer (DET) type of power system operating from a solar array source. A shunt type of regulator prevents the bus voltage from exceeding a preset voltage level. The power system utilizes a single differential amplifier with dual outputs to control the battery charge/shunt regulator and the discharge regulator. A two-voltage level, current limited, series charger and a current sensor control battery state of charge of the silver-cadmium battery pack. Premature termination of the battery charge is prevented by a power available gate that also initiates charge current to the battery upon availability of excess power.
Most of the results of singular perturbation theory have been concerned with initial value problems whereas optimal control problems are of two-point boundary value type. The portions of this theory applicable to the open loop state regulator problem are reviewed. For obtaining approximate solutions to the state regulator problem the method of matched asymptotic expansions is employed. This method has been developed in connection with certain fluid mechanics problems and is applicable to nonlinear as well as linear problems. It has been found in the past to be advantageous not to formulate this method generally but to apply it to each individual problem and this approach is adopted here. A general recipe for the method is given and its application is illustrated by using the method to obtain an approximate solution to a simple, specific state regulator problem.
The design concept for the TWT amplifier converter for possible use in the Thermoelectric Outer Planet Spacecraft (TOPS) is presented. An unusual combination of semiconductors and magnetics was utilized to achieve very stable voltage regulation on a number of separate outputs to satisfy the requirements of a high-power TWT, and at the same time operate at an efficiency of better than 90% from a 30-V source. The circuitry consists of an output filter, an auxiliary Jensen oscillator driving a high-reactance transformer to provide current limiting to the heater, a variable time delay, a main Jensen oscillator driving the power transformer with a maximum step-up ratio of 120 to 1, and series transistorized post regulators to provide precise voltage adjustment and low output impedance. This paper discusses the design of the high-reactance transformer and the high step-up ratio transformer, as well as the high-voltage series regulators that are limited in range and operate at the top of the unregulated output voltage. Test data are presented, and details of current transients caused by charging the filter circuits, input current ripple, and output voltage ripples are considered.
Valve features precise gas-pressure regulation and shuts off flow by remote control. Valve is made up of regulator valve cavity and spring-compression adjusts cavity. Elements in regulator cavity are conventional and include high-pressure inlet, ball which mates with seat, push rod, and pressure-sensing diaphragm.
The present work describes the design of a 10-kHz, 500-W switching buck type regulator used as a line regulator in a power conditioner for an ion thruster. The frequency response of the switching regulator had to be raised beyond the resonant frequency of the output LC filter to produce a positive total network impedance and prevent negative resistance oscillation. Analysis of this stability problem is given.
Female rats approximately 6 mo old were chronically centrifuged for up to 30 days at 2.76 G or 3.18 G and sacrificed at intervals for body-composition study. Both fat and the fat-free body mass (FFBM) were reduced during the 1st wk of centrifugation, with the fat showing considerably more variation both within and between groups. The FFBM was reduced below control level to the same extent in rats fed commercial chow, a high-fat diet, or a high-protein diet or in rats prefasted to produce a body-mass deficit at the start of centrifugation. There were no centrifugation-associated changes in body water content. It was concluded that body fat showed no evidence of regulation, FFBM is regulated at any constant level of acceleration between 1 and 4.15 G, and the change in FFBM induced by a change in acceleration is probably not regulated.
The space storable propulsion module is an advanced high performance (375 seconds Isp minimum) planetary spacecraft propulsion system with a mission life of 5-10 years. The propellants used are liquid fluorine and amine fuel. This application requires high pressure regulator accuracy to optimize propellant depletion characteristics. An advanced regulator concept was prepared which is compatible with both fuel and oxidizer and which features design concepts such as redundant bellows, all-metallic/ceramic construction, friction-free guidance of moving parts and gas damping. Computer simulation of the propulsion module performance over two mission profiles indicated satisfactory minimization of those propellant residual requirements imposed by regulator performance variables.
Method of regulating voltage-multiplier dc-dc converter utilizes regulating circuit that directly controls only fraction of input voltage, resulting in lightweight, efficient regulator.
A concept for regulating the voltage of a solar array by using a microprocessor to effect discrete voltage changes was demonstrated. Eight shorting switches were employed to regulate a simulated array at set-point voltages between 10,000 and 15,000 volts. The demonstration showed that the microprocessor easily regulated the solar array output voltage independently of whether or not the switched cell groups were binary sized in voltage. In addition, the microprocessor provided logic memory capability to perform additional tasks such as locating and insolating a faulty switch.
Parameters controlled in design determine the stability of hydraulic pressure regulators in service. The non-linear sensing line restrictor can provide stability, but degrades the transient response. Linear damping is not always physically realizable and is sensitive to clearance and viscosity. Design relationships are analytically derived through which regulators can be made to be stable without the use of either of these damping means. The analytical distinctions between the parameters derived and those in prior literature are discussed. An analytically derived circuit component that stabilizes an otherwise unstable regulator and its experimental verification is described.
Optimal regulator technique was compared for determining simulator control system gains with the conventional servo analysis approach. Practical considerations, associated with airborne motion simulation using a model-following system, provided the basis for comparison. The simulation fidelity specifications selected were important in evaluating the relative advantages of the two methods. Frequency responses for a JetStar aircraft following a roll mode model were calculated digitally to illustrate the various cases. A technique for generating forward loop lead in the optimal regulator model-following problem was developed which increases the flexibility of that approach. It appeared to be the only way in which the optimal regulator method could meet the fidelity specifications.
An apparatus for regulating pressure of treatment fluid during ophthalmic procedures is described. Flow sensing and pressure regulating diaphragms are used to modulate a flow control valve. The pressure regulating diaphragm is connected to the flow control valve to urge the valve to an open position due to pressure being applied to the diaphragm by bias means such as a spring. The flow sensing diaphragm is mechanically connected to the flow control valve and urges it to an opened position because of the differential pressure on the diaphragm generated by a flow of incoming treatment fluid through an orifice in the diaphragm. A bypass connection with a variable restriction is connected in parallel relationship to the orifice to provide for adjusting the sensitivity of the flow sensing diaphragm. A multiple lever linkage system is utilized between the center of the second diaphragm and the flow control valve to multiply the force applied to the valve by the other diaphragm and reverse the direction of the force.
State and local regulation of power plant construction and operation of solar power satellite (SPS) receiving stations is presented. Each receiving antenna station occupies a land area 100-200 km square, receives microwave transmissions from the solar power satellite, and converts them into electricity for transmission to the power grid. The long lead time associated with the SPS and the changing status of state and local regulation dictated emphasis on: generic classification of the types of regulation, and identification of regulatory vectors which affect rectenna facilities.