Search NASA⌕ Search

SEARCH · Search NASA

Results for “Redirect”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1948

Experimental investigation of the aerodynamic effects of distributed spanwise blowing on a fighter configuration

The results of wind tunnel tests at NASA Langley targeted at the performance and configurational characteristics of 0.1 and 0.13 scale model spanwise blowing (SWB) jet wing concepts are reported. The concept involves redirection of engine compressor bleed air to provide SWB at the fuselage-wing juncture near the wing leading edge. The tests covered the orientation of the outer panel nozzles, the effects of SWB operation on the performance of leading and trailing edge flaps and the effects of SWB on lateral stability. The trials were run at low speeds and angles of attack from 24-45 deg (landing). Both lift and longitudinal stability improved with the SWB, stall and leading edge vortex breakdown were delayed and performance increased with the SWB rate. Lateral stability was degraded below 20 deg angle of attack while instabilities were delayed above 20 deg due to roll damping.

Huffman, J. K.↗
NASA NTRS1985

Spectrophotovoltaic Power Generation

Optical Components of spectrophotovoltaic system concentrate light from Sun and redirect short-wavelength portion of spectrum to solar cell having large gap in energy band (gallium arsenide cell). Longer-wavelength portion of spectrum passes through beam splitter to cell with smaller gap in energy band (silicon band). Available energy in Sunlight thus exploited more fully and, improvements in energy-conversion efficiency possible.

Knowles, G.↗
NASA NTRS1985

Modeling of transient heat pipe operation

The overall goal is to gain a better understanding of the transient behavior of heat pipes operating under both normal and adverse conditions. Normal operation refers to cases where the capillary structure remains fully wetted. Adverse operation occurs when drying, re-wetting, choking, noncontinuum flow, freezing, thawing etc., occur within the heat pipe. The work was redirected towards developing the capability to predict operational behavior of liquid metal heat pipes used for cooling aerodynamic structures. Of particular interest is the startup of such heat pipes from an initially frozen state such as might occur during re-entry of a space vehicle into the Earth's atmosphere or during flight of hypersonic aircraft.

Colwell, G. T.↗
NASA NTRS1984

Circulation control technology applied to propulsive high lift systems

Technology developed for the Circulation Control Wing high-lift system has been extended to augment lift by entraining and redirecting engine thrust. Ejecting a thin jet sheet tangentially over a small curved deflecting surface adjacent to the slipstream of a turbofan engine causes the slipstream to flow around that deflecting surface. The angle of deflection is controlled pneumatically by varying the momentum of the thin jet sheet. The downward momentum of the slipstream enhances wing lift. This concept of pneumatically deflecting the slipstream has been applied to an upper surface blowing high-lift system and to a thrust deflecting system. The capability of the pneumatic upper surface blowing system was demonstrated in a series of investigations using a wind tunnel model and the NASA Quiet Short-haul Research Aircraft (QSRA). Full-scale thrust deflections greater than 90 deg were achieved. This mechanically simple system can provide increased maneuverability, heavy lift or overload capability, or short takeoff and landing performance.

Englar, R. J.↗
NASA NTRS1986

Isolated and interacting round parallel heated jets

An experimental study of the flowfield of heated and unheated single and dual jet configurations was performed. This study of two parallel jets is unique since most previous aerodynamic structure experiments were limited to single round and two-dimensional jets. The present closely spaced dual jet geometry was motivated by the potential jet noise reduction available from this configuration. This geometry has shown promise as a method for redirecting jet noise away from ground based observers in side by side or over/under turbofan engine mountings on aircraft (Simonich et al., 1984). Since the effectiveness of this noise reduction technique is based on the existence of two independent jets, an understanding of the aerodynamics of the merging process is essential to establishing the acoustic benefits. The experimental program was structured so that Mach number, jet exit temperature, and spacing to diameter ratios could be independently varied to isolate each effect.

Simonich, J. C.↗
NASA NTRS1986

Using a laser aureole to invert lidar return

An aureole generated by a laser beam was studied. The strength of the signal redirected towards a sensor high above the surface by a combination of one scattering event in the marine boundary layer (mbl) and one single reflection event from the ocean surface was estimated. A model of mbl aerosol size distributions was used to estimate Mie scattering for a wide range of meteorolocial conditions. The sea surface reflection was determined from a Gaussian model of the wave slopes. These laser aureoles which were estimated over the wide range of conditions and were normalized by the reflected laser light were found to be highly correlated with the optical depth of the boundary layer. By estimating optical depth from the aureole, the Bernoulli-Riccati inversion of lidar return could be constrained and the inversion accuracy improved. A Monte Carlo program was developed to study the laser aureole generated by up to 8 orders of reflection and scattering. The aureole was generated by a narrow, 10 nsec laser pulse at 1.06 microns and measured by a receiver 10 km above the ocean surface. The original theoretical computation compared well with the Monte Carlo method. When multiple scattereffects were included, the normalized aureole was still highly correlated with the mbl optical depth over the range of conditions.

Hooper, W. P.↗
NASA NTRS1987

Source-specular-reflector-sensor solid angles

A formula is derived that describes the size of the solid angle within which must be the normal to a flat specular reflector, if such a reflector is to redirect light from a small but finite extended source to a small but finite extended detector. The formula assumes the rules of geometrical optics and does not account for the effects of diffraction.

Vanderbilt, V. C.↗
NASA NTRS1988

Interactive Plotting Program

Interactive Plotting Program (IAP) provides fast and easy method of plotting data in presentable format. Extensive plot editing done with various IAP commands, typed interactively from terminal or read from batch command files. Ability to redirect output to variety of devices enables user to tailor plots with graphics terminal before printing. Designed to allow addition or deletion of code for any type of terminal or plotting device. Written in FORTRAN 77 and Assembler.

Moore, Judith G.↗
NASA NTRS1988

Multitemperature Cryogenic Radiative Cooler

Multiple radiator stages separated by V-groove shields protect main cooler from parasitic heat radiation and offer usable cooling themselves. Proposed cryogenic radiative cooler achieves lower temperatures previously possible with passive radiators in space. Provides useful cooling power at several temperatures instead of one. Cold-radiator stage protected by multiple shield assemblies intercepting radiation heat leaks from warmer supporting structure and redirects it out to space. Each shield assembly has effective cooling capacity enabling it to cool optical filter.

Bard, Steven↗
NASA NTRS1987

Alternative cometary targets for the Giotto extended mission

The plan to use an Earth gravity-assist maneuver to redirect the Giotto spacecraft toward Comet Grigg-Skjellerup (GS) for an encounter in July 1992, and 2 additional cometary opportunities are discussed. The first is an encounter with Comet Hartley-2 (H2) in Aug., 1991. The H2 is intrinsically brighter than GS and the encounter would take place much closer to the Earth. The other potential target is Comet du Toit-Hartley (DTH), which is of considerable scientific interest because it split into 2 pieces during its 1979 apparition. Ths GS and H2 missions are the most viable; DTH is eliminated because its aphelion of transfer orbit and Sun distance at encounter (both 1.2 AU) are incompatible with Giotto's degraded thermal insulation.

Farquhar, R. W.↗
NASA NTRS1987

The laser elevator - Momentum transfer using an optical resonator

In a conventional laser lightsail system the payload is propelled by the momentum imparted to it by the reflection of a laser beam without the use of any propellant. Because of the unfavorable relationship between energy and momentum in a light beam, these systems are very inefficient. The efficiency can be greatly improved, in principle, if the photons that impact the payload mirror are returned to the source and then redirected back toward the payload again. This system, which recirculates the laser beam, is defined as the 'laser elevator'. The gain of the laser elevator over conventional lightsails depends on the number of times the beam is recycled which is limited by the reflectance of the mirrors used, any losses in the transmission of the beam, and diffraction. Due to the increase pathlength of the folded beam, diffraction losses occur at smaller separations of the payload and the source mirror than for conventional lightsail system. The laser elevator has potential applications in launching to low earth orbit, orbital transfer, and rapid interplanetary delivery of small payloads.

Meyer, Thomas R.↗
NASA NTRS1987

Flow in out-of-plane double S-bends

An experimental investigation of developing flows through a combination of out-of-plane S-bend ducts was conducted to gain insight into the redirection of flow in geometries similar to those encountered in practical aircraft wing-root intake ducts. The present double S-bend was fabricated by placing previously investigated S-ducts and S-diffusers in series and with perpendicular planes of symmetry. Laser-Doppler anemometry was employed to measure the three components of mean velocity, the corresponding rms quantities, and Reynolds stresses in the rectangular cross-section ducts. Due to limited optical access, only two mean and rms velocity components were resolved in the circular cross-section ducts. The velocity measurements were complemented by wall static pressure measurements. The data indicates that the flows at the exit are complex and asymmetric. Secondary flows generated by the pressure field in the first S-duct are complemented or counteracted by the secondary flows produced by the area expansion and the curvature of the S-diffuser. The results indicate the dominance of the inlet conditions and geometry upon the development of secondary flows and demonstrate that the flows are predominantly pressure-controlled. The pressure distribution caused by the duct geometry determines the direction and magnitude of the bulk flow while the turbulence dictates the mixing characteristics and profiles in the near wall region.

Schmidt, M. C.↗
NASA NTRS1989

A segmented mirror antenna for radiometers

An antenna is designed for the radiometer application of the planned NASA Earth Science Geostationary Platforms in the 1990's. The antenna consists of two parts: a regular parabolic dish of 5 meters in diameter which converts the radiation from feeds into a collimated beam, and a movable mirror that redirects the beam to a prescribed scan direction. The mirror is composed of 28 segmented planar conducting plates, mostly one square meter in size. The secondary pattern of the antenna was analyzed based on a physical optics analysis. For frequencies between 50 and 230 GHz, and for a scan range of + or -8 deg (270 beamwidths scan at 230 GHz), the worst calculated beam efficiency is 95 percent. To cover such a wide frequency and scan range, each of the 28 plates is individually controlled for a tilting less than 4 deg, and for a sliding less than 0.5 cm. The sliding is done at discrete steps. At 230 GHz, a step size of 2 mil is sufficient. The plate positions must be reset for each frequency and for each scan direction. Once the position is set, the frequency bandwidth of the antenna is very narrow.

Lee, S. W.↗
NASA NTRS1988

Trajectories for the Sakigake extended-mission phase

The trajectory profile that will be used by Japan's Sakigake spacecraft to accomplish its extended-mission objectives is described. Currently, Sakigake is following a heliocentric trajectory that will return to the earth's vicinity in January 1992. Four earth gravity-assist maneuvers are planned to redirect Sakigake to an encounter with Comet Honda-Mrkos-Pajdusakova (HMP) in February 1996. While carrying out the earth-swingby maneuvers, the spacecraft will make several passes through previously unexplored regions of the distant geomagnetic tail.

Farquhar, R.↗
NASA NTRS1989

New energy conversion techniques in space, applicable to propulsion

The powering of aircraft with laser energy from a solar power satellite may be a promising new approach to the critical problem of the rising cost of fuel for aircraft transportation systems. The result is a nearly fuelless, pollution-free flight transportation system which is cost-competitive with the fuel-conservative airplane of the future. The major components of this flight system include a laser power satellite, relay satellites, laser-powered turbofans and a conventional airframe. The relay satellites are orbiting optical systems which intercept the beam from a power satellite and refocus and redirect the beam to its next target.

Hertzberg, A.↗
NASA NTRS1989

Stratiform clouds and their interaction with atmospheric motions

During the 1987 to 1988 academic year, three projects were finished and plans were made to redirect and focus work in a proposal now being reviewed. The completed work involves study of waves on an equatorial beta-plane in shear flow, investigation of the influence of orography on the index cycle, and analysis of a model of cloud street development in a thermally-forced, sheared environment. The proposed work involves study of boundary layer circulations supporting stratocumulus decks and investigation of how the radiative effects of these clouds modulate larger-scale flows such as those associated with the index oscillation.

Clark, John H. E.↗
NASA NTRS1991

Magnetic Deflection Of Welding Electron Beam

Electron-beam welds inside small metal parts produced with aid of magnetic deflector. Beam redirected so it strikes workpiece at effective angle. Weld joint positioned to where heavy microfissure concentration removed when subsequent machining required, increasing likelihood of removing any weld defects located in face side of electron-beam weld.

Malinzak, R. Michael↗
NASA NTRS1989

Vega-Giotto flyby missions and cometary cosmogony

The most important implication of the Vega/Giotto flyby missions to Halley's Comet for cometary cosmogony is the opportunity to absorb the results of the in-situ measurements as made onboard the spacecrafts. Unfortunately the exploration of ejecta form the nucleus was unable to provide an unambiguous definition of the chemical-mineralogical nature of the nucleus: it failed to provide information comparable to that which was expected from a sample return mission. However, the obtained results are significant enough to affect and redirect cosmogonical thinking. Accordingly, the understanding of the cometary-matter dichotomy is modified as deduced from the distiction of water-dominated volitiles and silicate-based non-volitiles. Organic carbon compounds emerge as a major constituent of cometary nuclei. Presently, it is likely that the revision of Whipple's classic concept of the icy conglomerate cannot be avoided. Affected by the Vega/Giotto flyby missions to Hally's Comet, cometary cosmogony seems to enter a new conceptual period. The results of the in-situ measurements (mass spectrometric, UV spectroscopic, and IR spectroscopic) appear to be of basic importance. A chemical explanation is employed to explain the occurrence inside the nuclei of the variety of species, as inferred from the mass spectrometric data, to predict the results of the processes possibly involved. A cosmochemical factor is postulated to operate behind the observed cometary phenomena. The chemistry of the interstellar medium, covering the circumstellar and interstellar dust, advances cometary cosmogony.

Lang, Bruno↗