SEARCH · Search NASA

Results for “STALLING - PREVENTION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9

All sources NASA NTRS DOE OSTI

NASA NTRS1983

A theory of rotating stall of multistage axial compressors. I - Small disturbances

An analysis is made of rotating stall in compressors of many stages, finding conditions under which a flow distortion can occur which is steady in a traveling reference frame, even through upstream total and downstream static pressure are constant. In the compressor, a pressure-rise hysteresis is assumed. Flow in entrance and exit ducts yield additional lags. These lags balance to give a formula for stall propagation speed. For small disturbances, it is required that the compressor characteristics be flat in the neighborhood of average flow coefficient. Results are compared with the experiments of Day and Cumpsty. If a compressor lag of about twice that due only to fluid inertia is used, predicted propagation speeds agree almost exactly with experimental values, taking into account changes of number of stages, stagger angle, row spacing, and number of stall zones. The agreement obtained gives encouragement for the extension of the theory to account for large amplitudes.

Moore, F. K.↗

NASA NTRS1984

Development and Certification of a New Stall Warning and Avoidance System

Several methods may be employed to improve natural stall characteristics. The method employed on all learjets to obtain improved stall characteristics is a stall warning and avoidance system that employs angle of attack vanes, an electronic computer, a control column shaker motor, and a torquer which drives the control column in a pusher mode to avoid unwanted further buildup of angle of attack. The new system was developed with changes that improve system response with no performance penalty or increase in turbulence sensitivity. The following changes were made included modified system time constants and (alpha) time rate of change of vane angle dead zone and the addition of an alpha signal limiter and an alpha cut out below a specified angle of attack.

Gertsen, W. M.↗

NASA NTRS1985

Nonlinear global stability analysis of compressor stall phenomena

Compressor stall phenomena are analyzed from the point of view of nonlinear control theory, based on bifurcation-catastrophe techniques. This new approach appears promising and offers insight into such well-known compressor instability problems as surge and rotating stall and suggests strategies for recovery. Three interlocking dynamic nonlinear state space models are developed. It is shown that the problem of rotating stall can be viewed as an induced bifurcation of solution of the unstalled model. Hysteresis effects are shown to exist in the stall/recovery process. Surge cycles are observed for some critical parameter values. The oscillatory behavior is seen to be due to development of limit cycles, generated by Hopf bifurcation of solutions. More specifically, it is observed that at certain critical values of parameters, a family of stable limit cycles with growning and then diminishing amplitudes is generated, then giving rise to an unstable family of limit cycles. This unstable family in turn bifurcates into other unstable families. To further illustrate the utility of the methodology, some partial computation of domains is carried out, and parameter sensitivity analysis is performed.

Razavi, H.↗

NASA NTRS1985

Evaluation of a stalled airfoil analysis program

The Stalled Airfoil Analysis Program (SAAP) is a computer code for predicting the aerodynamic characteristics of an airfoil up to, and beyond, stall. SAAP is presently evaluated through comparisons with experiments and with two other theoretical methods over an extensive range of airfoils and Reynolds number conditions. SAAP modeled drag more accurately than either of the other methods, and at angles of attack below stall yielded a smoother lift variation with angle of attack.

Rumsey, C. L.↗

NASA NTRS1985

Simulation of rotating stall by the vortex method

The vortex method, coupled to a boundary-layer solver, is applied to the numerical simulation of high Reynolds number incompressible flow in two-dimensional cascades. Periodic conditions are imposed along the plane of the cascade, with several blades per period. Good agreement is found with two finite-difference methods for a single-blade case. When a staggered cascade is treated with five independent blades, the simulation predicts rotating stall, for a range of angles of attack and stagger, and the essential features of the flow are correct. The stall cell steadily propagates along the cascade. The sensitivity of this phenomenon to two parameters is studied, and the stall boundary is found. Quantitative results and visualizations are presented.

Spalart, P. R.↗

NASA NTRS1988

The effects of compressibility on dynamic stall

In this paper, typical computational predictions and experimental measurements of compressible flow past an airfoil at dynamic stall conditions are studied and compared to develop an insight into the effect of compressibility on dynamic stall. The dependency of the critical Mach number on airfoil leading edge curvature, camber, and angle of attack is investigated. Evidence is presented to show that a local region of supersonic flow occurs on an oscillating airfoil, even for a freestream Mach number as low as 0.2, if the boundary layer remains attached and the angle of attack is sufficiently high; that a shock terminates this local supersonic bubble; and that the vorticity that this shock generates grows rapidly and becomes very unstable as the angle of attack increases beyond the value at which the maximum local flow speed first exceeds the speed of sound. It is suggested that these shock-induced effects compete with the dynamic viscous effects occurring in the boundary layer in determining the onset of separation, which can lead to premature dynamic stall and can significantly reduce the maximum dynamic lift that can otherwise be obtained.

Fung, K.-Y.↗

NASA NTRS1989

Airfoil stall penetration at constant pitch rate and high Reynolds number

The model wing consists of a set of fiberglass panels mounted on a steel spar that spans the 8 ft test section of the UTRC Large Subsonic Wind Tunnel. The first use of this system was to measure surface pressures and flow conditions for a series of constant pitch rate ramps and sinusoidal oscillations a Mach number range, a Reynolds number range, and a pitch angle range. It is concluded that an increased pitch rate causes stall events to be delayed, strengthening of the stall vortex, increase in vortex propagation, and increase in unsteady airloads. The Mach number range causes a supersonic zone near the leading edge, stall vortex to be weaker, and a reduction of unsteady airloads.

Lorber, Peter F.↗

NASA NTRS1989

Toward dynamic separation without dynamic stall

The concept of vorticity separation without dynamic stall is illustrated by flow visualization. A small airfoil with a rotating nose, originally built for the demonstration of static stall control, was placed in a wind tunnel and dynamically pitched. The flow around the airfoil during pitch was successfully visualized and filmed. It exhibited dynamic trailing edge separation of vorticity without leading edge dynamic stall. Diagrams of the airfoil assembly are included.

Freymuth, P.↗

NASA NTRS1989

Compressible studies on dynamic stall

The purpose of this work is to investigate the effects of compressibility on the dynamic stall phenomenon by numerical simulation of the unsteady flow. The full two-dimensional unsteady compressible Navier-Stokes equations are solved for flows over oscillating airfoils and airfoils pitching rapidly to high angles of attack. The free-stream speeds vary from low subsonic with mild compressibility effects, to moderate subsonic where strong compressibility effects appear close to the leading edge at high angles of attack. An Alternating Direction Implicit scheme is implemented for the numerical solution with the viscous terms retained in both directions. The numerical results are compared with available experimental data for a Sikorsky airfoil for compressible high Reynolds number flows. There is good agreement between the computed and measured unsteady lift and pitching moment coefficient time histories. The computed high-speed subsonic unsteady results give a good picture of the entire flow field, and the dynamic stall progression in the compressible flow regime. It was observed that compressibility effects are more severe close to the leading edge at moderate angles of attack, and that the dynamic stall vortex appears at lower angles of attack as the free-stream speed increases.

Ekaterinaris, J. A.↗

NASA NTRS1990

Schlieren studies of compressibility effects on dynamic stall of airfoils in transient pitching motion

Compressibility effects on the flowfield of an airfoil executing rapid transient pitching motion from 0 - 60 degrees over a wide range of Mach numbers and pitching rates were studied using a stroboscopic schlieren flow visualization technique. The studies have led to the first direct experimental documentation of multiple shocks on the airfoil upper surface flow for certain conditions. Also, at low Mach numbers, additional coherent vortical structures were found to be present along with the dynamic stall vortex, whereas at higher Mach numbers, the flow was dominated by a single vortex. The delineating Mach number for significant compressibility effects was 0.3 and the dynamic stall process was accelerated by increasing the Mach number above that value. Increasing the pitch rate monotonically delayed stall to angles of attack as large as 27 degrees.

Chandrasekhara, M. S.↗

NASA NTRS1991

A study of dynamic stall using real time interferometry

Dynamic stall over an oscillating airfoil in compressible flow was studied using a real-time interferometry technique. Instantaneous flow field data was obtained for various unsteady as well as steady flow conditions. Comparison of steady flow interferograms with those taken in unsteady flow reveal a significant delay in the development of leading edge suction peaks in the unsteady case. The interferograms permit detailed analysis of the leading edge pressure field; as many as 13 pressure values have been obtained around the leading edge in the first 1 percent of the airfoil chord. The results offer a significant new insight into the character of the dynamic stall vortex, and the stall delay that is observed during dynamic motions.

Carr, L. W.↗

NASA NTRS1991

Incipient torsional stall flutter aerodynamic experiments on a swept three-dimensional wing

The aerodynamics of small amplitude pitching motions near stall have been studied experimentally in order to improve understanding of the torsional stall flutter problem for propeller blades. A model wing was oscillated in pitch at several small amplitudes over a wide and representative range of conditions. Unsteady surface pressures were measured and integrated to determine the aerodynamic damping at five spanwise stations. Strong negative damping was found for motions centered near static stall for all studied reduced frequencies, Mach numbers, and sweep angles. The 30-deg sweptback configuration was found to become negatively damped over the entire span nearly simultaneously, while the unswept model exhibited local regions of negative damping that moved toward the wing tip as the mean angle of attack was increased.

Lorber, Peter F.↗

NASA NTRS1991

Neural network based expert system for compressor stall monitoring

This research is designed to apply a new information processing technology, artificial neural networks, to monitoring compressor stall. The outputs of neural networks support the dynamic knowledge data base of an expert system. This is the open-loop mode to avoid compressor stall. The integration of a control system with neural networks is the closed-loop mode in stall avoidance. The feasibility of the concept has been demonstrated for the compressor of 16-foot transonic/supersonic propulsion wind tunnels. The construction of a prototpye expert system has been initiated.

Lo, Ching F.↗

NASA NTRS1991

Reattachment studies of an oscillating airfoil dynamic stall flow field

The reattaching flow over an oscillating airfoil executing large amplitude sinusoidal motion around a mean angle of attack of 10 degrees has been studied using the techniques of stroboscopic schlieren, two component laser Doppler velocimetry and point diffraction interferometry, for a free stream Mach number of 0.3 and a reduced frequency of 0.05. The results show that the dynamically stalled flow reattaches in a process that begins when the airfoil is very close to the static stall angle on its downward stroke and progresses over the airfoil through a large range of angles of attack as the airfoil decreases to about 6 degrees. The airfoil suction peak shows a dramatic rise as the static stall angle is approached and the velocity profiles develop such that the flow near the surface is accelerated. The process completes through the disappearance of a separation bubble that forms over the airfoil.

Ahmed, S.↗

NASA NTRS1992

Effects Of Compressibility On Dynamic Stall

Report presents results of computations and measurements of compressible flow about an airfoil, angle of attack of which oscillates about static-stall angle. Study focuses on effects of compressibility on dynamic stall. Of particular interest are conditions determining onset of separation of flow, which leads to premature dynamic stall and consequent significant reduction of lift.

Carr, L. W.↗

NASA NTRS1992

Control of unsteady separated flow associated with the dynamic stall of airfoils

The two principal objectives of this research were to achieve an improved understanding of the mechanisms involved in the onset and development of dynamic stall under compressible flow conditions, and to investigate the feasibility of employing adaptive airfoil geometry as an active flow control device in the dynamic stall engine. Presented here are the results of a quantitative (PDI) study of the compressibility effects on dynamic stall over the transiently pitching airfoil, as well as a discussion of a preliminary technique developed to measure the deformation produced by the adaptive geometry control device, and bench test results obtained using an airfoil equipped with the device.

Wilder, Michael C.↗

NASA NTRS1991

The role of tip clearance in high-speed fan stall

A numerical experiment has been carried out to define the near-stall casing endwall flowfield of a high-speed fan rotor. The experiment used a simulation code incorporating a simple clearance model, whose calibration is presented. The results of the simulation show that the interaction of the tip leakage vortex and the in-pasage shock plays a major role in determining the fan flow range. More specifically, the computations imply that it is the area increase of this vortex as it passes through the in-passage shock, which is the source of the blockage associated with stall. In addition, for fans of this type, it is the clearance over the forward portion of the fan blade which controls the flow processes leading to stall.

Adamczyk, J. J.↗

NASA NTRS1992

Leading edge velocity field of an oscillating airfoil in compressible dynamic stall

Phase-averaged mean-velocity and turbulence data are obtained and analyzed for the leading-edge region of an oscillating airfoil under compressibility conditions. A two-component laser-Doppler velocimetry system was used to make the measurements. Results are compared for the two Mach numbers 0.3 and 0.4 at a reduced frequency of 0.05 with varying airfoil angles of attack. For a Mach number of 0.3, a separation bubble is present on the airfoil throughout the oscillation cycle and no dynamic stall occurs as the peak angle of attack is below the static stall angle. However, a slight imprint of vortical structures is seen in the shear layer enveloping the bubble at the top of the cycle, a result confirmed also by the vorticity contours and in agreement with the earlier stroboscopic schlieren studies. When the Mach number is 0.4, dynamic stall occurs with its origin in the break-up of the separation bubble. Turbulence intensities in the bubble were found to be very large.

Vandyken, R. D.↗