Search NASA⌕ Search

SEARCH · Search NASA

Results for “Skylab”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Digital autopilot for the SKYLAB orbital assembly.

In Project SKYLAB, the Command and Service Module which ferries astronaut crews to and from the Orbital Workshop is required to have the capability of providing attitude control for the entire Orbital Assembly during docked phases of the mission. A digital autopilot has been designed which meets this requirement. It is a direct descendant of the digital autopilot designed for and used extensively in project Apollo. There is a major difference however. For Apollo, it was reasonable to design an autopilot that treated the roll, pitch, and yaw axes independently. Because of the geometry of the Orbital Assembly, however, it is of considerable advantage to design the jet selection logic for SKYLAB such that the roll and pitch axes are treated as coupled, and also that the roll and yaw axes are treated as coupled. This paper discusses how inter-axis dependence has been incorporated in the Command and Service Module's digital autopilot while working within the limitations of the onboard computer.

Turnbull, J. F.↗
NASA NTRS1972

Passive stability of a spinning Skylab.

The results of an analytical investigation of the rotational dynamics of a spinning Skylab space station are presented. The passive stability of motion of a simplified model consisting of a rigid core body with two attached flexible appendages is investigated. The parameter plane stability technique is applied to the specific Skylab case to determine its transient response to external disturbances.

Seltzer, S. M.↗
NASA NTRS1970

Skylab program CSM verification analysis report

The application of the SINDA computer program for the transient thermodynamic simulation of the Apollo fuel cell/radiator system for the limit condition of the proposed Skylab mission is described. Results are included for the thermal constraints imposed upon the Pratt and Whitney fuel cell power capability by the Block 2 EPS radiator system operating under the Skylab fixed attitude orbits.

Schaefer, J. L.↗
NASA NTRS1973

Skylab experiments. Volume 2: Remote sensing of earth resources

This volume covers the broad area of earth resources in which Skylab experiments will be performed. A brief description of the Skylab program, its objectives, and vehicles is included. Section 1 introduces the concept and historical significance of remote sensing, and discusses the major scientific considerations involved in remotely sensing the earth's resources. Sections 2 through 6 provide a description of the individual earth resource sensors and experiments to be performed. Each description includes a discussion of the experiment background and scientific objectives, the equipment involved, and a discussion of significant experiment performance areas.

Source record↗
NASA NTRS1972

The earth resources experiment package on Skylab and proposed resource investigations.

In late 1973, NASA plans to launch a three-man experimental space station, the Skylab Workshop. Technical specifications regarding the instrumental facilities of the space station are presented, giving attention to the multispectral photographic facility, the IR spectrometer, the multispectral scanner, the L-band radiometer, and the S-193 sensor. The S-193 sensor will provide data applicable to studying varying ocean surfaces, wave conditions, sea and lake ice, ocean clouds, weather prediction, and soil types. All data from the sensors will be recorded on film and analog magnetic tape for return at the end of each manned period of Skylab.

Park, A. B.↗
NASA NTRS1972

Stabilizing a spinning Skylab.

This paper presents the results of a study of the dynamics of a spinning Skylab space station. The stability of motion of several simplified models with flexible appendages was investigated. A digital simulation model that more accurately portrays the complex Skylab vehicle is described, and simulation results are compared with analytically derived results.

Seltzer, S. M.↗
NASA NTRS1973

Microbiological testing of Skylab foods.

Review of some of the unique food microbiology problems and problem-generating circumstances the Skylab manned space flight program involves. The situations these problems arise from include: extended storage times, variations in storage temperatures, no opportunity to resupply or change foods after launch of the Skylab Workshop, first use of frozen foods in space, first use of a food-warming device in weightlessness, relatively small size of production lots requiring statistically valid sampling plans, and use of food as an accurately controlled part in a set of sophisticated life science experiments. Consideration of all of these situations produced the need for definite microbiological tests and test limits. These tests are described along with the rationale for their selection. Reported test results show good compliance with the test limits.

Heidelbaugh, N. D.↗
NASA NTRS1973

Skylab medical experiments altitude test crew observations.

The paper deals with the crew's observations during training and the SMEAT 56-day test. Topics covered include the crew's adaptation to the SMEAT environment and medical experiments protocol. Personal observations are made of daily activities surrounding the medical experiments hardware, Skylab clothing, supplementary activities, recreational equipment, food, and waste management. An assessment of these items and their contributions to the Skylab flight program is made.

Bobko, K. J.↗
NASA NTRS1973

X-ray observations of characteristic structures and time variations from the solar corona - Preliminary results from Skylab.

Examples taken from the S-054 X-ray telescope observations made during the first Skylab mission show the hot coronal plasma tracing the configuration of the magnetic fields. The high spectral resolution and sensitivity of the instrument has enabled the following two facts to be more firmly established: (1) that the 'quiet homogeneous corona' is in fact highly structured and that the structures observed appear to be the results of dispersed active region magnetic fields; and (2) that numerous bright points are distributed randomly on the disk. Their presence at high latitudes may play a role in solar cycle models. In addition, the capability of Skylab for studying time evolution has enabled the restructuring of coronal features to be seen at times of high activity, indicating a restructuring of the coronal magnetic fields.

Vaiana, G. S.↗
NASA NTRS1973

Detection of moisture and moisture related phenomena from Skylab

The author has identified the following significant results. This is a preliminary report on the ability to detect soil moisture variation from the two different sensors on board Skylab. Initial investigations of S190A and Sl94 Skylab data and ground truth has indicated the following significant results. (1) There was a decrease in Sl94 antenna temperature from NW to SE across the Texas test site. (2) Soil moisture increases were measured from NW to SE across the test site. (3) There was a general increase in precipitation distribution and radar echoes from NW to SE across the site for the few days prior to measurements. This was consistent with the soil moisture measurements and gives more complete coverage of the site. (4) There are distinct variations in soil textures over the test site. This affects the moisture holding capacity of soils and must be considered. (5) Strong correlation coefficients were obtained between S194 antenna temperature and soil moisutre content. As the antenna temperature decreases soil moisture increases. (6) The Sl94 antenna temperature correlated best with soil mositure content in the upper two inches of the soil. A correlation coefficient of .988 was obtained. (7) Sl90A photographs in the red-infrared region were shown to be useful for identification of Abilene clay loam and for determining the distribution of this soil type.

Eagleman, J. R.↗
NASA NTRS1973

Detection of moisture and moisture related phenomena from Skylab

The author has identified the following significant results. Correlations between the S-194 antenna temperature and soil moisture have been obtained for three sets of data; one for Skylab 2 and two for Skylab 3. The best correlations were obtained for the surface to one inch depth in two cases and for the surface to two inches for the third case. Correlation coefficients for the surface to one inch depth were -0.98, -0.95, and -0.82. The lowest correlation coefficient was obtained with total soil moisture variations less than 4% across the test site.

Eagleman, J. R.↗
NASA NTRS1973

Skylab SO71/SO72 circadian periodicity experiment

The circadian rhythm hardware activities from 1965 through 1973 are considered. A brief history of the programs leading to the development of the combined Skylab SO71/SO72 Circadian Periodicity Experiment (CPE) is given. SO71 is the Skylab experiment number designating the pocket mouse circadian experiment, and SO72 designates the vinegar gnat circadian experiment. Final design modifications and checkout of the CPE, integration testing with the Apollo service module CSM 117 and the launch preparation and support tasks at Kennedy Space Center are reported.

Fairchild, M. K.↗
NASA NTRS1973

Plan for the uniform mapping of earth resources and environmental complexes from Skylab imagery

The author has identified the following significant results. Below approximately 25% cover visual photointerpretation of vegetation analogs of Skylab 2 Sl9OA color infrared imagery is poor. Correct identifications of vegetation analogs in this category range from 28 to 57%. Good photointerpretation results (64 to 96%) were obtained on vegetation analogs with higher cover values. The four semidesert vegetation analogs (greasewood, saltbush, big sagebrush, and pinyon-juniper) are consistently distinguishable as a group. Photointerpretation accuracy equals 90.1%. When these same types are broken into two sub-groups (salt desert vegetation and shrub steppe/sparse pinyon-juniper vegetation) interpretation success drops to 76% and 85%, respectively. Band ratioing and transmittance differences between two forested analogs as imaged on Skylab 2 S19OA film shows significant differences. In the infrared wavelength both analogs have very similar transmittance characteristics while the visible wavelength shows separation between the two. Relative transmittance values for stands of ponderosa pine forestland and pinyon-juniper woodland are 719.3 + or - 65.9 and 223.6 + or - 48.1, respectively on negative transparencies. In image interpretation along the low-elevation fringe of forested regions these are the two forest analogs most frequently requiring separation.

Poulton, C. E.↗
NASA NTRS1974

Detection of moisture and moisture related phenomena from Skylab

The author has identified the following significant results. Skylab 2 data for June 5, 1973 (Texas site) relates favorably with previously calculated aircraft data when correlating brightness temperature to soil moisture. However, more detailed work is needed to determine the corrected surface temperature. In addition, correlations between the S194 antenna temperature and soil moisture have been obtained for five sets of Skylab data. The best correlations were obtained for the surface to one inch depth in four cases and for surface to two inches depth for the fifth case. Correlation coefficients for the surface to one inch depth were -0.98, -0.95, -0.90, -0.82, and -0.80.

Eagleman, J. R.↗
NASA NTRS1974

Calibration and evaluation of Skylab altimetry for geodetic determination of the geoid

The author has identified the following significant results. The analysis was based on a time series intrinsic relationship between the satellite ephemeris, altimeter measured ranges, and the corresponding a priori values of subsatellite geoidal heights. Using, least squares processing with parameter weighting, the objective was to recover: (1) the absolute geoidal heights of the subsatellite points; and (2) the associated altimeter calibration constants. Preliminary results from Skylab mission SL-2 are given, using various combinations from two sets of orbit ephemeris and altimeter ranges. It is shown that correctly scaled geoidal heights cannot be deduced by merely subtracting the altimeter range from the geodetic height of the satellite unless the satellite ephemeris and the altimeter have no unknown significant systematic errors or biases and drifts. It is emphasized that the primary objective of the Skylab altimeter is to determine the instrument feasibility. Any additional applications of the data such as for geodesy, geophysics, and oceanography are desirable. Although accurate orbit is required for such applications, it is not a prerequisite for determining the instrument feasibility.

Mourad, A. G.↗
NASA NTRS1973

Skylab experiments. Volume 5: Astronomy and space physics

The astronomy and space physics investigations conducted in the Skylab program include over 20 experiments in four categories to explore space phenomena that cannot be observed from earth. The categories of space research are as follows: (1) phenomena within the solar system, such as the effect of solar energy on Earth's atmosphere, the composition of interplanetary space, the possibility of an inner planet, and the X-ray radiation from Jupiter, (2) analysis of energetic particles such as cosmic rays and neutrons in the near-earth space, (3) stellar and galactic astronomy, and (4) self-induced environment surrounding the Skylab spacecraft.

Source record↗
NASA NTRS1973

Skylab experiments. Volume 7: Living and working in space

Experiments conducted on the Skylab vehicle that will measure and evaluate the ability of the crew to live and work effectively in space are discussed. The methods and techniques of human engineering as they relate to the design and evaluation of work spaces, requirements, and tools are described. The application of these methods and the Skylab measurements to the design of future spacecraft are analyzed.

Source record↗