Search NASA⌕ Search

SEARCH · Search NASA

Results for “THEORIES - WINGS SUPERSONIC”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Effects of structural coupling on mistuned cascade flutter and response

The effects of structural coupling on mistuned cascade flutter and response are analytically investigated using an extended typical section model. This model includes both structural and aerodynamic coupling between the blades. The model assumes that the structurally coupled system natural modes were determined and are represented in the form of N bending and N torsional uncoupled modes for each blade, where N is the number of blades and, hence, is only valid for blade dominated motion. The aerodynamic loads are calculated by using two dimensional unsteady cascade theories in the subsonic and supersonic flow regimes. The results show that the addition of structural coupling can affect both the aeroelastic stability and frequency. The stability is significantly affected only when the system is mistuned. The resonant frequencies can be significantly changed by structural coupling in both tuned and mistuned systems, however, the peak response is significantly affected only in the latter. Previously announced in STAR as N83-15672

Kielb, R. E.↗
NASA NTRS1989

Turbomachinery aeroelasticity at NASA Lewis Research Center

The turbomachinery aeroelastic effort is focused on unstalled and stalled flutter, forced response, and whirl flutter of both single rotation and counter rotation propfans. It also includes forced response of the Space Shuttle Main Engine (SSME) turbopump blades. Because of certain unique features of propfans and the SSME turbopump blades, it is not possible to directly use the existing aeroelastic technology of conventional propellers, turbofans or helicopters. Therefore, reliable aeroelastic stability and response analysis methods for these propulsion systems must be developed. The development of these methods for propfans requires specific basic technology disciplines, such as 2-D and 3-D steady and unsteady aerodynamic theories in subsonic, transonic and supersonic flow regimes; modeling of composite blades; geometric nonlinear effects; and passive and active control of flutter and response. These methods are incorporated in a computer program, ASTROP. The program has flexibility such that new and future models in basic disciplines can be easily implemented.

Kaza, Krishna Rao V.↗
NASA NTRS1992

Limitations on wind-tunnel pressure signature extrapolation

Analysis of some recent experimental sonic boom data has revived the hypothesis that there is a closeness limit to the near-field separation distance from which measured wind tunnel pressure signatures can be extrapolated to the ground as though generated by a supersonic-cruise aircraft. Geometric acoustic theory is used to derive an estimate of this distance and the sample data is used to provide a preliminary indication of practical separation distance values.

Mack, Robert J.↗
NASA NTRS1992

Natural laminar flow and laminar flow control

The present volume discusses the development history and basic concepts of laminar flow control, laminar flow flight experiments, subsonic laminar-flow airfoils, and a design philosophy for long-range laminar flow-control commercial transports with advanced supercritical airfoils. Also discussed are the relationship of wave-interaction theory to laminar flow control, supersonic laminar flow control, and the NASA-Langley 8-ft Transonic Pressure Tunnel.

Barnwell, R. W.↗
NASA NTRS1973

A kernel function method for computing steady and oscillatory supersonic aerodynamics with interference.

The method presented uses a collocation technique with the nonplanar kernel function to solve supersonic lifting surface problems with and without interference. A set of pressure functions are developed based on conical flow theory solutions which account for discontinuities in the supersonic pressure distributions. These functions permit faster solution convergence than is possible with conventional supersonic pressure functions. An improper integral of a 3/2 power singularity along the Mach hyperbola of the nonplanar supersonic kernel function is described and treated. The method is compared with other theories and experiment for a variety of cases.

Cunningham, A. M., Jr.↗
NASA NTRS1985

A multiple-scales model of the shock-cell structure of imperfectly expanded supersonic jets

The present investigation is concerned with the development of an analytical model of the quasi-periodic shock-cell structure of an imperfectly expanded supersonic jet. The investigation represents a part of a program to develop a mathematical theory of broadband shock-associated noise of supersonic jets. Tam and Tanna (1982) have suggested that this type of noise is generated by the weak interaction between the quasi-periodic shock cells and the downstream-propagating large turbulence structures in the mixing layer of the jet. In the model developed in this paper, the effect of turbulence in the mixing layer of the jet is simulated by the addition of turbulent eddy-viscosity terms to the momentum equation. Attention is given to the mean-flow profile and the numerical solution, and a comparison of the numerical results with experimental data.

Tam, C. K. W.↗
NASA NTRS1992

Effect of Cooling on Boundary-Layer Stability at Mach Number 3

This paper describes the calculation of the effect of wall cooling on the instability of a two-dimensional, flat-plate supersonic boundary layer under stratospheric flight conditions at Mach 3 using both the inviscid and viscous linear stability theories.

wall↗
NASA NTRS1982

Aerodynamics of Supersonic Aircraft

An integrated system for the analysis of supersonic configurations consists of an executive driver and eight basic computer programs that build up force coefficients of an selected configuration. System employs modified linearized theory for calculation of surface pressures and employs supersonic-area-rule concepts in combination with linearized theory for calculation of aerodynamic force coefficients.

Middleton, W. D.↗
NASA NTRS1983

Stability and control of a supersonic transport airplane during landing approach

Modal control theory was applied to determine feedback gains that provide desirable stability characteristics and satisfactory transient response to aileron deflection input. However, the peak value of lateral acceleration at the pilot's station does not satisfy a proposed criterion during a rolling maneuver. Optimal regulator theory does not provide a significant reduction of the peak lateral acceleration. The weighting matrices in the performance index were given an extreme variation, but the effect on lateral acceleration remained insignificant. Open loop control provided the desired bank angle (30 deg) with the desired roll rate (10 deg/sec), and provided a satisfactory level of lateral acceleration. However, a large adverse sideslip angle was required. In addition, the yawing velocity was negative for about two seconds and lateral acceleration changed sign during the maneuver. The problem persists and perhaps relaxed criteria must be proposed. The criteria could allow any combination of a lower average rolling velocity, a larger adverse sideslip angle excursion, and a higher peak lateral acceleration at the pilot's station.

Oehman, W. I.↗
NASA NTRS1999

Development of a Three-Dimensional PSE Code for Compressible Flows: Stability of Three-Dimensional Compressible Boundary Layers

A program is developed to investigate the linear stability of three-dimensional compressible boundary layer flows over bodies of revolutions. The problem is formulated as a two dimensional (2D) eigenvalue problem incorporating the meanflow variations in the normal and azimuthal directions. Normal mode solutions are sought in the whole plane rather than in a line normal to the wall as is done in the classical one dimensional (1D) stability theory. The stability characteristics of a supersonic boundary layer over a sharp cone with 50 half-angle at 2 degrees angle of attack is investigated. The 1D eigenvalue computations showed that the most amplified disturbances occur around x(sub 2) = 90 degrees and the azimuthal mode number for the most amplified disturbances range between m = -30 to -40. The frequencies of the most amplified waves are smaller in the middle region where the crossflow dominates the instability than the most amplified frequencies near the windward and leeward planes. The 2D eigenvalue computations showed that due to the variations in the azimuthal direction, the eigenmodes are clustered into isolated confined regions. For some eigenvalues, the eigenfunctions are clustered in two regions. Due to the nonparallel effect in the azimuthal direction, the eigenmodes are clustered into isolated confined regions. For some eigenvalues, the eigenfunctions are clustered in two regions. Due to the nonparallel effect in the azimuthal direction, the most amplified disturbances are shifted to 120 degrees compared to 90 degrees for the parallel theory. It is also observed that the nonparallel amplification rates are smaller than that is obtained from the parallel theory.

Balakumar, P.↗
NASA NTRS1972

Application of quadratic optimization to supersonic inlet control.

This paper describes the application of linear stochastic optimal control theory to the design of the control system for the air intake, the inlet, of a supersonic air-breathing propulsion system. The controls must maintain a stable inlet shock position in the presence of random airflow disturbances and prevent inlet unstart. Two different linear time invariant controllers are developed. One is designed to minimize a nonquadratic index, the expected frequency of inlet unstart, and the other is designed to minimize the mean square value of inlet shock motion. The quadratic equivalence principle is used to obtain a linear controller that minimizes the nonquadratic index. The two controllers are compared on the basis of unstart prevention, control effort requirements, and frequency response. It is concluded that while controls designed to minimize unstarts are desirable in that the index minimized is physically meaningful, computation time required is longer than for the minimum mean square shock position approach. The simpler minimum mean square shock position solution produced expected unstart frequency values which were not significantly larger than those of the nonquadratic solution.

Lehtinen, B.↗
NASA NTRS1980

A possible magnetic wake of Titan - Pioneer 11 observations

The paper deals with measurements of the magnetic field along the outbound leg of Pioneer's trajectory at Saturn, which suggest that the spacecraft may have passed through the magnetic wake of Titan at a distance of 145 Titan radii downstream from Titan. The data obtained over a period of several hours around the crossing of Titan's L shell exhibit a number of characteristics which are qualitatively consistent with predictions based on theories of the interaction between a supersonic magnetized plasma and a conducting or magnetized planetary body. In addition, values of the plasma mass density derived from the interaction geometry are consistent with an upper limit inferred from in situ plasma measurements obtained during the outbound leg of Pioneer's trajectory.

Jones, D. E.↗
NASA NTRS1990

Instability of a supersonic shock free elliptic jet

This paper presents a comparison of the measured and the computed spatial stability properties of an aspect ratio 2 supersonic shock free elliptic jet. The shock free nature of the elliptic jet provides an ideal test of validity of modeling the large scale coherent structures in the initial mixing region of noncircular supersonic jets with linear hydrodynamic stability theory. Both aerodynamic and acoustic data were measured. The data are used to compute the mean velocity profiles and to provide a description of the spatial composition of pressure waves in the elliptic jet. A hybrid numerical scheme is applied to solve the Rayleigh problem governing the inviscid linear spatial stability of the jet. The measured mean velocity profiles are used to provide a qualitative model for the cross sectional geometry and the smooth velocity profiles used in the stability analysis. Computational results are presented for several modes of instability at two jet cross sections. The acoustic measurements show that a varicose instability is the jet's perferred mode of motion. The stability analysis predicts that the Strouhal number varies linearly as a function of axial distance in the jet's initial mixing region, which is in good qualitative agreement with previous measurements.

Baty, Roy S.↗
NASA NTRS1951

Investigation of Off-design Performance of Shock-in-rotor Type Supersonic Blading

An analysis of the off-design performance of shock-in rotor-type supersonic blading is presented. The over-all losses are assumed divided into two groups;normal-shock losses, and external-wave losses. Throughout the range of relative entrance Mach numbers from 1.35 to starting, the largest losses can be attributed to the normal shock. An improvement in performance would be expected with a reduction of the normal-shock losses by the introduction of external compression waves.

CASCADES, EXPERIMENT↗
NASA NTRS1951

Flow Separation Ahead of a Blunt Axially Symmetric Body at Mach Numbers 1.76 to 2.10

The pressure distribution and drag were determined for a spherical-nosed axially symmetric body with thin projecting rods at Mach numbers of 1.76, 1.93, and 2.10. The upstream projection distance of the rods was varied over a wide range to study changes in the character of the flow separation and to determine the variation of drag and pressure distribution with tip projection. Drag coefficients between 0.18 and 0.30 were obtained for most tip projections at each Mach number.

WIND TUNNEL TESTS - LFPL - SUPERSONIC (18"x18")↗