Search NASA⌕ Search

SEARCH · Search NASA

Results for “TIME OPTIMAL CONTROL”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

Two neural network algorithms for designing optimal terminal controllers with open final time

Multilayer neural networks, trained by the backpropagation through time algorithm (BPTT), have been used successfully as state-feedback controllers for nonlinear terminal control problems. Current BPTT techniques, however, are not able to deal systematically with open final-time situations such as minimum-time problems. Two approaches which extend BPTT to open final-time problems are presented. In the first, a neural network learns a mapping from initial-state to time-to-go. In the second, the optimal number of steps for each trial run is found using a line-search. Both methods are derived using Lagrange multiplier techniques. This theoretical framework is used to demonstrate that the derived algorithms are direct extensions of forward/backward sweep methods used in N-stage optimal control. The two algorithms are tested on a Zermelo problem and the resulting trajectories compare favorably to optimal control results.

Plumer, Edward S.↗
NASA NTRS1987

On-line identification and attitude control for SCOLE

This paper documents on-line linear least-square identification and attitude control of SCOLE, a laboratory apparatus representing an offset-feed antenna attached to the Space Shuttle. Identification is done autonomously by starting a slew maneuver in pitch or roll with reaction jets and observing the time history data of associated Euler angles when the jets are quiescent. Linear least-square analysis is used to select the parameters that best fit the output of an Autoregressive (AR) model to the data. The control effectiveness of the jets is determined in a subsequent test, again using linear least squares. The parameters so derived are used to design switching lines for time-optimal attitude control. This report describes the identification and control algorithms and the experimental apparatus and procedures used. Also, experimental data are presented that reflect the performance of the identification algorithms and the attitude control system.

Montgomery, R. C.↗
NASA NTRS2018

Time-Varying Modification of Reference Model for Adaptive Control with Performance Optimization

This paper presents a new adaptive control ap- proach that involves a performance optimization objective. The control synthesis involves the design of a performance optimizing adaptive controller from a subset of control inputs. The resulting effect of the performance optimizing adaptive controller is to modify the initial reference model into a time-varying reference model which satisfies the performance optimization requirement obtained from an optimal control problem. The time-varying reference model modification is accomplished by the real-time solutions of the time-varying Riccati and Sylvester equations coupled with the least-squares parameter estimation of the sen- sitivities of the performance metric. The effectiveness of the proposed method is demonstrated by an application of maneuver load alleviation control for a flexible aircraft.

Adaptive Control↗
DOE OSTI2024

Transformer Neural Networks with Spatiotemporal Attention for Predictive Control and Optimization of Industrial Processes

In the context of real-time optimization and model predictive control of industrial systems, machine learning, and neural networks represent cutting-edge tools that hold promise for enhancing dynamic modeling. This work presents a novel transformer neural network architecture for real-time optimization and model predictive control. This network design includes a modified attention mechanism inspired by positional embedding attention from vision transformers and task-specific modifications to the input-output structure of the transformer’s decoder stack. Experiments were conducted using data from a 450 MW coal-fired power plant to evaluate this approach's effectiveness. The transformer neural network was compared with conventional recurrent models, including GRU and LSTM. The transformer exhibited a 6% increase in the R-squared (R2) value of predictions and an 83% reduction in mean squared error (MSE). Computation time was also reduced by 84% compared to conventional recurrent models.

Gallup, Ethan R.↗
NASA NTRS1986

Automation effects in a multiloop manual control system

An experimental and analytical study was undertaken to investigate human interaction with a simple multiloop manual control system in which the human's activity was systematically varied by changing the level of automation. The system simulated was the longitudinal dynamics of a hovering helicopter. The automation-systems-stabilized vehicle responses from attitude to velocity to position and also provided for display automation in the form of a flight director. The control-loop structure resulting from the task definition can be considered a simple stereotype of a hierarchical control system. The experimental study was complemented by an analytical modeling effort which utilized simple crossover models of the human operator. It was shown that such models can be extended to the description of multiloop tasks involving preview and precognitive human operator behavior. The existence of time optimal manual control behavior was established for these tasks and the role which internal models may play in establishing human-machine performance was discussed.

Hess, R. A.↗
NASA NTRS1980

Automatic flare transition penetrating wind shears

In this paper, the development of a digital three-dimensional automatic control law designated to achieve an optimal transition of a large commercial aircraft between the glideslope conditions and the desired final touchdown condition is presented. The linearized equations representing the perturbed motion of the aircraft from the nominal glideslope trajectory are presented. A method of incorporating the spatial, low-level wind shears into these perturbed equations of motion is indicated. It is shown that the system equations then assume the familiar form of the linear regulator problem, acted upon by a constant disturbance. A design procedure is presented to compute a digital, time-invariant, optimal control law for the discrete regulator problem acted upon by a constant disturbance. The response trajectories presented demonstrate the capability of this controller to perform optimal flare maneuvers in the presence of various wind shear conditions.

Nadkarni, A. A.↗
NASA NTRS1980

On maneuvering large flexible spacecraft using an annular momentum control device

A scheme for the control and maneuvering of a large flexible spacecraft by means of two flexible AMCD's using noncontacting magnetic suspension is presented. The system consists of a flexible vehicle, two flexible rings and a magnetic suspension and driving assembly. The necessary skewing of the rings for maneuvering of the vehicle is accomplished by moving the pairs of magnets along tracks distributed around the circumference of the vehicle. The equations of motion for each subsystem are derived by the Lagrangian approach. Attitude motions are described in terms of quasi-coordinates. For small vehicle angular rates and rings attitude motions, an ordering scheme can be used to separate the equations of motion according to the magnitude of the terms. The ordered equations of motion lead to a linear time-variant optimal control problem for the maneuvering of the spacecraft.

Oz, H.↗
DOE OSTI2026

Security Constrained Economic Optimization of Photovoltaic and Other Distributed Assets

The rapid growth of distributed energy resources (DERs), especially photovoltaic (PV) systems, has introduced new complexities in maintaining grid reliability, stability, and cost-effective operation. This project addresses these challenges by developing and demonstrating a scalable GridOS Distributed Energy Resource Management System (DERMS) that enables secure, real-time optimization and control of DERs at the distribution feeder level.

14 SOLAR ENERGY↗
NASA NTRS1969

The reverse Goddard problem.

Fuel-time optimal retrothrust control for vertical and gravity turn ballistic trajectories of soft landing nonlifting bodies based on Pontryagin principle

Bejczy, A. K.↗
NASA NTRS1972

An Optimization study on a hybrid computer

The maximum principle is applied to minimum-time optimal-control problems, and an optimization algorithm is presented which can be implemented on a hybrid computer. The state and adjoint equations are set up on ASTRAC 2, a high-speed analog computer capable of 1000 differential equation solutions per second. The optimization algorithm is implemented on a PDP-9, an 18-bit, digital computer. The optimization scheme has global and local search phases and uses a vector optimization criterion. Second and third-order bang-bang control systems are studied as examples.

Gonzalez, R. S.↗
NASA NTRS1994

Local performance optimization for a class of redundant eight-degree-of-freedom manipulators

Local performance optimization for joint limit avoidance and manipulability maximization (singularity avoidance) is obtained by using the Jacobian matrix pseudoinverse and by projecting the gradient of an objective function into the Jacobian null space. Real-time redundancy optimization control is achieved for an eight-joint redundant manipulator having a three-axis spherical shoulder, a single elbow joint, and a four-axis spherical wrist. Symbolic solutions are used for both full-Jacobian and wrist-partitioned pseudoinverses, partitioned null-space projection matrices, and all objective function gradients. A kinematic limitation of this class of manipulators and the limitation's effect on redundancy resolution are discussed. Results obtained with graphical simulation are presented to demonstrate the effectiveness of local redundant manipulator performance optimization. Actual hardware experiments performed to verify the simulated results are also discussed. A major result is that the partitioned solution is desirable because of low computation requirements. The partitioned solution is suboptimal compared with the full solution because translational and rotational terms are optimized separately; however, the results show that the difference is not significant. Singularity analysis reveals that no algorithmic singularities exist for the partitioned solution. The partitioned and full solutions share the same physical manipulator singular conditions. When compared with the full solution, the partitioned solution is shown to be ill-conditioned in smaller neighborhoods of the shared singularities.

Williams, Robert L., II↗
NASA NTRS2012

NASA Dryden Status: Aerospace Control and Guidance Sub-Committee Meeting 109

NASA Dryden has been engaging in some exciting work that will enable lighter weight and more fuel efficient vehicles through advanced control and dynamics technologies. The main areas of emphasis are Enabling Light-weight Flexible Structures, real time control surface optimization for fuel efficiency and autonomous formation flight. This presentation provides a description of the current and upcoming work in these areas. Additionally, status is for the Dreamchaser pilot training activity and KQ-X autonomous aerial refueling.

Jacobson, Steven R.↗