SEARCH · Search NASA

Results for “Unity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9

All sources NASA NTRS DOE OSTI

NASA NTRS1972

Normal impingement loads due to small air jets issuing from a base plate and reflecting off a platform for various jet Mach numbers, separation distances, and ambient pressures

An investigation was conducted in a 12.5-meter-diameter vacuum sphere to determine the impingement loads due to air jets issuing from and perpendicular to a circular base and reflecting off a square platform, that is, a simulation of rendezvous maneuvering, docking, launch, impact dampers etc. The nozzles had exit Mach numbers of 1, 3, 5, and 7. The ambient pressures were 0.0006, 5, 225, and 760 torr. Under near-field separation distances and at 0.0006 torr, reflections were significant; and ratios of the impingement force to thrust on both plates in the biplane arrangement varied from about 750 for exit Mach number 1 to 120 for exit Mach number 7. The far-field force ratios were near unity for the platform and zero for the base and indicated few, if any, reflections. Some reversals and rapid changes in loads were obtained at transition distances between the near and far fields. In general, increasing the exit Mach number or ambient pressure reduced the impingement loads.

Hoffman, S.↗

NASA NTRS1972

Influence of porous-wall thermal effectiveness on turbulent-boundary-layer heat transfer

In view of the interest in employing porous wall materials for which the wall thermal effectiveness is less than unity, the influence of the effectiveness on the convective heat-transfer coefficient is examined. A Couette-flow model of the turbulent boundary layer shows that the familiar expression for the Stanton number with mass transfer at the boundary is modified by a correction factor that accounts for the wall thermal effectiveness and the effectiveness of the film layer in protecting the surface from the hot gas stream. The correction term is found be of considerable importance for low values of blowing rate and wall thermal effectiveness.

Lecuyer, M. R.↗

NASA NTRS1972

Diffuse galactic light in the 1500-4200 angstrom region

Diffuse galactic light has been observed with the four stellar photometers of the OAO-2 in 29 of Kapteyn's selected areas. The data can be understood in terms of a wavelength dependent albedo of the interstellar grains with a pronounced minimum around 2200 A with a rapid increase towards unity at wavelengths below 2000 A.

Witt, A. N.↗

NASA NTRS1971

The three-dimensional steady radial expansion of a viscous gas from a sonic source into a vacuum.

The three-dimensional steady radial expansion of a viscous, heat-conducting, compressible fluid from a spherical sonic source into a vacuum is analyzed using the Navier-Stokes equations as a basis. It is assumed that the model fluid is a perfect gas having constant specific heats, a constant Prandtl number of order unity, and viscosity coefficients varying as a power of the absolute temperature. Limiting forms for the flow variable solutions are studied for the Reynolds number based on the sonic source conditions, going to infinity and the Newtonian parameter both fixed and going to zero. For the case of the viscosity-temperature exponent between .5 and 1, it is shown that the velocity as well as the pressure approach zero as the radial distance goes to infinity. The formulations of the distinct regions that span the domain extending from the sonic source to the vacuum are presented.

Bush, W. B.↗

NASA NTRS1972

An analytical study of the effect of coolant flow variables on the kinetic energy output of a cooled turbine blade row.

Demonstration that the change in output of a cooled turbine blade row relative to the specific output of the uncooled blade row can be positive, negative, or zero, depending on the velocity, injection location, injection angle, and temperature of the coolant. Comparisons between the analytical results and experimental results for four different cases of coolant discharge, all at a coolant temperature ratio of unity, show good agreement for three cases, and rather poor agreement for the other.

Prust, H. W., Jr.↗

NASA NTRS1972

Mariner 9 television reconnaissance of Mars and its satellites - Preliminary results.

At orbit insertion, the Martian surface was largely obscured by a dust haze with an extinction optical depth that ranged from near unity in the south polar region to probably greater than two over most of the planet. The only features clearly visible were the south polar cap, one dark spot in Nix Olympica, and three dark spots in the Tharsis region. During the third week, the atmosphere began to clear and surface visibility improved, but contrasts remained a fraction of their normal value. Each of the dark spots that apparently protrude through most of the dust-filled atmosphere has a crater or crater complex in its center. The craters apparently were formed by subsidence and resemble terrestrial calderas.

Masursky, H.↗

NASA NTRS1972

Radiative transfer effects on reflected shock waves. II - Absorbing gas.

Radiative cooling effects behind a reflected shock wave are calculated for an absorbing-emitting gas by means of an expansion procedure in the small density ratio across the shock front. For a gray gas shock layer with an optical thickness of order unity or less the absorption integral is simplified by use of the local temperature approximation, whereas for larger optical thicknesses a Rosseland diffusion type of solution is matched with the local temperature approximation solution. The calculations show that the shock wave will attenuate at first and then accelerate to a constant velocity. Under appropriate conditions the gas enthalpy near the wall may increase at intermediate times before ultimately decreasing to zero. A two-band absorption model yields end-wall radiant-heat fluxes which agree well with available shock-tube measurements.

Su, F. Y.↗

NASA NTRS1972

Requirements for laser radar detection of a barium ion cloud at five earth radii.

The requirements for a tuned laser radar capable of detecting and ranging a high altitude barium ion cloud release are discussed. A high energy pulsed dye laser tuned to the 455.4 nm Ba II resonance line is considered as the transmitter. Photon counting detection is employed and the resultant signal is integrated over a number of successive laser firings. The solar induced radiance of the cloud is the major background noise source. Detection and ranging may be achieved with signal-to-noise ratios of the order of unity using currently available equipment. This technique has the potential of improved resolution as compared to photographic measurements previously made.

Mumola, P. B.↗

NASA NTRS1972

Radiation resistance of a rectangular panel.

The radiation resistance corresponding to the natural modes of a finite rectangular panel is theoretically determined from the total energy radiated to the farfield. The panel is assumed to be simply supported in an infinite baffle. Asymptotic solutions for the low-frequency region are derived, and curves covering the entire frequency range for various mode shapes and aspect ratios are obtained through numerical integration. When the ratio of the acoustic wavenumber to the panel wavenumber is a constant much less than unity, the radiation resistance for all modes is a minimum if the intranodal area (the area between adjacent node lines) is square, and increases with the aspect ratio of the intranodal area.

Wallace, C. E.↗

NASA NTRS1972

Standard deviation of scatterometer measurements from space.

The standard deviation of scatterometer measurements has been derived under assumptions applicable to spaceborne scatterometers. Numerical results are presented which show that, with sufficiently long integration times, input signal-to-noise ratios below unity do not cause excessive degradation of measurement accuracy. The effects on measurement accuracy due to varying integration times and changing the ratio of signal bandwidth to IF filter-noise bandwidth are also plotted. The results of the analysis may resolve a controversy by showing that in fact statistically useful scatterometer measurements can be made from space using a 20-W transmitter, such as will be used on the S-193 experiment for Skylab-A.

Fischer, R. E.↗

NASA NTRS1972

Changes in the frequency distribution of energy deposited in short pathlengths as a function of energy degradation of the primary beam.

The frequency distributions of event size in the deposition of energy over small pathlengths have been measured after penetration of 44.3 MeV protons through various thicknesses of tissue-equivalent material. Results show that particle energy straggling of an initially monoenergetic proton beam after passage through an absorber causes the frequency distributions of energy deposited in short pathlengths of low atomic number materials to remain broad. In all cases investigated, the ratio of the most probable to the average energy losses has been significantly less than unity.

Baily, N. A.↗

NASA NTRS1972

The Nimbus 4 infrared spectroscopy experiment. I - Calibrated thermal emission spectra.

Measurement of the infrared spectrum of the earth and atmosphere between 400 and 1600/cm. In an effort to obtain spectra with high absolute accuracy, it was necessary to incorporate many factors into the calibration, including small departures from unity in the emissivity of the on-board calibration source, imbalance between cold and warm calibration ports, and effects due to orbital variations in instrument temperature. The inclusion of such higher order corrections, along with careful data screening processes, has ensured a high quality data set that can be used in a variety of geophysical and meteorological investigations. Representative samples of data are presented that illustrate the behavior of the thermal emission spectra under a variety of conditions encountered in a typical orbit, including extremes in temperature, surface reststrahlung (or residual ray) effects, and various types of cloud conditions.

Hanel, R. A.↗

NASA NTRS1972

Influence of thermal anisotropy on best-fit estimates of shock normals.

This paper deals with the influence of thermal anisotropy on least-squares estimates of interplanetary shock parameters and the associated normals by using the Rankine-Hugoniot equations. A practical theorem is given for quantitatively correcting for anisotropic effects by weighting the before and after magnetic fields by the same 'anisotropy parameter' h. The quantity h depends only on the thermal anisotropies before and after the shock and on the angles between the magnetic fields and the shock normal. It is shown that, for fast shocks and for a liberal range of realistic conditions, the quantity h lies in the range from 0.90 to 1.22. The theorem can also be applied to most slow shocks, but in those instances h usually should be lower and sometimes markedly lower than unity.

Lepping, R. P.↗

NASA NTRS1972

Surface temperature effect on subsonic stall.

Results of an analytical and experimental study of boundary layer flow over an aerodynamic surface rejecting heat to a cool environment. This occurs following reentry of a Space Shuttle vehicle. Analytical studies revealed that a surface to freestream temperature ratio, greater than unity tended to destabilize the boundary layer, hastening transition and separation. Therefore, heat transfer accentuated the effect of an adverse pressure gradient. Wind tunnel tests of a 0012-64 NACA airfoil showed that the stall angle was significantly reduced while drag tended to increase for freestream temperature ratios up to 2.2.

Macha, J. M.↗

NASA NTRS1972

Automated Microbial Metabolism Laboratory

The Automated Microbial Metabolism Laboratory (AMML) 1971-1972 program involved the investigation of three separate life detection schemes. The first was a continued further development of the labeled release experiment. The possibility of chamber reuse without inbetween sterilization, to provide comparative biochemical information was tested. Findings show that individual substrates or concentrations of antimetabolites may be sequentially added to a single test chamber. The second detection system which was investigated for possible inclusion in the AMML package of assays, was nitrogen fixation as detected by acetylene reduction. Thirdly, a series of preliminary steps were taken to investigate the feasibility of detecting biopolymers in soil. A strategy for the safe return to Earth of a Mars sample prior to manned landings on Mars is outlined. The program assumes that the probability of indigenous life on Mars is unity and then broadly presents the procedures for acquisition and analysis of the Mars sample in a manner to satisfy the scientific community and the public that adequate safeguards are being taken.

Source record↗

NASA NTRS1972

The turbulent boundary layer on a porous plate: An experimental study of the heat transfer behavior with adverse pressure gradients

An experimental investigation of the heat transfer behavior of the near equilibrium transpired turbulent boundary layer with adverse pressure gradient has been carried out. Stanton numbers were measured by an energy balance on electrically heated plates that form the bottom wall of the wind tunnel. Two adverse pressure gradients were studied. Two types of transpiration boundary conditions were investigated. The concept of an equilibrium thermal boundary layer was introduced. It was found that Stanton number as a function of enthalpy thickness Reynolds number is essentially unaffected by adverse pressure gradient with no transpiration. Shear stress, heat flux, and turbulent Prandtl number profiles were computed from mean temperature and velocity profiles. It was concluded that the turbulent Prandtl number is greater than unity in near the wall and decreases continuously to approximately 0.5 at the free stream.

Blackwell, B. F.↗

NASA NTRS1972

A theoretical study of mixing downstream of transverse injection into a supersonic boundary layer

A theoretical and analytical study was made of mixing downstream of transverse hydrogen injection, from single and multiple orifices, into a Mach 4 air boundary layer over a flat plate. Numerical solutions to the governing three-dimensional, elliptic boundary layer equations were obtained using a general purpose computer program. Founded upon a finite element solution algorithm. A prototype three-dimensional turbulent transport model was developed using mixing length theory in the wall region and the mass defect concept in the outer region. Excellent agreement between the computed flow field and experimental data for a jet/freestream dynamic pressure ratio of unity was obtained in the centerplane region of the single-jet configuration. Poorer agreement off centerplane suggests an inadequacy of the extrapolated two-dimensional turbulence model. Considerable improvement in off-centerplane computational agreement occured for a multi-jet configuration, using the same turbulent transport model.

Baker, A. J.↗

NASA NTRS1973

Deformation processes in forging ceramics

The deformation processes involved in the forging of refractory ceramic oxides were investigated. A combination of mechanical testing and forging was utilized to investigate both the flow and fracture processes involved. Deformation studies of very fine grain Al203 revealed an apparent transition in behavior, characterized by a shift in the strain rate sensitivity from 0.5 at low stresses to near unity at higher stresses. The behavior is indicative of a shift in control between two dependent mechanisms, one of which is indicated to be cation limited diffusional creep with significant boundary enhancement. The possible contributions of slip, indicated by crystallographic texture, interface control of the diffusional creep and inhomogeneous boundary sliding are also discussed. Additional experiments indicated an independence of deformation behavior on MgO doping and retained hot pressing impurities, at least for ultrafine grained material, and also an independence of test atmosphere.

Cannon, R. M.↗