Search NASA⌕ Search

SEARCH · Search NASA

Results for “asymmetric”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9

Asymmetric two-dimensional jet efflux from a channel

Irrotational flow of two-dimensional jets from a channel is treated without direct use of a logarithmic hodograph plane. An analytical approach is introduced for solving the general problem of two jets issuing from a channel with three end plates. Numerical values of the contraction coefficient and the angle of jet deflection are obtained for the special case where the two jets are located symmetrically and all the end plates are in line. Limiting cases of the resulting single-jet problem are the symmetric and asymmetric configurations solved by von Mises (1917). Results for the asymmetric case improve upon the theoretical values reported by von Mises and compare favorably with existing experimental data.

Martin, C. S.↗

Effects of asymmetric passband filtering on the phase of the Costas loop's reconstructed carrier

The reconstructed carrier of a telemetry return signal is used in deriving the Doppler and range information in the radiometric systems. When suppressed carrier BPSK signalling with Costas loop demodulation is used, there are concerns on the amount of shift in the reconstructed carrier phase, when the received signal suffers asymmetric bandpass filtering through the various stages of the receiver. It is concluded that the phase shifts due to asymmetric bandpass filtering on the Costas loop's reconstructed carrier can be slightly worse than those suffered by the residual carrier loop's reconstructed carrier. However, they are well within the error budgets of the radiometric system.

Woo, K. T.↗

Experimental investigation of the asymmetric body vortex wake

An experimental investigation of the asymmetric body vortex wake of a circular cylinder in high subsonic flow is presented. Laser velocimeter, force and moment, and surface hot wire measurements were obtained for a freestream Mach number of 0.6 and Reynolds number (based on body diameter) of 0.62 x 10 to the 6th. Two component laser velocimeter measurements were made at three body cross-flow planes, x/d = 4, 8, and 12, and angles of attack of 25, 35, and 45 deg. Laser vapor screen photographs were also obtained at these body stations and angles of attack. Surface hot wire measurements were used to determine if any vortex switching occurred at various angles of attack of the body. The laser velocimeter measurements are related to the vapor screen photographs and side force measurements. These results show that more than one asymmetric body vortex wake configuration can exist for the same angle of attack and body roll angle.

Oberkampf, W. L.↗

Careful numerical study of flowfields about asymmetric external conical corners

A numerical study of the flowfield about asymmetrical external axial corners formed by the juncture of swept compressive wedges is presented. The geometrical configuration allows a unified treatment of external corners typical of delta wings and rectangular inlets. The study investigates how the flow transitions from a symmetrical flowfield with a cross-flow stagnation point at the corner to an asymmetrical flowfield for which the flow spills over the corner. The effects of leading-edge sweep, wedge compression, and corner radius are investigated.

Salas, M. D.↗

Asymmetrical ClO3 - Its possible formation from ClO and O2 and its possible reactions

An analysis of recent accurate experimental studies of Cl2-photosensitized O3 decomposition, in which O3 disappearance and OClO formation were directly monitored, suggests the possibility that the suppression of the quantum yield in the presence of O2 may be due to the formation of asymmetrical chlorine trioxide (ClO.O2). Other intermediaries, such as Cl2O2, which may also form in the system are not thought to explain the observations. In addition to its capacity to oxidize, which it shares with other peroxo compounds, asymmetrical ClO3 appears to undergo an interesting class of reactions in which the loosely bound O2 adduct is relatively easily displaced by reactive atoms and radicals such as chlorine.

Prasad, S. S.↗

Control of the forebody vortex orientation by asymmetric air injection. Part A: Application to enhance departure/spin recovery of fighter aircraft. Part B: Details of the flow structure

A novel concept which was developed to provide powerful directional control effectiveness for a fighter aircraft at high angles of attack, where more traditional controls have very limited capability is discussed. The concept utilizes the energy concentrated in the strong forebody vortices (which form on slender bodies at high relative incidence) by controlling the lateral orientation of the vortices with respect to the body. The present concept seeks to utilize the inherent sensitivity of the vortex positioning and its bistable nature to an advantage allowing control of the forces which are developed. As it turns out, the direction or sense of the asymmetric vortex pair is much easier to control than to attenuate. The work which was done to develop the concept for application to an aircraft is described and is directed toward the effects of the concept on aircraft forces and moments and on the flight mechanics of the aircraft during maneuvering at high angles of attack. The objective was to utilize the side force associated with asymmetric vortices, in a controlled manner, to enhance the ability of the fighter to recover from a departure from controlled flight. The results from these water tunnel and wind tunnel experiments show that a small amount of tangential blowing along the forebody near the apex can effectively alter the forebody vortex system and generate large restoring yawing moments.

Skow, A. M.↗

An analysis of the asymmetric part of electron-electron Boltzmann integral

A numerical analysis of the asymmetric part of electon-electron collision integral is presented. The results are given in the form of graphs for two commonly considered plasma situations: the collision-dominated case (symmetric part of electron disribution is Maxwellian) and the field-dominated case (symmetric part of electron distribution is Druyvesteynian). The importance of the asymmetric part of e-e collision integral in the Boltzmann equation is also discussed.

Kunc, J. A.↗

Drag of two-dimensional small-amplitude symmetric and asymmetric wavy walls in turbulent boundary layers

Included are results of an experimental investigation of low-speed turbulent flow over multiple two-dimensional transverse rigid wavy surfaces having a wavelength on the order of the boundary-layer thickness. Data include surface pressure and total drag measurements on symmetric and asymmetric wall waves under a low-speed turbulent boundary-layer flow. Several asymmetric wave configurations exhibited drag levels below the equivalent symmetric (sine) wave. The experimental results compare favorably with numerical predictions from a Reynolds-averaged Navier-Stokes spectral code. The reported results are of particular interest for the estimation of drag, the minimization of fabrication waviness effects, and the study of wind-wave interactions.

Lin, J. C.↗

Suppression of asymmetric acid efflux and gravitropism in maize roots treated with auxin transport inhibitors of sodium orthovanadate

In gravitropically stimulated roots of maize (Zea mays L., hybrid WF9 x 38MS), there is more acid efflux on the rapidly growing upper side than on the slowly growing lower side. In light of the Cholodny/Went hypothesis of gravitropism which states that gravitropic curvature results from lateral redistribution of auxin, the effects of auxin transport inhibitors on the development of acid efflux asymmetry and curvature in gravistimulated roots were examined. All the transport inhibitors tested prevented both gravitropism and the development of asymmetric acid efflux in gravistimulated roots. The results indicate that auxin redistribution may cause the asymmetry of acid efflux, a finding consistent with the Cholodny/Went hypothesis of gravitropism. As further evidence that auxin-induced acid efflux asymmetry may mediate gravitropic curvature, sodium orthovanadate, an inhibitor of auxin-induced H+ efflux was found to prevent both gravitropism and the development of asymmetric acid efflux in gravistimulated roots.

Mulkey, T. J.↗

Combined trellis coding with asymmetric MPSK modulation: An MSAT-X report

Traditionally symmetric, multiple phase-shift-keyed (MPSK) signal constellations, i.e., those with uniformly spaced signal points around the circle, have been used for both uncoded and coded systems. Although symmetric MPSK signal constellations are optimum for systems with no coding, the same is not necessarily true for coded systems. This appears to show that by designing the signal constellations to be asymmetric, one can, in many instances, obtain a significant performance improvement over the traditional symmetric MPSK constellations combined with trellis coding. The joint design of n/(n + 1) trellis codes and asymmetric 2 sup n + 1 - point MPSK is considered, which has a unity bandwidth expansion relative to uncoded 2 sup n-point symmetric MPSK. The asymptotic performance gains due to coding and asymmetry are evaluated in terms of the minimum free Euclidean distance free of the trellis. A comparison of the maximum value of this performance measure with the minimum distance d sub min of the uncoded system is an indication of the maximum reduction in required E sub b/N sub O that can be achieved for arbitrarily small system bit-error rates. It is to be emphasized that the introduction of asymmetry into the signal set does not effect the bandwidth of power requirements of the system; hence, the above-mentioned improvements in performance come at little or no cost. MPSK signal sets in coded systems appear in the work of Divsalar.

Simon, M. K.↗

Combined trellis coding with asymmetric modulations

The use of asymmetric signal constellations combined with optimized trellis coding to improve the performance of coded systems without increasing the average or peak power, or changing the bandwidth constraints of a system is discussed. The trellis code, asymmetric signal set, and Viterbi decoder of the system model are examined. The procedures for assigning signals to state transitions of the trellis code are described; the performance of the trellis coding system is evaluated. Examples of AM, QAM, and MPSK modulations with short memory trellis codes are presented.

Divsalar, D.↗

Calculation of asymmetric vortex separation on slender delta wings with a vortex-sheet model

An inviscid vortex-sheet model based on the slender wing theory is developed to examine asymmetric vortex separation at zero sideslip on delta wings. It is found that multiple asymmetric vortex configurations exist at a given angle of attack. Available data on rolling moment measurements and flow visualization are used for correlation to prove the concept.

Lan, C. E.↗

Trellis coding with asymmetric modulations

Through the asymmetric design of signal constellations, it often becomes possible to obtain a performance gain over conventional symmetric constellations combined with trellis coding. Attention is given to the joint design of n/(n+1) trellis codes and asymmetric 2 exp (n+1)-point signal constellations having no bandwidth expansion relative to an uncoded 2 exp n-point symmetric signal set. The asymptotic performance gains due to coding and asymmetry are explained in terms of the minimum free Euclidean distance of the trellis; examples are given which show the performance gain due to the asymmetry of the signal set. Since asymmetry does not affect bandwidth or power requirements, these improvements come at little or no cost.

Divsalar, Dariush↗

Enhancing compressor distortion tolerance by asymmetric stator control

This paper describes a preliminary study of a method for increasing compressor tolerance in circumferential distortion through asymmetric vane stagger control. The changes in vane stagger about the circumference are used to increase compressor pressure rise and flow capability over part of the annulus and decrease these over the rest. The average pressure rise and flow thus remain roughly constant but the velocity distortion is reduced (and can even be made zero). Calculations are carried out to show the magnitude of the vane motions that must be used, and it is found that significant increases in distoriton attenuation can be achieved with realistic vane swings. In addition, the asymmetric vane stagger scheme leads to a substantial decrease in stall pressure rise loss due to inlet total pressure distortion. This type of control strategy appears worthy of further investigation, both theoretical and experimental.

Chen, G. T.↗

Calculation of symmetric and asymmetric vortex seperation on cones and tangent ogives based on discrete vortex models

An inviscid discrete vortex model, with newly derived expressions for the tangential velocity imposed at the separation points, is used to investigate the symmetric and asymmetric vortex separation on cones and tangent ogives. The circumferential locations of separation are taken from experimental data. Based on a slender body theory, the resulting simultaneous nonlinear algebraic equations in a cross-flow plane are solved with Broyden's modified Newton-Raphson method. Total force coefficients are obtained through momentum principle with new expressions for nonconical flow. It is shown through the method of function deflation that multiple solutions exist at large enough angles of attack, even with symmetric separation points. These additional solutions are asymmetric in vortex separation and produce side force coefficients which agree well with data for cones and tangent ogives.

Chin, S.↗

Effects of surface perturbations on the asymmetric vortex flow over a slender body

An experimental investigation of the effects of surface perturbations on the asymmetric flow past a slender body has been conducted for laminar flow conditions. Beads with diameters ranging from 3/32 to 12/32 in. were attached near the apex of a cone/cylinder model having a base diameter of 3.5 in. and a cone semiapex angle of 9 deg at an angle of attack of 40 deg in an attempt to alter the sense of the asymmetric vortex flow pattern. Circumferential position as well as longitudinal location were varied to determine the most effective bead position. Whether or not the beads were effective in controlling the magnitude and direction of the vortex asymmetries was determined by 3 circumferential rows of pressure taps and by a helium-bubble flow visualization technique. The most effective circumferential position was found to be approximately 140 deg from the windward ray. While holding this circumferential position constant, the effect of bead size at three stations further along the body was also investigated. It was found that the size of the bead necessary to reverse the asymmetry increased more rapidly than the growth in cylinder radius. In general, these results indicate that discrete geometric imperfections on a body's surface can force asymmetry in a given direction if they are sufficiently large relative to the local radius.

Moskovitz, Cary A.↗

Infrared supernova light curves and asymmetric stellar mass loss

Infrared dust emission echos from Type II supernovae are a natural consequence of the heating of circumstellar dust by the supernova light. Red supergiants, the likely progenitors of most Type II supernovae, are known in some cases to have asymmetric circumstellar envelopes. It is noted that an asymmetric dust distribution can have a substantial effect on the evolution of an infrared echo and results are presented for an ellipsoidal dust distribution. The angle between the symmetry axis and the line of sight is unknown in any particular case so that detailed observations of a number of supernovae will be necessary to test for asymmetries. Asymmetries may also be observable in the radio structure of supernovae and in a possible scattered-light echo.

Emmering, Robert T.↗

Effects of symmetric and asymmetric modes on transonic aeroelastic characteristics of full-span wing-body configurations

To accurately study the transonic aeroelastic characteristics, it is important to model the full aircraft configuration, including asymmetry. Recently, an accurate method of computing unsteady transonic flows on full-span wing-body configurations was developed using the transonic potential flow theory. In this work, the method is further developed to account for the aeroelasticity of full-span wing-body configurations. This is accomplished by simultaneously integrating the unsteady aerodynamic forces and modal structural equations of the wing-body configurations. To validate the method, aeroelastic computations are made for a wing-body configuration with a rectangular wing. The aeroelastic responses of this configuration are correlated with the responses of a similar isolated wing. The comparisons are favorable. Aeroelastic computations associated with symmetric and asymmetric modes are also made to study the influence of modal asymmetry on responses. This new development is further illustrated by computing aeroelastic characteristics of a typical fighter aircraft. The results from this study will be useful in accurately computing the transonic flutter boundaries of aircraft, including those associated with asymmetric modes.

Guruswamy, Guru P.↗