Search NASA⌕ Search

SEARCH · Search NASA

Results for “solution phase”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9

Generalized gradient algorithm for trajectory optimization

The generalized gradient algorithm presented and verified as a basis for the solution of trajectory optimization problems improves the performance index while reducing path equality constraints, and terminal equality constraints. The algorithm is conveniently divided into two phases, of which the first, 'feasibility' phase yields a solution satisfying both path and terminal constraints, while the second, 'optimization' phase uses the results of the first phase as initial guesses.

Zhao, Yiyuan↗

Markov reliability models for digital flight control systems

The reliability of digital flight control systems can often be accurately predicted using Markov chain models. The cost of numerical solution depends on a model's size and stiffness. Acyclic Markov models, a useful special case, are particularly amenable to efficient numerical solution. Even in the general case, instantaneous coverage approximation allows the reduction of some cyclic models to more readily solvable acyclic models. After considering the solution of single-phase models, the discussion is extended to phased-mission models. Phased-mission reliability models are classified based on the state restoration behavior that occurs between mission phases. As an economical approach for the solution of such models, the mean failure rate solution method is introduced. A numerical example is used to show the influence of fault-model parameters and interphase behavior on system unreliability.

Mcgough, John↗

Numerical analyses for treating diffusion in single-, two- and three-phase binary alloy systems

Numerical solutions were applicable for planar, cylindrical, or spherical geometries with any diffusion-zone size and any continuous variation of the diffusion coefficient with concentration. Special techniques were included in the analyses to account for differences in molal volumes, initiation and growth of an intermediate phase, disappearance of a phase, and the presence of an initial composition profile in the specimen. A major improvement in solution accuracy was achieved in the two phase analysis by employing a mass conservation criterion to establish the location of the interface rather than the conventional interface-flux-balance criterion. In the three phase analysis, computation time was minimized without sacrificing solution accuracy by treating the three phase problem as a two phase problem when the thickness of the intermediate phase was less than a preset small value. Three computer codes were developed to perform these analyses.

Tenney, D. R.↗

Phase partitioning experiment (8-IML-1)

Phase partitioning is a method of separating biological cells and macromolecules via their differential distribution in two phase aqueous polymer solutions. The ultimate goal of the experiment is to test the hypothesis that the efficiency of separation of closely related cell types, by partitioning in immiscible aqueous phases, will be enhanced in the non-convective environment provided by space. Before a cell separation experiment can be performed, the demixing of immiscible aqueous polymer solutions must be understood and controlled in order to optimize the experimental conditions for a cell separation experiment in the future. The present Phase Partitioning Experiment (PPE) is the third in a series, the first two flew on STS 51-D in Apr. 1985 and STS 26 in Oct. 1988. In those experiments the immiscible aqueous phases demixed spontaneously at different rates, the final disposition being one in which the phase which wetted the container wall surrounded the second phase which formed an 'egg yolk' in the center of the chamber.

Brooks, Donald E.↗

Optimal rendezvous in the neighborhood of a circular orbit

The minimum velocity change rendezvous solutions, when the motion may be linearized about a circular orbit, fall into two separate regions; the phase-for-free region and the general region. Phase-for-free solutions are derived from the optimum transfer solutions, require the same velocity change expenditure, but may not be unique. Analytic solutions are presented in two of the three subregions. An algorithm is presented for determining the unique solutions in the general region. Various sources of initial conditions are discussed and three examples presented.

Jones, J. B.↗

Optimal rendezvous in the neighborhood of a circular orbit

The minimum velocity-change rendezvous solutions, when the motion may be linearized about a circular orbit, fall into two separate regions; the phase-for-free region and the general region. Phase-for-free solutions are derived from the optimum transfer solutions, require the same velocity-change expenditure, but may not be unique. Analytic solutions are presented in two of the three subregions. An algorithm is presented for determining the unique solutions in the general region. Various sources of initial conditions are discussed and three examples are presented.

Jones, J. B.↗

New polymers for low-gravity purification of cells by phase partitioning

A potentially powerful technique for separating different biological cell types is based on the partitioning of these cells between the immiscible aqueous phases formed by solution of certain polymers in water. This process is gravity-limited because cells sediment rather than associate with the phase most favored on the basis of cell-phase interactions. In the present contract we have been involved in the synthesis of new polymers both to aid in understanding the partitioning process and to improve the quality of separations. The prime driving force behind the design of these polymers is to produce materials which will aid in space experiments to separate important cell types and to study the partitioning process in the absence of gravity (i.e., in an equilibrium state).

Harris, J. M.↗

Physical properties of immiscible polymers

The demixing of immiscible polymers in low gravity is discussed. Applications of knowledge gained in this research will provide a better understanding of the role of phase segregation in determining the properties of polymer blends made from immiscible polymers. Knowledge will also be gained regarding the purification of biological materials by partitioning between the two liquid phases formed by solution of the polymers polyethylene glycol and dextran in water. Testing of new apparatus for space flight, extension of affinity phase partitioning, refinement of polymer chemistry, and demixing of isopycnic polymer phases in a one gravity environment are discussed.

Harris, J. Milton↗

Numerical parametric studies of spray combustion instability

A coupled numerical algorithm has been developed for studies of combustion instabilities in spray-driven liquid rocket engines. The model couples gas and liquid phase physics using the method of fractional steps. Also introduced is a novel, efficient methodology for accounting for spray formation through direct solution of liquid phase equations. Preliminary parametric studies show marked sensitivity of spray penetration and geometry to droplet diameter, considerations of liquid core, and acoustic interactions. Less sensitivity was shown to the combustion model type although more rigorous (multi-step) formulations may be needed for the differences to become apparent.

Pindera, M. Z.↗

Effects of heat treating PM Rene' 95 slightly below the gamma' solvus

An investigation was performed on as-hot-isostatically-pressed (As-HIP) Rene' 95 to obtain additional information on the variation of the amount of gamma prime with solutioning temperatures near the gamma prime solvus temperature and the resulting effects on tensile and stress rupture strength of As-HIP Rene' 95. The amount of gamma prime phase was found to increase at a rate of about 0.5% per degree Celsius as the temperature decreased from the solvus temperature to about 50 C below the gamma prime solvus temperature. The change in the amount of gamma prime phase with decreasing solutioning temperature was observed to be primarily associated with decreasing solubilities of Al+Ti+Nb and increasing solubility of Cr in the gamma phase.

Dreshfield, R. L.↗

Phase conjugation by degenerate four wave mixing in disodium fluorescein solution in methanol

Organic dyes are known to show the resonant type of nonlinear optical properties, including phase conjugation. In the present work, disodium fluorescein in methanol is used as an organic nonlinear medium for degenerate four wave mixing at 532 nm to see the intensity dependence of the phase conjugate signal at different concentrations of the solution. It is observed that the maximum reflectivity of the signal occurs in a concentration range of 5 x 10(exp -3)/cu cm to 1.2 x 10(exp -2) g/cu cm. It is also observed that the intensity of the signal drops suddenly to less than half of its maximum outside the concentration range mentioned above. An investigation of the phase conjugate signal intensity by changing the delay time between probe signal and the forward pump is also examined. Briefly discussed is the possibility of population grating in dye liquids as a source of enhancing the third order susceptibility besides the other techniques mentioned in reference. The experiment is done by beam splitting the second harmonic (532 nm) of Nd:YAG laser, Q-switched at 20 pulses/sec (pulse width is approximately 8 and 200 mJ per pulse).

Abdeldayem, Hossin↗

Chaos in driven Alfven systems

The chaos in a one-dimensional system, which would be nonlinear stationary Alfven waves in the absence of an external driver, is characterized. The evolution equations are numerically integrated for the transverse wave magnetic field amplitude and phase using the derivative nonlinear Schroedinger equation (DNLS), including resistive wave damping and a long-wavelength monochromatic, circularly polarized driver. A Poincare map analysis shows that, for the nondissipative (Hamiltonian) case, the solutions near the phase space (soliton) separatrices of this system become chaotic as the driver amplitude increases, and 'strong' chaos appears when the driver amplitude is large. The dissipative system exhibits a wealth of dynamical behavior, including quasiperiodic orbits, period-doubling bifurcations leading to chaos, sudden transitions to chaos, and several types of strange attractors.

Hada, T.↗

Purification of biomaterials by phase partitioning

A technique which is particularly suited to microgravity environments and which is potentially more powerful than electrophoresis is phase partitioning. Phase partitioning is purification by partitioning between the two immiscible aqueous layers formed by solution of the polymers poly(ethylene glycol) and dextran in water. This technique proved to be very useful for separations in one-g but is limited for cells because the cells are more dense than the phase solutions thus tend to sediment to the bottom of the container before reaching equilibrium with the preferred phase. There are three phases to work in this area: synthesis of new polymers for affinity phase partitioning; development of automated apparatus for ground-based separations; and design of apparatus for performing simple phase partitioning space experiments, including examination of mechanisms for separating phases in the absence of gravity.

Harris, J. M.↗

Effects of Gas-Phase Radiation and Detailed Kinetics on the Burning and Extinction of a Solid Fuel

This is the first attempt to analyze both radiation and detailed kinetics on the burning and extinction of a solid fuel in a stagnation-point diffusion flame. We present a detailed and comparatively accurate computational model of a solid fuel flame along with a quantitative study of the kinetics mechanism, radiation interactions, and the extinction limits of the flame. A detailed kinetics model for the burning of solid trioxane (a trimer of formaldehyde) is coupled with a narrowband radiation model, with carbon dioxide, carbon monoxide, and water vapor as the gas-phase participating media. The solution of the solid trioxane diffusion flame over the flammable regime is presented in some detail, as this is the first solution of a heterogeneous trioxane flame. We identify high-temperature and low-temperature reaction paths for the heterogeneous trioxane flame. We then compare the adiabatic solution to solutions that include Surface radiation only and gas-phase and surface radiation using a black surface model. The analysis includes discussion of detailed flame chemistry over the flammable regime and, in particular, at the low stretch extinction limit. We emphasize the low stretch regime of the radiatively participating flame, since this is the region representative of microgravity flames. When only surface radiation is included, two extinction limits exist (the blow-off limit, and the low stretch radiative limit), and the burning rate and maximum flame temperatures are lower, as expected. With the inclusion of surface and gas-phase radiation, results show that, while flame temperatures are lower, the burning rate of the trioxane diffusion flame may actually increase at low stretch rate due to radiative feedback from the flame to the surface.

Rhatigan, Jennifer L.↗

The Curious Behavior of PSR JO537-6910

We report results from an extensive timing monitoring campaign of PSR JO537-6910, the 16-ms pulsar in the Large Magellanic Cloud, The source has been monitored using the Rossi X-ray Timing Explorer since January, 1999, and at least 18 glitches in its rotation rate have been seen. Despite this extreme activity, phase-connected timing solutions are maintained between the glitches. In addition to its high rotation rate and frequent large glitches, the pulsar has other unusual characteristics. First, a precursor is sometimes seen before the large glitches in which a large phase error is detected several days before the glitch. with no measurable change in pulsar frequency. Second, the size of a glitch is correlated with the time since the previous glitch. Third, phases measured during observations for several weeks after a glitch are often slightly below the extrapolation of best-fit model for the subsequent post-glitch data. It appears that a small fraction of the sudden increase in frequency decays with an e-folding time scale of about a week. We discuss the implications of these phenomena.

Marshall, Francis E.↗

Response of a Fabry-Perot cavity to phase modulated light

A solution to the lock-in detection method, which is valid for arbitrary values of the modulation frequency, is described. The theory for determining frequency modulation of a single frequency laser is presented. The theoretical predictions for the optimum modulation index are compared to experimental solutions for the quasi-static regime. Signal line shapes for first, second, and third harmonic generations are derived and examined. It is noted that there is good correlation between experimental and quasi-static theory data for the relation between small modulation frequency and resonance linewidth.

Hils, Dieter↗

Response of hot element flush wall gauges in oscillating laminar flow

The time dependent response characteristics of flush-mounted hot element gauges used as instruments to measure wall shear stress in unsteady periodic air flows were investigated. The study was initiated because anomalous results were obtained from the gauges in oscillating turbulent flows for the phase relation of the wall shear stress variation, indicating possible gauge response problems. Flat plate laminar oscillating turbulent flows characterized by a mean free stream velocity with a superposed sinusoidal variation were performed. Laminar rather than turbulent flows were studied, because a numerical solution for the phase angle between the free stream velocity and the wall shear stress variation that is known to be correct can be obtained. The focus is on comparing the phase angle indicated by the hot element gauges with corresponding numerical prediction for the phase angle, since agreement would indicate that the hot element gauges faithfully follow the true wall shear stress variation.

Giddings, T. A.↗