Search NASA⌕ Search

SEARCH · Search NASA

Results for “steerable”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 163 records · Page 9

Communicating through deep space

NASA's Deep Space Network (DSN) consists of a worldwide set of communication stations and a central control facility in California, enabling communication with spacecraft thousands of millions of miles from earth. The stations have gone from 26 m diameter antennas operating at 960 MHz to 70 m diameter (by 1988) at 8400 MHz. The DSN provides exceptional performance in high gain steerable antennas, ultra-low noise receivers, high power transmitters, frequency and time standards, and precise radio metric data. Spacecraft missions envisaged in the 1990's for the continuing exploration of the Solar System include an array of increasingly complex visits to the inner planets, asteroids and comets and the outer planets. The Deep Space Network planned for the mid-1980s may not meet all the needs of these missions without substantial change. Deep space stations may require conversion to operation with beam waveguides, higher frequency and relative frequency stability of 10 to the -16th. A deep space relay station in earth orbit could permit operation at higher frequencies, with attendant higher performance. Long range planning to select the appropriate future network configurations and develop the technologies essential to their implementation is underway.

Smith, J. G.↗

UHF and VHF radar observations of thunderstorms

A study of thunderstorms was made in the Summer of 1985 with the 430-MHz and 50-MHz radars at the Arecibo Observatory in Puerto Rico. Both radars use the 300-meter dish, which gives a beam width of less than 2 degrees even at these long wavelengths. Though the radars are steerable, only vertical beams were used in this experiment. The height resolution was 300 and 150 meters for the UHF and VHF, respectively. Lightning echoes, as well as returns from precipitation and clear-air turbulence were detected with both wavelengths. Large increases in the returned power were found to be coincident with increasing downward vertical velocities at UHF, whereas at VHF the total power returned was relatively constant during the life of a storm. This was attributed to the fact that the VHF is more sensitive to scattering from the turbulence-induced inhomogeneities in the refractive index and less sensitive to scatter from precipitation particles. On occasion, the shape of the Doppler spectra was observed to change with the occurrence of a lightning discharge in the pulse volume. Though the total power and mean reflectivity weighted Doppler velocity changed little during these events, the power is Doppler frequency bins near that corresponding to the updraft did increase substantially within a fraction of a second after a discharge was detected in the beam. This suggests some interaction between precipitation and lightning.

Holden, D. N.↗

HISCAT: A proposed new scatter facility in Northern Scandinavia

It is proposed that a new versatile ionospheric and atmospheric scatter radar be constructed in northern Scandavia through a multinational collaborative effort. The new facility tentatively named HISCAT (High frequency, High power, High latitude, Heating and Ionospheric Scatter facility), should be used for scientific investigations of: the physics of the neutral (middle) atmosphere; fundamental plasma phenomena, natural or artificially induced in the ionosphere; electrodynamic conditions at high altitudes above the auroral region and in the polar cap ionosphere; plasma waves in the solar atmosphere. The system should thus be able to operate as a mesosphere-stratosphere-troposphere (MST) radar, a so-called ionospheric modification facility, incoherent-scatter radar, coherent-scatter radar, and solar radar. Basically, the new facility should be a device that can operate simultaneously on several frequencies in the frequency range 5 to 50 MHz not covered by other instruments. It should comprise: powerful transmitters, capable of delivering a total average power of several megawatts; an advanced phased antenna array of high gain forming one or two steerable and well collimated beams; and an advanced data collection and analysis system.

Bostrom, R.↗

Simultaneous multibeam sounding of wind and turbulence

Most clear air radars use an antenna with either a few fixed beam positions or one that can be steered to a number of beam positions, one position at a time. For spatial studies of parameters that can change rapidly these conventional radar may be severely limited. The problem is that the fixed beam radars do not cover enough positions and the steerable radars may not be able to cover the entire field of interest in a short enough time period. Preliminary results are presented from a brief experiment that suggests a way to overcome some of these space-time problems in clear air radar research. A typical clear air radar antenna located in France was modified in a simple way to produce a number of beam simultaneouly. The radar, the modifications and the resulting beam patterns are described. Spectra is then shown obtained with the multibeam array and some results are presented on the spatial variations of reflectivity. Both the positive and negative aspects of using a multibeam antenna array for clear air radar studies are summarized.

Brun, E.↗

Method to determine the optimal parameters of the Arecibo 46.8-MHz antenna system

The spherical reflector at the Arecibo Observatory (AO) offers great advantages for the design of simple and inexpensive high performance steerable antennas at VHF. Light and small feeds have the added benefit that they can be quickly installed in the Arecibo platform. It is important to evaluate the performance of any given feed including the effects of the spherical reflector. The optimization is emphasized of two parameters, namely, the distance below the focal point of the reflector and the beam width of a point feed. For the design of the feed at 46.8 MHz at the AO there were other requirements independent of MST (mesosphere stratosphere troposphere) work. The design of the primary array is discussed along with its performance with the AO spherical reflector.

Ierkic, H. M.↗

The X-SAR System

During the past few years, there has been significant progress made in the planning for an X-band SAR, designed to fly in the shuttle together with the SIR-C system of NASA/JPL. New work and studies have been initiated to enable the goal of two missions in 1990 to be met. The antennas of X-SAR and SIR-C will be placed side-by-side on a pivoted steerable foldable structure, which will allow antenna movement without changing the attitude of the shuttle. This figure also shows the pallet, underneath the antenna structure, which houses the electronic sub-systems of both radars. Although the two radar systems, X-band SAR and the L- and C-band SAR of SIR-C, have different technical designs, their overall system performance, in terms of image quality, is expected to be similar. The current predicted performance of the X-SAR system based on results of the continuing Phase B studies is detailed. Differences between the performance parameters of X-SAR and those of SIR-C are only detailed in as far as they affect planning decisions to be made by experimenters.

Oettl, Herwig↗

Switches, lasers and electronically-hopped beam antennas in space - NASA's advanced communications technology satellite

The proposed design and operation of the Advanced Communications Technology Satellite (ACTS) are described. The ACTS is a three-axis stabilized spacecraft with an in-orbit weight of 2300 lbs and a beginning-of-life power of 1770 W; it is composed of a 20 GHz 2.2 m downlink antenna, a 30 GHz 3.3 m uplink antenna, a 1 m steerable antenna, and a laser package. The space segment communications payload uses high and low burst rate modes; the operations of these modes are discussed. The components of the laser intersatellite link instrument package are examined. Consideration is given to the ACTS's antennas, RF matrix switch system, and the base band processor. Diagrams of the ACTs systems are presented.

Lovell, Robert R.↗

Preliminary simultaneous L/C-band images from the JPL aircraft synthetic aperture radar

A squint mode processor for the processing of JPL aircraft SAR data collected in L-band and C-band is described which meets the criteria of optimum SNR, polarization isolation, and resolution. A steerable prefilter maximizes SNR while reducing the amount of data for processing efficiency. The resolution of images produced from data recorded at nonzero drift angle is improved by range migration compensation. The standard output products include high resolution images (with a range resolution of 7.5 m and an azimuth resolution of 2.74 m), four-look images (produced by averaging every four pixels in the azimuth direction for speckle reduction), and magnitude/phase-difference images (produced by correlating images of similar polarizations).

Lou, Yunling↗

DIRBE External Calibrator (DEC)

Under NASA Contract No. NAS5-28185, the Center for Space Engineering at Utah State University has produced a calibration instrument for the Diffuse Infrared Background Experiment (DIRBE). DIRBE is one of the instruments aboard the Cosmic Background Experiment Observatory (COBE). The calibration instrument is referred to as the DEC (Dirbe External Calibrator). DEC produces a steerable, infrared beam of controlled spectral content and intensity and with selectable point source or diffuse source characteristics, that can be directed into the DIRBE to map fields and determine response characteristics. This report discusses the design of the DEC instrument, its operation and characteristics, and provides an analysis of the systems capabilities and performance.

Wyatt, Clair L.↗

MSAT mobile electronically steered phased array antenna development

The Mobile Satellite Experiment (MSAT-X) breadboard antenna design demonstrates the feasibility of using a phased array in a mobile satellite application. An electronically steerable phased array capable of tracking geosynchronous satellites from anywhere in the Continental United States has been developed. The design is reviewed along with the test data. Cost analysis are presented which indicate that this design can be produced at a cost of $1620 per antenna.

Schmidt, Fred↗

Transonic low aspect ratio wing-winglet designs

A numerical design study has been conducted to ascertain the potential of winglets as a drag-reducing measure at high subsonic Mach numbers for low aspect ratio wings. The four variants of the winglet concept studied are a 'detuned' winglet with decreased incidence at the wing-winglet juncture; a steerable winglet; more gradual pressure recovery at the wing and winglet trailing edges; and the application of supercritical airfoil technology. A further study is conducted to assess the accuracy of the numerical code's predicted pressure drag values.

Kuhlman, John M.↗

More About Lens Antenna For Mobile/Satellite Communication

Report presents additional details of design of proposed phased-array antenna described in "Lens Antenna for Mobile/Satellite Communication" (NPO-16948). Intended to be compact and to lie flat on top of vehicle on ground. Transmits and receives circularly polarized radiation in frequency ranges of 821 to 825 MHz and 860 to 870 MHz. Transmitting and receiving beams electronically steerable to any of 48 evenly spaced directions to provide complete azimuth coverage, and would be fixed, but wide, in elevation, to provide coverage at elevation angles from 20 degrees to 60 degrees.

Rahmat-Samii, Y.↗

Computer-aided structural design of a lunar radio telescope

This paper describes a computer-aided structural design of the main reflector of a fully steerable radio telescope to be located (in the 21st century) on the moon, and presents the results of the structural analysis of the reflector. The reflector is a paraboloid with a surface area of 12,660 sq m and a focal ratio of 0.42. The reflector's surface will be covered by a 5.08 cm-thick sandwich panel made of thin-walled aluminum cells filled with low-density foam. The low weight of the design will be achieved by using graphite-epoxy as the structural material.

Akgul, Ferhat↗

Building a lunar observatory - An engineer's time table

This paper shows the feasibility of constructing a 400 ft diameter steerable parabolic radio dish-type observatory on the moon. A structural configuration and the construction procedure are presented. The estimated earth weight of the proposed structure, assuming that graphite-epoxy-invar is used, is about 42 tons. An engineering construction timeline is also presented. The proposed structural configuration of the observatory is shown to be realistic and attainable.

Chua, Koon Meng↗

Fabrication Of High-Tc Superconducting Integrated Circuits

Microwave ring resonator fabricated to demonstrate process for fabrication of passive integrated circuits containing high-transition-temperature superconductors. Superconductors increase efficiencies of communication systems, particularly microwave communication systems, by reducing ohmic losses and dispersion of signals. Used to reduce sizes and masses and increase aiming accuracies and tracking speeds of millimeter-wavelength, electronically steerable antennas. High-Tc superconductors preferable for such applications because they operate at higher temperatures than low-Tc superconductors do, therefore, refrigeration systems needed to maintain superconductivity designed smaller and lighter and to consume less power.

Bhasin, Kul B.↗

LLM: An L-band multibeam land mobile payload for Europe

The European Space Agency is developing, in the context of the ARTEMIS program, a multibeam reconfigurable mobile payload to provide pre-operational land-mobile satellite services at the L-band over Europe. The L-band Land-Mobile (LLM) payload features high capacity at L-band, efficient use of the L-band spectrum resources, and flexibility in reconfiguring the allocation of bandwith and RF power resources to the different beams. Additionally, a number of features were added to the payload purely for experimental purposes, like the provision of one steerable spot beam which can be repositioned anywhere within the coverage area, and the possibility to reuse L-band frequencies by spatial discrimination between non-adjacent beams, or via orthogonal polarizations. The architecture of the payload and the hardware implementation of the most critical subsystems are described.

Benedicto, J.↗

Experiments in teleoperator and autonomous control of space robotic vehicles

A program of research embracing teleoperator and automatic navigational control of freely flying satellite robots is presented. Current research goals include: (1) developing visual operator interfaces for improved vehicle teleoperation; (2) determining the effects of different visual interface system designs on operator performance; and (3) achieving autonomous vision-based vehicle navigation and control. This research program combines virtual-environment teleoperation studies and neutral-buoyancy experiments using a space-robot simulator vehicle currently under development. Visual-interface design options under investigation include monoscopic versus stereoscopic displays and cameras, helmet-mounted versus panel-mounted display monitors, head-tracking versus fixed or manually steerable remote cameras, and the provision of vehicle-fixed visual cues, or markers, in the remote scene for improved sensing of vehicle position, orientation, and motion.

Alexander, Harold L.↗

Grounded Coplanar Waveguide Feeds Phased-Array Antenna

Prototype electronically steerable K-band end-fire antenna includes phased array of four printed-circuit linear dipole elements fed by grounded coplanar waveguide (GCPW). Distribution-and-phasing network of antenna fed through single entering antenna split equally by three GCPW T junctions onto four GCPW transmission lines.

Ponchak, G.E.↗