Search NASA⌕ Search

SEARCH · Search NASA

Results for “Data Reduction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,621 records · Page 90

The effect of cyclic loading on the stiffness degradation of angle-ply composite laminates

An experimental investigation has been conducted to determine the effect of cyclic loading on the stiffness degradation of composite laminates. Specimens were tested in tension-tension fatigue at a frequency of 10 Hz and a stress ratio of 0.1, over a wide range of stress levels. The laminate employed for this investigation was made of graphite/epoxy in an angle-ply (+ or - 35)2s orientation. During this investigation both static and dynamic stiffness reduction data were recorded during constant amplitude fatigue testing, and the results are presented in tabular and graphical form.

Jones, D. L.↗

Production of global sea surface temperature fields for the Jet Propulsion Laboratory workshop comparisons

Sea surface temperature (SST) is measured from space by the advanced very high resolution radiometer (AVHRR), scanning multichannel microwave radiometer (SMMR), high resolution infrared sounder (HIRS) and VISSR atmospheric sounder (VAS). Typical accuracies have been reported from 0.5 C regionally to 2.0 C on a global basis. To evaluate the accuracy of the satellite-derived sea surface temperatures, a series of three workshops was organized to provide uniform data reduction and analysis. The analytical techniques used to intercompare satellite and in situ measurements are described in detail. Selected results showed the overall average rms errors were in the range 0.5-1.0 C.

Hilland, J. E.↗

D to H ratio and the origin and evolution of Titan's atmosphere

Potential causative factors for the unusually large ratio of CH3D to CH4 reported in the stratosphere of Titan (6 x 10 to the -4th) compared to that of Saturn (8.7 x 10 to the -5th) or Jupiter (6.7 x 10 to the -5th) are examined. With uncertainty in the observations and data reduction taken into account, an atmospheric enrichment factor of three or more is calculated for Titan relative to the planets. This enrichment factor is seen to be accounted for by condensation to form tropospheric methane clouds, fractionation occurring over a hypothetical CH4-C2H6 ocean and between the ocean and the clathrate crust beneath, fractionation which occurred during the formation of Titan, and fractionation as a result of the evolution of Titan's atmosphere. It is concluded that the greater part of the observed fractionation is probably derived from the last two of these mechanisms. The mechanisms studied do not account for the observed CH3D/CH4 value of 1.7 x 10 to the -3rd obtained by Kim and Caldwell (1982).

Pinto, J. P.↗

An experimental method for measuring droplet impingement efficiency on two- and three-dimensional bodies

An efficient and accurate method is described for extracting water droplet impingement efficiency data from dye impregnated blotter paper samples obtained by employing a dye-tracer technique in wind tunnel spray tests. The method is based on laser reflectance spectroscopy. A brief description of the test method, instrumentation, and data reduction system is also presented. Preliminary test results and analyses are included for a cylinder and a 65(2)015 airfoil.

Papadakis, M.↗

Holographic interferometry applied to symmetric aerodynamic models in a wind tunnel

The technique of holographic interferometry provides a means for noninvasive measurement of the air density distribution in the flow field in the vicinity of an aerodynamic model. A test of the applicability of this technique was the objective of this investigation. A holographic interferometer was installed in the 2- by 2-Foot Transonic Wind Tunnel at Ames Research Center. Several tests were conducted with this system on two axisymmetric models, one at subsonic and the other at supersonic speeds. Holograms were made of the flow field around the model for several test conditions. These holograms were reconstructed into interferograms in the laboratory. The fringe distribution (a measure of local densities) from a number of interferograms was digitized for subsequent data reduction. A computer program based on the Fourier transform technique was developed to convert the fringe distribution into a three-dimensional distribution of air density around the model. These results will be presented in this paper.

Perry, R. L.↗

Model deformation measurements at a cryogenic wind tunnel using photogrammetry

A photogrammetric closed circuit television system to measure model deformation at the National Transonic Facility (NTF) is described. The photogrammetric approach was chosen because of its inherent rapid data recording of the entire object field. Video cameras are used to acquire data instead of film cameras due to the inaccessibility of cameras which must be housed within the cryogenic, high pressure plenum of this facility. Data reduction procedures and the results of tunnel tests at the NTF are presented.

Burner, A. W.↗

A new 3D LDV system for the NASA Ames 6 x 6 ft. wind tunnel

An obvious extension of wind tunnel laser Doppler velocimetry (LDV), which is currently mainly limited to two-component measurements, would involve the measurement of three simultaneous velocity components. The present paper is concerned with an approach to reduce the degree of optical complexity involved in the design of a three-dimensional (3D) LDV system, taking into account the use of polarization separation. Such a system, utilizing polarization as well as color separation, has been designed and tested in a 6 x 6 foot supersonic wind tunnel. The considered instrument was designed for the on line measurement of three mean velocity components, turbulence levels, and shear stresses on a number of models under a wide variety of test conditions. Attention is given to optical details, data reduction, and sample application.

Owen, F. K.↗

X-ray observations of the bright quasar survey

Using the Einstein Observatory, X-ray observations of about 80 percent of the quasars in the Bright Quasar Survey located outside the declination range defined by 30 and 60 deg. X-ray emission has been detected above the 3-sigma level for 57 out of 66 quasars observed. This paper describes observations and data reduction and provides a summary of the more detailed analyses and discussion contained in the two accompanying papers (Schmidt and Green 1986, Avni and Tananbaum 1986).

Tananbaum, H.↗

Prospects for astrometry with the Hubble Space Telescope

The Hubble Space Telescope (HST), a large optical telescope having an aperture of 2.4 meters and a length of 8.8 meters, is being developed by NASA. This telescope will be placed into earth orbit by the Space Shuttle. Astrometric observations with the HST are made using a Fine Guidance Sensor which is capable of measuring the position of one object relative to another with an accuracy of + or - 0.002 arcseconds. The astrometric user of HST will be provided with an Astrometric Data Reduction Software package. The variety of astrometric problems to be investigated with HST is discussed.

Jefferys, W. H.↗

Radar stereomapping techniques and application to SIR-B images of Mt. Shasta

One of the goals of the SIR-B experiment was the definition of optimum radar incidence and intersection angles for radargrammetric stereoscopy by comparing the results from three separate data-reduction methods. To this end three overlapping images of the prime radargrammetric site (Mt. Shasta in northern California) were obtained, fewer than anticipated. This paper describes the mathematical basis for radar stereomapping, along with preliminary results from one of the methods (using a so-called 'analytical' stereoplotter) for the Mt. Shasta site. Height coordinate errors range from 60 to 170 m depending on the density (number per ground area) of ground control points used.

Leberl, F. W.↗

Research in lightning swept-stroke attachment patterns and flight conditions with the NASA F-106B airplane

Data on 637 direct lightning strikes and 117 close flashes observed by the NASA instrumented F-106B aircraft as part of the Storm Hazards Program at NASA Langley during 1980-1984 are compiled and analyzed, updating the report of Fisher and Plumer (1983). The airborne and ground-based measurement and recording apparatus and the flight and data-reduction procedures are described, and the results are discussed in terms of lightning-strike-conducive flight conditions and lightning attachment patterns. A peak strike rate of 2.1/min is found at altitude 38,000-40,000 ft and temperature below -40 C, with very few strikes below 20,000 ft. Four categories of swept-flash attachment pattern are identified, but it is pointed out that all exterior surfaces of the F-106B are potential attachment sites.

Fisher, B. D.↗

Mode II interlaminar fracture of graphite/epoxy and graphite/PEEK

The end notched flexure (ENF) specimen is employed in an investigation of the interlaminar fracture toughness in Mode II (skew symmetric shear) loading of unidirectional graphite/epoxy and graphite/PEEK composites. Important experimental parameters such as the influence of precracking and the data reduction scheme for the Mode II toughness are discussed. Nonlinear load-deflection response is significant for the tough thermoplastic resin composite but is also present for the brittle thermoset composite. The observed nonlinearities, which are highly rate dependent, are attributed to a combination of slow stable crack growth preceding unstable crack growth and material inelastic behavior in the process zone around the crack tip.

Carlsson, L. A.↗

Comet P/Halley 1910, 1986: An objective-prism study

V. M. Slipher of the Lowell Obs. collected a large amount of spectroscopic data during the 1910 apparition of Halley's comet. Three of his post perihelion objective-prism plates were selected, digitized, and subjected to modern digital data reduction procedures. Some of the important steps in the analysis where: (1) Density to intensity conversion for which was used 1910 slit spectra of Fe-arc lamp on similar plates (Sigma) and derived an average characteristic curve; (2) Flux calibration using the fact that during the period June 2 to 7 1910 P/Halley was very close (angular distance) to the bright star Alpha Sex (A0III, V-4.49), and the spectra of both star and comet were recorded on the same plates. The flux distribution of Alpha Sex was assumed to be similar to that of the standard star 58 Aql and derived a sensitivity curve for the system; (3) Atmospheric extinction using the standard curve for the Lowell Obs.; (4) Solar continuum subtraction using the standard solar spectrum binned to the spectral resolution. An example of a flux-calibrated spectrum of the coma (integrated over 87,000km) before the subtraction of solar continuum is presented.

Carsenty, U.↗

Computations for the 16-foot transonic tunnel, NASA, Langley Research Center, revision 1

The equations used by the 16 foot transonic tunnel in the data reduction programs are presented in eight modules. Each module consists of equations necessary to achieve a specific purpose. These modules are categorized in the following groups: tunnel parameters; jet exhaust measurements; skin friction drag; balance loads and model attitudes calculations; internal drag (or exit-flow distributions); pressure coefficients and integrated forces; thrust removal options; and turboprop options. This document is a companion document to NASA TM-83186, A User's Guide to the Langley 16 Foot Transonic Tunnel, August 1981.

Mercer, Charles E.↗

Laser fringe anemometry for aero engine components

Advances in flow measurement techniques in turbomachinery continue to be paced by the need to obtain detailed data for use in validating numerical predictions of the flowfield and for use in the development of empirical models for those flow features which cannot be readily modelled numerically. The use of laser anemometry in turbomachinery research has grown over the last 14 years in response to these needs. Based on past applications and current developments, the key issues which are involved when considering the application of laser anemometry to the measurement of turbomachinery flowfields are discussed. Aspects of laser fringe anemometer optical design which are applicable to turbomachinery research are briefly reviewed. Application problems which are common to both laser fringe anemometry (LFA) and laser transit anemometry (LTA) such as seed particle injection, optical access to the flowfield, and measurement of rotor rotational position are covered. The efficiency of various data acquisition schemes is analyzed and issues related to data integrity and error estimation are addressed. Real-time data analysis techniques aimed at capturing flow physics in real time are discussed. Finally, data reduction and analysis techniques are discussed and illustrated using examples taken from several LFA turbomachinery applications.

Strazisar, Anthony J.↗

High resolution infrared spectroscopy from space: A preliminary report on the results of the Atmospheric Trace Molecule Spectroscopy (ATMOS) experiment on Spacelab 3

The ATMOS (Atmospheric Trace Molecule Spectroscopy) experiment has the broad purpose of investigating the physical structure, chemistry, and dynamics of the upper atmosphere through the study of the distributions of the neutral minor and trace constituents and their seasonal and long-term variations. The technique used is high-resolution infrared absorption spectroscopy using the Sun as the radiation source, observing the changes in the transmission of the atmosphere as the line-of-sight from the Sun to the spacecraft penetrates the atmosphere close to the Earth's limb at sunrise and sunset. During these periods, interferograms are generated at the rate of one each second which yield, when transformed, high resolution spectra covering the 2.2 to 16 micron region of the infrared. Twenty such occultations were recorded during the Spacelab 3 flight, which have produced concentration profiles for a large number of minor and trace upper atmospheric species in both the Northern and Southern Hemispheres. Several of these species have not previously been observed in spectroscopic data. The data reduction and analysis procedures used following the flight are discussed; a number of examples of the spectra obtained are shown, and a bar graph of the species detected thus far in the analysis is given which shows the altitude ranges for which concentration profiles were retrieved.

Farmer, Crofton B.↗

Development of wind tunnel techniques for the solution of problems in planetary Aeolian processes

Kutzbach reports wind profiles over a series of roughness elements on a frozen lake and how the wind profile changed as the surface roughness was varied. The approach of the current study was to duplicate Kutzbach's roughness arrays in the wind tunnel at 1/20 and 1/40 scales, and to compare the wind profiles over these scale models to those derived by Kutzbach at full scale in the field. The effects of scale differences and data reduction techniques are discussed. Although the study suggests that wind tunnel scale models can predict parameters measured in the field, the development of more definitive guidelines requires a field experiment designed specifically for comparison with wind tunnel results.

Sullivan, Robert↗

Rare gas analysis of size fractions from the Fayetteville meteorite

Eight size separates of grains from the Fayetteville meteorite ranging from less than 20 microns to greater than 1 millimeter are being analyzed for their rare gas elemental and isotopic composition. Measurements on five samples were performed. All five reveal a mixture of solar, planetary, cosmic ray produced and radiogenic gases. The solar component is of particular interest since it suggest that the meteorite may represent a fragment of an ancient protoplanetary regolith which was exposed to the solar wind. Solar wind elements are implanted in the outer few hundred Angstroms of exposed grains and are therefore expected to be surface correlated. At present the data do not suggest that such a correlation exists, but the final conclusion must await further analyses and data reduction.

Jordan, Jim L.↗