Search NASA⌕ Search

SEARCH · Search NASA

Results for “Navigation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,621 records · Page 90

A description of the software analysis from flight and simulation data of the course cut limiter in the TCV b-737 area navigation computer

During automatic horizontal path captures, the (Terminal Configured Vehicle) B-737 airplane maintained smaller than designed path intercept angles and experienced a sawtooth bank angle oscillation during its turn towards the path. From flight data, it was determined that these anomalies were caused by the improper output of the course cut limiter in the horizontal path control law. The output from the course cut limiter did not obtain its full value and it was calculated stepwise discontinuously. The automatic horizontal path captures were then conducted on the TCV B-737 airplane real-time simulation. The path intercept angles were maintained properly and no bank angle oscillation was encountered. Data showed that the course cut limiter was calculated at its full value in a continuous manner. The intermediate calculations of the course cut limiter in the airplane's navigation computer were rewritten and rescaled in such a manner that truncation errors could be minimized. The horizontal path capture tests were then reflown. The airplane maintained the proper path intercept angle and no bank angle oscillations occurred on any of the tests.

Knox, C. E.↗

Calibration of Viking imaging system pointing, image extraction, and optical navigation measure

Pointing control and knowledge accuracy of Viking Orbiter science instruments is controlled by the scan platform. Calibration of the scan platform and the imaging system was accomplished through mathematical models. The calibration procedure and results obtained for the two Viking spacecraft are described. Included are both ground and in-flight scan platform calibrations, and the additional calibrations unique to optical navigation.

Breckenridge, W. G.↗

Simulation analysis of a microcomputer-based, low-cost omega navigation system

A status report is presented on a proposed low-cost Omega Navigation System (ONS) based on a microcomputer (Available commercially). Minimum hardware and maximum software are designed for. Electronic subsystems are discussed in detail, with block diagrams of the receiver and microcomputer interface modules, and a flowchart of the automatic synchronization process. The system is designed as a precision navaid for general aviation in the $1000 price range.

Lilley, R. W.↗

Self-navigating robot

Rangefinding equipment and onboard navigation system determine best route from point to point. Research robot has two TV cameras and laser for scanning and mapping its environment. Path planner finds most direct, unobstructed route that requires minimum expenditure of energy. Distance is used as measure of energy expense, although other measures such as time or power consumption (which would depend on the topography of the path) may be used.

Thompson, A. M.↗

Use of an inertial navigation system for accurate track recovery and coastal oceanographic measurements

A data acquisition system using a Litton LTN-51 inertial navigation unit (INU) was tested and used for aircraft track recovery and for location and tracking from the air of targets at sea. The characteristic position drift of the INU is compensated for by sighting landmarks of accurately known position at discrete time intervals using a visual sighting system in the transparent nose of the Beechcraft 18 aircraft used. For an aircraft altitude of about 300 m, theoretical and experimental tests indicate that calculated aircraft and/or target positions obtained from the interpolated INU drift curve will be accurate to within 10 m for landmarks spaced approximately every 15 minutes in time. For applications in coastal oceanography, such as surface current mapping by tracking artificial targets, the system allows a broad area to be covered without use of high altitude photography and its attendant needs for large targets and clear weather.

Oliver, B. M.↗

Ruler for making navigational computations

An extensive ruler used as a computer in navigation to calculate travel time between map points or to calculate ground speed is described. The ruler has a time scale that can be adjusted at length to equal map distances travelled at a designated speed in a time period such as sixty minutes. A means for fixing the length of the ruler is also provided.

Holmes, L., Jr.↗

Evaluation of STOL navigation avionics

Research projects, including work on a vector magnetometer for aircraft attitude measurement, are summarized. The earth's electric field phenomena was investigated in its application to aircraft control and navigation. Research on electronic aircraft cabin noise suppression is reviewed and strapdown inertial reference unit technical support is outlined.

Dunn, W. R., Jr.↗

Computer program for design and performance analysis of navigation-aid power systems. Program documentation. Volume 1: Software requirements document

A computer program has been developed for designing and analyzing the performance of solar array/battery power systems for the U.S. Coast Guard Navigational Aids. This program is called the Design Synthesis/Performance Analysis (DSPA) Computer Program. The basic function of the Design Synthesis portion of the DSPA program is to evaluate functional and economic criteria to provide specifications for viable solar array/battery power systems. The basic function of the Performance Analysis portion of the DSPA program is to simulate the operation of solar array/battery power systems under specific loads and environmental conditions. This document establishes the software requirements for the DSPA computer program, discusses the processing that occurs within the program, and defines the necessary interfaces for operation.

Goltz, G.↗

A video display interface for the LORAN-C navigation receiver development system

A microprocessor-based development system was designed and fabricated for prototype test of navigation receiver designs. During use of this system in the development of low-cost LORAN-C receiver/processor concepts, the limitations of the integral KIM-1 display were severely felt. It was to augment this numerical display that the video character display was produced. The circuit design presented meets the need for a flexible-format display capable of driving a small standard video monitor with only minimal demands upon microprocessor memory and MPU cycles.

Fischer, J. P.↗

Development and flight tests of a Kalman filter for navigation during terminal area and landing operations

A Kalman filter for aircraft terminal area and landing navigation was implemented and flight tested in the NASA Ames STOLAND avionics computer onboard a Twin Otter aircraft. This system combines navaid measurements from TACAN, MODILS, air data, radar altimeter sensors along with measurements from strap-down accelerometer and attitude angle sensors. The flight test results demonstrate that the Kalman filter provides improved estimates of the aircraft position and velocity as compared with estimates from the more standard complementary filter. The onboard computer implementation requirements to achieve this improved performance are discussed.

Schmidt, S. F.↗

Integrated guidance, navigation and control verification plan primary flight system

The verification process and requirements for the ascent guidance interfaces and the ascent integrated guidance, navigation and control system for the space shuttle orbiter are defined as well as portions of supporting systems which directly interface with the system. The ascent phase of verification covers the normal and ATO ascent through the final OMS-2 circularization burn (all of OPS-1), the AOA ascent through the OMS-1 burn, and the RTLS ascent through ET separation (all of MM 601). In addition, OPS translation verification is defined. Verification trees and roadmaps are given.

Source record↗

Airborne navigation system performance during RNAV/MLS transition

Aircraft position error sensitivity to sensor errors and flight path geometry is analyzed during RNAV/MLS transition using a digital computer simulation. The avionics sensitivity data provides information necessary to establish requirements for additional guidance law design and to establish airspace requirements for maneuvering to null out any residual RNAV errors upon MLS transition. The data base is also beneficial as planning information for subsequent flight testing. The parameters varied during the generation of the data base include flight profile, error source content and magnitude, ground facility location, runway/flight path orientation and navigation mode. The avionics, autopilots and aircraft dynamics correspond to the existing NASA Terminal Configured Vehicle. Significant transients were observed during MLS transition, primarily in the vertical channel. These transients have a significant impact on airspace requirements and operational procedures in the RNAV/MLS environment.

Heine, W.↗

The epoch state navigation filter

The formulation of a recursive maximum likelihood navigation system employing reference position and velocity vectors as state variables is presented. Convenient forms of the required variational equations of motion are developed together with an explicit form of the associated state transition matrix needed to refer measurement data from the measurement time to the epoch time. Computational advantages accrue from this design in that the usual forward extrapolation of the covariance matrix of estimation errors can be avoided without incurring unacceptable system errors. Simulation data for earth orbiting satellites are provided to substantiate this assertion.

Battin, R. H.↗

A reformulation of the Linear-Quadratic-Gaussian stochastic control problem for application to low thrust navigation analysis

The formulation of the classical Linear-Quadratic-Gaussian stochastic control problem as employed in low thrust navigation analysis is reviewed. A reformulation is then presented which eliminates a potentially unreliable matrix subtraction in the control calculations, improves the computational efficiency, and provides for a cleaner computational interface between the estimation and control processes. Lastly, the application of the U-D factorization method to the reformulated equations is examined with the objective of achieving a complete set of factored equations for the joint estimation and control problem.

Jacobson, R. A.↗

Mars gravity field derived from Viking-1 and Viking-2 - The navigation result

Viking-1 and Viking-2 Doppler tracking data taken during orbit phases characterized by 1500 km subperiapse altitudes have provided a basis for a determination of the Martian gravity field. Navigation results show that the linear combination of short-arc gravity estimates is an acceptable technique for obtaining gravity models over multiple data arcs. An ensemble field composed of Viking data and Mariner-9 a priori retains the inherent local accuracy of its constituent fields. At the same time, the model can be made to be valid globally by careful weighting of a priori Mariner-9 data. The sixth degree and order model presented reduces the error concerning the change in period by more than an order of magnitude during the high altitude (1500 km) phases of the Viking mission. The resulting areoid deviates by no more than 150 m from the areoid produced by the a priori Mariner-9 field.

Christensen, E. J.↗

LED display for solo aircraft instrument navigation

Solo pilot's task is made easier through convenient display of landing and navigation data. Use of display shows promise as more efficient means of presenting sequential instructions and data, such as course heading, altitude, and radio frequency, to minimize pilot's workload during solo instrument flight.

Crouch, R. K.↗

Navigation-aid power systems

Design synthesis and performance analysis (DSPA) program package is collection of subroutines used for computation of design and performance characteristics of viable solar-array-charged battery powered system for flashing-lamp buoys employed as maritime aids to navigation.

Goltz, G. L.↗

On-board landmark navigation and attitude reference parallel processor system

An approach to autonomous navigation and attitude reference for earth observing spacecraft is described along with the landmark identification technique based on a sequential similarity detection algorithm (SSDA). Laboratory experiments undertaken to determine if better than one pixel accuracy in registration can be achieved consistent with onboard processor timing and capacity constraints are included. The SSDA is implemented using a multi-microprocessor system including synchronization logic and chip library. The data is processed in parallel stages, effectively reducing the time to match the small known image within a larger image as seen by the onboard image system. Shared memory is incorporated in the system to help communicate intermediate results among microprocessors. The functions include finding mean values and summation of absolute differences over the image search area. The hardware is a low power, compact unit suitable to onboard application with the flexibility to provide for different parameters depending upon the environment.

Gilbert, L. E.↗