Some chemical aspects of upper-atmosphere research
Winds of upper atmosphere measured by chemiluminescent gas trail formed by chemical vaporizer release agents reacting with atomic oxygen
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Winds of upper atmosphere measured by chemiluminescent gas trail formed by chemical vaporizer release agents reacting with atomic oxygen
Hydrogen maser potential as stable frequency reference for precision tracking systems
The influence of X-ray heating on gas flows in binary X-ray systems is examined. A simple estimate is obtained for the evaporative wind flux from a stellar atmosphere due to X-ray heating which agrees with numerical calculations by Alme and Wilson (1974) but disagrees with calculations by Arons (1973) and by Basko and Sunyaev (1974) for the Her X-1/HZ Her system. The wind flux is sensitive to the soft X-ray spectrum. The self-excited wind mechanism does not work. Mass transfer in the Hercules system probably occurs by flow of the atmosphere of HZ Her through the gravitational saddle point of the system. The accretion gas stream is probably opaque with atomic density of not less than 10 to the 15th power per cu cm and is confined to a small fraction of 4(pi) steradians. Other binary X-ray systems are briefly discussed.
Eight comets were observed with the IUE at various-heliocentric and geocentric distances. Their UV spectra are remarkably similar despite the large differences in the dust to gas ratios. Since all the dominant atomic species (except N) radicals and ions of the coma are detected in this spectral region, the total gaseous output of the nucleus can be estimated. The abundance of the carbon atom-bearing species is still not very well known and there are indications that the CO content of the coma could vary from comet to comet.
The basic governing equations for the low-density, high-enthalpy flow regimes expected in the shock layers over the heat shields of the proposed aeroassisted orbital transfer vehicles are derived by combining and extending existing theories. The conservation equations are derived from gas kinetic principles for a four-component ionized gas consisting of neutral molecules, neutral atoms, singly ionized ions, and electrons, assuming a continuum flow. The differences among translational-rotational, vibrational, and electron temperatures are accounted for, as well as chemical nonequilibrium and electric-charge separation. Expressions for convective and viscous fluxes, transport properties, and the terms representing interactions among various energy modes are given explicitly. The expressions for the rate of electron-vibration energy transfer, which violates the Landau-Teller conditions, is derived by solving the system of master equations accounting for the multiple-level transitions.
The diffuse component of the galactic high energy gamma rays results mainly from the interaction of CR nuclei and electrons with the nuclei of the interstellar gas. An additional contribution is obtained from the interaction of CR electrons with the interstellar photons through the inverse-Compton (IC) process. Gamma ray astronomy therefore offers an excellent means to study the distribution of CR particles throughout the Galaxy, but it is essential to know the distribution of the target interstellar gas particles, the major constituents being atomic and molecular hydrogen. Large scale millimeter wave surveys of the CO molecule covering more than half of the Milky Way, obtained with the Columbia 1.2 m telescopes, are currently available and are used to trace the H2; the COS-B observations have sufficient resolution and sensitivity to constrain the relation between the integrated CO line intensity and the molecular hydrogen column density.
Two pneumatic two-fluid atomizers operating at high liquid and gas pressures produced water sprays that simulated small droplet clouds for use in studying icing effects on aircraft performance. To measure median volume diameter, MVD or D sub v.5, of small droplet water sprays, a scattered-light scanning instrument was developed. Drop size data agreed fairly well with calculated values at water and nitrogen pressures of 60 and 20 psig, respectively, and at water and nitrogen pressures of 250 and 100 psig, respectively, but not very well at intermediate values of water and nitrogen pressure. MVD data were correlated with D sub 0, W sub N, and W sub w, i.e., orifice diameter, nitrogen, and water flowrate, respectively, to give the expression for MVD in microns.
Two pneumatic two-fluid atomizers operating at high liquid and gas pressures produced water sprays that simulated small droplet clouds for use in studying icing effects on aircraft performance. To measure median volume diameter, MVD or D sub v.5, of small droplet water sprays, a scattered-light scanning instrument was developed. Drop size data agreed fairly well with calculated values at water and nitrogen pressures of 60 and 20 psig, respectively, and at water and nitrogen pressures of 250 and 100 psig, respectively, but not very well at intermediate values of water and nitrogen pressure. MVD data were correlated with D sub O, W sub N, and W sub w, i.e., orifice diameter, nitrogen, and water flowrate, respectively, to give the expression for MVD in microns.
Diamondlike carbon (DLC) films were grown by primary ion beam deposition and the growth rates were measured for various beam energies, types of hydrocarbon gases and their ratio to Ar, and substrate materials. The growth rate had a linear dependence upon hydrocarbon content in the discharge chamber, and only small dependence on other parameters. For given deposition conditions a threshold in the atomic ratio of carbon to argon gas was identified below which films did not grow on fused silica substrate, but grew on Si substrate and on existing DLC films. Ion source deposition parameters and substrate material were found to affect the deposition threshold and film growth rates.
The model presently used to examine the physical interactions between the ISM and the Oort Cloud can account for sputtering, sticking, and grain-impact erosion, as well as gas drag, by envisioning the ISM as a multiphase medium with distinct atomic and molecular cloud-phase regimes and coronal and warm/ambient gas-phase regimes. Erosion, which reduces the effectiveness of the thermal and radiation-damage processes acting on cometary surfaces in the Oort cloud, is found to be the dominant ISM interaction; ISM drag effects were found to efficiently remove submicron particles from the Cloud.
The X-ray iron line emission from NGC 1068 is modeled using the new multiline, multilevel, non-LTE radiative transport code Altair and a detailed atomic model for Ne-like through-stripped iron. The X-rays passing through the ionized gas induce iron K-alpha line emission. The atomic model was constructed to describe in detail the K-shell ionization and K-alpha line emission, as well as to calculate the ionization state properly. A greater equivalent width than previously predicted is found because the observed K-alpha line is produced not only by fluorescence but also by line scattering of the continuum into the line of sight. The K-alpha equivalent width and energy are functions not only of the ionization parameter, but also of the column depth and temperature. For a likely model of NGC 1068, it is found that the iron abundance is about twice solar, but that modifications of this model may permit a smaller abundance.
Accurate collision integrals for the interactions of N(4S0) + N(4S0), O(3P) + O(3P), and N(4S0) + O(3P) are reported. These are computed from a semiclassical formulation of the scattering using the best available representations of all of the potential energy curves needed to describe the collisions. Spectroscopic curves and other accurate measured data are used where available; the results of accurate ab initio electronic structure calculations are used to determine the remaining potential curves. The high-lying states are found to give the largest contributions to the collision cross sections. The nine collision integrals needed to determine transport properties to second order are tabulated for translational temperatures in the range 250-100,000 K. The viscosity, thermal conductivity, diffusion coefficient, and thermal diffusion factor for a gas composed of nitrogen and oxygen atoms in thermal equilibrium have been calculated. It is found that the second-order contribution to the transport properties is small. Graphs of these transport properties for various mixture ratios are presented for temperatures in the range 5000-15,000 K.
Accurate collision integrals are reported for the interactions of N(4 S 0) + N(4 S 0), O(3 P), and N(4 S 0) + O(3 P). These are computed from a semiclassical formulation of the scattering using the best available representations of all of the potential energy curves needed to describe the collisions. Experimental RKR curves and other accurate measured data are used where available; the results of accurate ab initio electronic structure calculations are used to determine the remaining potential curves. The high-lying states are found to give the largest contributions to the collision cross sections. The nine collision integrals, needed to determine transport properties to second order, are tabulated for translational temperatures in the range 250 K to 100,000 K. These results are intended to reduce the uncertainty in future predictions of the transport properties of nonequilibrium air, particularly at high temperatures. The viscosity, thermal conductivity, diffusion coefficient, and thermal diffusion factor for a gas composed of nitrogen and oxygen atoms in thermal equilibrium are calculated. It was found that the second order contribution to the transport properties is small. Graphs of these transport properties for various mixture ratios are presented for temperatures in the range 5000 to 15000 K.
A fraction of the oxygen in the Martian atmosphere continually escapes to space because dissociative recombination of the O2(+) ions in the ionosphere can impart sufficient energy to the product O atoms. In addition, ionization of the extended atomic oxygen corona resulting from the above process adds to escape since the solar wind can carry away O(+) ions born above a few hundred km altitude. A further by-product of this ion-pickup by the solar wind is an additional population of escaping oxygen atoms that are sputtered from the atmosphere near the exobase by pickup ions that are on reentry rather than escaping trajectories. This sputtering process can also remove carbon in the form of intact or dissociated CO2 since all atoms and molecules in the 'target' gas are subject to the collisional energy transfer that characterizes sputtering. We have estimated the present rates of escape of oxygen and carbon due to these mechanisms, as well as the rates at several epochs in the history of the solar system.
An analysis of the diffuse interstellar cloud complex in front of HD 179406 (20 Aql) is presented. Along this sight line, multispectral absortion- and emission-line studies have uncovered at least three distinct velocity components due to individual clouds. A dominant velocity component is seen in both the absorption and emission-line data sets at 3 +/- 1 km/s. It is argued that the cloud associated with this velocity component is responsible for most of the atomic and all of the molecular gas in front of 20 Aql. The present chemical and physical analysis of the cloud combines the diagnostic tools of radio emission-line data with those of UV and optical absorption data. Using non-LTE models to synthesize the observed absorption profiles, (C-12)O and (C-13)O column densities along this line of sight are determined. The (C-12)O/(C-13)O abundance ratio was found to be 50 +/- 15, similar to that found by Wannier et al. toward Zeta Oph. The physical conditions of the cloud have been investigated using ultraviolet absorption lines. Measurements indicate that the dominant absorption cloud has a gas pressure similar to that found in the local diffuse molecular cloud in Ophiuchus with nT = 20,000/cu cm K.
Liquid fuel dispersion in practical systems is typically achieved by spraying the fuel into a polydisperse distribution of droplets evaporating and burning in a turbulent gaseous environment. In view of the nearly unsurmountable difficulties of this two-phase flow, it would be useful to use an experimental arrangement that allow a systematic study of spray evolution and burning in configurations of gradually increasing levels of complexity, starting from laminar sprays to fully turbulent ones. An Electrostatic Spray (ES) of charged droplets lends itself to this type of combustion experiments under well-defined conditions and can be used to synthesize gradually more complex spray environments. In its simplest configuration, a liquid is fed into a small metal tube maintained at several kilovolts relative to a ground electrode few centimeters away. Under the action of the electric field, the liquid meniscus at the outlet of the capillary takes a conical shape, with a thin jet emerging from the cone tip. This jet breaks up farther downstream into a fine spray of charged droplets. Several advantages distinguish the electrospray from alternative atomization techniques: the self-dispersion property of the spray due to coulombic repulsion; the absence of droplet coalescence; the potential control of the trajectories of charged droplets by suitable disposition of electrostatic fields; and the decoupling of atomization, which is strictly electrostatic, from gas flow processes. Furthermore, as recently shown in our laboratory, the electrospray can produce quasi-monodisperse droplets over a very broad size range (1-100 microns). The ultimate objective of this research project is to study the formation and burning of electrosprays of liquid fuels first in laminar regimes and then in turbulent ones. Combustion will eventually be investigated in conditions of three-dimensional droplet-droplet interaction, for which experimental studies have been limited to either qualitative observations in sprays or more quantitative observations on simplified systems consisting of a small number of droplets or droplet arrays. The compactness and potential controllability of this spray generaiton system makes it appealing for studies to be undertaken in the next two years on electrospray combustion in reduced-gravity environments such as those achievable at NASA microgravity test facilities.
This report contains standard-state thermodynamic functions for 50 gaseous atomic elements plus deuterium and electron gas, 51 singly ionized positive ions, and 36 singly ionized negative ions. The data were generated by the NASA Lewis computer program PAC97, a modified version of PAC91 reported in McBride and Gordon. This report is being published primarily to document part of the data currently being used in several NASA Lewis computer programs. The data are presented in tabular and graphical format and are also represented in the form of least-squares coefficients. The tables give the following data as functions of temperature : heat capacity, enthalpy, entropy Gibbs energy, enthalpy of formation, and equilibrium constant. A brief discussion and a comparison of calculated results are given for several models for calculating ideal thermodynamic data for monatomic gases.
The basic governing equations for the low-density, high-enthalpy flow regimes expected in the shock layers over the heat shields of the proposed aeroassisted orbital transfer vehicles are derived by combining and extending existing theories. The conservation equations are derived from gas kinetic principles for a four-component ionized gas consisting of neutral molecules, neutral atoms, singly ionized ions, and electrons, assuming a continuum flow. The differences among translational-rotational, vibrational, and electron temperatures are accounted for, as well as chemical nonequilibrium and electric-charge separation. Expressions for convective and viscous fluxes, transport properties, and the terms representing interactions among various energy modes are explicitly given. The expressions for the rate of electron-vibration energy transfer, which violates the Landau-Teller conditions, are derived by solving the system of master equations accounting for the multiple-level transitions.