Search NASA⌕ Search

SEARCH · Search NASA

Results for “stability analysis”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 1,747 records · Page 97

Analysis of aeroelastic model stability augmentation systems

An analytical and mechanization study was conducted for two flutter stability augmentation systems. One concept uses only the wing trailing edge control surface. Another concept uses leading and trailing edge control surfaces operating simultaneously. The combined use of leading and trailing edge control surfaces should improve the surface coupling (controllability) with vertical bending and torsional structural modes and decrease the coupling between bending and torsional modes. The study was directed toward stability augmentation systems characteristics for the supersonic transport aircraft.

Sevart, F. D.↗

Summary and analysis of performance and stability characteristics of the refan JT8D-109 engine

The refan JT8D-109 performance and stability characteristics are reported as determined from sea level testing, altitude testing, and DC-9 flight testing. The test results are summarized as follows: (1) TSFC at SLS achieved design goal of 12.66 percent reduction. (2) TSFC at altitude average cruise power 0.5 percent higher than design goal, (3) TSFC at altitude maximum cruise power 1.7-3.7 percent higher than design goal, (4) ground starting consistent with JT8D-9 base engine, (5) successful flight starts without starter assist, (6) transient surge margin equivalent to JT8D-9, (7) stable engine operation with inlet distortion, and (8) stable engine operation during snap acceleration and deceleration. A flight idle setting is required for acceptable aborted-landing go-around acceleration time due to increase in low-rotor moment of inertia, and a performance improvement program should be conducted as part of any future certification program.

Sanberg, K. G.↗

Metal ion-containing epoxies

A variety of metallic and organometallic complexes to be used as potential additives for an epoxy used by the aerospace industry as a composite matrix resin were investigated. A total of 9 complexes were screened for compatibility and for their ability to accelerate or inhibit the cure of a highly crosslinkable epoxy resin. Methods for combining the metallic complexes with the resin were investigated, gel times recorded, and cure exotherms studied by differential scanning calorimetry. Glass transition temperatures of cured metal ion containing epoxy castings were determined by thermomechanical analysis. Thermal stabilities of the castings were determined by thermogravimetric analysis. Mechanical strength and stiffness of these doped epoxies were also measured.

Stoakley, D. M.↗

An analysis for crack layer stability

The problem of uncontrolled crack propagation and crack arrest is considered with respect to crack layer (CL) translational stability. CL propagation is determined by the difference between the energy release rate and the amount of energy required for material transformation, and necessary and sufficient conditions for CL instability are derived. CL propagation in polystyrene is studied for two cases. For the case of remotely applied fixed load fatigue, the sufficient condition of instability is shown to be met before the necessary condition, and the necessary condition controls the stability. For the fixed displacement case, neither of the instability conditions are met, and CL propagation remains stable, resulting in crack arrest.

Sehanobish, K.↗

Analysis of a swirl stabilized arcjet thruster

Viscous swirling flow through transonic converging-diverging nozzles (with and without centerbodies) is examined numerically. An implicit technique is used to solve the axisymmetric Thin Layer Naiver-Stokes equations. The effect of swirl and viscosity on low Reynolds number flows is shown by examining integral parameters and flowfield details.

Keith, Theo G., Jr.↗

Analysis of the linear stability of compressible boundary layers using the PSE

The application of linearized parabolic stability equations (PSE) to compressible flow is considered. The effect of mean-flow nonparallelism is found to be weak on 2D waves and strong on 3D waves. Results for a single choice of free-stream parameters that corresponds to the atmospheric conditions at 15,000 m above sea level are presented.

Bertolotti, F. P.↗

Aerodynamic characteristics of NACA RM-10 missile in 8- by 6-foot supersonic wind tunnel at Mach numbers from 1.49 to 1.98 I : presentation and analysis of pressure measurements (stabilizing fins removed)

Experimental investigation of flow about a slender body of revolution (NACA RM-10 missile) aligned and inclined to a supersonic stream was conducted at Mach numbers from 1.49 to 1.98 at a Reynolds number of approximately 30,000,000. Boundary-layer measurements at zero angle of attack are correlated with subsonic formulations for predicting boundary-layer thickness and profile. Comparison of pressure coefficients predicted by theory with experimental values showed close agreement at zero angle of attack and angle of attack except over the aft leeward side of body. At angle of attack, pitot pressure measurements in plane of model base indicated a pair of symmetrically disposed vortices on leeward side of body.

LOADS - FUSELAGE, NACELLES, AND CANOPIES↗

Quantitative Analysis of Spaceflight Drug Stability Data to Support a Predictive Pharmaceutical Testing Strategy

To systematically quantify the time-dependent effect of spaceflight on active pharmaceutical ingredient (API) degradation, data were extracted from available published and unpublished spaceflight drug stability studies. Seven studies were identified that investigated the stability of individual medications following storage aboard crewed spacecraft. Medications stored for up to 2.4 years in low earth orbit (LEO) show limited change in API potency that, in all cases, falls within 10% of matched terrestrial controls, and within 5% of controls for the most drugs. This investigation shows that spaceflight is associated with a ~1.5-fold increase in the degradation rate relative to lot-matched terrestrial controls. Spaceflight is associated with an increased probability of drug failure over time; however, the incremental increase in degradation risk associated with spaceflight is minor compared to the baseline risk associated with terrestrial controls. Since most drugs across all NASA-supported studies were repackaged solid oral formulations that had been removed from protective manufacturer packaging, it is likely that prolonged exposure to atmospheric factors during both terrestrial and spaceflight treatments is a key contributor to degradation. Unique spaceflight environmental factors, particularly ionizing radiation and elevated CO2, may contribute to the additional cumulative effect of spaceflight. The results of this study show that the effect of spaceflight on drug stability is minor relative to the terrestrial baseline; however, the degradation rate and time-dependent failure of terrestrial controls highlights an extremely critical need to evaluate the effect of current repackaging methods and development of operationally appropriate methods to protected repackaged solid oral medications from environmental factors that mediate degradation.

J F Reichard↗