Heat transfer characteristics of impinging steady and synthetic jets over vertical flat surface
In this paper, heat transfer characteristics of single-slot impinging steady and synthetic jets on a 25.4-mm × 25.4-mm vertical surface were experimentally investigated. The experiments were conducted with a fixed nozzle width of 1 mm. For the steady jet study, the parameters varied in the testing were nozzle length (4 mm, 8 mm, 12 mm, 15 mm), Reynolds (Re) number (100–2500), and dimensionless nozzle-to-plate spacing (H/D h = 5, 10, 15, 20). Correlations for average Nusselt (Nu) number were developed to accurately describe experimental data. The heat transfer coefficient over a vertical surface increases with increasing Re number. For a small nozzle-to-plate spacing (H/D h = 5), the average Nu number is not only a function of the Re number, but also a function of nozzle length. For large nozzle-to-plate spacing (H/D h ⩾ 10) and a nozzle length larger than 8 mm, the heat transfer coefficient is insensitive to H/D h and nozzle length. An 8-mm × 1-mm synthetic jet was studied by varying the applied voltage (20–100 V), frequency (200–600 Hz), and dimensionless nozzle-to-plate spacing (H/D h = 5, 10, 15, 20). Compared to the steady jet, the synthetic jet exhibited up to a 40% increase in the heat transfer coefficient. As a result, the dynamic Re number was introduced to correlate heat transfer characteristics between synthetic jets and steady jets. Using the dynamic Re number collapses the synthetic and steady jet data into a single Nu number curve.