Search NASA⌕ Search

SEARCH · Search NASA

Results for “34-m”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Minimizing the RMS surface distortions from gravity loadings of the 34-m HA-DEC antenna for deep space missions

The computer analysis of the 34-m HA-DEC antenna by the IDEAS program provided the rms distortions of the surface panels support points for full gravity loadings in the three directions of the basic coordinate system of the computer model. The rms distortions for the gravity vector not in line with any of the three basic directions were solved and contour plotted starting from three surface panels setting declination angle. By inspections of the plots, it was concluded that the setting or rigging angle of -15 degrees declination minimized the rms distortions for sky coverage of plus or minus 22 declination angles to 10 degrees of ground mask.

Katow, S. M.↗
NASA NTRS1993

Stability measurements of the radio science system at the 34-m high-efficiency antennas

From 1991 to 1993 the fractional frequency stability of the operational Radio Science System was measured at DSS's 15, 45, and 65. These stations are designed to have the most stable uplink and downlink equipment in the Deep Space Network (DSN). Some measurements were performed when the antenna was moving and the frequency was ramped. The stability, including contributions of all elements in the station except for the antenna and the hydrogen maser, was measured to be 0.3 to 1.3 x 10(exp -15) when the frequency was fixed, and 0.6 to 6.0 x 10(exp -15) when the frequency was ramped (sample interval, 1000 sec). Only one measurement out of fifteen exceeded specification. In all other cases, when previous measurements on the antenna and the hydrogen maser were added, a total system stability requirement of 5.0 x 10(exp -15) as met. In addition, ambient temperature was found to cause phase variation in the measurements at a rate of 5.5 deg of phase per deg C.

Pham, T. T.↗
NASA NTRS1987

Structural design options for the new 34 meter beam waveguide antenna

In addition to the successful network of 34 m High Efficiency antennas recently built by JPL, the Deep Space Network (DSN) is embarking on the construction of a 34 m high performance, research and development antenna with beam waveguide optics at the Venus site. The construction of this antenna presents many engineering challenges in the area of structural, mechanical, RF, and pointing system design. A set of functional and structural design requirements is outlined to guide analysts in the final configuration selection. Five design concepts are presented covering both the conventional center-fed beam optics as well as the nonconventional, by-pass beam configuration. The merits of each concept are discussed with an emphasis on obtaining a homologous design. The preliminary results of structural optimization efforts, currently in progress, are promising, indicating the feasibility of meeting, as a minimum, all X-band (8.4 GHz) requirements, with a goal towards meeting Ka-band (32 GHz) quality performance, at the present budget constraints.

Katow, S.↗
NASA NTRS1980

DSN Monitor and Control System, Mark III-80

The Deep Space Network monitor and control system, Mark III-80 is described. The major implementations required to evolve from the Mark III-78 to the Mark III-80 configuration are identified. The affected facilities are the deep space stations and the network operations control center (NOCC). At the deep space stations a stand-alone host processor is implemented. Included are software (host software) changes which provide downline loading to the stand-alone host processor from a disc unit of any idle data system computer. At deep space stations with a 34 m antenna, the microwave subsystem is provided with an interface which allows remote configuration selection at the central monitor and control operator's position. In the NOCC, software changes are implemented to provide precision power monitor and GCF monitor displays.

Leflang, J. G.↗
NASA NTRS1982

Tidbinbilla two-element interferometer

A phase-stable two-element interferometer has been formed by linking the 64- and 34-m antennas of the Deep Space Network at Tidbinbilla, Australia. Utilizing the existing first-stage maser receivers at 2.3 GHz to yield a system temperature of approximately 20 K, the system has a 5 sigma detection sensitivity of 50 mJy in 1 s, with a rms confusion of approximately 6 mJy. The 195-m north-south baseline permits positional measurements to approximately 2 arcsec of sources stronger than approximately 100 mJy over the declination range -80 to +30 deg. Such measurements are ideally suited for the optical identification of weak radio sources. It is planned to extend the frequency of operation of the instrument to 8.4 GHz in the near future.

Batty, M. J.↗
NASA NTRS1982

An advanced generation land mobile satellite system and its critical technologies

A conceptual design for a Land Mobile Satellite System (LMSS) for the 1990s is presented. LMSS involves small tranceivers accessing satellites directly, with ground reception through small car-top antennas. The satellite would have a large antenna and blanket coverage areas in the UHF. The call may originate from a home, be carried by wire to a gateway, transmitted to satellite on the S-band, converted to UHF on the satellite, and transmitted to the vehicle. The system design is constrained by the number of users in an area during the busiest hours, Shuttle storage, controllability factors, and the total area served. A 55-m antenna has been selected, with 87 spot beams and two 10 MHz UHF bands in the 806-890 MHz band. A 17 dB interbeam isolation level is required, implying that sufficient sub-bands can be generated to assure 8265 total channels. The mobile satellite (MSAT) would have an 83 m mast lower segment, a 34 m upper segment, and a second, 10 m antenna made of a deployable mesh. Various antenna function modes are considered.

Naderi, F.↗
NASA NTRS1984

The S201 far-ultraviolet imaging survey. III - A field in Sagittarius

Far-ultraviolet imagery of a 20 deg diameter field in Sagittarius, centered near (1950) R.A. 18 h 34 m, decl. -30 deg 25 arcmin, was obtained by the S201 far-ultraviolet camera during the Apollo 16 mission. In a 10-minute exposure covering the 1250-1600 A wavelength range, 1034 star images are detectable, with a limiting ultraviolet magnitude of about 10. Most of these objects are identified with early-type stars listed in the Smithsonian Astrophysical Observatory Star Catalog, the Catalog of Stellar Identifications, or both, but 203 objects remain unidentified or are identified with late-type stars. The photometric measurements appear to be in reasonable agreement with those of the International Ultraviolet Explorer for stars in common, and with expectations for A0 stars. A detailed photometric study was made of the Messier 8 region, and it is concluded that dust-scattered starlight contributes about half of the total radiation observed from the central region of M8.

Carruthers, G. R.↗
NASA NTRS1984

Antenna Microwave Subsystem

The Deep Space Net consists of 64-m, 34-m, and 26-m antennas, each with its own characteristics. The changes that are being made to each under the Mark IV program and additions required for some special spacecraft projects are discussed.

Parsons, P. L.↗
NASA NTRS1985

Subreflector Focusing Techniques Applied to New DSS-15 and DSS-45 34-meter Antennas

An improved technique to determine the subreflector translations required to properly focus a Cassegrainian antenna, under gravity loading, at a full range of elevation angles, is presented. This technique is applied to the 34-m antenna configuration installed at stations DSS-15 (Goldstone, California) and DSS-45 (Australia). The subreflector lateral and axial translations, to be stored into the antenna-control systems, are computed and tabulated. The relationships that govern the main parameters are also presented for future subreflector focusing analysis under wind and thermal loadings.

Hughes, R. D.↗
NASA NTRS1986

A conceptual 34-meter antenna feed configuration for joint DSN/SETI use from 1 to 10 GHz

The very satisfactory performance of a conceptual 34-m DSS-12 type HA-Dec antenna feed sysem over the frequency range of 1 to 10 GHz is demonstrated. A seven-feedhorn baseline design is developed which will allow Search for Extra-Terrestrial Intelligence (SETI) investigations using each horn over a 1.4:1 frequency range. A gain/system noise temperature (G/T) figure of merit is calculated for the frequency range of each horn; it is found that system performance down to 20 deg elevation is possible with a G/T degradation of less than 3 dB at every frequency. The design presented here will allow shared but independent antenna use by the Deep Space Network (DSN) and SETI with a minimum of operational impacts to DSN functions and no intrusions into the DSN microwave equipment configuration.

Slobin, S. D.↗
NASA NTRS1986

The new 34-meter antenna

The new 34-m high efficiency Azimuth - Elevation antenna configuration, including its features, dynamic characteristics and performance at 8.4-GHz frequencies is described. The current-technology features of this antenna produce a highly reliable configuration by incorporation of a main wheel and track azimuth support, central pintle pivot bearing, close tolerance surface panels and all-welded construction. Also described are basic drive controls that, as slaved to three automatic microprocessors, provide accurate and safe control of the antenna's steering tasks. At this time antenna installations are completed at Goldstone and Canberra and have operationally supported the Voyager - Uranus encounter. A third installation is being constructed currently in Madrid and is scheduled for completion in late 1986.

Pompa, M. F.↗
NASA NTRS1987

Low-noise cryogenic transmission line

New low-noise cryogenic input transmission lines have been developed for the Deep Space Network (DSN) at 1.668 GHz for cryogenically cooled Field Effect Transistors (FET) and High Electron Mobility Transistor (HEMT) amplifiers. These amplifiers exhibit very low noise temperatures of 5 K to 15 K, making the requirements for a low-noise input transmission line critical. Noise contribution to the total amplifier system from the low-noise line is less than 0.5 K for both the 1.668-GHz and 2.25-GHz FET systems. The 1.668-GHz input line was installed in six FET systems which were implemented in the DSN for the Venus Balloon Experiment. The 2.25-GHz input line has been implemented in three FET systems for the DSN 34-m HEF antennas, and the design is currently being considered for use at higher frequencies.

Norris, D.↗
NASA NTRS1987

Analysis of the ICE combiner for multiple antenna arraying

The passage of the International Cometary Explorer (ICE) through the tail of comet Giacobini-Zinner took place on September 11, 1985, at approximately 11:04 GMT. The signal-to-noise ratio of the data received from the ICE spacecraft during the comet encounter was improved by arraying the 64-m antenna channels A and B (RCP and LCP) with the two 34-m antennas. Specially designed combiners were built to combine the signals received by the three antennas at the different DSN sites to ensure that the spacecraft's weak signal was received. Although the ICE spacecraft was built with a 5-W transmitter and with a small antenna designed to provide data from no farther than 1 million miles, these combiners provided enough signal margin during the encounter to receive the ICE transmitted data from within the tail of comet Giacobini-Zinner, 44 million miles from earth.

Foster, C.↗
NASA NTRS1988

An optimal structure for a 34-meter millimeter-wave center-fed BWG antenna: The Cross-Box concept

An approach to the design of the planned NASA/JPL 34 m elevation-over-azimuth (Az-El) antenna structure at the Venus site (DSS-13) is presented. The antenna structural configuration accommodates a large (2.44 m) beam waveguide (BWG) tube centrally routed through the reflector-alidade structure, an elevation wheel design, and an optimal structural geometry. The design encompasses a cross-box elevation wheel-reflector base substructure that preserves homology while satisfying many constraints, such as structure weight, surface tolerance, stresses, natural frequency, and various functional constraints. The functional requirements are set to ensure that microwave performance at millimeter wavelengths is adequate. The cross-box configuration was modeled, optimized, and found to satisfy all DSN HEF baseline antenna specifications. In addition, the structure design was conceptualized and analyzed with an emphasis on preserving the structure envelope and keeping modifications relative to the HEF antennas to a minimum, thus enabling the transferability of the BWG technology for future retrofitting. Good performance results were obtained.

Chuang, K. L.↗
NASA NTRS1990

An Optimal Design For Steerable Dish Antenna With BWG

New design proposed for highly-efficient 34-m-diameter millimeter-wavelength antennas of NASA's Deep Space Network. Incorporates axial beam waveguide, BWG, and improved structure to maintain shape and alignment of reflecting surfaces. General approach to conceptual construction of structure to modularize overall system so critical constraint conditions pertaining to microwave optics and structural performance satisfied. Design retrofitted to existing NASA Deep Space Network 34-m antennas, or used as basis to build large ground-based steerable antennas. Engineering concepts involved in design adapted to design of other large, steerable antennas for telecommunications, radio astronomy, and military uses.

Chuang, K. L.↗
NASA NTRS1990

The determination of maximum deep space station slew rates for a high Earth orbiter

As developing national and international space ventures, which seek to employ NASA's Deep Space Network (DSN) for tracking and data acquisition, evolve, it is essential for navigation and tracking system analysts to evaluate the operational capability of Deep Space Station antennas. To commission the DSN for use in tracking a highly eccentric Earth orbiter could quite possibly yield the greatest challenges in terms of slewing capability; certainly more so than with a deep-space probe. The focus here is on the determination of the maximum slew rates needed to track a specific high Earth orbiter, namely the Japanese MUSES-B spacecraft of the Very Long Baseline Interferometry Space Observatory Program. The results suggest that DSN 34-m antennas are capable of meeting the slew rate requirements for the nominal MUSES-B orbital geometries currently being considered.

Estefan, J. A.↗
NASA NTRS1990

Structural fatigue in the 34-meter HA-Dec antennas

Structural modifications to the 34-m hour-angle-declination antennas, coupled with the use of the antennas beyond their intended lifespans, have led to structural fatigue, as evidenced by damage to the declination drive gear and cracks on the structural members and gussets. An analysis and simulation were made of the main antenna structural members. The analysis showed that the total stress to the antenna structure substantially exceeds the maximum levels recommended by the American Institute of Steel Construction (AISC). Although each of the separate static conditions of stress is only 50 percent of the total stress and does not reach the AISC reduced yield limit, fatigue can and did occur, causing the material to crack in the weakest places.

Vanhek, R. A.↗