Search NASA⌕ Search

SEARCH · Search NASA

Results for “Brine”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2019

Assessment of geophysical monitoring methods for detection of brine and CO 2 leakage in drinking water aquifers

Here, we evaluated and compared the effectiveness of four surface-based geophysical monitoring methods to downhole pressure and chemical methods to detect brine and CO 2 leakage in underground sources of drinking water overlying a CO 2 storage reservoir. This assessment uses synthetic monitoring data generated from 400 simulated aquifer impact data sets. Here, the six monitoring techniques can detect impacted groundwater once 20,000 tonnes of CO 2 have leaked into the drinking water resource. Geophysical methods are most effective at detecting shallow plumes. Although downhole monitoring methods outperform geophysical methods in detecting deep plumes, geophysical methods may help reduce the false negative during the post injection site care because they detect impacted groundwater where downhole sensors may be absent.

58 GEOSCIENCES↗
DOE OSTI2016

Measurements of CO 2 ‐brine relative permeability in Berea sandstone using pressure taps and a long core

Abstract We measured CO 2 ‐brine relative permeability by performing five steady‐state primary drainage experiments in a 116 mD Berea sandstone core at 20°C and 10.34 MPa. We used a long (60.8 cm) core and four pressure taps to study and minimize end effects that can plague CO 2 ‐brine relative permeability measurements, and we obtained in situ saturation profiles using a medical X‐ray Computed Tomography (CT) scanner. We found that entrance and exit effects propagated ∼5 cm into the core, but the center sections of the core had uniform saturation. From the saturations and pressure drops, we obtained both CO 2 and brine relative permeability in the center sections. We also obtained CO 2 relative permeability at the entrance section where the brine saturation was lower and not uniform. The 15‐cm long exit section of the core had non‐uniform saturation and a measured pressure drop that was on the order of the capillary pressure and hence was unreliable for calculating relative permeability. We found that the CO 2 and brine relative permeabilities determined in five experiments were consistent with each other and followed two simple Corey‐type models that are similar to those seen in oil‐brine relative permeability measurements. We discuss why end effects are much greater in the CO 2 ‐brine system than in oil‐brine systems, and how this is a possible explanation of the low CO 2 relative permeabilities recently reported for the CO 2 ‐brine systems. © 2016 Society of Chemical Industry and John Wiley & Sons, Ltd.

Chen, Xiongyu↗
DOE OSTI2017

Review of the impacts of leaking CO 2 gas and brine on groundwater quality

This review paper provides a synthetic view of the existing knowledge and summarizes data and findings of the recent literature on the subject of the potential leaking of CO2 from the deep subsurface storage reservoirs and the effects on aquifer quality. New ideas and concepts are developed and insights are also provided. The objectives of this paper are to: 1) present and discuss potential risks for groundwater degradation due to CO2 gas and brine exposure; 2) identify the set of geochemical data required to assess and predict aquifer responses to CO2 and brine leakage. Specifically, this paper will discuss the following issues: 1) Aquifer responses (such as changes in aqueous phase/groundwater chemical composition; changes in solid phase chemistry and mineralogy; changes in the extent and rate of reactions and processes and possible establishment of a new network of reactions and processes affecting or controlling overall mobility of major, minor, and trace elements; development of conceptual and reduced order models (ROMs) to describe and predict aquifer responses); 2) The degree of impact such as significant or insignificant changes in pH and major, minor, and trace element release that depend on the following controlling variables; the effect of leaking plume characteristics (gas composition, pure CO2 and/or CO2 -CH4 -H2S mixtures and brine concentration and composition (trace metals); aquifer properties [such as initial aqueous phase conditions and mineralogy: minerals controlling sediments’ response (e.g., calcite, Si bearing minerals, etc.)]; overview of relevant hydrogeological and geochemical processes related to the impact of CO2 gas and brine on groundwater quality; the fate of the elements released from sediments or transported with brine (such as precipitation/incorporation into minerals (calcite and other minerals), adsorption, electron transfer reactions, the role of natural attenuation; whether or not the release of metals following exposure to CO2 harmful (risk assessment).

Qafoku, Nikolla P.↗
DOE OSTI2020

Geochemical narrowing of cement fracture aperture during multiphase flow of supercritical CO2 and brine

For carbon capture and storage operations, wells are used as a necessary conduit for injecting CO2 at depth, but they can also act as leakage conduits if the cement seals are compromised. The specific objective of this research was to investigate the nature of self-healing of a fracture within cement under multiphase flow of CO2 and brine, and to compare this to a newly developed model. This was accomplished through a laboratory investigation, flowing reacting supercritical CO2 and brine through a cement fracture with multiphase flow. The influent end of the fracture was degraded as evidenced by the formation of cracks across the surface. At the effluent end of the fracture, the initial aperture of 137 µm was reduced to 50 µm. This reduction by 87 µm was similar to results from a recently developed model tested in this study, which predicted an aperture reduction of 80 µm. Our results demonstrated that the model accurately predicted the reactions which occurred in this multiphase flow system.

wellbore, cement, fracture, multiphase-flow, super↗
DOE OSTI2018

Experimental and modeling study of calcium carbonate precipitation and its effects on the degradation of oil well cement during carbonated brine exposure

Decalcification of cement in solutions of carbonated brine is important to a host of engineering applications, especially in subsurface service environments where cementitious materials are frequently utilized as engineered barriers for wellbore seals, as well as shaft and drift seals and waste forms for nuclear waste disposal. Analysis of leaching simulations and experiments shows that, depending on solution compositions (dissolved CO{sub 2} concentration, pH, Ca ion concentration), calcite precipitation occurring during leaching of cement in contact with carbonated brine can have a significant impact on cement reactivity, in some instances leading to complete arrest of reactivity via calcium carbonate ''pore-clogging''. We present modeling and experimental results that examine the range of solution conditions that can lead to pore-clogging. Analysis of the results shows that distinct regimes of leaching behavior, based on pH and pCO2, can be used to form a framework to better understand the occurrence of pore-clogging.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗
DOE OSTI2018

Transport and Fate of Natural Gas and Brine Escaping from a Hydrocarbon Reservoir Through a Failed Deepwater Well in the Oceanic Subsurface of the Gulf of Mexico

The possibility of broaching, or the release of fluids at the seafloor due to a damaged or faulty well, is a hazard that must be assessed in the well permitting process. Here, this paper describes a numerical simulation study of a real-life scenario where a complex, permeable sandy formation, connected to the seafloor via known chimneys/seeps, is intersected by a damaged production well that drains another deeper, gas-bearing formation. The objective of the study is to determine the transport and fate of hydrocarbon reservoir fluids (gas and brines) escaping into the sandy formation through the casing shoe of the failed well, and to determine the time it takes for these contaminants to reach the ocean floor. We conducted a detailed simulation study to represent the conditions, properties, and behavior of the system under such failure conditions, and we investigated the migration of gas and brine for a range of reservoir and chimney properties. A key conclusion is that, for such complex systems, modeling the three-dimensional geometry of the system in detail is the key to describing transport and assessing the time and magnitude of potential releases. For the system studied here, transport times range from under 2 years (highest permeabilities) to many decades, ensuring significant time to respond to potential broaching hazards. Lastly, under the conditions investigated in this study, we also determine that gas-dominated releases associated with low rates of water flow into the sandy formation are likely to cause hydrate formation that can reduce permeabilities in the colder, upper regions of the chimneys and possibly mitigate releases.

58 GEOSCIENCES↗
DOE OSTI2021

Conducting thermal energy to the membrane/water interface for the enhanced desalination of hypersaline brines using membrane distillation

Membrane distillation (MD) is a membrane-based thermal desalination process capable of treating hypersaline brines. Standard MD systems rely on preheating the feed to drive the desalination process. However, relying on the feed to carry thermal energy is limited by a decline of the thermal driving force as the water moves across the membrane, and temperature polarization. In contrast, supplying heat directly into the feed channel, either through the membrane or other channel surfaces, has the potential of minimizing temperature polarization, increasing single-pass water recoveries, and decreasing the number of heat exchangers in the system. When solar thermal energy can be utilized, particularly if the solar heat is optimally delivered to enhance water evaporation and process performance, MD processes can potentially be improved in terms of energy efficiency, environmental sustainability, or operating costs. Here we describe an MD process using layered composite membranes that include a high-thermal-conductivity layer for supplying heat directly to the membrane-water interface and the flow channel. Here, the MD system showed stable performance with water flux up to 9 L/m 2 /hr, and salt rejection >99.9% over hours of desalinating hypersaline feed (100 g/L NaCl). In addition to bench-scale system, we developed a computational fluid dynamics model that successfully described the transport phenomena in the system.

42 ENGINEERING↗
DOE OSTI2022

Impact of Concurrent Solubilization and Fines Migration on Fracture Aperture Growth in Shales during Acidized Brine Injection

Acidic hydraulic fracturing fluid chemically and physically alters shale rock fabric during injection and shut-in, creating a “reaction-altered zone” along the fracture faces. To better characterize the variable thickness and composition of this reaction-altered zone under advective flow, we take a coupled experimental and modeling approach. A fluidic cell, with six fiducial markers, is first fabricated to keep the rock sample in place during the core floods and to allow image alignment of acquired images. Then, we conduct a series of reactive core floods in a clay-rich siliceous Wolfcamp shale sample with 10 wt % carbonate, using a synthetic fracturing fluid under no confining stress and at room temperature. High-resolution computed tomography (CT) scans are periodically conducted to observe the spatial alteration of the fracture network. We then perform scanning electron microscopy (SEM-EDS) on the two orthogonal surfaces (fracture surface and freshly cut profile face) to generate high-resolution elemental maps that show the change in mineralogy, both with distance along a given flow path along a fracture surface and with depth from the fracture surface into the shale matrix. These results are contrasted against a two-dimensional (2D) advection-diffusion reaction model developed previously for batch reactions between shale and synthetic fracturing fluids. The model simulates the geochemical interaction occurring at the fracture/matrix interface and penetrating into the shale matrix during the reactive core flood. Both model and experimental results show that the acidic brine is neutralized during the core flood, corresponding to an increase in fracture aperture as a function of fluid volume injected with the greatest change near the inlet. SEM-EDS scans reveal significant dissolution of carbonates on the fracture surface without pyrite oxidation. The reactive transport model indicates that carbonate depletion into the shale interior should be observable, yet SEM-EDS shows no discernible loss of carbonate in the orthogonal profile face. The combination of these observations suggests an additional fracture evolution mechanism in the reactive system, i.e., fines migration. We show that fines migration enhances the access of fracturing fluid to the matrix resulting in a more pronounced fracture widening. Finally, we conclude that coupled mineral dissolution and fines migration govern fracture aperture growth during acidized brine injection. In this work, we effectively show the underlying risk of relying solely on models that do not include an important (transport) process that can alter the system significantly and propose a combined chemomechanical mechanism for fracture evolution appropriate for this shale mineralogy.

58 GEOSCIENCES↗
DOE OSTI2019

Ion partitioning between brines and ion exchange polymers

Quantitative failure of the ideal Donnan model to predict ion partitioning between relatively dilute electrolyte aqueous solutions and ion exchange polymers arises from neglecting non-ideal behavior of ions. Hypothetically, when a water swollen, charged polymer is equilibrated with concentrated salt solutions, most of the fixed charge groups are neutralized by sorbed counter-ions, which can screen electrostatic effects and create, in the membrane, an environment thermodynamically similar to that experienced by ions in the external electrolyte solution. In this study, a combined experimental and theoretical approach was used to test this hypothesis. A fundamental study of ion partitioning between a cation exchange membrane based on cross-linked poly(p-styrene sulfonate-co-divinylbenzene) and NaCl and CaCl2 concentrated brines is presented. At high electrolyte concentrations, the experimentally measured ion activity coefficients in the membrane match those in the contiguous external solution, and the ideal Donnan model provides an accurate prediction of co-ion and counter-ion concentrations in the polymer. This physical picture was further confirmed by the recently developed Manning-Donnan model.

catalysis (heterogeneous)↗