Search NASA⌕ Search

SEARCH · Search NASA

Results for “Dean vortex”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

12 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

A Study of Dean Vortex Development and Structure in a Curved Rectangular Channel with Aspect Ratio of 40 at Dean Numbers up to 430

Flow in a curved channel with mild curvature, an aspect ratio of 40 to 1, and an inner to outer radius ratio of 0.979 is studied at Dean numbers De ranging from 35 to 430. For positions from the start of curvature ranging from 85 to 145 degrees, the sequence of transition events begins with curved channel Poiseuille flow at De less than 40-64. As the Dean number increases, observations show initial development of Dean vortex pairs, followed by symmetric vortex pairs which, when viewed in spanwise/radial planes, cover the entire channel height (De=90-100). At De from 40 to 125-130, the vortex pairs often develop intermittent waviness in the form of vortex undulations. Splitting and merging of vortex pairs is also observed over the same experimental conditions as well as at higher De. When Dean numbers range from 130 to 185-200, the undulating wavy mode is replaced by a twisting mode with higher amplitudes of oscillation and shorter wavelengths. The twisting wavy mode results in the development of regions where turbulence intensity is locally augmented at Dean numbers from 150 to 185-200, principally in the upwash regions between the two individual vortices which make up each vortex pair. These turbulent regions eventually increase in intensity and spatial extent as the Dean number increases further, until individual regions merge together so that the entire cross section of the channel contains chaotic turbulent motions. When Dean numbers then reach 400-435, spectra of velocity fluctuations then evidence fully turbulent flow.

Ligrani, Phillip M.↗
NASA NTRS1992

Tollmien-Schlichting wave/Dean vortex interactions in curved channel flow

Results from direct numerical simulations are presented to show that the weakly nonlinear results of Daudpota et al. (1988) are in error with respect to the influence of the Tollmien-Schlichting wave on the Dean vortex. The results of a new weakly nonlinear theory are then presented, and it is shown that the new results are consistent with the direct numerical simulations.

Singer, Bart A.↗
NASA NTRS1992

Features of wavy vortices in a curved channel from experimental and numerical studies

Results are reported from an experimental study obtaining evidence of time-dependent, wavy vortex motions associated with undulating and twisting Dean vortices in a curved channel with 40-to-1 aspect ratio, and mild curvature (radius ratio = 0.979). The results are compared with direct numerical simulations of time-dependent 3D Navier-Stokes equations using boundary conditions in the spanwise and streamwise directions. When viewed in cross section, experimental visualizations of undulating and twisting vortex flows show rocking motion and changes in the direction of the flow between vortices that are like those observed in the simulations. Experimental spectra show that undulating vortices are replaced by the higher-frequency, shorter streamwise wavelength twisting vortices at higher Reynolds numbers. When undulating vortices are present, experimental power spectra and visualizations give frequencies that are somewhat lower than the most unstable frequencies predicted by linear stability analysis.

Ligrani, P. M.↗
NASA NTRS1992

A weakly nonlinear theory for wave-vortex interactions in curved channel flow

A weakly nonlinear theory is developed to study the interaction of Tollmien-Schlichting (TS) waves and Dean vortices in curved channel flow. The predictions obtained from the theory agree well with results obtained from direct numerical simulations of curved channel flow, especially for low amplitude disturbances. Some discrepancies in the results of a previous theory with direct numerical simulations are resolved.

Singer, Bart A.↗
NASA NTRS1997

Turbulence Measurements by the DC-8 Meteorological Measurement System

The instrumentation of a new MMS on the DC-8 aircraft is briefly described. Methods to compute and evaluate the turbulent dissipation rate epsilon, based on theory and MMS data, are discussed. Examples of turbulence measurements during encounters of a wake vortex, wave clouds, persistent contrails, mountain are gravity waves are illustrated.

Chan, K. R.↗
NASA NTRS1991

Applications of the ER-2 meteorological measurement system

The NASA ER-2 aircraft is used as a platform for high altitude atmospheric missions. The Meteorological Measurement System (MMS) was developed specifically for atmospheric research to provide accurate high resolution measurements of pressure, temperature, and the 3-D wind vector with a sampling rate of 5/s. The MMS consist of three subsystems: (1) an air motion sensing system to measure the velocity of the air with respect to the aircraft; (2) a high resolution inertial navigation system (INS) to measure the velocity of the aircraft with respect to the earth; and (3) a data acquisition system to sample, process, and record the measurement quantities. MMS data have been used extensively by ER-2 investigators in elucidating the polar ozone chemistry. Herein, applications on atmospheric dynamics are emphasized. Large scale (polar vortex, potential vorticity, model atmosphere), mesoscale (gravity waves, mountain waves) and microscale (heat fluxes) atmospheric phenomena are investigated and discussed.

Chan, K. Roland↗
NASA NTRS1987

The numerical simulation of subsonic flutter

The present paper describes a numerical simulation of unsteady, subsonic aeroelastic responses. The technique accounts for aerodynamic nonlinearities associated with angles of attack, vortex-dominated flow, static deformations, and unsteady behavior. The fluid and the wing together are treated as a single dynamic system, and the equations of motion for the structure and flowfield are integrated simultaneously and interactively in the time domain. The method employs an iterative scheme based on a predictor-corrector technique. The aerodynamic loads are computed by the general unsteady vortex-lattice method and are determined simultaneously with the motion of the wing. Two models are used to demonstrate the technique: a rigid wing on an elastic support experiencing plunge and pitch about the elastic axis, and a continuous wing rigidly supported at the root chord experiencing spanwise bending and twisting. The time domain solution coupled with the unsteady vortex-lattice method provides the capability of graphically depicting wing and wake motion. Several graphs that illustrate the time domain behavior of the wing and wake are presented.

Strganac, Thomas W.↗
NASA NTRS2002

Optimal Aircraft Control Upset Recovery With and Without Component Failures

This paper treats the problem of recovering sustainable nondescending (safe) flight in a transport aircraft after one or more of its control effectors fail. Such recovery can be a challenging goal for many transport aircraft currently in the operational fleet for two reasons. First, they have very little redundancy in their means of generating control forces and moments. These aircraft have, as primary control surfaces, a single rudder and pairwise elevators and aileron/spoiler units that provide yaw, pitch, and roll moments with sufficient bandwidth to be used in stabilizing and maneuvering the airframe. Beyond this, throttling the engines can provide additional moments, but on a much slower time scale. Other aerodynamic surfaces, such as leading and trailing edge flaps, are only intended to be placed in a position and left, and are, hence, very slow-moving. Because of this, loss of a primary control surface strongly degrades the controllability of the vehicle, particularly when the failed effector becomes stuck in a non-neutral position where it exerts a disturbance moment that must be countered by the remaining operating effectors. The second challenge in recovering safe flight is that these vehicles are not agile, nor can they tolerate large accelerations. This is of special importance when, at the outset of the recovery maneuver, the aircraft is flying toward the ground, as is frequently the case when there are major control hardware failures. Recovery of safe flight is examined in this paper in the context of trajectory optimization. For a particular transport aircraft, and a failure scenario inspired by an historical air disaster, recovery scenarios are calculated with and without control surface failures, to bring the aircraft to safe flight from the adverse flight condition that it had assumed, apparently as a result of contact with a vortex from a larger aircraft's wake. An effort has been made to represent relevant airframe dynamics, acceleration limits, and actuator limits faithfully, since these contribute to the lack of agility and control power that plays an important role in defining what can be achieved with the vehicle when it is in extremis.

Sparks, Dean W.↗
NASA NTRS1994

Low-dimensional description of the dynamics in separated flow past thick airfoils

Results are presented for the numerical simulation of unsteady viscous incompressible flow past thick airfoils. Specifically, flow past a NACA 4424 at an angle of attack of 2.5 deg and Reynolds numbers in the range of 1700-4000 has been simulated using the spectral element method. At these conditions the flow is separatedd and an unsteady wake is formed. Application of the method of empirical eigenfunction reveals the structure of the most energetic components of the flow. These are found to occur in pairs that, through phase exchange, are responsible for the vortex shedding. A set of ordinary differential equations is obtained for the amplitudes of these eigenfunctions by a Galerkin projection of the Navier-Stokes equations. The solutions of the model system are compared with the full simulation. The work is of relevance to the transition process and observed routes to chaos in airfoil wakes.

Deane, Anil E.↗
NASA NTRS1990

Predicting Unsteady Aeroelastic Behavior

New method for predicting subsonic flutter, static deflections, and aeroelastic divergence developed. Unsteady aerodynamic loads determined by unsteady-vortex-lattice method. Accounts for aspect ratio and angle of attack. Equations for motion of wing and flow field solved iteratively and simultaneously. Used to predict transient responses to initial disturbances, and to predict steady-state static and oscillatory responses. Potential application for research in such unsteady structural/flow interactions as those in windmills, turbines, and compressors.

Strganac, Thomas W.↗
NASA NTRS1987

A new method to predict unsteady aeroelastic behavior

A new method for predicting subsonic flutter and static deflections, including divergence, has been developed. The present method accounts for aspect ratio and, in the case of flutter, static deflections. The angle of attack is limited only by the occurrence of stall or vortex bursting near the wing. The innovation in the present method is to integrate simultaneously and interactively the equations of motion of the structure and the flowfield. The present approach employs an iterative scheme based on the predictor-corrector method. The general unsteady vortex-lattice method (UVLM) is used to predict the aerodynamic loads. Because the UVLM predicts the wakes as part of the solution, the history of the motion is taken into account; hysteresis is predicted. The deflection (for both bending and torsion) is expressed as an expansion in terms of the free-vibration modes. The time-dependent coefficients in these expansions serve as the generalized coordinates. Numerical examples illustrating the calculation of static deflections and transient dynamic responses above and below the flutter boundary are included.

Strganac, Thomas W.↗
NASA NTRS2021

Deriving Deformable Mirror Performance Requirements in Simulation with Experimental Verification

Coronagraph instruments rely on predictable and stable deformable mirror (DM) surface displacement to achieve the contrast required to detect Earth-sized exoplanets orbiting nearby Solar-type stars. Anomalous DM behavior, such as unstable or pinned actuators, can limit contrast in coronagraphs. Simulating how these undesired behaviors affect the performance of a high contrast imaging architecture is important for developing requirements on their associated hardware. Simulating a vortex coronagraph (VC) with two deformable mirrors, this study quantifies how the number of pinned actuators affect the performance of Focal Plane Wavefront Sensing and Control algorithms using both Grid Search Electric Field Conjugation (EFC) and Planned EFC, which uses Beta-Bumping. The simulation also quantifies how various types of voltage noise such as zero-mean Gaussian noise, zero-mean periodic noise, and drift can affect the contrast of a VC during an observation run. A tolerance of a change in the Mean Normalized Intensity of ${1\times10^{-11}}$ is allocated to both types of error. If Planned EFC is used, only 1 pinned actuator on both DMs can be tolerated. If only pure Grid Search EFC is used the DMs cannot have any pinned actuators. For the case of zero-mean Gaussian noise and zero-mean periodic noise, one can tolerate a noise standard deviation of no more than ${\sigma = 0.45 \text{ mV}}$. For drift, we can only tolerate ${\sigma = 0.30 \text{ mV}}$ or less. These results show that the DM electronics and the DM themselves need to be nearly defect free to avoid having more than 1 pinned actuator. The electronics need to be tested for different types of noise statistics and that both the average and standard deviation of the noise should be measured.

Dean L. Palmer↗