SEARCH · Search NASA

Results for “Electric double-layer capacitor”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

11 records

All sources NASA NTRS DOE OSTI

DOE OSTI2023

Solid-state polymer magnesium supercapacitor

Here, the present article focuses on the development of a highly ion-conductive, solvent-free, solid-state polymer electrolyte membrane (PEM) via photopolymerization of polyethylene glycol diacrylate (PEGDA) network from its homogeneous melt mixtures containing succinonitrile (SCN) plasticizer and magnesium bis(trifluoromethane sulfonyl) imide Mg(TFSI) 2 salt. The above solid-state Mg-PEM exhibits a Helmholtz electric double-layer capacitor (EDLC) behavior in its supercapacitive symmetric carbonaceous electrode configuration. The electrochemical stability for this PEM membrane (20/40/40 PEGDA/SCN/Mg (TFSI) 2 ) was found to be approximately 3 V from linear sweep voltammetry with a specific capacitance of about 44 F/g from cyclic voltammetry and an energy density of approximately 17 Wh/kg in the 0–2 V range from the constant current density (CCD) experiment. Of particular interest is its excellent capacity retention of over 11,200 cycles, thus tested with the Coulombic efficiency of over 87%. Moreover, the energy density after extensive cycling for 11,200 has increased to approximately 56 Wh/kg at 10 mV/s in the potential range of 0–3 V relative to 17 Wh/kg in the potential range of 0–2 V at the same scan rate, attesting the excellent electrochemical stability and long life of the present Mg-PEM supercapacitor.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

DOE OSTI2023

On the Interplay between Size and Disorder in Suppressing Intercalation-Induced Phase Transitions in Pseudocapacitive Nanostructured MoS 2

Pseudocapacitors are an emerging class of energy storage materials that offer an attractive compromise between the energy density of batteries and power density of electric double-layer capacitors. Decreasing particle size and increasing surface area of battery materials is a common approach for introducing pseudocapacitive behavior and increasing power density. However, in many cases, as the crystal size is reduced, lattice disorder of unknown extent is also introduced, making it difficult to characterize the relative contribution of size and disorder to fast-charging performance. Here, in this work, a series of nanostructured MoS 2 materials are synthesized with different crystallite sizes and degrees of crystallinity to decouple the effects of size and disorder on charge/discharge kinetics. The extent and type of disorder in each material is quantified by total X-ray scattering experiments and pair distribution function analyses. Electrochemical characterization, including galvanostatic rate capability, cyclic voltammetry, and various kinetic analyses, are used to demonstrate that both decreasing particle size and introducing lattice disorder are effective strategies for increasing charge storage kinetics, and that the effects are additive. Finally, operando X-ray diffraction measurements show that both size and disorder can be used suppress first-order Li + intercalation-induced phase transitions, a key feature for enabling pseudocapacitive charge storage.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Optimizing protic ionic liquid electrolyte for pre-intercalated Ti 3 C 2 T x MXene supercapacitor electrodes

Electrical double-layer capacitors (EDLCs) are of increasing importance in energy storage from renewable sources. The properties of the electrode and electrolyte materials influence the energy and power densities of EDLCs. We examined the specific capacitance and ion dynamics of a protic ionic liquid confined in pre-intercalated Ti 3 C 2 T x MXene. Our electrochemical measurements demonstrated that the creation of a protic ionic liquid, 1-butyl-3-H-imidazolium bis(trifluoromethanesulfonyl)imide (BuIMH-NTf2), using a mixture of ionic liquid, 1-butyl imidazole (BuIM), and salt, bis(trifluoromethanesulfonyl)imide (HNTf2), in a ratio of 0.8:0.2 led to the optimal capacitance. Remarkably, quasi-elastic neutron scattering measurements revealed increased particle mobility at this composition, attributed to the more efficient accumulation of BuIMH + on the electrode surface. This deposit of additional ions results in fewer BuIM molecules away from the surface, enhancing their mobility due to reduced crowding. This composition-dependent electrochemical behavior will guide the formulation of more efficient protic ionic liquid systems, enabling faster ion transport in energy storage devices.

36 MATERIALS SCIENCE↗

NASA NTRS2015

Flexible Hybrid Battery/Pseudocapacitor

Batteries keep devices working by utilizing high energy density, however, they can run down and take tens of minutes to hours to recharge. For rapid power delivery and recharging, high-power density devices, i.e., supercapacitors, are used. The electrochemical processes which occur in batteries and supercapacitors give rise to different charge-storage properties. In lithium ion (Li+) batteries, the insertion of Li+, which enables redox reactions in bulk electrode materials, is diffusion controlled and can be slow. Supercapacitor devices, also known as electrical double-layer capacitors (EDLCs) store charge by adsorption of electrolyte ions onto the surface of electrode materials. No redox reactions are necessary, so the response to changes in potential without diffusion limitations is rapid and leads to high power. However, the charge in EDLCs is confined to the surface, so the energy density is lower than that of batteries.

Tucker, Dennis S.↗

NASA NTRS1994

Pyrrole-Based Conductive Polymers For Capacitors

Polypyrrole films containing various dopant anions exhibit superior capacitance characteristics. Used with nonaqueous electrolytes. Candidate for use in advanced electrochemical double-layer capacitors capable of storing electrical energy at high densities. Capacitors made of these films used in automobiles and pulsed power supplies.

Nagasubramanian, Ganesan↗

NASA NTRS2011

Substituted Quaternary Ammonium Salts Improve Low-Temperature Performance of Double-Layer Capacitors

Double-layer capacitors are unique energy storage devices, capable of supporting large current pulses as well as a very high number of charging and discharging cycles. The performance of doublelayer capacitors is highly dependent on the nature of the electrolyte system used. Many applications, including for electric and fuel cell vehicles, back-up diesel generators, wind generator pitch control back-up power systems, environmental and structural distributed sensors, and spacecraft avionics, can potentially benefit from the use of double-layer capacitors with lower equivalent series resistances (ESRs) over wider temperature limits. Higher ESRs result in decreased power output, which is a particular problem at lower temperatures. Commercially available cells are typically rated for operation down to only 40 C. Previous briefs [for example, Low Temperature Supercapacitors (NPO-44386), NASA Tech Briefs, Vol. 32, No. 7 (July 2008), p. 32, and Supercapacitor Electrolyte Solvents With Liquid Range Below 80 C (NPO-44855), NASA Tech Briefs, Vol. 34, No. 1 (January 2010), p. 44] discussed the use of electrolytes that employed low-melting-point co-solvents to depress the freezing point of traditional acetonitrile-based electrolytes. Using these modified electrolyte formulations can extend the low-temperature operational limit of double-layer capacitors beyond that of commercially available cells. This previous work has shown that although the measured capacitance is relatively insensitive to temperature, the ESR can rise rapidly at low temperatures, due to decreased electrolyte conductance within the pores of the high surface- area carbon electrodes. Most of these advanced electrolyte systems featured tetraethylammonium tetrafluoroborate (TEATFB) as the salt. More recent work at JPL indicates the use of the asymmetric quaternary ammonium salt triethylmethylammonium tetrafluoroborate (TEMATFB) or spiro-(l,l')-bipyrrolidium tetrafluoroborate (SBPBF4) in a 1:1 by volume solvent mixture of acetonitrile (AN) and methyl formate (MF) enables double-layer capacitor cells to operate well below -40 C with a relatively low ESR. Typically, a less than twofold increase in ESR is observed at -65 C relative to room-temperature values, when these modified electrolyte blends are used in prototype cells. Double-layer capacitor coin cells filled with these electrolytes have displayed the lowest measured ESR for an organic electrolyte to date at low temperature (based on a wide range of electrolyte screening studies at JPL). The cells featured high-surface-area (approximately equal to 2,500 m/g) carbon electrodes that were 0.50 mm thick and 1.6 cm in diameter, and coated with a thin layer of platinum to reduce cell resistance. A polyethylene separator was used to electrically isolate the electrodes.

Brandon, Erik J.↗

NASA NTRS2012

Low Temperature Double-layer Capacitors with Improved Energy Density: An Overview of Recent Development Efforts

Electrochemical double-layer capacitors are finding increased use in a wide range of energy storage applications, particularly where high pulse power capabilities are required. Double-layer capacitors store charge at a liquid/solid interface, making them ideal for low temperature power applications, due to the facile kinetic processes associated with the rearrangement of the electrochemical double-layer at these temperatures. Potential low temperature applications include hybrid and electric vehicles, operations in polar regions, high altitude aircraft and aerospace avionics, and distributed environmental and structural health monitoring. State-of-the-art capacitors can typically operate to -40 C, with a subsequent degradation in power performance below room temperature. However, recent efforts focused on advanced electrolyte and electrode systems can enable operation to temperatures as low as -70 C, with capacities similar to room temperature values accompanied by reasonably low equivalent series resistances. This presentation will provide an overview of recent development efforts to extend and improve the wide temperature performance of these devices.

Supercapacitors↗

NASA NTRS2012

Low Temperature Double-layer Capacitors with Improved Energy Density: An Overview of Recent Development Efforts

energy storage↗

NASA NTRS2008

Low-Temperature Supercapacitors

An effort to extend the low-temperature operational limit of supercapacitors is currently underway. At present, commercially available non-aqueous supercapacitors are rated for a minimum operating temperature of -40 C. A capability to operate at lower temperatures would be desirable for delivering power to systems that must operate in outer space or in the Polar Regions on Earth. Supercapacitors (also known as double-layer or electrochemical capacitors) offer a high power density (>1,000 W/kg) and moderate energy density (about 5 to 10 Wh/kg) technology for storing energy and delivering power. This combination of properties enables delivery of large currents for pulsed applications, or alternatively, smaller currents for low duty cycle applications. The mechanism of storage of electric charge in a supercapacitor -- at the electrical double-layer formed at a solid-electrode/liquid-electrolyte interface -- differs from that of a primary or secondary electrochemical cell (i.e., a battery) in such a manner as to impart a long cycle life (typically >10(exp 6) charge/discharge cycles).

Brandon, Erik J.↗

DOE OSTI2023

Distance-dependent dielectric constant at the calcite/electrolyte interface: Implication for surface complexation modeling

Hypothesis: The electrical double layer formed at the mineral/electrolyte interface is often modeled using mean-field approaches based on a continuum description of the solvent whose dielectric constant is assumed to decrease monotonically with decreasing distance to the surface. In contrast, molecular simulations show that the solvent polarizability oscillates near the surface similar to the water density profile - as shown previously, for example, by Bonthuis et al. (D.J. Bonthuis, S. Gekle, R.R. Netz, Dielectric Profile of Interfacial Water and its Effect on Double-Layer Capacitance, Phys Rev Lett 107(16) (2011) 166102). Here, we showed that molecular and mesoscale pictures agree by spatially averaging the dielectric constant obtained from molecular dynamics simulations over the distances relevant to the mean-field representation. In addition, the values of capacitances used to describe the electrical double layer in Surface Complexation Models (SCMs) of the mineral/electrolyte interface can be estimated using molecularly informed spatially averaged dielectric constants and positions of hydration layers. Experiments: First, we used molecular dynamics simulations to model the calcite 101¯4/electrolyte interface. Next, by using atomistic trajectories, we calculated the distance-dependent static dielectric constant and water density in the direction normal to the. Finally, we applied spatial compartmentalization consistent with the model of parallel-plate capacitors connected in series to estimate SCM capacitances. Findings: Computationally expensive simulations are required to determine the dielectric constant profile of interfacial water near the mineral surface. On the other hand, water density profiles are readily assessable from much shorter simulation trajectories. Our simulations confirmed that dielectric and water density oscillations at the interface are correlated. Here, we parametrized linear regression models to estimate the dielectric constant directly from the local water density. This is a significant computational shortcut compared to slowly converging calculations relying on total dipole moment fluctuations. The amplitude of the interfacial dielectric constant oscillation can exceed the dielectric constant of the bulk water, suggesting an ice-like frozen state, but only if there are no electrolyte ions. The interfacial accumulation of electrolyte ions causes a decrease in the dielectric constant due to the reduction of water density and re-orientation of water dipoles in ion hydration shells. Finally, we show how to use the computed dielectric properties to estimate SCM's capacitances.

58 GEOSCIENCES↗

DOE OSTI2025

Vertically Aligned Carbon Nanotubes Grown on Copper Foil as Electrodes for Electrochemical Double Layer Capacitors

This study reports a binder-free, catalyst-free method for fabricating vertically aligned carbon nanotubes (VACNTs) directly on copper (Cu) foil using plasma-enhanced chemical vapor deposition (PECVD) for electrochemical double-layer capacitor (EDLC) applications. This approach eliminates the need for catalyst layers, polymeric binders, or substrate pre-treatments, simplifying electrode design and enhancing electrical integration. The resulting VACNTs form a dense, uniform, and porous array with strong adhesion to the Cu substrate, minimizing contact resistance and improving conductivity. Electrochemical analysis shows gravimetric specific capacitance (C grav ) and areal specific capacitance (C areal ) of 8 F g −1 and 3.5 mF cm −2 at a scan rate of 5 mV/s, with low equivalent series resistance (3.70 Ω) and charge transfer resistance (0.48 Ω), enabling efficient electron transport and rapid ion diffusion. The electrode demonstrates excellent rate capability and retains 92% of its initial specific capacitance after 3000 charge–discharge cycles, indicating strong cycling stability. These results demonstrate the potential of directly grown VACNT-based electrodes for high-performance EDLCs, particularly in applications requiring rapid charge–discharge cycles and sustained energy delivery.

25 ENERGY STORAGE↗