SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A five-stage solid-fuel sounding-rocket system which can boost a payload of 25 pounds to an altitude of 525 nautical miles and that of 100 pounds to 300 nautical miles is described. Data obtained from a typical flight test of the system are discussed.
A hydrogen peroxide fueled rocket system, which is to be used as a research tool in flight studies of stall and spin maneuvers, was installed on a light, four place general aviation airplane. The pilot controlled rocket system produces moments about either the roll or the yaw body axis to augment or oppose the aerodynamic forces and inertial moments acting on the airplane during various flight maneuvers, including the spin. These controlled moments of a known magnitude can be used in various ways to help analyze and interpret the importance of the various factors which influence airplane maneuvers. The rocket system and its installation in the airplane are described, and the results of flight rests used to measure rudder and aileron effectiveness at airspeeds above the stall are presented. These tests also serve to demonstrate the operational readiness of the rocket system for future research operations.
Jacketed multilayer insulation system design, fabrication and compression testing for liquid hydrogen storage tank
The objective of this paper is to present a brief survey of three areas in which advances of solid propulsion have enabled improved design of tactical rockets. The three areas are microwave attenuation, acceleration-combustion interactions, and performance optimization. In each of the three areas, improved understanding has significantly contributed to rocket technology. The problems remaining are far from solved, however, and the three subjects are fruitful areas for fundamental investigations.
Solid state data storage digital telemetry system which makes it possible to store and retransmit after reentry blackout
1. Kennedy Space Center (KSC) is developing a mobile launching system with autonomous propellant loading capabilities for liquid-fueled rockets. An autonomous system will be responsible for monitoring and controlling the storage, loading and transferring of cryogenic propellants. The Physics Simulation Software will reproduce the sensor data seen during the delivery of cryogenic fluids including valve positions, pressures, temperatures and flow rates. The simulator will provide insight into the functionality of the propellant systems and demonstrate the effects of potential faults. This will provide verification of the communications protocols and the autonomous system control. 2. The High Pressure Gas Facility (HPGF) stores and distributes hydrogen, nitrogen, helium and high pressure air. The hydrogen and nitrogen are stored in cryogenic liquid state. The cryogenic fluids pose several hazards to operators and the storage and transfer equipment. Constant monitoring of pressures, temperatures and flow rates are required in order to maintain the safety of personnel and equipment during the handling and storage of these commodities. The Gas House Autonomous System Monitoring software will be responsible for constantly observing and recording sensor data, identifying and predicting faults and relaying hazard and operational information to the operators.
Thrust-terminating system conceived to reduce thrust of solid-propellant rocket motor in controlled manner such that thrust loads not increased or decreased beyond predictable levels. Concept involves explosively cutting opposing venting pairs in case of rocket motor above nozzles to initiate venting of chamber and reduction of thrust. Vents sized and numbered to control amount and rate of reduction in thrust.
One efficient way of propelling a spacecraft in space is by means of a rocket (thruster). It is important to understand the process which governs the action. The propulsion system of all rockets consists of a fuel storage system of which there are many different types, due to the different varieties of fuels. There must also be a fuel transport system. The fuel is then expanded in an expansion region, triggered by some form of combustion, and is then accelerated to the nozzle region where it is expelled through the nozzle. The expelled propellant from the rocket comes out and creates a plume. The plume's interaction with spacecraft structures is the focus of this study.
Exposure of assembled and fueled bipropellant liquid rocket propulsion system to ethylene oxide and heat sterilization environments
Commander John Young and pilot Bob Crippin show a short film about the 2 and 1/2 day space mission which encompasses 170 flight objectives. Following the film, they answer questions from the press which cover topics ranging from ejection systems to solid rocket fuels.
The mass budget is detailed for system architectures that use rocket fuels of propellants derived from Deimos and Phobos to transport 10000 ton payloads of exofuel (exoatmospheric fuels) or exomass (exoatmospheric mass) to earth orbits. A point design for the system architecture is used that includes a self-sustaining cycle, which requires no materials from earth, and an infrastructure, which must be emplaced to start the cycle. Both the use of steam rockets and the use of liquid oxygen and liquid hydrogen is examined. It is shown that a system delivering 10000 tons of payload to a highly elliptical earth orbit requires approximately 23000 tons of water for use by nuclear heated steam rockets to effect completely propulsive, round trip maneuvers. It is also shown that about 8000 tons will be available for sale at low earth orbit, each cycle, and that the number of cycles can number in the tens before critical components are replaced.
Monopropellant hydrazine-fueled rocket used as post injection propulsion system for Mariner C spacecraft
A system for multiple burns from a solid fuel rocket motor may extinguish rocket fuel after the rocket has been ignited. The motor may be extinguished via rapid decompression of the combustion chamber. The fuel may then be reignited by a suitable igniter, and the process of extinguishing and reigniting may be repeated, enabling multi-burn maneuvers. A decompressive extinguishing plug nozzle may extinguish solid rocket fuel after the rocket has been ignited and/or keep a rocket in a disarmed (zero thrust) state until the rocket is to be armed. The nozzle may include a plug that mostly impedes the opening of the nozzle and an outer cowl that is movable to rapidly decompress the combustion chamber. This rapid decompression extinguishes the solid rocket fuel. In some aspects, the fuel can be reignited and extinguished multiple times.
A proposed gas strut system would separate a liquid-fueled second rocket stage from a solid-fueled first stage using an array of pre-charged struts. The strut would be a piston-and-cylinder mechanism containing a compressed gas. Adiabatic expansion of the gas would drive the extension of the strut. The strut is designed to produce a force-versus-time profile, chosen to prevent agitation of the liquid fuel, in which the force would increase from an initial low value to a peak value, then decay toward the end of the stroke. The strut would include a piston chamber and a storage chamber. The piston chamber would initially contain gas at a low pressure to provide the initial low separation force. The storage chamber would contain gas at a higher pressure. The piston would include a longitudinal metering rod containing an array of small holes, sized to restrict the flow gas between the chambers, that would initially not be exposed to the interior of the piston chamber. During subsequent expansion, the piston motion would open more of the metering holes between the storage and piston chambers, thereby increasing the flow of gas into the piston chamber to produce the desired buildup of force.
A computer simulation system has been developed for the Space Shuttle's advanced Centaur liquid fuel booster rocket, in order to conduct systems safety verification and flight operations training. This simulation utility is designed to analyze functional system behavior by integrating control avionics with mechanical and fluid elements, and is able to emulate any system operation, from simple relay logic to complex VLSI components, with wire-by-wire detail. A novel graphics data entry system offers a pseudo-wire wrap data base that can be easily updated. Visual subsystem operations can be selected and displayed in color on a six-monitor graphics processor. System timing and fault verification analyses are conducted by injecting component fault modes and min/max timing delays, and then observing system operation through a red line monitor.
Gaseous film cooling of rocket motor with injection near throat
The objective of this research is to produce metallic hydrogen in the laboratory using an innovative approach, and to study its metastability properties. Current theoretical and experimental considerations expect that extremely high pressures of order 4-6 megabar are required to transform molecular hydrogen to the metallic phase. When metallic hydrogen is produced in the laboratory it will be extremely important to determine if it is metastable at modest temperatures, i.e. remains metallic when the pressure is released. Then it could be used as the most powerful chemical rocket fuel that exists and revolutionize rocketry, allowing single-stage rockets to enter orbit and chemically fueled rockets to explore our solar system.
Construction of the world’s largest liquid hydrogen (LH 2 ) storage tank is almost complete at launch pad 39B at NASA Kennedy Space Center (KSC) in Florida. With a usable capacity of 4732 m 3 (1.25 Mgal), this new vessel is roughly 50% larger than its sister tank, which is located 170 m (550 ft) to the southeast. Once the new sphere is fully commissioned these two tanks will provide a combined LH 2 storage capacity of 7950 m 3 (2.1 Mgal) to fuel the new Space Launch System rocket in support of future Artemis exploration missions to the Moon and Mars.