Results for “In-Sb”

NASA NTRS1990

Interface dependence of band offsets in lattice-matched isovalent heterojunctions

Using a previously developed self-consistent dipole theory, we find that the interface dependence of band offsets for lattice-matched isovalent heterojunction is generally small. Specifically, we find the difference between the (001) and (110) band offsets for the common-anion heterojunctions AlP/GaP, AlAs/GaAs, AlSb/GaSb, and CdTe/HgTe to be, at most, 0.02 eV. An investigation of the various details in the calculations leads to an error estimate of +/-0.03 eV; the differences are therefore insignificant. For the noncommon-anion systems, the difference between two different bonding configurations of the (001) interface is noted. Although the differences between the various interfaces are found to be slightly larger than for the common-anion cases, the only significant difference is found to occur between the In-Sb and Ga-As (001) interfaces, where it is 0.1 eV. In this case, the (110) band offset lies midway between the two.

Lambrecht, Walter R. L.↗

NASA NTRS2006

Quantum-Dot Laser for Wavelengths of 1.8 to 2.3 micron

The figure depicts a proposed semiconductor laser, based on In(As)Sb quantum dots on a (001) InP substrate, that would operate in the wavelength range between 1.8 and 2.3 m. InSb and InAsSb are the smallest-bandgap conventional III-V semiconductor materials, and the present proposal is an attempt to exploit the small bandgaps by using InSb and InAsSb nanostructures as midinfrared emitters. The most closely related prior III-V semiconductor lasers are based, variously, on strained InGaAs quantum wells and InAs quantum dots on InP substrates. The emission wavelengths of these prior devices are limited to about 2.1 m because of critical quantum-well thickness limitations for these lattice mismatched material systems. The major obstacle to realizing the proposed laser is the difficulty of fabricating InSb quantum dots in sufficient density on an InP substrate. This difficulty arises partly because of the weakness of the bond between In and Sb and partly because of the high temperature needed to crack metalorganic precursor compounds during the vapor-phase epitaxy used to grow quantum dots: The mobility of the weakly bound In at the high growth temperature is so high that In adatoms migrate easily on the growth surface, resulting in the formation of large InSb islands at a density, usually less than 5 x 10(exp 9) cm(exp -2), that is too low for laser operation. The mobility of the In adatoms could be reduced by introducing As atoms to the growth surface because the In-As bond is about 30 percent stronger than is the In-Sb bond. The fabrication of the proposed laser would include a recently demonstrated process that involves the use of alternative supplies of precursors to separate group-III and group-V species to establish local non-equilibrium process conditions, so that In(As)Sb quantum dots assemble themselves on a (001) InP substrate at a density as high as 4 x 10(exp 10) cm(exp -2). Room-temperature photoluminescence spectra of quantum dots formed by this process indicate that they emit at wavelengths from 1.7 to 2.3 microns.

Qiu, Yueming↗