Search NASA⌕ Search

SEARCH · Search NASA

Results for “Laser-induced plasma plumes”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2011

Assessment Study of Small Space Debris Removal by Laser Satellites

Space debris in Earth orbit poses significant danger to satellites, humans in space, and future space exploration activities. In particular, the increasing number of unidentifiable objects, smaller than 10 cm, presents a serious hazard. Numerous technologies have been studied for removing unwanted objects in space. Our approach uses a short wavelength laser stationed in orbit to vaporize these small objects. This paper discusses the power requirements for space debris removal using lasers. A short wavelength laser pumped directly or indirectly by solar energy can scan, identify, position, and illuminate the target, which will then be vaporized or slow down the orbital speed of debris by laser detonation until it re-enters the atmosphere. The laser-induced plasma plume has a dispersive motion of approximately 105 m/sec with a Lambertian profile in the direction of the incoming beam [1-2]. The resulting fast ejecting jet plume of vaporized material should prevent matter recombination and condensation. If it allows any condensation of vaporized material, the size of condensed material will be no more than a nanoscale level [3]. Lasers for this purpose can be indirectly pumped by power from an array of solar cells or directly pumped by the solar spectrum [4]. The energy required for vaporization and ionization of a 10 cm cube (~ 2700 gm) of aluminum is 87,160 kJ. To remove this amount of aluminum in 3 minutes requires a continuous laser beam power of at least 5.38 MW under the consideration of 9% laser absorption by aluminum [5] and 5% laser pumping efficiency. The power needed for pumping 5.38 MW laser is approximately 108 MW, which can be obtained from a large solar array with 40% efficiency solar cells and a minimal area of 450 meters by 450 meters. This solar array would collect approximately 108 MW. The power required for system operation and maneuvering can be obtained by increasing solar panel size. This feasibility assessment covers roughly the power requirement, laser system, and a potential operational scenario.

Choi, Sang H.↗
NASA NTRS2026

Recommended Practices in Laser-Induced Fluorescence (LIF) Diagnostics for Electric Propulsion

Laser-induced fluorescence (LIF) spectroscopy uses Doppler-shifted laser photons to excite a bound electron transition in an atom or ion, with subsequent fluorescence emission detected in order to measure the local velocity distribution function (VDF) and/or particle density. Due to its non-invasive nature, high spatial resolution, and acceptable difficulty of implementation, LIF has become a favored diagnostic for electric propulsion (EP) plasmas, particularly in the study of Hall thrusters. This paper presents recommended best practices for LIF measurements in electric thrusters, drawn from over three decades of implementation heritage in the EP community. Focusing on both single-photon LIF (typically used to measure VDFs) and two-photon LIF (TALIF, typically used to determine densities), the paper covers selection of atomic transitions to target, experimental setups, and interpretation of data. A number of special topics and advanced applications are discussed, including uncertainty analysis, techniques for high-speed measurements, and applications to a variety of propellants.

plasma plume↗
NASA NTRS2018

Optimization of the Magnetic Field Topology in the Hall Effect Rocket with Magnetic Shielding

NASA's Hall Effect Rocket with Magnetic Shielding (HERMeS) 12.5 kilowatt Technology Demonstration Unit-1 (TDU-1) has been the subject of extensive technology maturation in preparation for flight system development. The TDU-1 thruster implements a magnetically shielded field topology and has demonstrated the elimination of the discharge channel erosion. Extensive wear testing of the TDU Hall thrusters has identified the thruster front pole covers as the next life limiting component. This effort aims to explore and investigate alternate magnetic field topologies to assess whether reductions in the front pole cover erosion can be attained while still maintaining very low erosion rates on the discharge channel walls. NASA GRC (Glenn Research Center) and JPL (Jet Propulsion Laboratory) have begun a magnetic field topology characterization and optimization study by designing four candidate magnetic field topologies that reduce the effectiveness of the shielding along the discharge channel walls with the intent to also reduce the erosion rates along the pole covers. Three of the four candidate magnetic field topologies have been manufactured subjected to an extensive test campaign that includes performance, plume, and stability characterization. In the Phase I test segment, the thruster's oscillation magnitude and laser-induced fluorescence (LIF) measurements of the plasma plume were performed for the three candidate topologies. In Phase I, the thruster's oscillation magnitude and LIF measurements were performed for the three candidate topologies. Phase I test results found that the B1 configuration attained lower oscillation levels than the baseline topology (B0). Additionally, laser induced fluorescence measurements along the discharge chamber centerline found that upstream retraction of the thruster’s peak magnetic field does result in an upstream shift of the acceleration zone but the magnitude of the shift does not correspond one-to-one to the shift in the location of the peak radial magnetic field magnitude. Phase II test segment will include performing performance, stability, plume, and erosion measurements for the various candidate magnetic field topologies..

Kamhawi, Hani↗
NASA NTRSDate not supplied

The Side Plume of Magnetically Shielded Hall Thrusters

A combination of near-thruster laser-induced fluorescence and far-field plasma probe measurements collected from two magnetically shielded Hall thrusters have shown that there exist an independent ion population of medium-energy (on average, 60-190 eV) exiting out the side (60° to 100° from firing axis) of the thrusters. Studying the trends with background pressure and known discrepancies between the laser-induced fluorescence and far-field plasma probe data suggest that at zero pressure the side plume is likely to exhibit higher energy and lower density than at facility background pressures. The possibility that these ions were produced by the modified two-stream instability is explored and while the agreement is good, there are areas of notable disagreement. Based on the idea that production of the side plume and channel exit striations are due to the same plasma wave actions, a theory was explored that explains why striations form under certain circumstances but not others. Another theory, based on the idea that side plume production only occurs over certain portion of the global discharge oscillation cycle, was also explored and areas of disagreement were identified. While the exact mechanism for side plume acceleration remains unclear, if the theory behind side plume production is correct, then side plume can be expected to be present in a wide range of magnetically-shielded as well as non-shielded Hall thrusters.

Hall thruster↗
NASA NTRSDate not supplied

The Side Plume of Magnetically Shielded Hall Thrusters

A combination of near-thruster laser-induced fluorescence and far-field plasma probe measurements collected from two magnetically shielded Hall thrusters have shown that there exist an independent ion population of medium-energy (on average, 60-190 eV) exiting out the side (60° to 100° from firing axis) of the thrusters. Studying the trends with background pressure and known discrepancies between the laser-induced fluorescence and far-field plasma probe data suggest that at zero pressure the side plume is likely to exhibit higher energy and lower density than at facility background pressures. The possibility that these ions were produced by the modified two-stream instability is explored and while the agreement is good, there are areas of notable disagreement. Based on the idea that production of the side plume and channel exit striations are due to the same plasma wave actions, a theory was explored that explains why striations form under certain circumstances but not others. Another theory, based on the idea that side plume production only occurs over certain portion of the global discharge oscillation cycle, was also explored and areas of disagreement were identified. While the exact mechanism for side plume acceleration remains unclear, if the theory behind side plume production is correct, then side plume can be expected to be present in a wide range of magnetically-shielded as well as non-shielded Hall thrusters.

Electric propulsion↗
NASA NTRS2016

Laser-Induced Fluorescence Measurements of Energetic Ions in a 100-A LaB6 Hollow Cathode

Increasingly long-duration space missions require a better understanding of the failure mechanisms of hollow cathodes to enable prediction of lifetime. Energetic ions have been measured in the plume of hollow cathodes but the energies are higher than can be explained classically. One of the mechanisms that appears to be contributing to the ion heating is ion acoustic turbulence (IAT), which has been investigated with plasma probes recently at JPL. In this work the ion velocity distribution has been measured using laser-induced fluorescence (LIF) at several high-current operating conditions on the centerline of a 100 A class hollow cathode at JPL. A retarding potential analyzer was (RPA) was used to measure the ion energy profile in the far plume and a Langmuir probe was used to measure electron temperature and plasma potential fluctuations. RPA energies are shown to correlate with the values measured by LIF. The ion temperature is shown to increase with distance downstream of the cathode. A parametric study of the ion heating as a function of discharge current and cathode flow rate was performed. It was found that for increasing current the ion temperature evolution did not vary even though the wave IAT wave energy increased. The effect of flow rate was more pronounced, with higher values reducing both ion temperature and wave energy linearly. These results indicate that IAT is at least partially responsible for energetic ion production in the hollow cathode plume.

Dodson, Christopher A.↗
NASA NTRS1993

A comparison of arcjet plume properties to model predictions

This paper describes an experimental study of the plasma plume properties of a 1 kW class hydrogen arcjet thruster and the comparison of measured temperature and velocity field to model predictions. The experiments are based on laser-induced fluorescence excitation of the Balmer-alpha transition. The model is based on a single-fluid magnetohydrodynamic description of the flow originally developed to predict arcjet thruster performance. Excellent agreement between model predictions and experimental velocity is found, despite the complex nature of the flow. Measured and predicted exit plane temperatures are in disagreement by as much as 2000K over a range of operating conditions. The possible sources for this discrepancy are discussed.

Cappelli, M. A.↗
NASA NTRS1992

Characterization of electric thruster plumes using multiplexed laser induced fluorescence measurements

The use of laser-induced fluorescence to obtain spatially resolved measurements of propellant velocities and temperatures in electric thruster plumes is discussed, with emphasis on two innovations of the technique, namely simultaneous recording of the optogalvanic signal in a hollow cathode lamp for the purpose of calibrating Doppler shifts, and two-beam multiplexing to allow the measurement of two velocity components at once. It is also shown how information on plume fluctuations can be obtained from the multiplxed LIF data. The techniques are demonstrated on the plume from a low power arcjet, operated on argon, and its extension to the measurement of ion velocities in electrostatic ion thrusters and stationary plasma thrusters is discussed.

Ruyten, W. M.↗