Ex situ bismuth doping for efficient CdSeTe thin-film solar cells with open-circuit voltages exceeding 900 mV
We dope CdTe solar cells with Bi after the device structure is completed using a solution process.
CdTe solar cell↗
SEARCH · Search NASA
Results for “MV”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A measurement of cosmic-ray positron and negatron spectra between 50 and 800 MV
A balloon-borne spark chamber magnetic spectrometer has been used to measure the spectra of cosmic-ray positrons and negatrons at energies between 50 and 800 MV. The data reported here were obtained during two flights from Fort Churchill, Manitoba, in July 1972. The present results indicate that the dominance of negatrons from primary sources, found in earlier experiments above 200 MV, extends down to at least 50 MV. Solar modulation of the positron component is found to be consistent with that of the total electron spectrum, assuming that the positron component is entirely attributable to collisions between cosmic-ray nuclei and the interstellar gas.
Daugherty, J. K.↗
Towards a 700 mV silicon solar cell
The key to improved silicon solar cell performance lies in increasing cell open circuit voltage. Not only does improved voltage direclty increase cell efficiency, but it also increases the limiting value of fill factor and decreases the temperature sensitivity of the cell. Limits on attainable open circuit voltage are not well defined. A thermodynamic limit of 850 mV exists for black body silicon cells, with 700 mV long regarded as a practical limit. This paper describes experimental work which has resulted in experimental devices with open circuit voltages approaching 700 mV. Values up to 694 (AM0, 25 C) have been demonstrated. The cells are similar in structure to conventional p-n junction cells, but particular attention is paid to passivating the entire top surface of the cell, including regions under the top contact.
Green, M. A.↗
Determination of the Three-Dimensional Morphology of ALH84001 and Biogenic MV-1 Magnetite: Comparison of Results from Electron Tomography and Classical Transmission Electron Microscopy
Dated at approximately 3.9 billion years of age, carbonate disks, found within fractures of the host rock of Martian meteorite ALH84001, have been interpreted as secondary minerals that formed at low temperature in an aqueous medium. Heterogeneously distributed within these disks are magnetite nanocrystals that are of Martian origin. Approximately one quarter of these magnetites have morphological and chemical similarities to magnetite particles produced by magnetotactic bacteria strain MV-1, which are ubiquitous in aquatic habitats on Earth. Moreover, these types of magnetite particles are not known or expected to be produced by abiotic means either through geological processes or synthetically in the laboratory. The remaining three quarters of the ALH84001 magnetites are likely products of multiple processes including, but not limited to, precipitation from a hydrothermal fluid, thermal decomposition of the carbonate matrix in which they are embedded, and extracellular formation by dissimilatory Fe-reducing bacteria. We have proposed that the origins of magnetites in ALH84001 can be best explained as the products of multiple processes, one of which is biological. Recently the three-dimensional (3-D) external morphology of the purported biogenic fraction of the ALH84001 magnetites has been the subject of considerable debate. We report here the 3-D geometry of biogenic magnetite crystals extracted from MV-1 and of those extracted from ALH84001 carbonate disks using a combination of high resolution classical and tomographic transmission electron microscopy (TEM). We focus on answering the following questions: (1) which technique provides adequate information to deduce the 3-D external crystal morphology?; and, (2) what is the precise 3-D geometry of the ALH84001 and MV-1 magnetites?
Thomas-Keprta, Kathie L.↗
The hot white dwarf in the cataclysmic variable MV Lyrae
We have obtained the first far-ultraviolet spectrum of the novalike cataclysmic variable MV Lyrae using the Far Ultraviolet Spectroscopic Explorer. We also obtained contemporaneous optical light curves and spectra. All data are from a deep faint accretion state of MV Lyr.
hot white dwarf↗
The interplanetary scattering mean free path from 1 to 3 x 1000 MV
The paper reports a statistical study of published intensity-time profiles of proton and electron solar particle events from 1967 to 1974. The purpose of the study was to examine systematically the temporal and rigidity dependence of the interplanetary scattering mean free path from approximately 1000 to 3000 MV. The observed t-max, the time from release of particles at the sun to the time of maximum flux at the spacecraft, were interpreted in terms of a propagation model to obtain the average radial scattering mean-free path. This path (1) appears to be species independent when it is derived from proton and electron solar particle events, (2) varies less than a factor of 2 from solar maximum to solar minimum, and (3) is nearly rigidity independent below approximately 500 MV. The path values obtained at low rigidities are inconsistent with path values derived theoretically from the interplanetary magnetic field fluctuations.
Zwickl, R. D.↗
Soft X-ray emission from the vicinity of MV Lyr
Evidence for a soft X-ray source at the location of the nova-like variable star MV Lyr is presented. Data from the smallest field of view of the A2 experiment on board HEAO-1 in the range 0.18 to 2.5 keV reveals a source of 0.18 to 0.43 keV emission, designated H1901+43, with a count rate corresponding to a flux of 4 x 10 to the -12th erg/sq cm per sec if a spectral temperature of 3 x 10 to the 5th K is assumed. The two-dimensional error box of H1901+43 is observed to contain the UX UMa star MV Lyr, which is suggested as the only obvious candidate for the source of X-ray emission, in accordance with the observations of soft X-ray emission from other cataclysmic variables, notably AM Her, U Gem and SS Cyg.
Mason, K. O.↗
IUE and optical observations of MV Lyrae at intermediate and low states
Ultraviolet observations of MV Lyrae were obtained with the aid of the International Ultraviolet Explorer (IUE) spacecraft on 1979 December 2 when MV Lyr was at a normal low state and on 1980 December 8. The optical observations were obtained at Kitt Peak, Lick Observatory, and the University of Washington Observatory with various image-tube scanners and photometers. The photometric colors were found to be very blue at the very low state and at the normal low state. Robinson et al. (1981) have identified three components in their very low-state optical spectra. The significance of the observations is discussed.
Szkody, P.↗
MV-3 communication subsystem
The operational mobile VLBI data acquisition system (MV-3) requires that a voice link be established between the mobile data system and a fixed site. A communications subsystem was incorporated in the MV-3 design which consists of HF radio, VHF mobile radio telephone and conventional land line telephone. The HF antenna design was optimized for short and long range transmission using both inverted V and yagi antennas mounted on a self-supporting telescoping mast.
Parks, G. S.↗
Statistical Analyses Comparing Prismatic Magnetite Crystals in ALH84001 Carbonate Globules with those from the Terrestrial Magnetotactic Bacteria Strain MV-1
Here we use rigorous mathematical modeling to compare ALH84001 prismatic magnetites with those produced by terrestrial magnetotactic bacteria, MV-1. We find that this subset of the Martian magnetites appears to be statistically indistinguishable from those of MV-1.
Thomas-Keprta, Kathie L.↗
Demonstration of $E$ acc = 10 MV m −1 with Nb 3 Sn cavities in a cryomodule
Accelerating cryomodules with superconducting cavities are key components for particle accelerators. The efficiency, energy gain and operating temperature of cavities drive the operating and capital costs; hence, advances in these areas enable future accelerators. While superconducting cavities are currently made from Nb, Nb 3 Sn, with a superconducting transition temperature and superheating field approximately twice that of Nb, is poised to substantially improve the efficiency and energy gain. We present results from the first cryomodule with two five-cell 1.5 GHz superconducting radiofrequency Nb cavities coated with Nb 3 Sn, which attained an accelerating gradient of ⩾10 MV m −1 with low cryogenic loss at 4.4 K.
70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗
A measurement of the fast luminescent decays of the MV-50 LED.
The fast luminescent decay of the MV-50 GaAs doped Si light-emitting diode has been studied. This diode is found to provide a fast, inexpensive, bright, and convenient light source for the calibration of fast optical timing systems. A simple passive electronic module is described that allows driving the light source directly by a laboratory pulse generator.
Sutton, J. F.↗
Monitor and control equipment for the MV-3 mobile very long baseline interferometry station
The system, designed around a commercially available process controller, is described. The hardware design, selection of the process control equipment, the design of the interface to other systems, and the analog monitor and process control assembly used to operate the equipment from the MV-3 central computer are discussed.
Sniffin, R. W.↗
A measurement of the fast luminescent decays of the MV-50 LED
Fast luminescent decay of silicon light-emitting diode
Sutton, J. F.↗
Evaluation of the MV (CAPON) Coherent Doppler Lidar Velocity Estimator
The performance of the CAPON velocity estimator for coherent Doppler lidar is determined for typical space-based and ground-based parameter regimes. Optimal input parameters for the algorithm were determined for each regime. For weak signals, performance is described by the standard deviation of the good estimates and the fraction of outliers. For strong signals, the fraction of outliers is zero. Numerical effort was also determined.
Lottman, B.↗
Influence of Solutocapillary Convection on Macrovoid Defect Formation in Polymeric Membranes
Macrovoids (MVs) are large (10-50 micrometers) pores often found in polymeric membranes prepared via phase-inversion techniques. They are generally considered undesirable, as they adversely affect the permeability properties and performance of polymeric membranes for microfiltration, ultrafiltration, and reverse osmosis. However, MVs can be useful in certain thin-film applications in which vapor transmission is necessary, or for use as reservoirs for enzymes or liquid membrane material. If more could be learned about the nature and causes of MV formation, it might be possible to devise techniques to control and/or prevent MV formation that are more effective than those currently employed. Two hypotheses for the MV growth mechanism have been advanced. Reuvers proposed that once initiated, MV growth can be attributed to diffusion of (primarily) solvent to the MV nuclei. Because this mechanism does not involve gross movement of the MV, the presence or absence of body forces such as buoyancy should not significantly affect MV growth. On the other hand, Shojaie et al. proposed that solutocapillary convection induced by a steep surface-tension gradient along the MV/bulk solution interface enhances mass transfer to the growing MV. This interfacial convection exerts a force that pulls the growing MV downward into the casting solution. Both buoyancy and viscous drag hinder MV growth by inhibiting this motion. Thus, removing the buoyancy force by casting in microgravity should augment MV growth according to this hypothesis. Whereas neither surface tension nor gravity has a significant effect on MV growth according to the first hypothesis, buoyancy forces should be important if the second hypothesis is correct. The overall goal of this research is to test these two hypotheses in order to improve our understanding of the MV growth processing solvent-cast polymeric membranes. Studying MV growth in low-gravity conditions is pivotal to our ability to discriminate between these two hypotheses.
Pekny, M. R.↗
Influence of Solutocapillary Convection on Macrovoid Defect Formation in Polymeric Membranes
The focus of this research project involved the dry-cast process for polymeric membrane formation, whereby evaporation of solvent from an initially homogeneous polymer/solvent/ nonsolvent solution results in phase separation and the formation of polymer-rich and polymer-lean phases. Under certain conditions the polymer-lean phase gives rise to very large and usually undesirable, tear-drop-shaped pores (size approx. 10 - 50 microns) termed macrovoids (MVs). Although in many cases the presence of MV pores has deleterious effects on membrane performance, there are a number of innovative applications where the presence of such pores is highly desirable. Although researchers have proposed a variety of mechanisms for MV formation over the past three decades, two main hypotheses are currently favored: one asserts that MV growth can be attributed solely to diffusion (the diffusive growth hypothesis), whereas the other states that solutocapillary convection (the SC hypothesis) at the MV interface contributes to growth. The overall goal of this research was to obtain a more comprehensive understanding of the fundamental mechanism of MV growth. This research incorporates a coupled modeling and experimental approach to test a solutocapillary convection hypothesis for the growth of macrovoid pores in polymeric membranes. Specifically, we utilized a modification of the first principles model developed by two of the PIs (ARG and WBK) for dry-cast CA membranes. For the experimental component, two separate and mutually complementary approaches were used to study MV growth. In the first, membranes cast in a zero-g environment aboard the NASA KC-135 aircraft were compared with those cast on the ground to assess the effect of the buoyancy force on membrane morphology and MV size and shape. In the second approach, videomicroscopy flow visualization (VMFV) was utilized to observe MV formation and growth in real time and to assess the effect of surface tension on the MV growth dynamics. As a result of these fundamental studies, our research group advanced a new hypothesis for MV pore development in polymeric membranes.
Greenberg, Alan R.↗
A distinct subpopulation of membrane vesicles in Pseudomonas putida is enriched in enzymes for lignin catabolism
Bacterial membrane vesicles (MVs) mediate diverse microbial processes and are emerging as powerful biomedical tools, but MV population heterogeneity remains an open question. Here, we separate, enumerate, and characterize two MV populations from the soil bacterium Pseudomonas putida during growth with or without lignin-derived carbon, a major carbon source from plant cells in the rhizosphere. Small MVs (MV-S, diameter ~100 nm) were produced from all cultures, whereas large MVs (MV-L, diameter ~300 nm) were observed during the late stationary phase of lignin cultivations. MV-S contained selectively packaged proteins with diverse physiological functions, whereas the MV-L proteome was smaller and largely enriched in outer membrane proteins. Interestingly, enzymes known to mediate the catabolism of lignin-derived aromatic compounds were enriched in MV-S. Overall, this study highlights the need for careful consideration of MV populations in microbial systems.
59 BASIC BIOLOGICAL SCIENCES↗