Results for “Minimum quantity lubrication”

DOE OSTI2022

Macroscale superlubricity by a sacrificial carbon nanotube coating

Superlubricity, i.e., coefficient of friction (COF) below 0.01, was earlier limited to microscale in controlled environments in the earlier literature and more recently realized for macroscale sliding of ceramic or carbon surfaces lubricated by water or other polar fluids. However, there is lack of report of superlubricity for the most common bearing system, i.e., steel-steel contact in non-polar oil lubrication. Here, in this work, we present ultra-low COF of 0.001–0.007 by using a sacrificial coating composed of vertically-aligned carbon nanotubes (CNTs) for macroscale steel-steel sliding under minimum quantity lubrication (MQL) of a polyalphaolefin (PAO) oil in the ambient environment. Raman spectroscopy and electron microscopy analyses detected graphene-containing tribofilms on both the steel surfaces, which was produced by the fractured CNT flakes and metallic wear debris during running-in. The in situ formed graphene-graphene contact interface presumably possesses a low shear resistance leading to superlubricity. The presence of oil, despite as little as one droplet, has proven to be crucial. Such a superlubricity performance has shown good sustainability in extended testing of more than 500,000 cycles and strong ability of accommodating changes in sliding conditions. Results here demonstrate feasibility with fundamental insights for achieving ambient environment macroscale superlubricity.

36 MATERIALS SCIENCE↗

DOE OSTI2020

Comparing energy and water use of aqueous and gas-based metalworking fluids

Gas-based metalworking fluids (MWFs) have been proposed as alternative coolants and lubricants in machining operations to mitigate concerns surrounding water use and pollution, industrial hygiene, occupational health, and performance limitations associated with water-based (aqueous) MWFs that are ubiquitously used in the metals manufacturing industry. This study compares the primary energy and water use associated with the consumptive use, delivery, and disposal of aqueous MWFs with three gas-based MWFs in the literature-minimum quantity lubricant-in-compressed air (MQL), liquid/gaseous N-2, and liquid/supercritical CO2. The comparison accounts for reported differences in machining performance in peer-reviewed experimental studies across several machining processes and materials. The analysis shows that despite the reported improvement in tool life with N-2 and CO2-based MWFs, the electricity- and water-intensive separation and purification processes for N-2 and CO2 lead to their higher primary energy and water use per volume of material machined relative to water-based MWFs. Although MQL is found to have lower primary energy use, significant consumptive water use associated with the vegetable oil commonly used with this MWF leads to higher overall water use than aqueous MWF, which is operated in a recirculative system. Gas-based MWFs thus shift the water use upstream of the manufacturing plant. Primary energy and water use of gas-based MWFs could be reduced by focusing on achieving higher material removal rates and throughput compared to aqueous MWF instead of solely targeting improvements in tool life. Additionally, the consumptive use of CO2 and N-2 MWFs could be minimized by optimizing their flow rates and delivery to precisely meet the cooling and lubrication needs of specific machining processes instead of flooding the tool and workpiece with these gases. This article met the requirements for a gold-gold JIE data openness badge described at http://jie.click/badges.

cutting fluids↗