Search NASA⌕ Search

SEARCH · Search NASA

Results for “NOZZLE EXPANSION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1961

The Effect on Thrust Minus Base Drag of Exchanging Base Area for Nozzle Expansion in Supersonic Nozzles at Transonic Mach Numbers

A wind-tunnel investigation to determine the effect on thrust minus base drag of exchanging base area for nozzle overexpansion on a cylindrical afterbody with a single supersonic nozzle has been conducted a t Mach numbers from 0.9 t o 1.4. The throat-to-base diameter ratio has been varied from 0.320 to 0.550; the jet-to-base diameter ratio has been varied from 0.320 to 1, resulting in a jet Mach number variation of 1.0 to 3.897. The jet total-pressure ratio ranged from 2 to approximately 22. The results indicated that a proper balance between nozzle over-expansion and base area exists, which will produce the maximum afterbody net-thrust factor over a given operating range. For a given Mach number and throat-to-base diameter ratio, the optimum values of jet-to-base diameter ratio corresponding to the peak values of the net-thrust factor are, in general, larger than the values at the jet design pressure ratio and tend to increase with increasing j e t total-pressure ratio in a manner similar to the design values. Also, for given values of throat-to-base diameter ratio and jet total-pressure ratio, the optimum value of jet-to-base diameter ratio changed as the free-stream Mach number was varied from transonic to low supersonic speeds. The magnitude of the changes varied with jet total-pressure ratio and throat-to-base diameter ratio.

Slocumb, Travis H.↗
NASA NTRS1973

Double expansion nozzles for shock tunnels and Ludwieg tubes

Double expansion nozzles use a shock system located between two sonic throats in order to exchange total pressure for flow cross-sectional area. They can be useful for gaskinetic and aerodynamic flows that otherwise cannot take advantage of available pressure capability. This paper reports experiments with a 7.5 by 10 cm, Mach 3 nozzle operated in both conventional and double expansion nozzle modes using 7.5 by 10 cm and 2.5 cm I.D. Ludwieg drive tubes, respectively. Pressure traces document a simple starting model for the double expansion case, while holographic interferometry has been used to establish and compare nozzle flow quality. Interferometry is also used to estimate turbulence levels through onset of fringe breakdown. The measurements generally show that, with careful design, double expansion nozzles can be used to extend facility performance without loss in flow quality and with acceptable loss in testing time.

Russell, D. A.↗
NASA NTRS1971

Vibrational population distributions in nonequilibrium nozzle expansion flows

Experimental measurements and theoretical calculations of the vibrational population distribution in nonequilibrium nozzle expansion flows of gas mixtures are reported. These studies were directed toward determining whether vibrational energy exchange pumping could lead to laser action on the vibrational bands of a diatomic molecule. Three different types of experiments were conducted. These showed (1) that vibrational energy was preferentially transferred from N2 to CO in supersonic nozzle flows containing these gases; (2) that under some conditions this vibrational energy exchange pumping mechanism created population inversions in the vibrational levels of CO; and (3) that at large expansion ratios the magnitude of these population inversions was sufficient to sustain lasing in the nozzle. A theoretical model was developed to calculate vibrational state population distributions in gas dynamic expansions of a mixture of diatomic gases. Although only isothermal calculations have been completed, these data indicate that population inversions are predicted for conditions similar to those obtained in the nozzle expansion flows.

Watt, W. S.↗
NASA NTRS1956

Effect of combustion-chamber pressure and nozzle expansion ratio on theoretical performance of several rocket propellant systems

Theoretical calculations of specific impulse to determine the separate effects of increasing the combustion-chamber pressure and the nozzle expansion ratio on the performance of the propellants, hydrogen-fluorine, hydrogen-oxygen, ammonia-fluorine and AN-F-58 fuel - white fuming nitric acid (95 percent). The results indicate that an increase in specific impulse obtainable with an increase in combustion-chamber pressure is almost entirely caused by the increased expansion ratio through the nozzle.

FUELS - ROCKETS (INCLUDES FUEL AND OXIDANT)↗
NASA NTRS2005

Review of HxPyOz-Catalyzed H + OH Recombination in Scramjet Nozzle Expansions; and Possible Phosphoric Acid Enhancement of Scramjet Flameholding, from Extinction of H3PO4 + H2 - Air Counterflow Diffusion Flames

Recent detailed articles by Twarowski indicate that small quantities of phosphorus oxides and acids in the fuel-rich combustion products of H2 + phosphine (PH3) + air should significantly catalyze H, OH and O recombination kinetics during high-speed nozzle expansions -- to reform H2O, release heat, and approach equilibrium more rapidly and closely than uncatalyzed kinetics. This paper is an initial feasibility study to determine (a) if addition of phosphoric acid vapor (H3PO4) to a H2 fuel jet -- which is much safer than using PH3 -- will allow combustion in a high-speed scramjet engine test without adverse effects on localized flameholding, and (b) if phosphorus-containing exhaust emissions are environmentally acceptable. A well-characterized axisymmetric straight-tube opposed jet burner (OJB) tool is used to evaluate H3PO4 addition effects on the air velocity extinction limit (flame strength) of a H2 versus air counterflow diffusion flame. Addition of nitric oxide (NO), also believed to promote catalytic H-atom recombination, was evaluated for comparison. Two to five mass percent H3PO4 in the H2 jet increased flame strength 4.2%, whereas airside addition decreased it 1%. Adding 5% NO to the H2 caused a 2% decrease. Products of H-atom attack on H3PO4 produced an intense green chemiluminescence near the stagnation point. The resultant exothermic production of phosphorus oxides and acids, with accelerated H-atom recombination, released sufficient heat near the stagnation point to increase flame strength. In conclusion, the addition of H3PO4 vapor (or more reactive P sources) to hydrogen in scramjet engine tests may positively affect flameholding stability in the combustor and thrust production during supersonic expansion -- a possible dual benefit with system design / performance implications. Finally, a preliminary assessment of possible environmental effects indicates that scramjet exhaust emissions should consist of phosphoric acid aerosol, with gradual conversion to phosphate aerosol. This is compared to various natural abundances and sources.

Pellett, Gerald↗
NASA NTRS1954

Effect of Jet-nozzle-expansion Ratio on Drag of Parabolic Afterbodies

The interaction of the flow from one convergent and two convergent-divergent nozzles on parabolic afterbodies was studied at free-stream Mach numbers of 2.0, 1.6, and 0.6 over a range of jet pressure ratio. The influence of the jet on boattail and base drag was very pronounced. Study of the total external afterbody drag values at supersonic speeds indicated that, over most of the high-pressure-ratio range, increasing the nozzle design expansion ratio increased the drag even though the boattail area was reduced. Increasing the pressure ratio tended to increase slightly the total-drag increment caused by angle-of-attack operation.

Englert, Gerald W↗
NASA NTRS1989

Rocket nozzle expansion ratio analysis for dual-fuel earth-to-orbit vehicles

Results are reported from a recent study of the effects of Space Shuttle Main Engine expansion ratio modifications, in the cases of both single-stage and two-stage systems. Two-position nozzles were employed; after varying the lower expansion ratio while the higher was held constant at 120, the lower expansion ratio was held constant at 40 or 60 while the higher expansion ratio was varied. The expansion ratios for minimum vehicle dry mass are different for single-stage and two-stage systems. For two-stage systems, a single expansion ratio of 77.5 provides a lower dry mass than any two-position nozzle.

Martin, James A.↗
NASA NTRS1959

ONE-DIMENSIONAL FLOW WITH CHEMICAL REACTION IN NOZZLE EXPANSIONS

This report presents calculations for a system involving the constituents CO, 02, CO2, and an inert gas having the thermal properties of a mixture of N2 and H20. The proportions of constituents are the same as those of a stoichiometric hydrocarbon-air system; however, only one overall reaction, that of CO + 1/2 O2 ⇄ C02, is assumed to occur. The results of calculations at simulated Mach numbers of 4, 7, and 10 are shown. The effect of uncertainties in the reaction rate constant are also shown. A comparison of the results of the more exact calculations with interpretations based on Penner's criteria is presented. Modes of energy storage other than chemical (for example, vibrational and rotational modes) were assumed to be at equilibrium. Finally, the extent of entropy change in the nonequilibrium reacting gas flow is discussed.

T W Reynolds↗
NASA NTRS1996

An Experimental and Computational Investigation of a Translating Throat Single Expansion-Ramp Nozzle

A translating throat single expansion-ramp nozzle (SERN) concept was designed to improve the off-design performance of a SERN with a large, fixed expansion ratio. The concept of translating the nozzle throat provides the SERN with a variable expansion ratio. An experimental and computational study was conducted to predict and verify the internal performance of this concept. Three nozzles with expansion ratios designed for low, intermediate, and high Mach number operating conditions were tested in the Jet-Exit Test Facility at the NASA Langley Research Center. Each nozzle was tested with a concave and a convex geometric expansion ramp surface design. Internal nozzle performance, paint-oil flow and focusing Schlieren flow visualization were obtained for nozzle pressure ratios (NPR's) up to 13. The Navier-Stokes code, PAB3D, with a k-epsilon turbulence model was utilized to verify experimental results at selected NPR's and to predict the performance at conditions unattainable in the test facility. Two-dimensional simulations were computed with near static free-stream conditions and at nozzle pressure ratios of 5, 9, and 13 for the concave ramp, low Mach number configuration and at the design NPR of 102 for the concave ramp, high Mach number configuration. Remarkable similarities between predicted and experimental flow characteristics, as well as performance quantities, were obtained.

Deere, Karen A.↗
NASA NTRS1996

An experimental and computational investigation of a translating throat single expansion-ramp nozzle

A translating throat single expansion-ramp nozzle (SERN) concept was designed to improve the off-design performance of a SERN with a large, fixed expansion ratio. The concept of translating the nozzle throat provides the SERN with a variable expansion ratio. An experimental and computational study was conducted to predict and verify the internal performance of this concept. Three nozzles with expansion ratios designed for low, intermediate, and high Mach number operating conditions were tested in the Jet-Exit Test Facility at the NASA Langley Research Center. Each nozzle was tested with a concave and a convex geometric expansion ramp surface design. Internal nozzle performance, paint-oil flow and focusing Schlieren flow visualization were obtained for nozzle pressure ratios (NPR's) up to 13. The Navier-Stokes code, PAB3D, with a k-epsilon turbulence model was utilized to verify experimental results at selected NPRs and to predict the performance at conditions unattainable in the test facility. Two-dimensional simulations were computed with near static free-stream conditions and at nozzle pressure ratios of 5, 9, and 13 for the concave ramp, low Mach number configuration and at the design NPR of 102 for the concave ramp, high Mach number configuration. Remarkable similarities between predicted and experimental flow characteristics, as well as performance quantities, were obtained.

Deere, Karen A.↗
NASA NTRS1992

Single expansion ramp nozzle simulations

The single-expansion-ramp-nozzle (SERN) experiment underway at NASA Ames Research Center simulates the National Aerospace Plane propulsive jet-plume flow. Recently, limited experimental data has become available from an experiment with a generic nozzle/afterbody model in a hypersonic wind tunnel. The present paper presents full three-dimensional solutions obtained with the implicit Navier-Stokes solver, FL3D, for the baseline model and a version of the model with side extensions. Analysis of the computed flow clearly shows the complex 3-D nature of the flow, critical flow features, and the effect of side extensions on the plume flow development. Flow schematics appropriate for the conditions tested are presented for the baseline model and the model with side extensions. The computed results show excellent agreement with experimental shadowgraph and with surface pressure measurements. The computed and experimental surface oil-flows show the same features but may be improved by appropriate turbulence modeling.

Ruffin, Stephen M.↗