NASA NTRSDate not supplied
Traditional approaches for aircraft certification require the assumption of an initial flaw condition, either represented as barely visible impact damage (BVID) or through inclusion of a Teflon insert to serve as surrogate damage. Based on the initial composite damage state, the structure must be shown to demonstrate structural durability and damage tolerance (DaDT) according to the following criteria: a. Damage displays no detrimental growth under cyclic loading b. The structure is able to sustain design limit load (DLL) Currently, the only available manner for validating structural performance is through test. Since damage can occur over a wide variety of areas within a structure, this approach has proven to be increasingly expensive and time consuming for composite airframes and acreage structure within the design-test-certification building block. A further complicating factor is the requirement to accurately capture the most critical damage morphologies as a starting condition. To understand the severity of the damage, it is either required to experimentally determine the most critical areas at tremendous expense or rely on legacy data of similar structural testing, which limits design space expansion. A preferred solution is to use advanced analysis to provide improved understanding of load margins for critical locations based on a wide variety of potential starting damage conditions. The standard industry approach for DaDT certification adheres to the use of the traditional virtual crack closure technique (VCCT) method. VCCT is generally a preferred method because it conforms to the current certification principles of damage from a known flaw, and when used correctly, can be effective at predicting delamination propagation under static and cyclic loading. The VCCT method requires the inclusion of an initial flaw in the finite element (FE) model requiring a-priori knowledge of the flaw location. This in turn requires a plethora of analysis cases to be examined to cover a reasonable span of potential damage states. Additionally, the VCCT approach requires node-to-node connectivity rendering it incompatible with the best practices and approaches for using continuum damage mechanics (CDM) based progressive damage and failure analysis (PDFA) tools within a typical FE solver. Alternatives to VCCT have emerged in the form of cohesive elements which utilize the cohesive zone model (CZM). Unlike VCCT which models linear elastic fracture mechanics, cohesive elements couples continuum and fracture based responses through the use of bilinear traction separation laws. These laws are defined based on a penalty stiffness, a cohesive strength, and a strain energy release rate. The approach can be mesh regularized with native cohesive elements within many FE solvers such as Abaqus and LS-DYNA. In Phase I of the NASA Advanced Composites Consortium (ACC) post-buckled stiffened panel with BVID, Strength and Life [1], the performance of cohesive elements were benchmarked in comparison to VCCT and LEFM solutions and showed good agreement using Abaqus explicit [2]. To realize savings on current and future programs, it is still necessary to close technical gaps related to the use of cohesive elements with Abaqus Standard. Within a program environment, standard finite element analysis is the preferred analytical capability for quasi-static loading as it eliminates uncertainty due to oscillatory behavior commonly seen with explicit analysis. This oscillatory behavior creates difficulties in writing margins of safety based on the analysis. The use of negative tangent stiffness material models complicates convergence which typically requires the use of numerical controls such as viscous damping to overcome. To date, there has not been a comprehensive study on how to establish best practices for cohesive element convergence for predictive capability within the Abaqus implicit solver. In pursuit of these goals, under the NASA ACC program, several numerical benchmark problems were proposed including pure mode I (double cantilevered beam – DCB), pure mode II (end notch flexure – ENF), and symmetric/unsymmetric evolving mixed mode (single leg bend – SLB). This paper focuses on the use of cohesive elements to model the delamination through the use of CZM. Specifically, finite element models for the DCB, ENF, symmetric SLB, and unsymmetric SLB, are developed and various solution controls for convergence are studied to develop a best practice. Once the best practice has been developed, the predictive capability of the objective CZM model is used to analyze the hat pull-off strength of a standard hat stiffened configuration under various loading conditions.