Search NASA⌕ Search

SEARCH · Search NASA

Results for “T-matrix particle scattering”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

How Much Attenuation Extinguishes mm-Wave Vertically Pointing Radar Return Signals?

Vertically pointing radars (VPRs) operating at millimeter wavelengths measure the power return from raindrops enabling precipitation retrievals as a function of height. However, as the rain rate increases, there are combinations of rain rate and rain path length that produce sufficient attenuation to prevent the radar from detecting raindrops all the way through rain shafts. This study explores the question: Which rain rate and path length combinations completely extinguish radar return signals for VPRs operating between 3 and 200 GHz? An important step in these simulations is converting attenuated radar reflectivity factor into radar received signal-to-noise ratio (SNR) in order to determine the range where the SNR drops below the receiver detection threshold. Configuring the simulations to mimic a U.S. Department of Energy Atmospheric Radiation Mission (ARM) W-band (95 GHz) radar deployed in Brazil, the simulation results indicate that a W-band radar could observe raindrops above 3.5 km only when the rain rate was less than approximately 4 mm h -1 . The deployed W-band radar measurements confirm the simulation results with maximum observed heights ranging between 3 and 4.5 km when a surface disdrometer measured 4 mm h -1 rain rate (based on 25-to-75 percentiles from over 25,000 W-band radar profiles). In summary, this study contributes to our understanding of how rain and atmospheric gas attenuation impacts the performance of millimeter-wave VPRs and will help with the design and configuration of multi-frequency VPRs deployed in future field campaigns.

54 ENVIRONMENTAL SCIENCES↗

Characterization of a modified printed optical particle spectrometer for high-frequency and high-precision laboratory and field measurements

Abstract. The printed optical particle spectrometer (POPS) is a lightweight, low-cost instrument for measurements of aerosol number concentrations and size distributions. This work reports on modifications of the Handix Scientific commercial version of the POPS to facilitate its use in multi-instrument aerosol sampling systems. The flow system is modified by replacing the internal pump with a needle valve and a vacuum pump. The instrument is integrated into closed-flow systems by routing the sheath flow from filtered inlet air. A high-precision multichannel analyzer (MCA) card is added to sample the analog pulse signal. The MCA card is polled at 10 Hz frequency using an external data acquisition system and improves upon the count-rate limitation associated with the POPS internal data acquisition system. The times required to change the concentration between 90 % and 10 % and vice versa for a step change in concentration were measured to be 0.17 and 0.41 s at a flow rate of 5 cm3 s−1. This yields a sampling frequency of ∼ 1–2 Hz, below which the amplitude of measured fluctuations is captured with > 70 % efficiency. The modified POPS was integrated into the dual tandem differential mobility analyzer system to explore the coalescence of dimer particles. Results show that the pulse-height response increases upon dimer coalescence. The magnitude of the increase is broadly consistent with the change in light-scattering amplitude predicted by the T-matrix method. It is anticipated that this modified version of the POPS will extend the utilization of the technique for a range of field and laboratory applications.

54 ENVIRONMENTAL SCIENCES↗

Light scattering study of highly absorptive, non-fractal, hematite aggregates

In this paper, we present measurements of the scattered light intensity by aerosolized hematite aggregate particles. The measurements were made at a wavelength of 532 nm in the scattering angle range from 0.32° to 157°. Hematite has high values of the real and imaginary parts of the refractive index m = n + iκ = 3 + i0.5 at the studied wavelength. Scanning electron micrographs (SEM) indicated that the particles were aggregates whereas the optical microscope pictures showed that the aerosol had a bimodal distribution with effective mean diameters of roughly 1 and 10 µm. This is consistent with the light scattering results which displayed two Guinier regimes. The aggregates were composed of smaller grains with an approximate size of 200 nm. Ultra Small-Angle X-ray Scattering (USAXS) indicate that the aggregates were uniform and non-fractal. Mie calculations for a sphere equivalent to the aggregate size were compared to the experimentally observed results. The observed results showed an enhanced backscattering, whereas the Mie calculations did not due to the large imaginary part of the refractive index. Hematite aggregates were simulated by assuming they were composed of spherical monomers inside a spherical volume. Then the light scattering was calculated using the T-matrix method for these simulated aggregates. The calculated results show an enhanced backscattering. We present a dimensional analysis to estimate the extent of multiple scattering within the aggregate and find a correlation between the average number of scattering events within the aggregate and the enhancement in the backscattering.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Revisiting the Hail Radar Reflectivity–Kinetic Energy Flux Relation by Combining T-Matrix and Discrete Dipole Approximation Calculations to Size Distribution Observations

The retrieval of hail kinetic energy with weather radars or its simulation in numerical models is challenging because of the shape complexity and variable density of hailstones. We combine 3D scans of individual hailstones with measurements of the particle size distributions (PSD) and T-matrix calculations to understand how hail reflectivity Z changes when approximating hailstones as spheroids, as compared to the realistic shapes obtained by 3D scanning technology. Additionally, recent terminal velocity relations are used to compare Z to the hail kinetic energy flux E ˙ . We parameterize the hail backscattering cross sections at L, S, C, and X bands as a function of size between 0.5 and 5.0 cm, matching the range of the observed PSDs. The scattering calculations use the T-matrix method for size parameters below 1.0 and the discrete dipole approximation (DDA) method otherwise. The DDA calculations are done for 48 digital models of realistic hailstones of sizes between 1 and 5 cm. The DDA cross sections are calculated for multiple orientations and averaged assuming a fully random orientation distribution to provide a single value per hailstone. The T-matrix reflectivity assuming solid ice spheres presents negligible differences to DDA results for size parameters below 1.0. Therefore, T matrix was used to fill in the gaps left by the DDA calculations. The results are mapped to the same size bins of the observed PSDs, allowing the calculation of the radar reflectivity. This is then correlated to E ˙ , allowing a potential improvement of past retrieval methods of E ˙ from Z in multiple wavelengths.

54 ENVIRONMENTAL SCIENCES↗

Neutron-neutron scattering length from the 6 He(p,pα)nn reaction

We propose a novel method to measure the neutron-neutron scattering length using the 6 He(p,pα)nn reaction in inverse kinematics at high energies. The method is based on the final-state interaction (FSI) between the neutrons after the sudden knockout of the α particle. We show that the details of the neutron-neutron relative-energy distribution allow for a precise extraction of the s-wave scattering length. Here, we present the state of the art in regard to the theory of this distribution. The distribution is calculated in two steps. First, we calculate the ground-state wave function of 6 He as a αnn three-body system. For this purpose we use Halo effective field theory, which also provides uncertainty estimates for the results. We compare our results at this stage to model calculations done with the computer code face. In a second step we determine the effects of the nn FSI using the nn t-matrix. We compare these FSI results to approximate FSI approaches based on standard FSI enhancement factors. While the final distribution is sensitive to the nn scattering length, it depends only weakly on the effective range. Throughout we emphasize the impact of theoretical uncertainties on the neutron-neutron relative-energy distribution, and discuss the extent to which those uncertainties limit the extraction of the neutron-neutron scattering length from the reaction 6 He(p,pα)nn.

6 ≤ A ≤ 19↗